An improved procedure for obtaining and maintaining well characterized partial water saturation states on concrete samples to be used for mass transport tests

A conditioning procedure is proposed allowing to install into the concrete specimens any selected value of water saturation degree with homogeneous moisture distribution. This is achieved within the least time and the minimum alteration of the concrete specimens. The protocol has the following steps: obtaining basic drying data at 50 °C (water absorption capacity and drying curves); unidirectional drying of the specimens at 50 °C until reaching the target saturation degree values; redistribution phase in closed containers at 50 °C (with measurement of the quasi-equilibrium relative humidities); storage into controlled environment chambers until and during mass transport tests, if necessary. A water transport model is used to derive transport parameters of the tested materials from the drying data, i.e., relative permeabilities and apparent water diffusion coefficients. The model also allows calculating moisture profiles during isothermal drying and redistribution phases, thus allowing optimization of the redistribution times for obtaining homogeneous moisture distributions.

Moisture Distribution in Partially Saturated Concrete Studied by Impedance Spectroscopy

The moisture content and its spatial distribution has a great influence on the durability properties of concrete structures. Several non-destructive techniques have been used for the determination of the total water content, but moisture distribution is difficult to determine. In this paper impedance spectroscopy is used to study the water distribution in concrete samples with controlled and homogeneously distributed moisture contents. The technique is suitable for the determination of water distribution inside the sample, using the appropriate equivalent circuits. It is shown that using the selected drying procedures there is no change in the solid phase of the samples, although the technique can only be used for the qualitative study of variations in the solid phase when samples are too thick. The results of this work show that for a wide range of concrete percentages of saturation, from full to 18 % saturation, practically all the pores keep at least a thin layer of electrolyte covering their walls, since the capacitance measurement results are practically independent of the saturation degree.

Design of online practical lessons in colorimetry

Applied colorimetry is an important module in the program of the elective subject "Colour Science: industrial applications”. This course is taught in the Optics and Optometry Degree and it has been used as a testing for the application of new teaching and assessment techniques consistent with the new European Higher Education Area. In particular, the main objective was to reduce the attendance to lessons and encourage the individual and collective work of students. The reason for this approach is based on the idea that students are able to work at their own learning pace. Within this dynamic work, we propose online lab practice based on Excel templates that our research group has developed ad-hoc for different aspects of colorimetry, such as conversion to different colour spaces, calculation of perceptual descriptors (hue, saturation, lightness), calculation of colour differences, colour matching dyes, etc. The practice presented in this paper is focused on the learning of colour differences. The session is based on a specific Excel template to compute the colour differences and to plot different graphs with these colour differences defined at different colour spaces: CIE ΔE, CIE ΔE94 and the CIELAB colour space. This template is implemented on a website what works by addressing the student work at a proper and organized way. The aim was to unify all the student work from a website, therefore the student is able to learn in an autonomous and sequential way and in his own pace. To achieve this purpose, all the tools, links and documents are collected for each different proposed activity to achieve guided specific objectives. In the context of educational innovation, this type of website is normally called WebQuest. The design of a WebQuest is established according to the criteria of usability and simplicity. There are great advantages of using WebQuests versus the toolbox “Campus Virtual” available in the University of Alicante. The Campus Virtual is an unfriendly environment for this specific purpose as the activities are organized in different sectors depending on whether the activity is a discussion, an activity, a self-assessment or the download of materials. With this separation, it is more difficult that the student follows an organized sequence. However, our WebQuest provides a more intuitive graphical environment, and besides, all the tasks and resources needed to complete them are grouped and organized according to a linear sequence. In this way, the student guided learning is optimized. Furthermore, with this simplification, the student focuses on learning and not to waste resources. Finally, this tool has a wide set of potential applications: online courses of colorimetry applied for postgraduate students, Open Course Ware, etc.

Spin degree of freedom in two dimensional exciton condensates

We present a theoretical analysis of a spin-dependent multicomponent condensate in two dimensions. The case of a condensate of resonantly photoexcited excitons having two different spin orientations is studied in detail. The energy and the chemical potentials of this system depend strongly on the spin polarization. When electrons and holes are located in two different planes, the condensate can be either totally spin polarized or spin unpolarized, a property that is measurable. The phase diagram in terms of the total density and electron-hole separation is discussed.

The curricular value of mathematics in non-mathematics degree

Higher education should provide the acquisition of skills and abilities that allow the student to play a full and active role in society. The educational experience should offer a series of conceptual, procedural and attitudinal contents that encourage “learning to know, learning to do, learning to be and learning to live together”. It is important to consider the curricular value of mathematics in the education of university undergraduates who do not intend to study mathematics but for whom the discipline will serve as an instrumental. This work discusses factors that form part of the debate on the curricular value of mathematics in non-mathematics degrees.

