Guia temàtica Biblioteca ETSAB: Terratrèmols i arquitectura

Postprint (author’s final draft)

Sequencing lifeline repairs after an earthquake: an economic approach

Recoveries after recent earthquakes in the U.S. and Japan have shown that large welfare gains can be achieved by reshaping current emergency plans as incentive-compatible contracts. We apply tools from the mechanisms design literature to show ways to integrate economic incentives into the management of natural disasters and discuss issues related to the application to seismic event recovery. The focus is on restoring lifeline services such as the water, gas, transportation, and electric power networks. We put forward decisional procedures that an uninformed planner could employ to set repair priorities and help to coordinate lifeline firms in the post-earthquake reconstruction.

On the design of peer punishment experiments

We discuss how technologies of peer punishment might bias the results that are observed in experiments. A crucial parameter is the “fine-to-fee” ratio, which describes by how much the punished subjects income is reduced relatively to the fee the punishing subject has to pay to inflict punishment. We show that a punishment technology commonly used in experiments embeds a variable fine-to-fee ratio and show that it confounds the empirical findings about why, whom, and how much subjects punish.

Competition with forward contracts: a laboratory analysis motivated by electricity market design

We use experiments to study the efficiency effects for a market as a whole of adding the possibility of forward contracting to a pre-existing spot market. We deal separately with the cases where spot market competition is in quantities and where it is in supply functions. In both cases we compare the effect of adding a contract market with the introduction of an additional competitor, changing the market structure from a triopoly to a quadropoly. We find that, as theory suggests, for both types of competition the introduction of a forward market significantly lowers prices. The combination of supply function competition with a forward market leads to high efficiency levels.

1st National Accessiblity Plan 2004-2012: achieving equal opportunities and full participation through design for all

According to official statistics, disabled people in Spain number 3.5 million and make up 8.8% of the Spanish population. This group of people are increasingly being recognised as members of society with equal rights, and many of their demands are gradually being transformed into solutions that benefit society as a whole. One example is improved accessibility. Accessible built environments are more human and inclusive places, as well as being easier to get around. Improved accessibility is now recognised as a requirement shared by all members of society, although it is achieved thanks to the demands of disabled people and their representatives. The 1st National Accessibility Plan is a strategic framework for action aimed at ensuring that new products, services and built environments are designed to be accessible for as many people as possible (Design for All) and that existing ones are gradually duly adapted.

From creative ideas to new emerging ventures: the process of identification and exploitation among finnish design entrepreneurs

This study focuses on identification and exploitation processes among Finnish design entrepreneurs (i.e. selfemployed industrial designers). More specifically, this study strives to find out what design entrepreneurs do when they create new ventures, how venture ideas are identified and how entrepreneurial processes are organized to identify and exploit such venture ideas in the given industrial context. Indeed, what does educated and creative individuals do when they decide to create new ventures, where do the venture ideas originally come from, and moreover, how are venture ideas identified and developed into viable business concepts that are introduced on the markets? From an academic perspective: there is a need to increase our understanding of the interaction between the identification and exploitation of emerging ventures, in this and other empirical contexts. Rather than assuming that venture ideas are constant in time, this study examines how emerging ideas are adjusted to enable exploitation in dynamic market settings. It builds on the insights from previous entrepreneurship process research. The interpretations from the theoretical discussion build on the assumption that the subprocesses of identification and exploitation interact, and moreover, they are closely entwined with each other (e.g. McKelvie & Wiklund, 2004, Davidsson, 2005). This explanation challenges the common assumption that entrepreneurs would first identify venture ideas and then exploit them (e.g. Shane, 2003). The assumption is that exploitation influences identification, just as identification influences exploitation. Based on interviews with design entrepreneurs and external actors (e.g. potential customers, suppliers and collaborators), it appears as identification and exploitation of venture ideas are carried out in close interaction between a number of actors, rather than alone by entrepreneurs. Due to their available resources, design entrepreneurs have a desire to focus on identification related activities and to find external actors that take care of exploitation related activities. The involvement of external actors may have a direct impact on decisionmaking and various activities along the processes of identification and exploitation, which is something that previous research does not particularly emphasize. For instance, Bhave (1994) suggests both operative and strategic feedback from the market, but does not explain how external parties are actually involved in the decisionmaking, and in carrying out various activities along the entrepreneurial process.

Limited liability and mechanism design in procurement

In the presence of cost uncertainty, limited liability introduces the possibility of default in procurement with its associated bank-ruptcy costs. When financial soundness is not perfectly observable, we show that incentive compatibility implies that financially less sound contractors are selected with higher probability in any feasible mechanism. Informational rents are associated with unsound financial situations. By selecting the financially weakest contractor, stronger price competition (auctions) may not only increase the probability of default but also expected rents. Thus, weak conditions are suffcient for auctions to be suboptimal. In particular, we show that pooling firms with higher assets may reduce the cost of procurement even when default is costless for the sponsor.

The Design and efficiency of loyalty rewards

The goal of this paper is to reexamine the optimal design and efficiency of loyalty rewards in markets for final consumption goods. While the literature has emphasized the role of loyalty rewards as endogenous switching costs (which distort the efficient allocation of consumers), in this paper I analyze the ability of alternative designs to foster consumer participation and increase total surplus. First, the efficiency of loyalty rewards depend on their specific design. A commitment to the price of repeat purchases can involve substantial efficiency gains by reducing price-cost margins. However, discount policies imply higher future regular prices and are likely to reduce total surplus. Second, firms may prefer to set up inefficient rewards (discounts), especially in those circumstances where a commitment to the price of repeat purchases triggers Coasian dynamics.

