47 resultados para Low-cost mechanization
Resumo:
Dissertation presented at Faculty of Sciences and Technology of the New University of Lisbon to attain the Master degree in Electrical and Computer Science Engineering
Resumo:
Both Oporto and the North Region of Portugal definitions of tourism have evolved significantly during the past decade. In this journey it is relevant to highlight the contribution of the arrival of Low Cost Carriers (LCCs) at Francisco Sá Carneiro Airport, thus contributing to a rapid expansion of this region as a tourism destination. Hence, this work project aims to understand the touristic and economic impact motivated by the entry of LCCs in Oporto and in the North Region of Portugal and tries to understand if this event was in fact an asset in the development of the aforementioned tourism destinations.
Resumo:
Contém resumo
Resumo:
This work studies fuel retail firms’ strategic behavior in a two-dimensional product differentiation framework. Following the mandatory provision of “low-cost” fuel we consider that capacity constraints force firms to eliminate of one the previously offered qualities. Firms play a two-stage game choosing fuel qualities from three possibilities (low-cost, medium quality and high quality fuel) and then prices having exogenous opposite locations. In the highest level of consumers’ heterogeneity, a subgame perfect Nash equilibrium exists in which firms both choose minimum quality differentiation. Consumers’ are worse off if no differentiation occurs in medium and high qualities. The effect over prices from the mandatory “low-cost” fuel law is ambiguous.
Resumo:
Modern fully integrated receiver architectures, require inductorless circuits to achieve their potential low area, low cost, and low power. The low noise amplifier (LNA), which is a key block in such receivers, is investigated in this thesis. LNAs can be either narrowband or wideband. Narrowband LNAs use inductors and have very low noise figure, but they occupy a large area and require a technology with RF options to obtain inductors with high Q. Recently, wideband LNAs with noise and distortion cancelling, with passive loads have been proposed, which can have low NF, but have high power consumption. In this thesis the main goal is to obtain a very low area, low power, and low-cost wideband LNA. First, it is investigated a balun LNA with noise and distortion cancelling with active loads to boost the gain and reduce the noise figure (NF). The circuit is based on a conventional balun LNA with noise and distortion cancellation, using the combination of a common-gate (CG) stage and common-source (CS) stage. Simulation and measurements results, with a 130 nm CMOS technology, show that the gain is enhanced by about 3 dB and the NF is reduced by at least 0.5 dB, with a negligible impact on the circuit linearity (IIP3 is about 0 dBm). The total power dissipation is only 4.8 mW, and the active area is less than 50 x 50 m2 . It is also investigated a balun LNA in which the gain is boosted by using a double feedback structure.We propose to replace the load resistors by active loads, which can be used to implement local feedback loops (in the CG and CS stages). This will boost the gain and reduce the noise figure (NF). Simulation results, with the same 130 nm CMOS technology as above, show that the gain is 24 dB and NF is less than 2.7 dB. The total power dissipation is only 5.4 mW (since no extra blocks are required), leading to a figure-of-merit (FoM) of 3.8 mW
Resumo:
Dissertation presented in partial fulfillment of the requirements for the degree of Master in Biotechnology
Resumo:
Dissertação apresentada na Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para a obtenção do Grau de Mestre em Engenharia Informática.
Resumo:
Advanced Materials, Vol. 17, nº 5
Resumo:
Dissertação apresentada na Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para obtenção do grau de Mestre em Engenharia Electrotécnica e de Computadores
Resumo:
Dissertação apresentada na faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para a obtenção do grau de Mestre em Engenharia Electrotécnica e de Computadores
Resumo:
Thesis submitted to Faculdade de Ciências e Tecnologia of the Universidade Nova de Lisboa, in partial fulfilment of the requirements for the degree of Master in Computer Science
Resumo:
Dissertação apresentada na Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para a obtenção do grau de Mestre em Engenharia Electrotécnica e de Computadores
Resumo:
Dissertação apresentada à Faculdade de Ciências e Tecnologia da Universidade Nova de Lisboa para a obtenção do grau de Mestre em Bioenergia
Resumo:
Dissertação apresentada como requisito parcial para obtenção do grau de Mestre em Estatística e Gestão de Informação
Resumo:
Trabalho de Projeto apresentado para o cumprimento dos requisitos necessários à obtenção de grau de Mestre em Novos Media e Práticas Web