Image quality assessment in digital mammography: part I. Technical characterization of the systems.

In many European countries, image quality for digital x-ray systems used in screening mammography is currently specified using a threshold-detail detectability method. This is a two-part study that proposes an alternative method based on calculated detectability for a model observer: the first part of the work presents a characterization of the systems. Eleven digital mammography systems were included in the study; four computed radiography (CR) systems, and a group of seven digital radiography (DR) detectors, composed of three amorphous selenium-based detectors, three caesium iodide scintillator systems and a silicon wafer-based photon counting system. The technical parameters assessed included the system response curve, detector uniformity error, pre-sampling modulation transfer function (MTF), normalized noise power spectrum (NNPS) and detective quantum efficiency (DQE). Approximate quantum noise limited exposure range was examined using a separation of noise sources based upon standard deviation. Noise separation showed that electronic noise was the dominant noise at low detector air kerma for three systems; the remaining systems showed quantum noise limited behaviour between 12.5 and 380 µGy. Greater variation in detector MTF was found for the DR group compared to the CR systems; MTF at 5 mm(-1) varied from 0.08 to 0.23 for the CR detectors against a range of 0.16-0.64 for the DR units. The needle CR detector had a higher MTF, lower NNPS and higher DQE at 5 mm(-1) than the powder CR phosphors. DQE at 5 mm(-1) ranged from 0.02 to 0.20 for the CR systems, while DQE at 5 mm(-1) for the DR group ranged from 0.04 to 0.41, indicating higher DQE for the DR detectors and needle CR system than for the powder CR phosphor systems. The technical evaluation section of the study showed that the digital mammography systems were well set up and exhibiting typical performance for the detector technology employed in the respective systems.

Is there an advantage to be gained from adding digital image cytometry of brush cytology to a standard biopsy protocol in patients with Barrett's esophagus?

BACKGROUND AND STUDY AIMS: The current gold standard in Barrett's esophagus monitoring consists of four-quadrant biopsies every 1-2 cm in accordance with the Seattle protocol. Adding brush cytology processed by digital image cytometry (DICM) may further increase the detection of patients with Barrett's esophagus who are at risk of neoplasia. The aim of the present study was to assess the additional diagnostic value and accuracy of DICM when added to the standard histological analysis in a cross-sectional multicenter study of patients with Barrett's esophagus in Switzerland. METHODS: One hundred sixty-four patients with Barrett's esophagus underwent 239 endoscopies with biopsy and brush cytology. DICM was carried out on 239 cytology specimens. Measures of the test accuracy of DICM (relative risk, sensitivity, specificity, likelihood ratios) were obtained by dichotomizing the histopathology results (high-grade dysplasia or adenocarcinoma vs. all others) and DICM results (aneuploidy/intermediate pattern vs. diploidy). RESULTS: DICM revealed diploidy in 83% of 239 endoscopies, an intermediate pattern in 8.8%, and aneuploidy in 8.4%. An intermediate DICM result carried a relative risk (RR) of 12 and aneuploidy a RR of 27 for high-grade dysplasia/adenocarcinoma. Adding DICM to the standard biopsy protocol, a pathological cytometry result (aneuploid or intermediate) was found in 25 of 239 endoscopies (11%; 18 patients) with low-risk histology (no high-grade dysplasia or adenocarcinoma). During follow-up of 14 of these 18 patients, histological deterioration was seen in 3 (21%). CONCLUSION: DICM from brush cytology may add important information to a standard biopsy protocol by identifying a subgroup of BE-patients with high-risk cellular abnormalities.

Determination of Transmembrane Water Fluxes in Neurons Elicited by Glutamate Ionotropic Receptors and by the Cotransporters KCC2 and NKCC1: A Digital Holographic Microscopy Study.

Digital holographic microscopy (DHM) is a noninvasive optical imaging technique that provides quantitative phase images of living cells. In a recent study, we showed that the quantitative monitoring of the phase signal by DHM was a simple label-free method to study the effects of glutamate on neuronal optical responses (Pavillon et al., 2010). Here, we refine these observations and show that glutamate produces the following three distinct optical responses in mouse primary cortical neurons in culture, predominantly mediated by NMDA receptors: biphasic, reversible decrease (RD) and irreversible decrease (ID) responses. The shape and amplitude of the optical signal were not associated with a particular cellular phenotype but reflected the physiopathological status of neurons linked to the degree of NMDA activity. Thus, the biphasic, RD, and ID responses indicated, respectively, a low-level, a high-level, and an "excitotoxic" level of NMDA activation. Moreover, furosemide and bumetanide, two inhibitors of sodium-coupled and/or potassium-coupled chloride movement strongly modified the phase shift, suggesting an involvement of two neuronal cotransporters, NKCC1 (Na-K-Cl) and KCC2 (K-Cl) in the genesis of the optical signal. This observation is of particular interest since it shows that DHM is the first imaging technique able to monitor dynamically and in situ the activity of these cotransporters during physiological and/or pathological neuronal conditions.