Design of Novel Frequency Generation Circuit with Application to Ultra-Wideband Distributed Oscillators

Given the urgence of a new paradigm in wireless digital trasmission which should allow for higher bit rate, lower latency and tigher delay constaints, it has been proposed to investigate the fundamental building blocks that at the circuital/device level, will boost the change towards a more efficient network architecture, with high capacity, higher bandwidth and a more satisfactory end user experience. At the core of each transciever, there are inherently analog devices capable of providing the carrier signal, the oscillators. It is strongly believed that many limitations in today's communication protocols, could be relieved by permitting high carrier frequency radio transmission, and having some degree of reconfigurability. This led us to studying distributed oscillator architectures which work in the microwave range and possess wideband tuning capability. As microvave oscillators are essentially nonlinear devices, a full nonlinear analyis, synthesis, and optimization had to be considered for their implementation. Consequently, all the most used nonlinear numerical techniques in commercial EDA software had been reviewed. An application of all the aforementioned techniques has been shown, considering a systems of three coupled oscillator ("triple push" oscillator) in which the stability of the various oscillating modes has been studied. Provided that a certain phase distribution is maintained among the oscillating elements, this topology permits a rise in the output power of the third harmonic; nevertheless due to circuit simmetry, "unwanted" oscillating modes coexist with the intenteded one. Starting with the necessary background on distributed amplification and distributed oscillator theory, the design of a four stage reverse mode distributed voltage controlled oscillator (DVCO) using lumped elments has been presented. All the design steps have been reported and for the first time a method for an optimized design with reduced variations in the output power has been presented. Ongoing work is devoted to model a wideband DVCO and to implement a frequency divider.

Detecció, identificació de Mycobacterium tuberculosis i caracterització molecular de la resistència als principals antituberculosos en mostra clínica directa mitjançant piroseqüenciació: aplicabilitat en l’estudi de la clonalitat de les soques.

L’augment de soques de Mycobacerium tuberculosis multiresistents i l’aparició de soques extremadament resistents, ha posat de manifest la necessitat de disposar de nous mètodes de detecció precoç de M.tuberculosis i les seves resistències als principals fàrmacs antituberculosos, així com l’estudi eficaç dels brots, per a poder dur a terme un control eficient de la malaltia. L’objectiu de l’estudi va ser determinar la capacitat de la piroseqüenciació per a detectar i identificar micobacteris a partir d’aïllats clínics i mostra directa, determinar el seu patró de resistència a Rifampicina, Isoniacida, Etambutol, Fluoroquinolones, Canamicina i Capreomicina i explorar la seva potencialitat per a ser emprada en el tipatge molecular de les soques. Mitjançant la optimització de la tecnologia de la piroseqüenciació pels gens analitzats, i el disseny de primers específics, hem verificat la utilitat de la piroseqüenciació per al maneig de la tuberculosi. S’ha pogut estudiar la presència de mutacions relacionades amb resistències a fàrmacs de primera línia en el 96.5% de les posicions analitzades en soca clínica i en el 70.4% en mostra directa. Van concordar amb el resultats obtinguts per altres mètodes fenotípics i/o fenotípics el 97.1% i el 98.2% del resultats obtinguts en soca clínica i mostra directa respectivament. La piroseqüenciació ens ha permet analitzar la presència de mutacions relacionades amb resistències a antituberculosos de segona línia, servint com a mètode de confirmació en l’anàlisi d’altres mètodes genotípics. La tècnica ens ha permès també identificar els principals micobacteris no tuberculosos implicats en la infecció humana, sòls o en coinfecció. Resultats preliminars mostren que l’anàlisi amb piroseqüenciació pot ser d’utilitat per l’estudi clonal de les soques de M.tuberculosis. Les nostres observacions mostren la piroseqüenciació com una eina valuosa en l’àmbit clínic, ja que permet una reducció de la demora del diagnòstic, estudi filogenètic i detecció de resistències M.tuberculosis, i per tant una millora de l’aplicació del tractament adequat, ajudant al control de la malaltia.

Open to the users' needs : combining user-centered design, standards and open source software

This case study introduces our continuous work to enhance the virtual classroom in order to provide faculty and students with an environment open to their needs, compliant with learning standards and, therefore compatible with other e-learning environments, and based on open source software. The result is a modulable, sustainable and interoperable learning environment that can be adapted to different teaching and learning situations by incorporating the LMS integrated tools as well as wikis, blogs, forums and Moodle activities among others.

Educational innovation in large groups. Design of an experimental study implemented at the Polytechnic University of Madrid

The present paper shows de design of an experimental study conducted with large groups using educational innovation methodologies at the Polytechnic University of Madrid. Concretely, we have chosen the course titled "History and Politics of Sports" that belongs to the Physical Activity and Sport Science Degree. The selection of this course is because the syllabus is basically theoretical and there are four large groups of freshmen students who do not have previous experiences in a teaching-learning process based on educational innovation. It is hope that the results of this research can be extrapolated to other courses with similar characteristics.

Decentralized model reference control of flexible cable-stayed beam structures

A decentralized model reference controller is designed to reduce the magnitude of the transversal vibration of a flexible cable-stayed beam structure induced by a seismic excitation. The controller design is made based on the principle of sliding mode such that a priori knowledge