Integrating Evidence-Based Practice in the Training Programme Bachelor’s Degree in Nursing, University Jaume I

The Evidence-Based Practice (EBP) aims to combine a form methodological process of professional experience in health with the most current information on the clinical situation. The professional novice can make better decisions despite lacking sufficient years in clinical practice. We then train the student in correct habits within the methodological process by which you can strengthen both their knowledge and their attitude and ability, allowing secure customs, where all of your work is based on PBE.

Workshops in “Construction of Structures I”: A new teaching methodology in the Building Engineering Degree

Both the current economic situation in the construction sector and the continuous normative changes in the building area imply the use of new methodologies to enhance students’ competences in the degree of Building Engineer. The aim of this paper is to present, analyse and discuss the development of constructive workshops as a new teaching methodology used in the subject of Construction of Structures I at the University of Alicante to complement the constructive and technical knowledge acquired by our students and to enhance their communicative and representation skills essential for their professional practice in the future. The used methodology is based on the development of three-dimensional construction details (in groups of 3 or 4 students) to be shown in two A1-pannels exposed in the corridors of the Polytechnic School. Thus, students’ work approaches constructive problems in a global way by discussing simultaneously with teachers and other groups about the most suitable solution on each case. This contribution has multiperspective results and improves criticism of students in different areas, encouraging new learning strategies and active participation. What is more, on-line information and web applications have been used to prepare and organize this kind of workshops, allowing students to use new technologies as a complementary learning methodology. In conclusion, the use of these new workshops in the Degree of Building Engineer stimulates an interactive class versus a traditional lecture where the participative groups´ attitude and the development of oral presentations dissolve the traditional boundaries regarding public communication skills of the students in the Degree.

Construction of Structures I in Moodle: a new teaching methodology in the Degree of Building Engineer

The subject of Construction of Structures I studies, from a constructive point of view and taking into account current legislation, reinforced concrete structures used in buildings, through the acquisition of knowledge and construction criteria required in the profession of a Technical Architect. The contents acquired in this course are essential for further professional development of technicians and are closely related to many of the subjects taught in the same or other courses of the Degree in Technical Architecture at the University of Alicante. The aim of this paper is to present, analyze and discuss the development of a new methodology proposed in the mentioned subject, as it supposed an important change in the traditional way of teaching Construction and Structures I. In order to incorporate new teaching tools in 2013-2014, the course has been implemented by using a Moodle software tool to promote blended learning with online exercises. Our Moodle community allows collaborative work within an open-source platform where teachers and students share a new and personalized learning environment. Students are easily used to the interface and the platform, value the constant connection with teachers or other fellows and completely agree with the possibility of making questions or share documents 24 hours a day. The proposed methodology consists of lectures and practical classes. In the lectures, the basics of each topic are discussed; class attendance, daily study and conducting scheduled exercises are indispensable. Practical classes allow to consolidate the knowledge gained in theory classes by solving professional exercises and actual construction problems related to structures, that shall be compulsorily delivered online. So, after the correction of the teacher and the subsequent feedback of students, practical exercises ensure lifelong learning of the student, who can download any kind of material at any time (constructive details, practical exercises and even corrected exams). Regarding the general evaluation system, goals achievement is assessed on an ongoing basis (65% of the final mark) along the course through written and graphic evidences in person and online, as well as a individual development of a workbook. In all cases, the acquisition of skills, the ability to synthesize, the capacity of logical and critical thinking are assessed. The other 35 % of the mark is evaluated by a complementary graphic exam. Participation in the computing platform is essential and the student is required to do and present, at least 90% of the practices proposed. Those who do not comply with the practices in each specific date could not be assessed continuously and may only choose the final exam. In conclusion, the subject of Construction of Structures I is essential in the development of the regulated profession of Technical Architect as they are considered, among other professional profiles, as specialists in construction of building structures. The use of a new communication platform and online teaching allows the acquisition of knowledge and constructive approaches in a continuous way, with a more direct and personal monitoring by the teacher that has been highly appreciated by almost 100% of the students. Ultimately, it is important to say that the use of Moodle in this subject is a very interesting tool, which was really well welcome by students in one of the densest and important subjects of the Degree of Technical Architecture.

Is video-case an efficient tool to complement the practical learning in real contexts? Effects on satisfaction and performance in Social Work Degree students

Este documento es un artículo inédito que ha sido aceptado para su publicación. Como un servicio a sus autores y lectores, Alternativas. Cuadernos de trabajo social proporciona online esta edición preliminar. El manuscrito puede sufrir alteraciones tras la edición y corrección de pruebas, antes de su publicación definitiva. Los posibles cambios no afectarán en ningún caso a la información contenida en esta hoja, ni a lo esencial del contenido del artículo.