Ferromagnetic shape memory alloys: structural and thermal properties

The most extensively studied Heusler alloys are those based on the Ni-Mn-Ga system. However, to overcome the high cost of Gallium and the usually low martensitic transformation temperature, the search for Ga-free alloys has been recently attempted, particularly, by introducing In, Sn or Sb. In this work, two alloys (Mn50Ni35.5In14.5 and Ni50Mn35In15) have been obtained by melt spinning. We outline their structural and thermal behaviour. Mn50Ni35.5In14.5 alloy has the transformation above room temperature whereas Ni50Mn35In15 does not have this transformation in the temperature range here analyzed

Analysis of sensitivity with respect to a compositional parameter : A comment on 'Local sensitivity analysis for compositional data with application to soil texture in hydrologic modelling' by L. Loosvelt and co-authors

A comment about the article “Local sensitivity analysis for compositional data with application to soil texture in hydrologic modelling” writen by L. Loosvelt and co-authors. The present comment is centered in three specific points. The first one is related to the fact that the authors avoid the use of ilr-coordinates. The second one refers to some generalization of sensitivity analysis when input parameters are compositional. The third tries to show that the role of the Dirichlet distribution in the sensitivity analysis is irrelevant

Individual-based modelling and simulation: towards a better understanding of growth dynamics from small inocula

Postprint (published version)

On the thermal noise introduced by a resistor in a circuit

Comentari sobre l'article publicat anteriorment pels mateixos autors: Vargas, M; Pallás, R; The seemingly paradoxical noise behaviour some active circuits. IEEE Transactions on Instrumentation and Measurement. 1994, vol. 43, núm. 5, p. 764-767

Comments on "On resistor-induced thermal noise in linear circuits"

Correspondència referida a l'article de R. Giannetti, publicat ibid. vol.49 p.87-88

Energy-based modelling and simulation of the interconnection of a back-to-back converter and a doubly-fed induction machine

This paper describes the port interconnection of two subsystems: a power electronics subsystem (a back-to-back AC/CA converter (B2B), coupled to a phase of the power grid), and an electromechanical subsystem (a doubly-fed induction machine (DFIM). The B2B is a variable structure system (VSS), due to presence of control-actuated switches: however, from a modelling simulation, as well as a control-design, point of view, it is sensible to consider modulated transformers (MTF in the bond graph language) instead of the pairs of complementary switches. The port-Hamiltonian models of both subsystems are presented and, using a power-preserving interconnection, the Hamiltonian description of the whole system is obtained; detailed bond graphs of all subsystems and the complete system are also provided. Using passivity-based controllers computed in the Hamiltonian formalism for both subsystems, the whole model is simulated; simulations are run to rest the correctness and efficiency of the Hamiltonian network modelling approach used in this work.

Computational Approach to the Study of Thermal Spin Crossover Phenomena

The key parameters associated to the thermally induced spin crossover process have been calculated for a series of Fe(II) complexes with mono-, bi-, and tridentate ligands. Combination of density functional theory calculations for the geometries and for normal vibrational modes, and highly correlated wave function methods for the energies, allows us to accurately compute the entropy variation associated to the spin transition and the zero-point corrected energy difference between the low- and high-spin states. From these values, the transition temperature, T 1/2, is estimated for different compounds.

Modelling tourist itineraries in heritage cities: Routes around Old The District of Girona

Tourists do not follow random behavior in heritage cities, but they are consciously or unconsciously guided by socially constructed itineraries. This article studies the shaping of these itineraries in a heritage city (Girona), using the direct observation methodology during the visit (following the tourists from a prudent distance and gathering all the information about their visits) and the conventional questionnaire at the end of the visit. It also establishes which the sociodemographic, environmental and informative factors are that explain this behavior. The simultaneous use of the observation method and a questionnaire was found to be a useful technique for analyzing tourists' behavior and the factors that explain this behavior

Design of PCM thermal storage unit for a HVAC system

L'objectiu del projecte és el disseny d'una unitat d'emmagatzematge d'energia térmica que optimitzi i millori l'eficiència del sistema de climatització. Aquesta unitat contindrà materials de canvi de fase (PCM) per emmagatzemar l'energia i estarà acoblada a un sistema de climatització format per una bomba de calor i una unitat de tractament de l'aire.

