Identification of Some Additional Loss Components in High-Power Low-Voltage Permanent Magnet Generators

Permanent magnet generators (PMG) represent the cutting edge technology in modern wind mills. The efficiency remains high (over 90%) at partial loads. To improve the machine efficiency even further, every aspect of machine losses has to be analyzed. Additional losses are often given as a certain percentage without providing any detailed information about the actual calculation process; meanwhile, there are many design-dependent losses that have an effect on the total amount of additional losses and that have to be taken into consideration. Additional losses are most often eddy current losses in different parts of the machine. These losses are usually difficult to calculate in the design process. In this doctoral thesis, some additional losses are identified and modeled. Further, suggestions on how to minimize the losses are given. Iron losses can differ significantly between the measured no-load values and the loss values under load. In addition, with embedded magnet rotors, the quadrature-axis armature reaction adds losses to the stator iron by manipulating the harmonic content of the flux. It was, therefore, re-evaluated that in salient pole machines, to minimize the losses and the loss difference between the no-load and load operation, the flux density has to be kept below 1.5 T in the stator yoke, which is the traditional guideline for machine designers. Eddy current losses may occur in the end-winding area and in the support structure of the machine, that is, in the finger plate and the clamping ring. With construction steel, these losses account for 0.08% of the input power of the machine. These losses can be reduced almost to zero by using nonmagnetic stainless steel. In addition, the machine housing may be subjected to eddy current losses if the flux density exceeds 1.5 T in the stator yoke. Winding losses can rise rapidly when high frequencies and 10–15 mm high conductors are used. In general, minimizing the winding losses is simple. For example, it can be done by dividing the conductor into transposed subconductors. However, this comes with the expense of an increase in the DC resistance. In the doctoral thesis, a new method is presented to minimize the winding losses by applying a litz wire with noninsulated strands. The construction is the same as in a normal litz wire but the insulation between the subconductors has been left out. The idea is that the connection is kept weak to prevent harmful eddy currents from flowing. Moreover, the analytical solution for calculating the AC resistance factor of the litz-wire is supplemented by including an end-winding resistance in the analytical solution. A simple measurement device is developed to measure the AC resistance in the windings. In the case of a litz-wire with originally noninsulated strands, vacuum pressure impregnation (VPI) is used to insulate the subconductors. In one of the two cases studied, the VPI affected the AC resistance factor, but in the other case, it did not have any effect. However, more research is needed to determine the effect of the VPI on litz-wire with noninsulated strands. An empirical model is developed to calculate the AC resistance factor of a single-layer formwound winding. The model includes the end-winding length and the number of strands and turns. The end winding includes the circulating current (eddy currents that are traveling through the whole winding between parallel strands) and the main current. The end-winding length also affects the total AC resistance factor.

Managing Human Factor in Accounting Change - Introducing Activity Based Costing System to Organization

Tutkimuksen tavoitteena on identifioida yleisimmät toimintolaskennan implementointiin liittyvät ongelmat ja muutosprojektin onnistumiseen vaikuttavat tekijät. Tavoitteena on myös saada kokonaisvaltainen kuva siitä, miksi laskentatoimen muutokset ovat vaikeita implementoida ja miten ihmisten käyttäytyminen vaikuttaa muutosprosessin onnistumiseen. Sekä laskentatoimen että muutosjohtamisen teorioita tarkastellaan laaja-alaisen kuvan saamiseksi siitä, miten ihmisiin ja heidän käyttäytymiseensä liittyvät tekijät vaikuttavat muutosprojektin onnistumiseen tai epäonnistumiseen. Tutkielma käyttää empiirisiä tutkimustuloksia pohjana aiheen tarkastelulle. Tutkielma tarjoaa ehdotuksia tulevaisuuden tutkimukselle liittyen laskentatoimen muutoksen kriittisiin tekijöihin. Kiinnostavimpia alueita tulevaisuuden tutkimukselle on pohtia tarkemmin, miten työntekijöiden oletukset johtajien motiiveista muutoksen takana vaikuttavat muutosvastarintaan sekä miten organisaation rakenne ja muutosvastarintavaikuttavat muutoksen institutionaalistamiseen.

Oxidized LDL lipids as a risk factor for atherosclerosis

University of Turku, Faculty of Medicine, Department of Clinical Medicine, Department of Physical Activity and Health, Paavo Nurmi Centre, Doctoral Programme of Clinical Investigation, University of Turku, Turku, Finland. Annales Universitatis Turkuensis. Medica – Odontologica, Turku, Finland, 2014. Background: Atherosclerosis progression spans an entire lifetime and has a wide pool of risk factors. Oxidized LDL (oxLDL) is a crucial element in the progression of atherosclerosis. As a rather new member in the atherosclerosis risk factor family, its interaction with the traditional pro-atherogenic contributors that occur at different ages is poorly known. Aims: The aim of this study was to investigate oxLDL and its relation to major contributing risk factors in estimating atherosclerosis risk in data consisting mostly of adult men. The study subjects of this study consisted of four different sets of data, one of which contained also women. The age range of participants was 18-100 years and totaled 2337 participants (of whom 69% were men). Data on anthropometric and hormonal parameters, laboratory measures and medical records were assessed during 1998-2009. Results: Obesity was paralleled with high concentrations of oxLDL, which consequentially was reduced by weight reduction. Importantly, successful weight maintenance preserveed this benefit. A shift from insulin sensitivity to insulin resistance increased oxLDL. Smokers had more oxLDL than non-smokers. A combination of obesity and smoking, or smoking and low serum total testosterone,resulted in even higher levels of oxLDL than any of the three conditions alone. Proportioning oxLDL to HDL-c or apoA1 stood out as a risk factor of all-cause mortality in the elderly. Conclusions: OxLDL was associated with aging, androgens, smoking, obesity, insulin metabolism, weight balance and other circulating lipid classes. Through this variety of metabolic environments containing both constant conditions (aging and gender) as well as lifestyle issues, these findings supported an essential and multidimensional role that oxLDL plays in atherosclerosis pathogenesis.