Cross-Layer Admission Control to Enhance the Support of Real-Time Applications in WSN

Real-time monitoring applications may be used in a wireless sensor network (WSN) and may generate packet flows with strict quality of service requirements in terms of delay, jitter, or packet loss. When strict delays are imposed from source to destination, the packets must be delivered at the destination within an end-to-end delay (EED) hard limit in order to be considered useful. Since the WSN nodes are scarce both in processing and energy resources, it is desirable that they only transport useful data, as this contributes to enhance the overall network performance and to improve energy efficiency. In this paper, we propose a novel cross-layer admission control (CLAC) mechanism to enhance the network performance and increase energy efficiency of a WSN, by avoiding the transmission of potentially useless packets. The CLAC mechanism uses an estimation technique to preview packets EED, and decides to forward a packet only if it is expected to meet the EED deadline defined by the application, dropping it otherwise. The results obtained show that CLAC enhances the network performance by increasing the useful packet delivery ratio in high network loads and improves the energy efficiency in every network load.

Longshore Transport Estimation on Ofir Beach in Northwest Portugal: Sand-Tracer Experiment

This work aims to shed some light on longshore sediment transport (LST) in the highly energetic northwest coast of Portugal. Data achieved through a sand-tracer experiment are compared with data obtained from the original and the new re-evaluated longshore sediment transport formulas (USACE Waterways Experiment Station’s Coastal Engineering and Research Center, Kamphuis, and Bayram bulk formulas) to assess their performance. The field experiment with dyed sand was held at Ofir Beach during one tidal cycle under medium wave-energy conditions. Local hydrodynamic conditions and beach topography were recorded. The tracer was driven southward in response to the local swell and wind- and wave-induced currents (Hsb=0.75mHsb=0.75m, Tp=11.5sTp=11.5s, θb=8−12°θb=8−12°). The LST was estimated by using a linear sediment transport flux approach. The obtained value (2.3×10−3m3⋅s−12.3×10−3m3⋅s−1) approached the estimation provided by the original Bayram formula (2.5×10−3m3⋅s−12.5×10−3m3⋅s−1). The other formulas overestimated the transport, but the estimations resulting from the new re-evaluated formulas also yield approximate results. Therefore, the results of this work indicated that the Bayram formula may give satisfactory results for predicting the longshore sediment transport on Ofir Beach.

Trace Elements in Ambient Air at Porto Metropolitan Area—Checking for Compliance with New European Union (Eu) Air Quality Standards

Because of the scientific evidence showing that arsenic (As), cadmium (Cd), and nickel (Ni) are human genotoxic carcinogens, the European Union (EU) recently set target values for metal concentration in ambient air (As: 6 ng/m3, Cd: 5 ng/m3, Ni: 20 ng/m3). The aim of our study was to determine the concentration levels of these trace elements in Porto Metropolitan Area (PMA) in order to assess whether compliance was occurring with these new EU air quality standards. Fine (PM2.5) and inhalable (PM10) air particles were collected from October 2011 to July 2012 at two different (urban and suburban) locations in PMA. Samples were analyzed for trace elements content by inductively coupled plasma–mass spectrometry (ICP-MS). The study focused on determination of differences in trace elements concentration between the two sites, and between PM2.5 and PM10, in order to gather information regarding emission sources. Except for chromium (Cr), the concentration of all trace elements was higher at the urban site. However, results for As, Cd, Ni, and lead (Pb) were well below the EU limit/target values (As: 1.49 ± 0.71 ng/m3; Cd: 1.67 ± 0.92 ng/m3; Ni: 3.43 ± 3.23 ng/m3; Pb: 17.1 ± 10.1 ng/m3) in the worst-case scenario. Arsenic, Cd, Ni, Pb, antimony (Sb), selenium (Se), vanadium (V), and zinc (Zn) were predominantly associated to PM2.5, indicating that anthropogenic sources such as industry and road traffic are the main source of these elements. High enrichment factors (EF > 100) were obtained for As, Cd, Pb, Sb, Se, and Zn, further confirming their anthropogenic origin.

