An adaptive IoT management infrastructure for eco transport networks

The complexity associated with fast growing of B2B and the lack of a (complete) suite of open standards makes difficulty to maintain the underlying collaborative processes. Aligned to this challenge, this paper aims to be a contribution to an open architecture of logistics and transport processes management system. A model of an open integrated system is being defined as an open computational responsibility from the embedded systems (on-board) as well as a reference implementation (prototype) of a host system to validate the proposed open interfaces. Embedded subsystem can, natively, be prepared to cooperate with other on-board units and with IT-systems in an infrastructure commonly referred to as a center information system or back-office. In interaction with a central system the proposal is to adopt an open framework for cooperation where the embedded unit or the unit placed somewhere (land/sea) interacts in response to a set of implemented capabilities.

Use of a-SiC:H Semiconductor-Based Transducer for Glucose Sensing through FRET Analysis

Glucose sensing is an issue with great interest in medical and biological applications. One possible approach to glucose detection takes advantage of measuring changes in fluorescence resonance energy transfer (FRET) between a fluorescent donor and an acceptor within a protein which undergoes glucose-induced changes in conformation. This demands the detection of fluorescent signals in the visible spectrum. In this paper we analyzed the emission spectrum obtained from fluorescent labels attached to a protein which changes its conformation in the presence of glucose using a commercial spectrofluorometer. Different glucose nanosensors were used to measure the output spectra with fluorescent signals located at the cyan and yellow bands of the spectrum. A new device is presented based on multilayered a-SiC:H heterostructures to detect identical transient visible signals. The transducer consists of a p-i'(a-SiC:H)-n/p-i(a-Si:H)-n heterostructure optimized for the detection of the fluorescence resonance energy transfer between fluorophores with excitation in the violet (400 nm) and emissions in the cyan (470 nm) and yellow (588 nm) range of the spectrum. Results show that the device photocurrent signal measured under reverse bias and using appropriate steady state optical bias, allows the separate detection of the cyan and yellow fluorescence signals presented.

Measurement of Photo Capacitance in Amorphous Silicon Photodiodes

This paper discusses the photodiode capacitance dependence on imposed light and applied voltage using different devices. The first device is a double amorphous silicon pin-pin photodiode; the second one a crystalline pin diode and the last one a single pin amorphous silicon diode. Double amorphous silicon diodes can be used as (de)multiplexer devices for optical communications. For short range applications, using plastic optical fibres, the WDM (wavelength-division multiplexing) technique can be used in the visible light range to encode multiple signals. Experimental results consist on measurements of the photodiode capacitance under different conditions of imposed light and applied voltage. The relation between the capacitive effects of the double diode and the quality of the semiconductor internal junction will be analysed. The dynamics of charge accumulations will be measured when the photodiode is illuminated by a pulsed monochromatic light.

Sensing Cloud Optimization to Solve ED of Units with Valve-Point Effects and Multi-fuels

In this paper a solution to an highly constrained and non-convex economical dispatch (ED) problem with a meta-heuristic technique named Sensing Cloud Optimization (SCO) is presented. The proposed meta-heuristic is based on a cloud of particles whose central point represents the objective function value and the remaining particles act as sensors "to fill" the search space and "guide" the central particle so it moves into the best direction. To demonstrate its performance, a case study with multi-fuel units and valve- point effects is presented.

Distributed Model Predictive Control for Housing with Hourly Auction of Available Energy

This paper presents a distributed model predictive control (DMPC) for indoor thermal comfort that simultaneously optimizes the consumption of a limited shared energy resource. The control objective of each subsystem is to minimize the heating/cooling energy cost while maintaining the indoor temperature and used power inside bounds. In a distributed coordinated environment, the control uses multiple dynamically decoupled agents (one for each subsystem/house) aiming to achieve satisfaction of coupling constraints. According to the hourly power demand profile, each house assigns a priority level that indicates how much is willing to bid in auction for consume the limited clean resource. This procedure allows the bidding value vary hourly and consequently, the agents order to access to the clean energy also varies. Despite of power constraints, all houses have also thermal comfort constraints that must be fulfilled. The system is simulated with several houses in a distributed environment.

