Detection of matchings in a sequence of underwater images through texture analysis

This paper presents an approach to ameliorate the reliability of the correspondence points relating two consecutive images of a sequence. The images are especially difficult to handle, since they have been acquired by a camera looking at the sea floor while carried by an underwater robot. Underwater images are usually difficult to process due to light absorption, changing image radiance and lack of well-defined features. A new approach based on gray-level region matching and selective texture analysis significantly improves the matching reliability

A Quantitative method for the characterization of lytic metastases of the bone from radiographic images

The aim of our study was to assess the diagnostic usefulness of the gray level parameters to distinguish osteolytic lesions using radiological images. Materials and Methods: A retrospective study was carried out. A total of 76 skeletal radiographs of osteolytic metastases and 67 radiographs of multiple myeloma were used. The cases were classified into nonflat (MM1 and OL1) and flat bones (MM2 and OL2). These radiological images were analyzed by using a computerized method. The parameters calculated were mean, standard deviation, and coefficient of variation (MGL, SDGL, and CVGL) based on gray level histogram analysis of a region-of-interest.Diagnostic utility was quantified bymeasurement of parameters on osteolyticmetastases andmultiplemyeloma, yielding quantification of area under the receiver operating characteristic (ROC) curve (AUC). Results: Flat bone groups (MM2 and OL2) showed significant differences in mean values of MGL ( = 0.048) and SDGL ( = 0.003). Their corresponding values of AUC were 0.758 for MGL and 0.883 for SDGL in flat bones. In nonflat bones these gray level parameters do not show diagnostic ability. Conclusion: The gray level parametersMGL and SDGL show a good discriminatory diagnostic ability to distinguish between multiple myeloma and lytic metastases in flat bones.

Evaluación de la regeneración ósea mediante procesado de imagen

La regeneració òssia és un procés estudiat per experts de tot el món. Aquests experts estudien materials capaços d’accelerar el procés de formació de teixit ossi en zones on s’han produït defectes ossis. Després d’un determinat període de temps de l’aplicació dels materials d’estudi en la zona on hi havia una manca de teixit ossi, s’obtenen imatges d’aquesta zona on l’expert mitjançant l’ inspecció visual d’aquestes imatges avalua si l’os s’ha regenerat bé o no. El problema d’aquest mètode d’avaluació es que requereix d’un expert on la valoració d’aquest és subjectiva i difícil de quantificar, el que pot provocar que hi hagi discordança entre experts. Amb la finalitat de aprofitar les imatges en que es basa l’expert per avaluar la capacitat de regeneració òssia dels materials d’estudi es proposa realitzar un anàlisi quantitatiu de la regeneració òssia basat en el processament d’imatge. L’algorisme dissenyat es capaç de classificar imatges de la mandíbula en: imatges de regeneració bona i dolenta mitjançant la parametrització de l’histograma de nivells de grisos de la imatge, solucionant la falta d’objectivitat del mètode d’avaluació de la regeneració òssia i la necessitat d’un expert per realitzar-la.

Reversible and high capacity data hiding in medical images

In this paper we introduce a highly efficient reversible data hiding system. It is based on dividing the image into tiles and shifting the histograms of each image tile between its minimum and maximum frequency. Data are then inserted at the pixel level with the largest frequency to maximize data hiding capacity. It exploits the special properties of medical images, where the histogram of their nonoverlapping image tiles mostly peak around some gray values and the rest of the spectrum is mainlyempty. The zeros (or minima) and peaks (maxima) of the histograms of the image tiles are then relocated to embed the data. The grey values of some pixels are therefore modified.High capacity, high fidelity, reversibility and multiple data insertions are the key requirements of data hiding in medical images. We show how histograms of image tiles of medical images can be exploited to achieve these requirements. Compared with data hiding method applied to the whole image, our scheme can result in 30%-200% capacity improvement and still with better image quality, depending on the medical image content. Additional advantages of the proposed method include hiding data in the regions of non-interest and better exploitation of spatial masking.

