Good governance and the extractive industries in sub-saharan Africa

This article critically examines the challenges that come with implementing the Extractive Industries Transparency Initiative (EITI)a policy mechanism marketed by donors and Western governments as a key to facilitating economic improvement in resource-rich developing countriesin sub-Saharan Africa. The forces behind the EITI contest that impoverished institutions, the embezzlement of petroleum and/or mineral revenues, and a lack of transparency are the chief reasons why resource-rich sub-Saharan Africa is underperforming economically, and that implementation of the EITI, with its foundation of good governance, will help address these problems. The position here, however, is that the task is by no means straightforward: that the EITI is not necessarily a blueprint for facilitating good governance in the region's resource-rich countries. It is concluded that the EITI is a policy mechanism that could prove to be effective with significant institutional change in host African countries but, on its own, it is incapable of reducing corruption and mobilizing citizens to hold government officials accountable for hoarding profits from extractive industry operations.

Improved process topology for membrane distillation

In membrane distillation in a conventional membrane module, the enthalpies of vaporisation and condensation are supplied and removed by changes in the temperatures of the feed and permeate streams, respectively. Less than 5% of the feed can be distilled in a single pass, because the potential changes in the enthalpies of the liquid streams are much smaller than the enthalpy of vaporisation. Furthermore, the driving force for mass transfer reduces as the feed stream temperature and vapour pressure fall during distillation. These restrictions can be avoided if the enthalpy of vaporisation is uncoupled from the heat capacities of the feed and permeate streams. A specified distillation can then be effected continuously in a single module. Calculations are presented which estimate the performance of a flat plate unit in which the enthalpy of distillation is supplied and removed by the condensing and boiling of thermal fluids in separate circuits, and the imposed temperature difference is independent of position. Because the mass flux through the membrane is dependent on vapour pressure, membrane distillation is suited to applications with a high membrane temperature. The maximum mass flux in the proposed module geometry is predicted to be 30 kg/m2 per h at atmospheric pressure when the membrane temperature is 65°C. Operation at higher membrane temperatures is predicted to raise the mass flux, for example to 85 kg/m2 per h at a membrane temperature of 100°C. This would require pressurisation to 20 bar to prevent boiling at the heating plate of the feed channel. Pre-pressurisation of the membrane pores and control of the dissolved gas concentrations in the feed and the recyled permeate should be investigated as a means to achieve high temperature membrane distillation without pore penetration and wetting.

Direct contact membrane distillation

This review looks at the work carried out over the past 15 years on membrane distillation and reports the conditions utilized for research. The process is still used mainly at the laboratory scale, but a few pilot plants have been built across the world, mostly for desalination and the production of potable water. Studies into membrane distillation have been concerned with the effect of mass transfer, heat transfer, and stirring rate, but the most important effect that has to be considered with this process is temperature polarization. A section on temperature polarization and the effect of boundary layers is included in this review.

Permeate flux modeling of membrane distillation

This paper concerns the modeling of membrane distillation. The model developed has been used to predict permeate fluxes using different initial operating conditions. PVDF and PTFE membranes were successfully used in a flat plate module to experimentally confirm the theoretical results. The correlation between theory and experiment was close for both membranes. The PTFE membranes produced higher fluxes than PVDF. A Versapor membrane was also used for this work. This membrane is a composite, with a thin porous layer on a support layer. It was found not to be suitable for membrane distillation. A comparison of the heat flux was also carried out. Again, there was good correlation between theory and experiment

Advances in module design for membrane distillation

This review looks at the work carried out over the past 15 years on membrane distillation and reports the conditions utilized for research. The process is still used mainly at the laboratory scale, but a few pilot plants have been built across the world, mostly for desalination and the production of potable water. Studies into membrane distillation have been concerned with the effect of mass transfer, heat transfer, and stirring rate, but the most important effect that has to be considered with this process is temperature polarization. A section on temperature polarization and the effect of boundary layers is included in this review.

Perspectives on community representation within the Extractive Industries Transparency Initiative: experiences from south-east Madagascar

This article critically examines the nature and quality of governance in community representation and civil society engagement in the context of trans-national large-scale mining, drawing on experiences in the Anosy Region of south-east Madagascar. An exploration of functional relationships between government, mining business and civil society stakeholders reveals an equivocal legitimacy of certain civil society representatives, created by state manipulation, which contributes to community disempowerment. The appointment of local government officials, rather than election, creates a hierarchy of upward dependencies and a culture where the majority of officials express similar views and political alliances. As a consequence, community resistance is suppressed. Voluntary mechanisms such as Corporate Social Responsibility (CSR) and the Extractive Industries Transparency Initiative (EITI) advocate community stakeholder engagement in decision making processes as a measure to achieve public accountability. In many developing countries, where there is a lack of transparency and high levels of corruption, the value of this engagement, however, is debatable. Findings from this study indicate that the power relationships which exist between stakeholders in the highly lucrative mining industry override efforts to achieve "good governance" through voluntary community engagement. The continuing challenge lies in identifying where the responsibility sits in order to address this power struggle to achieve fair representation.

Corporate social responsibility in the extractive industries: experiences from developing countries

This paper introduces a special issue on ‘Corporate Social Responsibility in the Extractive Industries: Experiences from Developing Countries’. Drawing upon case study analysis from Latin America, sub-Saharan Africa and Asia, the papers in this issue broaden understanding of how multinational mining and oil and gas companies have embraced the CSR challenge and responded to criticisms of their performance in developing countries. This paper provides an introduction to the debate on CSR in the extractive industries in developing countries, reviewing the key issues examined on this subject to date.