Optoelectronic Digital Capture Device Based on Si/C Multilayer Heterostructures

Combined tunable WDM converters based on SiC multilayer photonic active filters are analyzed. The operation combines the properties of active long-pass and short-pass wavelength filter sections into a capacitive active band-pass filter. The sensor element is a multilayered heterostructure produced by PE-CVD. The configuration includes two stacked SiC p-i-n structures sandwiched between two transparent contacts. Transfer function characteristics are studied both theoretically and experimentally. Results show that optical bias activated photonic device combines the demultiplexing operation with the simultaneous photodetection and self amplification of an optical signal acting the device as an integrated photonic filter in the visible range. Depending on the wavelength of the external background and irradiation side, the device acts either as a short- or a long-pass band filter or as a band-stop filter. The output waveform presents a nonlinear amplitude-dependent response to the wavelengths of the input channels. A numerical simulation and two building-blocks active circuit is presented and gives insight into the physics of the device.

Optoelectronic Logic Functions Based on Reconfigurable SiC Multilayer Devices

WDM multilayered SiC/Si devices based on a-Si:H and a-SiC:H filter design are approached from a reconfigurable point of view. Results show that the devices, under appropriated optical bias, act as reconfigurable active filters that allow optical switching and optoelectronic logic functions development. Under front violet irradiation the magnitude of the red and green channels are amplified and the blue and violet reduced. Violet back irradiation cuts the red channel, slightly influences the magnitude of the green and blue ones and strongly amplifies de violet channel. This nonlinearity provides the possibility for selective removal of useless wavelengths. Particular attention is given to the amplification coefficient weights, which allow taking into account the wavelength background effects when a band needs to be filtered from a wider range of mixed signals, or when optical active filter gates are used to select and filter input signals to specific output ports in WDM communication systems. A truth table of an encoder that performs 8-to-1 multiplexer (MUX) function is presented.

A Voltage Limiter Circuit for Indoor Light Energy Harvesting Applications

A voltage limiter circuit for indoor light energy harvesting applications is presented. This circuit is a part of a bigger system, whose function is to harvest indoor light energy, process it and store it, so that it can be used at a later time. This processing consists on maximum power point tracking (MPPT) and stepping-up, of the voltage from the photovoltaic (PV) harvester cell. The circuit here described, ensures that even under strong illumination, the generated voltage will not exceed the limit allowed by the technology, avoiding the degradation, or destruction, of the integrated die. A prototype of the limiter circuit was designed in a 130 nm CMOS technology. The layout of the circuit has a total area of 23414 mu m(2). Simulation results, using Spectre, are presented.

The electric vehicle integration into the power system: an application to the portuguese case

Electric vehicles (EV) offer a great potential to address the integration of renewable energy sources (RES) in the power grid, and thus reduce the dependence on oil as well as the greenhouse gases (GHG) emissions. The high share of wind energy in the Portuguese energy mix expected for 2020 can led to eventual curtailment, especially during the winter when high levels of hydro generation occur. In this paper a methodology based on a unit commitment and economic dispatch is implemented, and a hydro-thermal dispatch is performed in order to evaluate the impact of the EVs integration into the grid. Results show that the considered 10 % penetration of EVs in the Portuguese fleet would increase load in 3 % and would not integrate a significant amount of wind energy because curtailment is already reduced in the absence of EVs. According to the results, the EV is charged mostly with thermal generation and the associated emissions are much higher than if they were calculated based on the generation mix.