Bristle pattern formation in the thorax formation of Drosophila: a systems level approach

A fundamental question in developmental biology is how tissues are patterned to give rise to differentiated body structures with distinct morphologies. The Drosophila wing disc offers an accessible model to understand epithelial spatial patterning. It has been studied extensively using genetic and molecular approaches. Bristle patterns on the thorax, which arise from the medial part of the wing disc, are a classical model of pattern formation, dependent on a pre-pattern of trans-activators and –repressors. Despite of decades of molecular studies, we still only know a subset of the factors that determine the pre-pattern. We are applying a novel and interdisciplinary approach to predict regulatory interactions in this system. It is based on the description of expression patterns by simple logical relations (addition, subtraction, intersection and union) between simple shapes (graphical primitives). Similarities and relations between primitives have been shown to be predictive of regulatory relationships between the corresponding regulatory factors in other Systems, such as the Drosophila egg. Furthermore, they provide the basis for dynamical models of the bristle-patterning network, which enable us to make even more detailed predictions on gene regulation and expression dynamics. We have obtained a data-set of wing disc expression patterns which we are now processing to obtain average expression patterns for each gene. Through triangulation of the images we can transform the expression patterns into vectors which can easily be analysed by Standard clustering methods. These analyses will allow us to identify primitives and regulatory interactions. We expect to identify new regulatory interactions and to understand the basic Dynamics of the regulatory network responsible for thorax patterning. These results will provide us with a better understanding of the rules governing gene regulatory networks in general, and provide the basis for future studies of the evolution of the thorax-patterning network in particular.

Multifractal wavelet filter of natural images

Natural images are characterized by the multiscaling properties of their contrast gradient, in addition to their power spectrum. In this Letter we show that those properties uniquely define an intrinsic wavelet and present a suitable technique to obtain it from an ensemble of images. Once this wavelet is known, images can be represented as expansions in the associated wavelet basis. The resulting code has the remarkable properties that it separates independent features at different resolution level, reducing the redundancy, and remains essentially unchanged under changes in the power spectrum. The possible generalization of this representation to other systems is discussed.

Linear and nonlinear terrain deformation maps from a reduced set of interferometric SAR images

In this paper, an advanced technique for the generation of deformation maps using synthetic aperture radar (SAR) data is presented. The algorithm estimates the linear and nonlinear components of the displacement, the error of the digital elevation model (DEM) used to cancel the topographic terms, and the atmospheric artifacts from a reduced set of low spatial resolution interferograms. The pixel candidates are selected from those presenting a good coherence level in the whole set of interferograms and the resulting nonuniform mesh tessellated with the Delauney triangulation to establish connections among them. The linear component of movement and DEM error are estimated adjusting a linear model to the data only on the connections. Later on, this information, once unwrapped to retrieve the absolute values, is used to calculate the nonlinear component of movement and atmospheric artifacts with alternate filtering techniques in both the temporal and spatial domains. The method presents high flexibility with respect to the required number of images and the baselines length. However, better results are obtained with large datasets of short baseline interferograms. The technique has been tested with European Remote Sensing SAR data from an area of Catalonia (Spain) and validated with on-field precise leveling measurements.

Measuring sustained superior performance at the firm level

This paper proposes a two-dimensional Strategic Performance Measure (SPM) to evaluate the achievement of sustained superior performance. This proposal builds primarily on the fact that, under the strategic management perspective, a firm's prevalent objective is the pursuit of sustained superior performance. Three basic conceptual dimensions stem from this objective: relativity, sign dependence, and dynamism. These are the foundations of the SPM, which carries out a separate evaluation of the attained superior performance and of its sustainability over time. In contrast to existing measures of performance, the SPM provides: (i) a dynamic approach by considering the progress or regress in performance over time, and (ii) a cardinal measurement of performance differences and its changes over time. The paper also proposes an axiomatic framework that a measure of strategic performance should comply with to be theoretically and managerially sound. Finally, an empirical illustration of the Spanish banking sector during 1987-1999 is herein provided by discussing some relevant cases.