Investigation of flux in flat-plate modules for membrane distillation

A theoretical model for predicting the behaviour of membrane distillation by incorporating mass and heat transfer equations has been used to find permeate fluxes, and has been validated experimentally. The model accurately predicts mass and heat transfer. The main work studied the effect of module design using a flat-plate module in laminar flow conditions. Areas of investigation included the use of channels across the membrane surface, decreasing the available membrane surface area, and widening the inlet and outlet channels. The work showed that widening the channels increased the flux. Increased flux was also obtained by the use of channels on the permeate side, though not on the feed side.

Volatile flavour profile of goat meat extracted by three widely used techniques

Three procedures for the isolation of volatiles from grilled goat meat were compared: dynamic headspace entrainment on Tenax TA, simultaneous steam distillation-extraction, and solid-phase microextraction. Headspace entrainment on Tenax TA extracted the highest number of Maillard-derived volatile compounds. Two hundred and three volatile components were identified: 159 are reported for the first time in goat meat. Most of the volatiles detected (155) were lipid oxidation products, such as hydrocarbons, aldehydes, alcohols, ketones, carboxylic acids and esters. Forty-eight Maillard-derived compounds were identified. comprising pyrazines, pyrroles, thiophenes, furanthiol derivatives, alkyl and alicyclic sulphides, pyridines, and thiazoles. Some reported character impact compounds of cooked meat, e.g., 12-methyltridecanal, (EE)-2,4-decadienal, methional, and dimethyl trisulphide were identified in the volatile profile of goat meat, together with a series of C-2 to C-5 alkylformylcyclopentenes, which have been reported in cooked chicken, pork, beef and lamb, as being important for the characteristic flavour impression of different animal species. (C) 2009 Published by Elsevier Ltd.

Mathematical modelling for the digital society

We argue the case for a new branch of mathematics and its applications: Mathematics for the Digital Society. There is a challenge for mathematics, a strong “pull” from new and emerging commercial and public activities; and a need to train and inspire a generation of quantitative scientists who will seek careers within the associated sectors. Although now going through an early phase of boiling up, prior to scholarly distillation, we discuss how data rich activities and applications may benefit from a wide range of continuous and discrete models, methods, analysis and inference. In ten years time such applications will be common place and associated courses may be embedded within the undergraduate curriculum.

Novel developments in process optimisation using predictive control

In industrial practice, constrained steady state optimisation and predictive control are separate, albeit closely related functions within the control hierarchy. This paper presents a method which integrates predictive control with on-line optimisation with economic objectives. A receding horizon optimal control problem is formulated using linear state space models. This optimal control problem is very similar to the one presented in many predictive control formulations, but the main difference is that it includes in its formulation a general steady state objective depending on the magnitudes of manipulated and measured output variables. This steady state objective may include the standard quadratic regulatory objective, together with economic objectives which are often linear. Assuming that the system settles to a steady state operating point under receding horizon control, conditions are given for the satisfaction of the necessary optimality conditions of the steady-state optimisation problem. The method is based on adaptive linear state space models, which are obtained by using on-line identification techniques. The use of model adaptation is justified from a theoretical standpoint and its beneficial effects are shown in simulations. The method is tested with simulations of an industrial distillation column and a system of chemical reactors.

Development and application of a novel algorithm for steady-state optimising control using dynamic information

A novel optimising controller is designed that leads a slow process from a sub-optimal operational condition to the steady-state optimum in a continuous way based on dynamic information. Using standard results from optimisation theory and discrete optimal control, the solution of a steady-state optimisation problem is achieved by solving a receding-horizon optimal control problem which uses derivative and state information from the plant via a shadow model and a state-space identifier. The paper analyzes the steady-state optimality of the procedure, develops algorithms with and without control rate constraints and applies the procedure to a high fidelity simulation study of a distillation column optimisation.

‘Inherited commitments’: do changes in ownership affect corporate social responsibility (CSR) at African gold mines?

This paper critically examines the issue of ‘inherited corporate social responsibility’ in the gold mining industry, focusing specifically on the case of sub-Saharan Africa, a region plagued with excessive corruption, rampant poverty and weak governance. Whilst there appears to be little incentive to proactively engage with communities and implement cutting-edge environmental policies in the region, mine managers argue otherwise, highlighting a number of reasons for embracing corporate social responsibility (CSR). After briefly reviewing the philosophical underpinnings of CSR, the paper provides an in-depth analysis of these arguments, in the process, underscoring how tenuous the case for CSR in the extractive industries, and gold mining more specifically, is in the context of sub-Saharan Africa. Following a change in ownership, new management faces few pressures to embrace CSR in its entirety and therefore, more often than not, finds itself in a position to implement programs and policies of its choice. More research is needed that further popularizes the issue of ‘inherited CSR’ in the gold mining sector and extractive industries more generally.

The impact of land-use practices on soil microbes

The extensive use of land resources for food production, fibre for construction, wood pulp for paper, removal for extractive industries, sealing for urban and industrial development and as a receiver (either deliberate or accidental) of polluting substances has wrought huge changes in the chemistry, structure and biology of soils, away from their natural state.