Preventing Bullying and Harassment A Support Manual for Iowa’s Sample District Harassment and Bullying Policy, May 2005

Support manual for preventing bullying and harassment in school.

Sexual Harassment in the Workplace: Sample Policy

An informational sheet about developing and implementing a policy which prohibits sexual harassment in the workplace.

Sample Policy Prohibiting Harassment in the Workplace, 2006

A key component in preventing harassment is having each employer develop and implement a policy which prohibits harassment in the workplace. Having such a policy in place is also an important part of an employer’s defense should a harassment complaint be filed against the employer. This policy should be separate from and in addition to a general anti-discrimination policy. A good policy will set forth procedures that will encourage victims to come forward, that will protect confidentiality of the persons involved, that guards against retaliation, and that brings complaints to a resolution.

Bridge Deck Rehabilitation Rebonding a Delaminated PCC Overlay By Epoxy Injection, HR-1036, 1989

The Iowa demonstration project to promote the rehabilitation of bridge deck concrete by rebonding delaminations with injected epoxy is a 150 ft x 150 ft high truss bridge on Iowa route No. 210 over Indian Creek near Maxwell in Story County (Service level D, AADT-730, Inventory Rating HS-16.9, Operating Rating HS-25). The objective of this study was to evaluate the effectiveness of repairing a delaminated bridge deck by epoxy injection, specifically a bridge deck with a delaminated portland cement concrete overlay. Observations noted during the project lead to the following conclusions: The delaminations rebonded with epoxy have remained solid through five years. The percentage of delamination has stayed essentially the same for both the epoxy injected and non-repaired areas. Epoxy injection appears to be a practical, cost effective alternative to other forms of deck rehabilitation when undertaken at the proper time. Cost effectiveness would reduce dramatically if delayed until breakouts have occurred. On the other hand it would be a slow, labor intensive process if undertaken too early when delaminations are small.