Mass and size distribution measurement of particulates from a gas turbine combustor using modern mobility analyzer and particle sizer

SMPS and DMS500 analysers were used to measure particulate size distributions in the exhaust of a fully annular aero gas turbine engine at two operating conditions to compare and analyse sources of discrepancy. A number of different dilution ratio values were utilised for the comparative analysis, and a Dekati hot diluter operating at a temperature of 623°K was also utilised to remove volatile PM prior to measurements being made. Additional work focused on observing the effect of varying the sample line temperatures to ascertain the impact. Explanations are offered for most of the trends observed, although a new, repeatable event identified in the range from 417°K to 423°K – where there was a three order of magnitude increase in the nucleation mode of the sample – requires further study.

Hypothesis management in situation assessment

A situation assessment uses reports from sensors to produce hypotheses about a situation at a level of aggregation that is of direct interest to a military commander. A low level of aggregation could mean forming tracks from reports, which is well documented in the tracking literature as track initiation and data association. In this paper there is also discussion on higher level aggregation; assessing the membership of tracks to larger groups. Ideas used in joint tracking and identification are extended, using multi-entity Bayesian networks to model a number of static variables, of which the identity of a target is one. For higher level aggregation a scheme for hypothesis management is required. It is shown how an offline clustering of vehicles can be reduced to an assignment problem.

Host model uncertainties in aerosol radiative forcing estimates: results from the AeroCom Prescribed intercomparison study

Simulated multi-model “diversity” in aerosol direct radiative forcing estimates is often perceived as a measure of aerosol uncertainty. However, current models used for aerosol radiative forcing calculations vary considerably in model components relevant for forcing calculations and the associated “host-model uncertainties” are generally convoluted with the actual aerosol uncertainty. In this AeroCom Prescribed intercomparison study we systematically isolate and quantify host model uncertainties on aerosol forcing experiments through prescription of identical aerosol radiative properties in twelve participating models. Even with prescribed aerosol radiative properties, simulated clear-sky and all-sky aerosol radiative forcings show significant diversity. For a purely scattering case with globally constant optical depth of 0.2, the global-mean all-sky top-of-atmosphere radiative forcing is −4.47Wm−2 and the inter-model standard deviation is 0.55Wm−2, corresponding to a relative standard deviation of 12 %. For a case with partially absorbing aerosol with an aerosol optical depth of 0.2 and single scattering albedo of 0.8, the forcing changes to 1.04Wm−2, and the standard deviation increases to 1.01W−2, corresponding to a significant relative standard deviation of 97 %. However, the top-of-atmosphere forcing variability owing to absorption (subtracting the scattering case from the case with scattering and absorption) is low, with absolute (relative) standard deviations of 0.45Wm−2 (8 %) clear-sky and 0.62Wm−2 (11 %) all-sky. Scaling the forcing standard deviation for a purely scattering case to match the sulfate radiative forcing in the Aero- Com Direct Effect experiment demonstrates that host model uncertainties could explain about 36% of the overall sulfate forcing diversity of 0.11Wm−2 in the AeroCom Direct Radiative Effect experiment.

Land surface temperature retrieval from Sentinel 2 and 3 Missions

In this work we explore the synergistic use of future MSI instrument on board Sentinel-2 platform and OLCI/SLSTR instruments on board Sentinel-3 platform in order to improve LST products currently derived from the single AATSR instrument on board the ENVI- SAT satellite. For this purpose, the high spatial resolu- tion data from Setinel2/MSI will be used for a good characterization of the land surface sub-pixel heteroge- neity, in particular for a precise parameterization of surface emissivity using a land cover map and spectral mixture techniques. On the other hand, the high spectral resolution of OLCI instrument, suitable for a better characterization of the atmosphere, along with the dual- view available in the SLTSR instrument, will allow a better atmospheric correction through improved aero- sol/water vapor content retrievals and the implementa- tion of novel cloud screening procedures. Effective emissivity and atmospheric corrections will allow accu- rate LST retrievals using the SLSTR thermal bands by developing a synergistic split-window/dual-angle algo- rithm. ENVISAT MERIS and AATSR instruments and different high spatial resolution data (Landsat/TM, Proba/CHRIS, Terra/ASTER) will be used as bench- mark for the future OLCI, SLSTR and MSI instruments. Results will be validated using ground data collected in the framework of different field campaigns organized by ESA.