Elongation behaviour of elastic stitch types in household sewing machines: stretch-stitches versus serger overlock stitces

Lectio praecursoria

Determination of compression behaviour of coating layer

The strength properties of paper coating layer are very important in converting and printing operations. Too great or low strength of the coating can affect several problems in printing. One of the problems caused by the strength of coating is the cracking at the fold. After printing the paper is folded to final form and the pages are stapled together. In folding the paper coating can crack causing aesthetic damage over printed image or in the worst case the centre sheet can fall off in stapling. When folding the paper other side undergoes tensile stresses and the other side compressive stresses. If the difference between these stresses is too high, the coating can crack on the folding. To better predict and prevent cracking at the fold it is good to know the strength properties of coating layer. It has measured earlier the tensile strength of coating layer but not the compressive strength. In this study it was tried to find some way to measure the compressive strength of the coating layer and investigate how different coatings behave in compression. It was used the short span crush test, which is used to measure the in-plane compressive strength of paperboards, to measure the compressive strength of the coating layer. In this method the free span of the specimen is very small which prevent buckling. It was measured the compressive strength of free coating films as well as coated paper. It was also measured the tensile strength and the Bendtsen air permeance of the coating film. The results showed that the shape of pigment has a great effect to the strength of coating. Platy pigment gave much better strength than round or needle-like pigment. On the other hand calcined kaolin, which is also platy but the particles are aggregated, decreased the strength substantially. The difference in the strength can be explained with packing of the particles which is affecting to the porosity and thus to the strength. The platy kaolin packs up much better than others and creates less porous structure. The results also showed that the binder properties have a great effect to the compressive strength of coating layer. The amount of latex and the glass transition temperature, Tg, affect to the strength. As the amount of latex is increasing, the strength of coating is increasing also. Larger amount of latex is binding the pigment particles better together and decreasing the porosity. Compressive strength was increasing when the Tg was increasing because the hard latex gives a stiffer and less elastic film than soft latex.

Social capital, coping and information behaviour of long-term unemployed people in Finland

Avhandlingen studerar hur långtidsarbetslösa klarar av sin situation, hurdant socialt kapital och informationsbeteende de har, samt granskar hur de ovannämnda faktorerna är relaterade till varandra. Därtill undersöks om det finns skillnader mellan finsk- och svenskspråkiga långtidsarbetslösa på de här tre livsområdena. I undersökningen består socialt kapital av sociala relationer, deltagande i organisatoriska aktiviteter samt känslan av tillhörighet med olika grupper och samfund. Gällande informationsbeteende är fokus på vardaglig informationssökning, vilka källor som används, och hurdana problem man stöter på när man söker information. Som mest påfrestande upplevdes arbetslösheten av män, som var i början eller mitten av sin arbetskarriär. De äldre (över 55 år) verkade på många sätt klara av arbetslöshetssituationen bättre än de yngre, som drabbades hårdare av ekonomiska problem och stress. Kvinnor kunde bättre än män bibehålla en positiv inställning, de hade t.ex. starkare sociala nätverk som stöd, medan mäns sociala relationer i högre grad verkade vila på en arbetsgemenskap, som blev allt svagare i och med utdragen arbetslöshet. Yngre män upplevde också ofta att deras hälsa hade försämrats, när den för kvinnor och äldre arbetslösa i genomsnitt blev bättre. När arbetslösas bemästring av arbetslöshetssituationen, sociala relationer och informationssökning granskades, framgick att människor som var aktiva på ett livsområde också var aktiva på andra livsområden. I de flesta fall framkom inte några större skillnader mellan finsk- och svenskspråkiga arbetslösa. Beträffande informationssökning var de upplevda problemen ändå av diametralt motsatt karaktär – för svenskspråkiga åsamkade för lite tillgänglig information ofta problem, medan problemet för de finskspråkiga var att hitta det väsentliga i informationsflödet. Finskspråkiga kände sig också mera fast anknutna till sin boendemiljö och det finska samhället i stort, svenskspråkiga hade däremot i genomsnitt bredare och tätare sociala nätverk.

