First-principles periodic calculation of four-body spin terms in high-Tc cuprate superconductors

A general mapping between the energy of pertinent magnetic solutions and the diagonal terms of the spin Hamiltonian in a local representation provides the first general framework to extract accurate values for the many body terms of extended spin Hamiltonians from periodic first-principle calculations. Estimates of these terms for La2CuO4, the paradigm of high-Tc superconductor parent compounds, and for the SrCu2O3 ladder compound are reported. For La2CuO4, present results support experimental evidence by Toader et al. [Phys. Rev. Lett. 94, 197202 (2005)]. For SrCu2O3 even larger four-body spin amplitudes are found together with Jl/Jr=1 and non-negligible ferromagnetic interladder exchange.

First-principles periodic calculation of four-body spin terms in high-Tc Cuprate superconductors

A general mapping between the energy of pertinent magnetic solutions and the diagonal terms of the spin Hamiltonian in a local representation provides the first general framework to extract accurate values for the many body terms of extended spin Hamiltonians from periodic first-principle calculations. Estimates of these terms for La2CuO4, the paradigm of high-Tc superconductor parent compounds, and for the SrCu2O3 ladder compound are reported. For La2CuO4, present results support experimental evidence by Toader et al. [Phys. Rev. Lett. 94, 197202 (2005)]. For SrCu2O3 even larger four-body spin amplitudes are found together with Jl/Jr=1 and non-negligible ferromagnetic interladder exchange.

Human capital in export-based internationalisation. "Managerial determinants and their influence upon the export behaviour of the firm: four case-studies of catalan exporting SMEs"

Export activities are a major source of economic growth and are considered important both at the national level and for individual businesses. Moreover, in the case of SMEs, they gain particular relevance, exporting being the most common foreign market entry mode for these firms. The decision maker’s role in the export activity is crucial, particularly in the case of SMEs. However, the extant literature on internationalization is characterized by a lack of consensus among scholars as to what constitutes the managerial factor in determining exporting. Therefore, this study focuses on the following issue: Which are the decision maker’s characteristics and perceptions that may influence the export behaviour of Catalan SMEs? To address this question a multiple case study method is applied across four Catalan exporting SMEs. The methodology chosen for analysing the empirical data is relying on the proposition testing approach while the investigation is conducted including both within and cross-case analysis. The findings show that high educational level, language skills, high risk tolerance, innovativeness as well as strongly perceived export stimuli as compared to low and easy to overcome export barriers positively influence the export involvement and development of SMEs. The study provides further insights into the research topic by jointly studying managerial characteristics and perceptions. Additionally, the majority of research on exporting topics has been carried out in the USA, so there is a clear need of investigation in the field in other countries, moreover in Spain where the exporting activities have not been as widely studied.

Evaluation of four whole-plant inoculation methods to analyze the pathogenicity of Erwinia amylovora under quarantine conditions

Four methods were tested to assess the fire-blight disease response on grafted pear plants. The leaves of the plants were inoculated with Erwinia amylovora suspensions by pricking with clamps, cutting with scissors, local infiltration, and painting a bacterial suspension onto the leaves with a paintbrush. The effects of the inoculation methods were studied in dose-time-response experiments carried out in climate chambers under quarantine conditions. A modified Gompertz model was used to analyze the disease-time relatiobbnships and provided information on the rate of infection progression (rg) and time delay to the start of symptoms (t0). The disease-pathogen-dose relationships were analyzed according to a hyperbolic saturation model in which the median effective dose (ED50) of the pathogen and maximum disease level (ymax) were determined. Localized infiltration into the leaf mesophile resulted in the early (short t0) but slow (low rg) development of infection whereas in leaves pricked with clamps disease symptoms developed late (long t0) but rapidly (high rg). Paintbrush inoculation of the plants resulted in an incubation period of medium length, a moderate rate of infection progression, and low ymax values. In leaves inoculated with scissors, fire-blight symptoms developed early (short t0) and rapidly (high rg), and with the lowest ED50 and the highest ymax

Identification of myxobacteria-derived HIV inhibitors by a high-throughput two-step infectivity assay