A note on Spatial Autocorrelation at a Local Level

In this paper we analyze the existence of spatial autocorrelation at a local level in Catalonia using variables such as urbanisation economies, population density, human capital and firm entries. From a static approach, our results show that spatial autocorrelation is weak and diminishes as the distance between municipalities increases. From a dynamic approach, however, spatial autocorrelation increased over the period we analysed. These results are important from a policy point of view, since it is essential to know how economic activities are spatially concentrated or disseminated. Key words: spatial autocorrelation, municipalities. JEL classification: R110, R120

Human capital as a factor of growth and employment at the regional level. The case of Spain

We use statistical techniques to quantify the effects of school attainment on individual wages, participation rates and employment probabilities in Spain, and to measure the contribution of education to labour productivity at the regional level. These estimates are then combined with data on private and public expenditure on education and with information on taxes and social benefits to construct measures of the private and social returns to schooling, to explore the effects of public policies on private incentives to invest in human capital, and to analyse the long-term effects of schooling on public finances. The results are used, together with estimates of the returns to alternative assets, to draw some tentative conclusions regarding the adequacy of the aggregate investment patterns observed in the regions of Spain, and to identify changes in the design of national and EU cohesion and growth policies that may help enhance their effectiveness.

Human capital in a global and knowledge-based economy. Part 2. Asssessment at the EU country level.

This report is an extension and partial update of de la Fuente and Ciccone (2002). It constructs estimates of the private and social rates of return on schooling for fourteen EU countries using microeconometric estimates of Mincerian wage equations, the results of cross-country growth regressions and OECD data on educational expenditures, tax rates and social benefits. The results are used to draw some tentative conclusions regarding the optimality of observed investment patterns and educational subsidy levels.

Lipschitz harmonic capacity and Bilipschitz images of cantor sets

For bilipschitz images of Cantor sets in Rd we estimate the Lipschitz harmonic capacity and show this capacity is invariant under bilipschitz homeomorphisms.

Industrial location at a local level: some comments about the territorial level of the analysis

This paper contributes to the existing literature on industrial location by discussing some issues regarding the territorial levels that have been used in location analysis. We analyse which could be the advantages and disadvantages of performing locational analysis at a different local levels. We use data for new manufacturing firms located at municipality, county and travel to work areas level. We show that location determinants vary according to the territorial level used in the analysis, so we conclude that the level at which we perform the investigation should be carefully selected. Keywords: industrial location, cities, agglomeration economies, count data models.

Desenvolupament d'interfícies HW per a FPGA des de Matlab

Aquest projecte consisteix en el desenvolupament d’estructures hardware digitals, sintetitzables sobre FPGA i realitzades des d’un entorn gràfic de disseny a nivell de sistema (alt nivell). S'ha escollit el Simulink (entorn gràfic que treballa sobre el software matemàtic Matlab de Mathworks) com a entorn de disseny, i que gràcies a la interfície proporcionada per Altera (DSPBuilder) és capaç de generar codi VHDL sintetitzable. Concretament ens centrarem en la gestió d’un sistema capturador d'imatges de comptadors del cabal d'aigua, en el qual volem fer la caracterització del comptador. Aquest capturador consta bàsicament d'un sensor d'imatge i una FPGA. En aquesta caracterització el que es pretén es ajustar els diferents paràmetres del sistema per fer que la lectura sigui òptima per a cada model de comptador que existeixen al mercat, com ara l'exposició del sensor, el guany d'un color, la realització d'un filtrat de la imatge, etc.

Price level convergence, purchasing power parity and multiple structural breaks: an application to US cities

This article provides a fresh methodological and empirical approach for assessing price level convergence and its relation to purchasing power parity (PPP) using annual price data for seventeen US cities. We suggest a new procedure that can handle a wide range of PPP concepts in the presence of multiple structural breaks using all possible pairs of real exchange rates. To deal with cross-sectional dependence, we use both cross-sectional demeaned data and a parametric bootstrap approach. In general, we find more evidence for stationarity when the parity restriction is not imposed, while imposing parity restriction provides leads toward the rejection of the panel stationar- ity. Our results can be embedded on the view of the Balassa-Samuelson approach, but where the slope of the time trend is allowed to change in the long-run. The median half-life point estimate are found to be lower than the consensus view regardless of the parity restriction.