Improving Transition Outcomes: CASE (Career And Self Awareness) Prototype: Contact Information

Contact information for the CASE (Career And Self Awareness) prototype.

Dusproportionate Minority Contact in Iowa's Juvenile Justice System, April 2006

This report was developed to provide summary information to allow state agency staff, practitioners and juvenile justice system officials to access a specific section of Iowa’s Three Year Plan. It includes the Disproportionate Minority Contact (DMC) section of Iowa’s 2006 Juvenile Justice and Delinquency Prevention Act formula grant Three-Year Plan. The complete Three Year Plan serves as Iowa’s application for Juvenile Justice and Delinquency Prevention Act formula grant funding.

Asphalt Cement Concrete Longitudinal Joint Adhesive Crafco PN 34524 (Iowa DOT New Product C-98-7), HR-2084, 2000

The joint between two lanes of asphalt pavement is often the first area of a roadway which shows signs of deterioration and requires maintenance. As the final lift of hot asphalt is being placed in a construction project, it is being forced p against the adjoining lane of cold asphalt, forming the longitudinal joint. The mating of the two lanes, to form a high quality seal, is often not fully successful and later results in premature stripping or raveling as water enters the unsealed joint. The application of a hot poured rubberized asphaltic joint sealant along the joint face in the final stage of construction should help to form a watertight joint seal. A new product, especially formulated for the longitudinal joint in asphalt pavements was proposed to improve joint sealing. The following describes the experimental application of the new product, Crafco, PN 34524.

Attachment of Combination Rails to Concrete Parapets Utilizing Epoxy Adhesive Anchors, RPFP-IOWA-1, 2015

The Iowa Department of Transportation (IaDOT) was interested in investigating the use of epoxy adhesive anchorages for the attachment of posts used in the BR27C combination bridge rail system. Alternative anchorage concepts were developed using a modified version of the ACI 318-11 procedures for embedded anchor design. Four design concepts were developed for review by IaDOT, including: (1) a four-bolt square anchorage, (2) a four-bolt spread anchorage, (3) a twobolt centered anchorage, and (4) a two-bolt offset anchorage. IaDOT representatives selected the four-bolt spread anchorage and the two-bolt offset anchorage as the preferred designs for evaluation. In addition to these two proposed configurations, IaDOT also requested that the researchers evaluate a third option that had been previously installed on the US-20 bridge near Hardin, IA. The proposed alternative anchorages and the original cast-in-place anchorage for the BR27C combination bridge rail were evaluated through dynamic component testing. The test of the original cast-in-place anchorage was used a baseline for comparison with the alternative designs. Test no. IBP-1 of the original cast-in-place anchorage developed a peak load of 22.9 kips (101.9 kN) at a deflection of 1.5 in. (38 mm). All three of the tested alternative anchorages provided greater load capacity than the original cast-in-place design and were deemed acceptable surrogates. Of the three alternative designs, the two-bolt offset design was deemed the best option.

Update Regarding Disproportionate Minority Contact (DMC) Progress of Iowa Communities, December 1, 2015

The Iowa State Court Administrator’s Office (SCA) created the CASP Advisory Committee in October 2013 to develop a state plan addressing disproportionate minority contact (DMC) in the juvenile justice system. The planning was assisted with a discretionary grant awarded from the federal Office of Juvenile Justice and Delinquency Prevention (OJJDP).