Corrosion behaviour of boiler tube materials during combustion of fuels containing Zn and Pb

Många förbränningsanläggningar som bränner utmanande bränslen såsom restfraktioner och avfall råkar ut för problem med ökad korrosion på överhettare och/eller vattenväggar pga. komponenter i bränslena som är korrosiva. För att minimera problemen i avfallseldade pannor hålls ångparametrarna på en relativt låg nivå, vilket drastiskt minskar energiproduktionen. Beläggningarna i avfallseldade pannor består till största delen av element som är förknippade med högtemperaturkorrosion: Cl, S, alkalimetaller, främst K och Na, och tungmetaller som Pb och Zn, och det finns också indikationer av Br-förekomst. Det låga ångtrycket i avfallseldade pannor påverkar också stålrörens temperatur i pannväggarna i eldstaden. I dagens läge hålls temperaturen normalt vid 300-400 °C. Alkalikloridorsakad (KCl, NaCl) högtemperaturkorrosion har inte rapporterats vara relevant vid såpass låga temperaturer, men närvaro av Zn- och Pb-komponenter i beläggningarna har påvisats förorsaka ökad korrosion redan vid 300-400 °C. Vid förbränning kan Zn och Pb reagera med S och Cl och bilda klorider och sulfater i rökgaserna. Dessa tungmetallföreningar är speciellt problematiska pga. de bildar lågsmältande saltblandningar. Dessa lågsmältande gasformiga eller fasta föreningar följer rökgasen och kan sedan fastna eller kondensera på kallare ytor på pannväggar eller överhettare för att sedan bilda aggressiva beläggningar. Tungmetallrika (Pb, Zn) klorider och sulfater ökar risken för korrosion, och effekten förstärks ytterligare vid närvaro av smälta. Motivet med den här studien var att få en bättre insikt i högtemperaturkorrosion förorsakad av Zn och Pb, samt att undersöka och prediktera beteendet och motståndskraften hos några stålkvaliteter som används i överhettare och pannväggar i tungmetallrika förhållanden och höga materialtemperaturer. Omfattande laboratorie-, småskale- och fullskaletest utfördes. Resultaten kan direkt utnyttjas i praktiska applikationer, t.ex. vid materialval, eller vid utveckling av korrosionsmotverkande verktyg för att hitta initierande faktorer och förstå deras effekt på högtemperaturkorrosion.

The bifurcational behaviour of the spatially distributed Rayleigh equation

At the present work the bifurcational behaviour of the solutions of Rayleigh equation and corresponding spatially distributed system is being analysed. The conditions of oscillatory and monotonic loss of stability are obtained. In the case of oscillatory loss of stability, the analysis of linear spectral problem is being performed. For nonlinear problem, recurrent formulas for the general term of the asymptotic approximation of the self-oscillations are found, the stability of the periodic mode is analysed. Lyapunov-Schmidt method is being used for asymptotic approximation. The correlation between periodic solutions of ODE and PDE is being investigated. The influence of the diffusion on the frequency of self-oscillations is being analysed. Several numerical experiments are being performed in order to support theoretical findings.

Chaotic Behaviour of Active Magnetic Bearing System by Time Series Analysis

Chaotic behaviour is one of the hardest problems that can happen in nonlinear dynamical systems with severe nonlinearities. It makes the system's responses unpredictable. It makes the system's responses to behave similar to noise. In some applications it should be avoided. One of the approaches to detect the chaotic behaviour is nding the Lyapunov exponent through examining the dynamical equation of the system. It needs a model of the system. The goal of this study is the diagnosis of chaotic behaviour by just exploring the data (signal) without using any dynamical model of the system. In this work two methods are tested on the time series data collected from AMB (Active Magnetic Bearing) system sensors. The rst method is used to nd the largest Lyapunov exponent by Rosenstein method. The second method is a 0-1 test for identifying chaotic behaviour. These two methods are used to detect if the data is chaotic. By using Rosenstein method it is needed to nd the minimum embedding dimension. To nd the minimum embedding dimension Cao method is used. Cao method does not give just the minimum embedding dimension, it also gives the order of the nonlinear dynamical equation of the system and also it shows how the system's signals are corrupted with noise. At the end of this research a test called runs test is introduced to show that the data is not excessively noisy.