Drug-resistance and therapy failure due to drug-drug interactions are the main challenges in current treatment against Human Immunodeficiency Virus (HIV) infection. As such, there is a continuous need for the development of new and more potent anti-HIV drugs. Here we established a high-throughput screen based on the highly permissive TZM-bl cell line to identify novel HIV inhibitors. The assay allows discriminating compounds acting on early and/or late steps of the HIV replication cycle. The platform was used to screen a unique library of secondary metabolites derived from myxobacteria. Several hits with good anti-HIV profiles were identified. Five of the initial hits were tested for their antiviral potency. Four myxobacterial compounds, sulfangolid C, soraphen F, epothilon D and spirangien B, showed EC50 values in the nM range with SI > 15. Interestingly, we found a high amount of overlapping hits compared with a previous screen for Hepatitis C Virus (HCV) using the same library. The unique structures and mode-of-actions of these natural compounds make myxobacteria an attractive source of chemicals for the development of broad-spectrum antivirals. Further biological and structural studies of our initial hits might help recognize smaller drug-like derivatives that in turn could be synthesized and further optimized.

High pressure processing of swede (Brassica napus): Impact on quality properties

The effects of combined pressure/temperature treatments (200, 400 and 600 MPa, at 20 and 40 °C) on the physical and nutritional properties of swede roots (Brassica napus var. napobrassica) were assessed. Changes induced by high pressure processing (HPP) on the original properties of swede samples were compared with those produced by thermal treatment (blanching). All studied treatments altered the physical properties of swede, resulting in a loss of hardness and water binding capacity. The strongest alteration of texture was observed after HPP at 400 MPa, while 600 MPa was the treatment that better preserved the texture properties of swede. Blanching caused less total colour changes (ΔE) than HPP. Antioxidant properties of swede were measured as total antioxidant capacity, ascorbic acid and total phenol content. All treatments caused a loss of antioxidant capacity, which was less pronounced after HPP at 600 MPa and 20 °C and blanching. Four glucosinolates were detected in swede roots, glucoraphanin, progoitrin, glucobrassicanapin and glucobrassicin. Glucobrassicanapin and glucobrassicin contents were reduced with all studied treatments. Progoitrin content was not affected by blanching and HPP at 200 MPa. HPP at higher pressure levels (400 and 600 MPa), though, induced an increase of progoitrin levels. The results indicated that blanching and HPP at 600 MPa and 20 °C were the treatments that better preserved the original quality properties of swede.

L'exploitation des ressources végétales dans les Pyrénées orientales durant l'holocène: analyse anthracologique des structures d'élevage, de four et de charbonnières dans l'Alt Urgell (Chaîne du Cadí) et la Vallée du Madriu (Andorre)

Dans ce travail, nous présentons le résultat des recherches anthracologiques réalisées sur des sites archéologiques de haute montagne dans les Pyrénées orientales. Cette recherche s’insère dans un projet d’archéologie du paysage. Les zones d’étude se situent dans les Pré-Pyrénées sur le versant méridional de la chaîne du Cadí (vallée de la Vansa, Alt Urgell), et dans la vallée du Madriu, située dans les Pyrénées axiales, en Andorre. Le but principal de l’analyse anthracologique a été de connaître et comprendre la dynamique et la relation qui unissent les populations qui ont occupé ces vallées avec le milieu forestier de haute montagne. Les échantillons ont été récupérés sur des structures archéologiques associés à l’exploitation forestière (charbonnières, fours pour la fabrication de résine), au pastoralisme (cabanes et enclos) et à l’exploitation minière-métallurgique (four de grillage), avec une chronologie qui débute au Néolithique Ancien et finit à l’époque moderne et contemporaine (XVIII-XIXe siècles). Les résultats indiquent une variabilité taxonomique pauvre avec la présence majoritaire du Pinus et la présence ponctuelle d’autres espèces arbustives (Ericaceae et Juniperus) et arborées, comme Betula alba ou Abies alba. Différentes formations végétales de haute montagne ont été identifiées, selon leur localisation en versant ensoleillé ou ombragé, ainsi que leur altitude. Les résultats montrent des traces d’exploitation forestière dès le Néolithique Ancien, une intensification des activités à l’Antiquité, même si l’impact anthropique majeur correspond à l’activité de charbonnage d’époque moderne.