Dual-wavelength digital holographic microscopy with sub-nanometer axial accuracy

We present dual-wavelength Digital Holographic Microscopy (DHM) measurements on a certified 8.9 nm high Chromium thin step sample and demonstrate sub-nanometer axial accuracy. We introduce a modified DHM Reference Calibrated Hologram (RCH) reconstruction algorithm taking into account amplitude contributions. By combining this with a temporal averaging procedure and a specific dual-wavelength DHM arrangement, it is shown that specimen topography can be measured with an accuracy, defined as the axial standard deviation, reduced to at least 0.9 nm. Indeed, it is reported that averaging each of the two wavefronts recorded with real-time dual-wavelength DHM can provide up to 30% spatial noise reduction for the given configuration, thanks to their non-correlated nature. ©2008 COPYRIGHT SPIE

Under- and over-water halves of Gyrinidae beetle eyes harbor different corneal nanocoatings providing adaptation to the water and air environments.

Whirligig beetles (Gyrinidae) inhabit water surfaces and possess unique eyes which are split into the overwater and underwater parts. In this study we analyze the micro- and nanostructure of the split eyes of two Gyrinidae beetles genera, Gyrinus and Orectochilus. We find that corneae of the overwater ommatidia are covered with maze-like nanostructures, while the corneal surface of the underwater eyes is smooth. We further show that the overwater nanostructures possess no anti-wetting, but the anti-reflective properties with the spectral preference in the range of 450-600 nm. These findings illustrate the adaptation of the corneal nanocoating of the two halves of an insect's eye to two different environments. The novel natural anti-reflective nanocoating we describe may find future technological applications.

Label-free cytotoxicity screening assay by digital holographic microscopy

Abstract We introduce a label-free technology based on digital holographic microscopy (DHM) with applicability for screening by imaging, and we demonstrate its capability for cytotoxicity assessment using mammalian living cells. For this first high content screening compatible application, we automatized a digital holographic microscope for image acquisition of cells using commercially available 96-well plates. Data generated through both label-free DHM imaging and fluorescence-based methods were in good agreement for cell viability identification and a Z'-factor close to 0.9 was determined, validating the robustness of DHM assay for phenotypic screening. Further, an excellent correlation was obtained between experimental cytotoxicity dose-response curves and known IC values for different toxic compounds. For comparable results, DHM has the major advantages of being label free and close to an order of magnitude faster than automated standard fluorescence microscopy.

Biosphere/lithosphere interface : microbially-mediated CaCO3 precipitation in hypersaline and freshwater environments