Compact thermal storage: a-state-of-the-art review of experimental results

Thermal energy storage (TES) can increase the thermal energy effieresa, of a process by reusing the waste heat from industrial process, solar energy or other sources. There are different ways to store thermal energy: by sensible heat, by latest heat, by sorption process or by chemical reaction. This thesrs provides a-state-of-the-art review of the experimental performance of TES systems based on solid gas sorption process and chemical reactions. The importance of theses processes is that provides a heat loss free storage system with a high energy density.

Analysis of thermal properties of phase change materials (PCM) using differential scanning calorimeter (DSC)

Commercially available PCM RT 20, RT 27, SP 22, A17 and SP 25 A8. Were analyzed using dynamic and step method of heat flux DSC. The results of the dinamic and step method were compared with commercial valures. It was found that RT 20 & RT 27 showed good conforming of results with commercial values while SP 22 A17 & SP 25 A8 did not show conformity.

Improvement of the thermal performance of commercial freezers using phase change materials (PCM)

The aim of this work is to improve the thermal performance of commercial freezers using phase change materials (PCM) and the prove the importance of the correct PCM selection (melting temperature) for each application. To do this a vertical freezer with and without macro encapsulation PCM are used to assess the benefits of using PCM in minimizing temperature fluctuations and to maintain at the lowest possible temperature the freezer under heat of losses.

Differences in phasic development rate amongst wheat cultivars independent of responses to photoperiod and vernalization. A viewpoint of the intrinsic earliness hypothesis

Differences amongst wheat cultivars in the rate of reproductive development are largely dependent on differences in their sensitivity to photoperiod and vernalization. However, when these responses are accounted for, by growing vernalized seedlings under long photoperiods, cultivars can still differ markedly in time to ear emergence. Control of rate of development by this ‘third factor’ has been poorly understood and is variously referred to as intrinsic earliness, earliness in the narrow sense, basic vegetative period, earliness per se, and basic development rate. Certain assumptions are made in the concept of intrinsic earliness. They are that differences in intrinsic earliness (i) are independent of the responses of the cultivars to photoperiod and vernalization, (ii) apply only to the length of the vegetative period up to floral initiation (as suggested by several authors), (iii) are maintained under different temperatures, measured either in days or degree days. As a consequence of this, the ranking of cultivars (from intrinsically early to intrinsically late) must be maintained at different temperatures. This paper, by the re-analysis of published data, examines the extent to which these assumptions can be supported. Although it is shown that intrinsic earliness operates independently of photoperiod and vernalization responses, the other assumptions were not supported. The differences amongst genotypes in time to ear emergence, grown under above-optimum vernalization and photoperiod (that is when the response to these factors is saturated), were not exclusively due to parallel differences in the length of the vegetative phase, and the length of the reproductive phase was independent of that of the vegetative phase. Thus, it would be possible to change the relative allocation of time to vegetative and reproductive periods with no change in the full period to ear emergence. The differences in intrinsic earliness between cultivars were modified by the temperature regime under which they were grown, i.e. the difference between cultivars (both considering the full phase to ear emergence or some sub-phases) was not a constant amount of time or thermal time at different temperatures. In addition, in some instances genotypes changed their ranking for ‘intrinsic earliness’ depending on the temperature regime. This was interpreted to mean that while all genotypes are sensitive to temperature they differ amongst themselves in the extent of that sensitivity. Therefore, ‘intrinsic earliness’ should not be considered as a static genotypic characteristic, but the result of the interaction between the genotype and temperature. Intrinsic earliness is therefore likely to be related to temperature sensitivity. Some implications of these conclusions for plant breeding and crop simulation modelling are discussed.

Content value chains modelling using a copyright ontology

Existing digital rights management (DRM) systems, initiatives like Creative Commons or research works as some digital rights ontologies provide limited support for content value chains modelling and management. This is becoming a critical issue as content markets start to profit from the possibilities of digital networks and the World Wide Web. The objective is to support the whole copyrighted content value chain across enterprise or business niches boundaries. Our proposal provides a framework that accommodates copyright law and a rich creation model in order to cope with all the creation life cycle stages. The dynamic aspects of value chains are modelled using a hybrid approach that combines ontology-based and rule-based mechanisms. The ontology implementation is based on Web Ontology Language and Description Logic (OWL-DL) reasoners, are directly used for license checking. On the other hand, for more complex aspects of the dynamics of content value chains, rule languages are the choice.