16 resultados para Crystal growth from melt
em Consorci de Serveis Universitaris de Catalunya (CSUC), Spain
Resumo:
We obtained Ba3Yb(BO3)3 single crystals by the flux method with solutions of the BaB2O4Na2OYb2O3 system. The evolution of the cell parameters with temperature shows a slope change at temperatures near 873 K, which may indicate a phase transition that is not observed by changes appearing in the x-ray powder patterns or by differential thermal analysis (DTA). The evolution of the diffraction patterns with the temperature shows incongruent melting at temperatures higher than 1473 K. DTA indicates that there is incongruent melting and this process is irreversible. Ba3Yb(BO3)3 has a wide transparency window from 247 to 3900 nm. We recorded optical absorption and emission spectra at room and low temperature, and we determined the splitting of Yb3+ ions. We used the reciprocity method to calculate the maximum emission cross section of 0.28 10-20 cm2 at 966 nm. The calculated lifetime of Yb3+ in Ba3Yb(BO3)3 is trad = 2.62 ms, while the measured lifetime is t = 3.80 ms.
Resumo:
Two alloys, Fe80Nb10B10 and Fe70Ni14Zr6B10, were produced by mechanical alloying. The formation of thenanocrystallites (about 7-8 nm at 80h MA) was detected by X-ray diffraction. After milling for 80 h, differentialscanning calorimetry scans show low-temperature recovery processes and several crystallization processes related with crystal growth and reordering of crystalline phases. The apparent activation energy values are 315 ± 40 kJ mol–1 for alloy A, and 295 ± 20 kJ mol–1 and 320 ± 25 kJ mol–1 for alloy B. Furthermore, a melt-spun Fe-based ribbon was mechanically alloyed to obtain a powdered-like alloy. The increase of the rotation speed and the ball-to-powderweight ratio reduces the necessary time to obtain the powdered form
Resumo:
The dolomite veins making up rhythmites common in burial dolomites are not cement infillings of supposed cavities, as in the prevailing view, but are instead displacive veins, veins that pushed aside the host dolostone as they grew. Evidence that the veins are displacive includes a) small transform-fault-like displacements that could not have taken place if the veins were passive cements, and b) stylolites in host rock that formed as the veins grew in order to compensate for the volume added by the veins. Each zebra vein consists of crystals that grow inward from both sides, and displaces its walls via the local induced stress generated by the crystal growth itself. The petrographic criterion used in recent literature to interpret zebra veins in dolomites as cements - namely, that euhedral crystals can grow only in a prior void - disregards evidence to the contrary. The idea that flat voids did form in dolostones is incompatible with the observed optical continuity between the saddle dolomite euhedra of a vein and the replacive dolomite crystals of the host. The induced stress is also the key to the self-organization of zebra veins: In a set of many incipient, randomly-spaced, parallel veins just starting to grow in a host dolostone, each vein¿s induced stress prevents too-close neighbor veins from nucleating, or redissolves them by pressure-solution. The veins that survive this triage are those just outside their neighbors¿s induced stress haloes, now forming a set of equidistant veins, as observed.
Resumo:
We communicate a detailed study of the epitaxial growth of CeO2 on MgO. The key feature of the growth is the dependence of the in¿plane orientation of the CeO2 epitaxial layer on the MgO surface morphology. Atomic force microscopic (AFM) measurements, x¿ray analyses, as well as high¿resolution transmission electron microscopy (HRTEM) investigations reveal that on rough substrates a cube¿on¿cube growth of CeO2 on MgO occurs while on smooth substrates the CeO2 unit cell is rotated around the surface normal by 45° with respect to the MgO unit cell when the deposition rate is low (~0.3 Å/s) during the first stages of growth. This growth mechanism can be used for a defined fabrication of 45° grain boundaries in the CeO2 layer by controlling the surface roughness of the MgO substrate. This report demonstrates that these 45° grain boundaries may be used to fabricate YBa2Cu3O7¿x Josephson junctions.
Resumo:
This article analyses the effect of immigration flows on the growth and efficiency of manufacturing firms in Spanish cities. To date, most studies have tended to focus on the effect immigrants have on labour markets at an aggregate level. Here, however, we undertake an exhaustive analysis at the firm level and report conclusive empirical findings. Ten years ago, Spain began to register massive immigration flows, concentrated above all on its most dynamic and advanced regions. Here, therefore, rather than focusing on the impact this has had on Spain’s labour market (changes to the skill structure of the workforce, increase in labour supply, the displacement of native workers, etc.), we examine the arrival of immigrants in terms of the changes this has meant to the structure of the country’s cities and their amenities. Thus, we argue that the impact of immigration on firm performance should not only be considered in terms of the labour market, but also in terms of how a city’s amenities can affect the performance of firms. Employing a panel data methodology, we show that the increasing pressure brought to bear by immigrants has a positive effect on the evolution of labour productivity and wages and a negative effect on the job evolution of these manufacturing firms. In addition, both small and new firms are more sensitive to the pressures of such immigrant inflows, while foreign market oriented firms report higher productivity levels and a less marked impact of immigration than their counterparts. In this paper, we also present a set of instruments to correct the endogeneity bias, which confirms the effect of local immigration flows on the performance of manufacturing firms.