Geological map of Europe exhibiting the different systems of rocks according to the most recent researches and inedited materials by Roderick I. Murchison and James Nicol ; constructed by A. Keith Johnston

Kartta kuuluu A. E. Nordenskiöldin kokoelmaan

Analysing the power consumption behaviour of Ethernet switch using Design of Experiment

At present, one of the main concerns of green network is to minimize the power consumption of network infrastructure. Surveys show that, the highest amount of power is consumed by the network devices during its runtime. However to control this power consumption it is important to know which factors has highest impact on this matter. This paper is focused on the measurement and modeling the power consumption of an Ethernet switch during its runtime considering various types of input parameters with all possible combinations. For the experiment, three input parameters are chosen. They are bandwidth, link load and number of connections. The output to be measured is the power consumption of the Ethernet switch. Due to the uncertain power consuming pattern of the Ethernet switch a fully-comprehensive experimental evaluation would require an unfeasible and cumbersome experimental phase. Because of that, design of experiment (DoE) method has been applied to obtain adequate information on the effects of each input parameters on the power consumption. The whole work consists of three parts. In the first part a test bed is planned with input parameters and the power consumption of the switch is measured. The second part is about generating a mathematical model with the help of design of experiment tools. This model can be used for measuring precise power consumption in different scenario and also pinpoint the parameters with higher influence in power consumption. And in the last part, the mathematical model is evaluated by comparing with the experimental values.

Effects of algal turbidity on foraging and antipredator behaviour of the three-spined stickleback (Gasterosteus aculeatus)

The aim of this thesis was to examine how aquatic organisms, such as fish, behave in an altered environmental condition. Many species of fish use vision as their primary tool to gain information about their surrounding environment. The visual conditions of aquatic habitats are often altered as a result of anthropogenic disturbance, such as eutrophication that initiates algal turbidity. In general, turbidity reduces the visibility and can be hypothesized to have an influence on the behaviour of fish. I used the three-spined stickleback (Gasterosteus aculeatus) as a model species and conducted four studies in the laboratory to test how algal turbidity affects its behaviour. In this thesis, two major behavioural aspects are discussed. The first is antipredator behaviour. In study I, the combined effects of turbidity and shoot density on habitat choice (shelter vs open) behaviour was tested on a group of sticklebacks (20 fish) in the presence and absence of piscivorous perch (Perca fluviatilis). In study II, I examined the behavioural responses of feeding sticklebacks when they were exposed to the sudden appearance of an avian predator (the silhouette of a common tern, Sterna hirundo). The study was done in turbid and clear water using three different groups sizes (1, 3 and 6 fish). The second aspect is foraging behaviour. Study III & IV focused on the effects of algal turbidity on the foraging performance of sticklebacks. In study III, I conducted two separate experiments to examine the effects of turbidity on prey consumption and prey choice of sticklebacks. In this experiment turbidity levels and the proportion of large and small prey (Daphnia spp.) were manipulated. In study IV, I studied whether a group of six sticklebacks can distribute themselves according to food input at two feeding stations in a way that provided each fish with the same amount of food in clear and turbid water. I also observed whether the fish can follow changes in resource distribution between the foraging patches. My results indicate an overall influence of algal turbidity on the antipredator and foraging behaviour of sticklebacks. In the presence of a potential predator, the use of the sheltered habitat was more pronounced at higher turbidity. Besides this, sticklebacks reduced their activity levels with predator presence at higher turbidity and shoot density levels, suggesting a possible antipredator adaptation to avoid a predator. When exposed to a sudden appearance of an avian predator, sticklebacks showed a weaker antipredator response in turbid water, which suggests that turbidity degrades the risk assessment capabilities of sticklebacks. I found an effect of group size but not turbidity in the proportion of sticklebacks that fled to the shelter area, which indicates that sticklebacks are able to communicate among group members at the experimental turbidity levels. I found an overall negative effect of turbidity on food intake. Both turbidity and changes in the proportion of prey sizes played a significant role in a stickleback’s prey selection. At lower turbidity levels (clear <1 and 5 NTU) sticklebacks showed preferences for large prey, whereas in more turbid conditions and when the proportion of large to small prey increased sticklebacks became increasingly random in their prey selection. Finally, my results showed that groups of sticklebacks disperse themselves between feeding stations according to the reward ratios following the predictions of the ideal free distribution theory. However, they took a significantly longer time to reach the equilibrium distribution in turbid water than in clear water. In addition, they showed a slower response to changes in resource distribution in a turbid environment. These findings suggest that turbidity interferes with the information transfer among group foragers. It is important to understand that aquatic animals are often exposed to a degraded environment. The findings of this thesis suggest that algal turbidity negatively affects their behavioural performance. The results also shed light on the underlying behavioural strategies of sticklebacks in turbid conditions that might help them adapt to an altered environmental situation and increase their survival. In conclusion, I hold that although algal turbidity has detrimental effects on the antipredator and foraging behaviour of sticklebacks, their behavioural adjustment might help them adapt to a changing environment.