Adaptive filtering for high quality HMM based speech synthesis

In this work an adaptive filtering scheme based on a dual Discrete Kalman Filtering (DKF) is proposed for Hidden Markov Model (HMM) based speech synthesis quality enhancement. The objective is to improve signal smoothness across HMMs and their related states and to reduce artifacts due to acoustic model's limitations. Both speech and artifacts are modelled by an autoregressive structure which provides an underlying time frame dependency and improves time-frequency resolution. Themodel parameters are arranged to obtain a combined state-space model and are also used to calculate instantaneous power spectral density estimates. The quality enhancement is performed by a dual discrete Kalman filter that simultaneously gives estimates for the models and the signals. The system's performance has been evaluated using mean opinion score tests and the proposed technique has led to improved results.

Simuladores Fisiológicos na avaliação metrológica de esfigmomanómetros

Este documento apresenta uma avaliação sobre o uso dos simuladores fisiológicos como padrão para avaliação metrológica dos esfigmomanómetros automáticos na estimação da pressão sanguínea pelo método não invasivo (PNI). O presente estudo procurou avaliar o enquadramento destes equipamentos com os procedimentos das normas e recomendações usadas para apreciação metrológica dos esfigmomanómetros digitais. No contexto da prática metrológica existente determinou-se a existência de uma oportunidade de melhoria nos processos relacionados. O trabalho procurou obter resposta a diversas questões, relacionando a medição da pressão pelo método não invasivo, com o uso dos simuladores fisiológicos, o contexto em que estes podem ser usados, as formas de simulação, as medições e os resultados, procurando a perspetiva metrológica como enquadramento. As recomendações existentes [1] [2] [3] [4] [5] [6] [7] [8], são muito claras nos procedimentos, validação e nos desvios permitidos para os monitores da tensão arterial (MTA), equipamento que permite a avaliação dos parâmetros fisiológicos do paciente, no entanto, quando se pretende avançar para outro domínio, como o do uso dos simuladores, em particular para a simulação da PNI, não existem recomendações ou normas tão claras, e não existe sobretudo um padrão de referência que imite a natureza dinâmica que caracteriza a pressão sanguínea. O trabalho procurou ainda estabelecer a ligação entre o método clássico de auscultação (o principio de determinação da PS), a técnica digital de medição e os simuladores, para uma melhor compreensão do que é a pressão sanguínea, e como relacionar a problemática da simulação e a de um padrão de referência. Neste trabalho estão ainda presentes abordagens a diversos tópicos, como as validações clínicas, acessórios, ou a metrologia e que influenciam no final os equipamentos e o contexto que se pretende avaliar. Os diversos equipamentos testados procuraram conter amostras diversificadas, quer para os MTA de uso profissional ou doméstico, assim como para os simuladores. A avaliação dos simuladores foi realizada contra um grupo de MTAs. Foi testada a influência na medição, causada pela mudança de acessórios, ou seja, nos resultados, merecendo consideração pela perspetiva metrológica. No resumo dos testes e do estudo sobre este tema, verificou-se que esta tipologia de equipamentos pode contribuir como complemento do processo de calibração típico (estático). Não constitui por si só um método alternativo, mas permitiu estimar possíveis limites de erro e desvio padrão a partir da observação dos resultados práticos, limites esses inferiores aos processos de validação clínica. Atendendo às particularidades, estimou-se como desvio aceitável um erro mais desvio padrão de 5 + 3 mmHg para o processo de simulação. Contudo considera-se ainda importante os testes adicionais em que o simulador permite, ao verificar as medidas de segurança implementadas no equipamento e a condição dos acessórios, que como verificado afetam os resultados. No entanto nem todos os simuladores se mostram adequados a este processo pelo que a qualidade da seleção do equipamento para este fim pode eventualmente reduzir ainda mais os possíveis limites.