Abstract: Microbial mats very efficiently cycle elements, such as C, 0, N, S and H, which makes them key players of redox processes at the biosphere-lithosphere interface. They are characterized by high metabolic activities and high turnover rates (production and consumption) of biomass, which mainly consists of cell material and of extracellular organic matter (EOM). The EOM forms a matrix, embedding the microbial cells and fulfilling various functions within the microbial mat, including: mat attachment to surfaces; creation of micro-domains within the mat; physical stabilization under hy- drodynamic stress and the protection of the cells in multiple other stress conditions. EOM mainly consists of polysaccharides, amino acids, and a variety of chemical func-tional groups {e.g., -C00H, - SH -OH). These groups strongly bind cations such as Ca2+ and Mg2+ and thus exert a strong control on carbonate mineral formation within the microbial mat. A feedback mechanism between community metabolisms, their prod¬ucts, and the surrounding physicochemical microenvironment thus influences the de¬gree of carbonate saturation favoring either carbonate precipitation or dissolution. We investigated the driving forces and mechanisms of microbialite formation in the Sari ne River, FR, Switzerland, the hypersaline lake, Big Pond, Bahamas and in labo¬ratory experiments. The two fundamentally different natural systems allowed us to compare the geochemical conditions and microbial metabolisms, necessary for car¬bonate formation in microbial mats. Although carbonates are oversaturated in both environments, precipitation does not occur on physicochemical substrates (i.e. out¬side the microbial mats). In the Sarine a high crystal nucleation threshold exceeds the carbonate saturation, despite the high carbonate alkalinity in the water column. Cyanobacterial photosynthesis strongly locally enhances the carbonate alkalinity, whereas the EOM attract and immobilize calcium, which increases the saturation state and finally leads to carbonate precipitation within the EOM (in this case the cyanobacterial sheath) as nucleation template. In Big Pond, the presence of calcium- chelating anions (i.e. sulfate) and EOM, as well as the presence of magnesium, lowers the calcium activity in the water column and mat, and thus inhibits carbonate pre¬cipitation. Coupled with other heterotrophic metabolisms, sulfate reduction uses the EOM as carbon source, degrading it. The resulting EOM consumption creates alkalin¬ity, releases calcium and consumes sulfate in mat-micro domains, which leads to the formation of carbonate layers at the top of the microbial mat. Résumé: Interface biosphère/lithosphère: médiation microbienne de la précipitation de CaC03 dans des environnements en eaux douces et hypersalines Les tapis microbiens engendrent une circulation très efficace des éléments, tels que C, 0, N, S et H, ce qui en fait des acteurs clé pour les processus d'oxydoréduction à l'inter¬face biosphère-lithosphère. Ils sont caractérisés par des taux élevés d'activité méta¬bolique, ainsi que par la production et la consommation de biomasse, principalement constituée de cellules microbiennes et de matière organique extracellulaire (MOE). Dans un tapis microbien, les cellules microbiennes sont enveloppées par une matrice de MOE qui a différentes fonctions dont l'attachement du tapis aux surfaces, la créa¬tion de micro-domaines dans le tapis, la stabilisation physique en situation de stress hydrodynamique, et la protection des cellules dans de multiples autres conditions de stress. La MOE se compose principalement de polysaccharides, d'acides aminés, et d'une variété de groupes fonctionnels chimiques (par exemple, COOH, -SH et -OH). Ces groupes se lient fortement aux cations, tels que Ca2+ et Mg2+, et exercent ainsi un contrôle fort sur la formation de CaC03 dans le tapis microbien. Un mécanisme de rétroaction, entre les métabolismes de la communauté microbienne, leurs produits, et le microenvironnement physico-chimique, influence le degré de saturation de car¬bonate, favorisant soit leur précipitation, soit leur dissolution. Nous avons étudié le moteur et les mécanismes de minéralisation dans des tapis de la Sarine, FR, Suisse et du lac hypersalin, Big Pond, aux Bahamas, ainsi que durant des expériences en laboratoire. Les deux systèmes naturels, fondamentalement dif¬férents, nous ont permis de comparer les conditions géochimiques et les métabolis¬mes nécessaires à la formation des carbonates dans des tapis microbiens. Bien que les carbonates soient sursaturés dans les deux environnements, la précipitation ne se produit pas sur des substrats physico-chimiques (en dehors du tapis microbien). Dans la Sarine, malgré un taux d'alcalinité élevé, les valeurs de seuil pour la nucléa- tion de carbonates sont plus hautes que la saturation du carbonate. La photosynthèse cyanobactérienne augmente localement l'alcalinité, alors que la MOE attire et immo¬bilise le calcium, ce qui augmente l'état de saturation et conduit finalement à la pré¬cipitation des carbonates, en utilisant la MOE comme substrat de nucléation. À Big Pond, la présence de chélateurs de calcium, notamment les anions (p.ex. le sulfate) et la MOE, ainsi que la présence de magnésium, réduit l'activité du calcium et inhibe en conséquence la précipitation des carbonates. Couplée avec d'autres métabolismes hétérotrophes, la réduction des sulfates utilise la MOE comme source de carbone, en la dégradant. Cette consommation de MOE crée l'alcalinité, consomme des sulfates et libère du calcium dans des micro-domaines, conduisant à la formation de couches de carbonates dans le haut du tapis microbien.

Noninvasive characterization of the fission yeast cell cycle by monitoring dry mass with digital holographic microscopy.

Digital holography microscopy (DHM) is an optical technique which provides phase images yielding quantitative information about cell structure and cellular dynamics. Furthermore, the quantitative phase images allow the derivation of other parameters, including dry mass production, density, and spatial distribution. We have applied DHM to study the dry mass production rate and the dry mass surface density in wild-type and mutant fission yeast cells. Our study demonstrates the applicability of DHM as a tool for label-free quantitative analysis of the cell cycle and opens the possibility for its use in high-throughput screening.