Mulheres em morte-cor: os objetos que fazem e desfazem corpos e cancros metastáticos

Este texto sintetiza o último capítulo da investigação de doutoramento – Objetos feitos de cancro: a cultura material como pedaço de doença em histórias de mulheres contadas pela arte. Através de uma reflexão em torno dos objetos e materialidades que ganham forma e relevo em projetos artísticos referentes à experiência feminina do cancro, esta tese propõe conceitos alternativos de cultura material e de doença oncológica. Rejeita-se uma separação ou diferenciação entre dimensões materiais e intangíveis na doença, entendendo-se os objetos de cultura material como pedaços de cancro, ou seja, enquanto partes constitutivas das ideias, sensações, emoções e gestos que fazem a experiência do corpo doente. Objetos hospitalares, domésticos e pessoais, de uso coletivo ou individual, onde se incluem materialidades descartáveis, vestuário, mobiliário, equipamento e máquinas, compõem uma lista de realidades que se encastram nas experiências do corpo em diagnóstico, internamento, tratamento, reconstrução, remissão, recorrência, metastização e morte. Dando nome a esta continuidade indivisa, propus os conceitos “objeto nosoencastrável” e “doença modular”, pretendendo, na forma como defino as coisas, os mesmos encaixes que existem na realidade vivida. Para compreender a ação, os usos e os sentidos dos objetos que fazem e são pedaços de cancro(s), o campo de trabalho desta investigação abrangeu as imagens e os textos explicativos de cento e cinquenta projetos artísticos produzidos por ou com mulheres que viveram a experiência desta doença. Expostos na Internet, os exercícios criativos, amadores ou profissionais, de fotografia comercial e artística, pintura, desenho, colagem, modelagem, escultura, costura e tricô serviram de terreno narrativo e visual, permitindo-me encontrar a versão émica dos encaixes entre cultura material e doença. Tocar a continuidade entre objetos e cancros, juntando os saberes do corpo, da arte e da antropologia, assentou numa abordagem teórica e metodológica onde ensaiei o potencial heurístico daquilo a que chamo a “terceira metade das coisas e do conhecimento”.

James W. Carey as critical theorist of the information age

This paper suggests that the thought of the North-American critical theorist James W. Carey provides a relevant perspective on communication and technology. Having as background American social pragmatism and progressive thinkers of the beginning of the 20th century (as Dewey, Mead, Cooley, and Park), Carey built a perspective that brought together the political economy of Harold A. Innis, the social criticism of David Riesman and Charles W. Mills and incorporated Marxist topics such as commodification and sociocultural domination. The main goal of this paper is to explore the connection established by Carey between modern technological communication and what he called the “transmissive model”, a model which not only reduces the symbolic process of communication to instrumentalization and to information delivery, but also politically converges with capitalism as well as power, control and expansionist goals. Conceiving communication as a process that creates symbolic and cultural systems, in which and through which social life takes place, Carey gives equal emphasis to the incorporation processes of communication.If symbolic forms and culture are ways of conditioning action, they are also influenced by technological and economic materializations of symbolic systems, and by other conditioning structures. In Carey’s view, communication is never a disembodied force; rather, it is a set of practices in which co-exist conceptions, techniques and social relations. These practices configure reality or, alternatively, can refute, transform and celebrate it. Exhibiting sensitiveness favourable to the historical understanding of communication, media and information technologies, one of the issues Carey explored most was the history of the telegraph as an harbinger of the Internet, of its problems and contradictions. For Carey, Internet was seen as the contemporary heir of the communications revolution triggered by the prototype of transmission technologies, namely the telegraph in the 19th century. In the telegraph Carey saw the prototype of many subsequent commercial empires based on science and technology, a pioneer model for complex business management; an example of conflict of interest for the control over patents; an inducer of changes both in language and in structures of knowledge; and a promoter of a futurist and utopian thought of information technologies. After a brief approach to Carey’s communication theory, this paper focuses on his seminal essay "Technology and ideology. The case of the telegraph", bearing in mind the prospect of the communication revolution introduced by Internet. We maintain that this essay has seminal relevance for critically studying the information society. Our reading of it highlights the reach, as well as the problems, of an approach which conceives the innovation of the telegraph as a metaphor for all innovations, announcing the modern stage of history and determining to this day the major lines of development in modern communication systems.