Caracterización de rodales irregulares de Abies alba Mill. capitalizados en existencias del Valle de Arán (Pirineos, España) y de las cortas de entresaca practicadas

Se describe, en una zona de la vertiente norte de los Pirineos españoles, la estructura dasocrática de rodales irregulares de abeto excesivamente capitalizados en existencias volumétricas, así como la naturaleza de las intervenciones de entresaca que se les aplican al objeto de contrarrestar la tendencia hacia una indeseable uniformidad de la masa. La situación inicial revela una elevada espesura, con importantes excedentes de individuos pertenecientes a las clases diamétricas de madera gruesa, y que conduce a formas selvícolas tipológicas en avanzado proceso de regularización. Empero, la estabilidad mecánica de los pies se manifiesta alejada de sus umbrales críticos en todos los estratos, y la capacidad de regeneración del sistema resulta aceptable. El tratamiento de entresaca realizado, cuya severidad se centró fundamentalmente sobre los pies de diámetro superior a 30 cm, mantiene todavía una situación de espesura excesiva que impide la adscripción de los rodales a estructuras equilibradas, pero ha permitido la liberación de la competencia vertical de los pies en edad de latizal.

Distribution, Abundance and Molecular Analysis of Genus Barbadocladius Cranston & Krosch (Diptera, Chironomidae) in Tropical, High Altitude Andean Streams and Rivers

The distribution of the genus Barbadocladius Cranston & Krosch (Diptera: Chironomidae), previously reported from Chile to Bolivia, has extended northwards. Larvae, pupae and pupal exuviae of this genus have been found in the high mountain tropical streams of Peru to 9°22′56″, but are restricted to very high altitude streams (altitudes over 3,278 m asl) compared to the lower altitude streams (below 1,100 m asl) in which the genus is reported in Chile and Argentina. Based on morphological studies, both described species in the genus, Barbadocladius andinus Cranston & Krosch and Barbadocladius limay Cranston & Krosch, have been found in Peru as pupae or pupal exuviae. Morphological analysis of the larvae and pupae revealed no differences between the two described species from Patagonia and Peru, which are of similar size and with a similar armament of hooklets and spines in pupal tergites and sternites. However, molecular analysis of larvae and pupae revealed that in Peru, there are at least two different evolutionary lines, one distributed widely and another restricted to one site. Phylogenetic analysis (using cox1 mitochondrial sequences) of all available sequences of Barbadocladius shows that the Chilean and Argentinean material differs from that of Peru. Therefore, a total of four molecular segregates are identified, although morphologically, neither larvae nor the pupae may be differentiated.

Development, physical-chemical stability and release studies of four alcohol-free spironolactone suspensions for use in pediatrics

Dissolution studies have become of great significance because, in most cases, drug dissolution is the rate-limiting step in the absorption process. As occurs with solid oral dosage forms, heterogeneous disperse systems (suspensions) could also have some problems with their in vitro dissolution. The objective of this study was to evaluate influence of the excipients on the release of spironolactone from four alcohol free suspensions (pharmaceutical compounding) of spironolactone 5 mg/mL suitable for pediatric use. Also the comparison of the physical and chemical stability of the suspensions stored at 4, 25 and 40 ºC over a 60- day period has been studied. Rheological behavior, particle size, a prediction of long-term physical stability, pH and assay of spironolactone by HPLC were assessed at prefixed times. The dissolution profile of each suspension was determined and compared with that of the commercial tablets. A microbiological study of the best formula was also performed. Chemically, the four spironolactone suspensions were stable for 60 days stored at three temperatures; Suspension IV had optimum pH values and the highest recovery percentage. In terms of physical stability, sedimentation occurred in Suspension IV and flotation of spironolactone in Suspensions I, II and III. Suspension III had the highest viscosity and the slowest drug release. Suspension IV was also microbiologically stable for 60 days. In conclusion, Suspension IV had the best properties and the least suitable form was Suspension III, as its high viscosity made it difficult to achieve homogeneous redispersion, and it had the slowest dissolution profile.