Resumo:
We present our recent achievements in the growing and optical characterization of KYb(WO4)2 (hereafter KYbW) crystals and demonstrate laser operation in this stoichiometric material. Single crystals of KYbW with optimal crystalline quality have been grown by the top-seeded-solution growth slow-cooling method. The optical anisotropy of this monoclinic crystal has been characterized, locating the tensor of the optical indicatrix and measuring the dispersion of the principal values of the refractive indices as well as the thermo-optic coefficients. Sellmeier equations have been constructed valid in the visible and near-IR spectral range. Raman scattering has been used to determine the phonon energies of KYbW and a simple physical model is applied for classification of the lattice vibration modes. Spectroscopic studies (absorption and emission measurements at room and low temperature) have been carried out in the spectral region near 1 µm characteristic for the ytterbium transition. Energy positions of the Stark sublevels of the ground and the excited state manifolds have been determined and the vibronic substructure has been identified. The intrinsic lifetime of the upper laser level has been measured taking care to suppress the effect of reabsorption and the intrinsic quantum efficiency has been estimated. Lasing has been demonstrated near 1074 nm with 41% slope efficiency at room temperature using a 0.5 mm thin plate of KYbW. This laser material holds great promise for diode pumped high-power lasers, thin disk and waveguide designs as well as for ultrashort (ps/fs) pulse laser systems.
Resumo:
A simple and most promising oxide-assisted catalyst-free method is used to prepare silicon nitride nanowires that give rise to high yield in a short time. After a brief analysis of the state of the art, we reveal the crucial role played by the oxygen partial pressure: when oxygen partial pressure is slightly below the threshold of passive oxidation, a high yield inhibiting the formation of any silica layer covering the nanowires occurs and thanks to the synthesis temperature one can control nanowire dimensions
Resumo:
Postprint (published version)
Resumo:
The interrelation among economic growth, income inequality, and fiscal performance is very complex. The paper provides the analysis of the interrelations among these variables jointly by the structural VAR methodology, examining also transmission channels among them. This approach allows exploring dynamic interactions among them and feedback effects on each other. The empirical analysis is implemented for the Anglo-Saxon countries, the UK, the USA, and Canada. We find that income inequality has negative effect on economic growth in the case of the UK. The effect is positive in the cases of the USA and Canada. The increase in income inequality worsens fiscal performance for all the countries
Resumo:
Near-infrared spectroscopy (NIRS) was used to analyse the crude protein content of dried and milled samples of wheat and to discriminate samples according to their stage of growth. A calibration set of 72 samples from three growth stages of wheat (tillering, heading and harvest) and a validation set of 28 samples was collected for this purpose. Principal components analysis (PCA) of the calibration set discriminated groups of samples according to the growth stage of the wheat. Based on these differences, a classification procedure (SIMCA) showed a very accurate classification of the validation set samples : all of them were successfully classified in each group using this procedure when both the residual and the leverage were used in the classification criteria. Looking only at the residuals all the samples were also correctly classified except one of tillering stage that was assigned to both tillering and heading stages. Finally, the determination of the crude protein content of these samples was considered in two ways: building up a global model for all the growth stages, and building up local models for each stage, separately. The best prediction results for crude protein were obtained using a global model for samples in the two first growth stages (tillering and heading), and using a local model for the harvest stage samples.
Resumo:
We had described that epidermal growth factor (EGF) interfered with the lipolytic effect of catecholamines in isolated adipocytes. Since catecholamines stimulate the release of EGF from submandibular salivary glands to blood plasma in male mice, we studied whether EGF affected also the lipolytic response to adrenaline in whole animals. We studied the effect of adrenaline in sialoadenectomized and sham-operated mice receiving or not a high dose of EGF following adrenaline injection. There was no difference in plasma EGF concentration between sham-operated and sialoadenectomized animals receiving saline. After adrenaline administration plasma EGF increased by 20-fold in sham-operated but did not increase in sialoadenectomized mice. Indeed, the increase was much higher (more than 100-fold) in mice receiving exogenous EGF. The effect of adrenaline on plasma concentration of both glycerol and nonesterified fatty acids was higher as lower was plasma EGF concentration. Isolated adipocytes obtained from sham-operated or sialoadenectomized mice had identical lipolytic response to adrenaline. The lipolytic response of adipocytes to isoproterenol was decreased by addition of EGF. To study whether the interference with the in vivo lipolytic effect of adrenaline had further metabolic consequences, we measured plasma b-hydroxybutyrate concentration in plasma. There was no difference in the response to adrenaline between sham-operated and sialoadenectomized mice in spite of the difference in plasma nonsterified fatty acid concentration. Studies in isolated hepatocytes indicated that ketogenesis run at near maximal rate in this range of substrate concentration. These results suggest that EGF in the physiological range decreases the lipolytic effect of adrenaline but does not compromise further metabolic events like the enhancement of ketogenesis.