HRM specificities’ on Portugal hotel units

This paper presents the main Human Resources Management (HRM) specificities’ on Portuguese hotel units. We try to understand the role of HRM on behavior of co-workers and quality service in hotel units and to know the future tendency of human capital profile on Portuguese hotel units and the role of HRM function on management of their staff. We, also, try to explore if Portuguese culture has influence on HRM specificities’ of hotel units. This phenomenon has a special relevance in the Portuguese context, because this country is known a growing process of tourism industry in recent years. Furthermore, little is known about HRM department’ contributions to their human capital management and development. This paper is one of the first to focus specifically on Portuguese hotel units and it also seeks to present findings that stem from the Human Resources Managers’ perspective. The paper is based on qualitative case studies. The data were collected through semi-structured interviews of 12 human resource managers from 12 hotel units located in Portugal. The results show that although there is not an effective HRM, current HRM practices are enough to encouraging pro-environmental behavior in their staff and they have a direct effect on customer satisfaction and competitiveness of sector. However, managers recognize there is need introduce some change on short-term to promote a better performance of staff with effect on customers satisfaction and competitiveness on sector in Portugal. According to these results, the paper discusses the major theoretical and practical implications.

Software development for estimation of optical clearing agent’s diffusion coefficients in biological tissues

The study of chemical diffusion in biological tissues is a research field of high importance and with application in many clinical, research and industrial areas. The evaluation of diffusion and viscosity properties of chemicals in tissues is necessary to characterize treatments or inclusion of preservatives in tissues or organs for low temperature conservation. Recently, we have demonstrated experimentally that the diffusion properties and dynamic viscosity of sugars and alcohols can be evaluated from optical measurements. Our studies were performed in skeletal muscle, but our results have revealed that the same methodology can be used with other tissues and different chemicals. Considering the significant number of studies that can be made with this method, it becomes necessary to turn data processing and calculation easier. With this objective, we have developed a software application that integrates all processing and calculations, turning the researcher work easier and faster. Using the same experimental data that previously was used to estimate the diffusion and viscosity of glucose in skeletal muscle, we have repeated the calculations with the new application. Comparing between the results obtained with the new application and with previous independent routines we have demonstrated great similarity and consequently validated the application. This new tool is now available to be used in similar research to obtain the diffusion properties of other chemicals in different tissues or organs.

21st century quality: Looking into the “Crystal ball”

The discussion of possible scenarios for the future of Quality is on the priority list of major Quality Practitioners Societies. EOQ – European Organization for Quality (EOQ, 2014) main team for its 58th EOQ-Congress held June 2014 in Göteborg was “Managing Challenges in Quality Leadership” and ASQ - American Society for Quality (ASQ, 2015) appointed “the Future of Quality” for Quality Progress Magazine November 2015 issue. In addition, the ISO 9001:2008 revision process carried by ISO/TC 176 aims to assure that ISO 9001:2015 International Standard remains stable for the next 10 years (ISO, 2014) contributing to an increased discussion on the future of quality. The purpose of this research is to review available Quality Management approaches and outline, adding an academic perspective, expected developments for Quality within the 21st Century. This paper follows a qualitative approach, although data from international organizations is used. A literature review has been undertaken on quality management past and potential future trends. Based on these findings a model is proposed for organization quality management development and propositions for the future of quality management are advanced. Firstly, a state of the art of existing Quality Management approaches is presented, for example, like Total Quality Management (TQM) and Quality Gurus, ISO 9000 International Standards Series (with an outline of the expected changes for ISO 9001:2015), Six Sigma and Business Excellence Models.Secondly, building on theoretical and managerial approaches, a two dimensional matrix – Quality Engineering (QE - technical aspects of quality) and Quality Management (QM: soft aspects of quality) - is presented, outlining five proposed characterizations of Quality maturity levels and giving insights for applications and future developments. Literature review highlights that QM and QE may be addressing similar quality issues but their approaches are different in terms of scope breadth and intensity and they ought to complement and reciprocally reinforce one another. The challenges organizations face within the 21st century have stronger uncertainty, complexity, and differentiation. Two main propositions are advanced as relevant for 21st Century Quality: - QM importance for the sustainable success of organizations will increase and they should be aware of the larger ecosystem to be managed for improvement, possibly leading to the emergence of a new Quality paradigm, The Civilizacional Excellence paradigm. - QE should get more attention from QM and the Quality professionals will have to: a) Master and apply in wider contexts and in additional depth the Quality Tools (basic, intermediate and advanced); b) Have the soft skills needed for its success; c) Be results oriented and better understand and demonstrate the relationships between approaches and results These propositions challenge both scholars and practitioners for a sustained and supported discussion on the future of Quality. “All things are ready, if our mind be so.” (Shakespeare, Henry V, circa 1599).