9 resultados para Most Productive Scale Size
em University of Queensland eSpace - Australia
Resumo:
We conducted a demographic and genetic study to investigate the effects of fragmentation due to the establishment of an exotic softwood plantation on populations of a small marsupial carnivore, the agile antechinus (Antechinus agilis), and the factors influencing the persistence of those populations in the fragmented habitat. The first aspect of the study was a descriptive analysis of patch occupancy and population size, in which we found a patch occupancy rate of 70% among 23 sites in the fragmented habitat compared to 100% among 48 sites with the same habitat characteristics in unfragmented habitat. Mark-recapture analyses yielded most-likely population size estimates of between 3 and 85 among the 16 occupied patches in the fragmented habitat. Hierarchical partitioning and model selection were used to identify geographic and habitat-related characteristics that influence patch occupancy and population size. Patch occupancy was primarily influenced by geographic isolation and habitat quality (vegetation basal area). The variance in population size among occupied sites was influenced primarily by forest type (dominant Eucalyptus species) and, to a lesser extent, by patch area and topographic context (gully sites had larger populations). A comparison of the sex ratios between the samples from the two habitat contexts revealed a significant deficiency of males in the fragmented habitat. We hypothesise that this is due to male-biased dispersal in an environment with increased dispersal-associated mortality. The population size and sex ratio data were incorporated into a simulation study to estimate the proportion of genetic diversity that would have been lost over the known timescale since fragmentation if the patch populations had been totally isolated. The observed difference in genetic diversity (gene diversity and allelic richness at microsatellite and mitochondrial markers) between 16 fragmented and 12 unfragmented sites was extremely low and inconsistent with the isolation of the patch populations. Our results show that although the remnant habitat patches comprise approximately 2% of the study area, they can support non-isolated populations. However, the distribution of agile antechinus populations in the fragmented system is dependent on habitat quality and patch connectivity. (C) 2004 Elsevier Ltd. All rights reserved.
Resumo:
The generation of new knowledge through research can contribute significantly to the improvement of services for individuals with intellectual and developmental disabilities. This study extends a previous study by Sigafoos, Roberts, and Couzens [Aust. N.Z.J. Dev. Disabil. 17 (1991) 331] by examining research productivity in intellectual and developmental disability in Australian journals for 1990-1999. Institutions that published research articles on intellectual and developmental disabilities in Australian journals in the 1990s were identified by noting the affiliations of authors. The most productive institutions were primarily universities in Australia and the United States of America. Publication trends in the decade of the 1990s are compared with trends of the previous decade (1980-1990). (C) 2003 Published by Elsevier Ltd.
Resumo:
Since the Second World War, Australian governments have adopted various approaches to governing nonmetropolitan Australia. The authors profile three distinct approaches to governance characterised as (1) state-centred regionalism; (2) new localism; and (3) new forms of multifaceted regionalism. Although recent policy initiatives have been justified by the argument that the region is the most suitable scale for planning and development in nonmetropolitan Australia, in practice the institutional landscape is a hybrid of overlapping local, regional, and national scales of action. The authors compare this new, multifaceted, regionalism with the so-called 'new regionalism currently being promoted in Western Europe and North America. It is argued that new regionalism differs in quite important ways from the regionalism currently being fostered in Australia. In Australia, the centrality of sustainability principles, and the attempt to foster interdependence amongst stakeholders from the state, market, and civil society, have produced a layer of networked governance that is different from that overseas. It is argued that there is a triple bottom-line 'promise' in the Australian approach which differs from the Western Europe/North American model, and which has the potential to deliver enhanced economic, social, and environmental outcomes.
Resumo:
Because organizations are making large investments in Information systems (IS), efficient IS project management has been found critical to success. This study examines how the use of incentives can improve the project success. Agency theory is used to: identify motivational factors of project success, help the IS owners to understand to what extent management incentives can improve IS development and implementation (ISD/I). The outcomes will help practitioners and researchers to build on theoretical model of project management elements which lead to project success. Given the principal-agent nature of most significant scale of IS development, insights that will allow for greater alignment of the agent’s goals with those of the principal through incentive contracts, will serve to make ISD/I both more efficient and more effective, leading to more successful IS projects.
Resumo:
The best accepted method for design of autogenous and semi-autogenous (AG/SAG) mills is to carry out pilot scale test work using a 1.8 m diameter by 0.6 m long pilot scale test mill. The load in such a mill typically contains 250,000-450,000 particles larger than 6 mm, allowing correct representation of more than 90% of the charge in Discrete Element Method (DEM) simulations. Most AG/SAG mills use discharge grate slots which are 15 mm or more in width. The mass in each size fraction usually decreases rapidly below grate size. This scale of DEM model is now within the possible range of standard workstations running an efficient DEM code. This paper describes various ways of extracting collision data front the DEM model and translating it into breakage estimates. Account is taken of the different breakage mechanisms (impact and abrasion) and of the specific impact histories of the particles in order to assess the breakage rates for various size fractions in the mills. At some future time, the integration of smoothed particle hydrodynamics with DEM will allow for the inclusion of slurry within the pilot mill simulation. (C) 2004 Elsevier Ltd. All rights reserved.
Resumo:
The patterns of rock comminution within tumbling mills, as well as the nature of forces, are of significant practical importance. Discrete element modelling (DEM) has been used to analyse the pattern of specific energy applied to rock, in terms of spatial distribution within a pilot AG/SAG mill. We also analysed in some detail the nature of the forces, which may result in rock comminution. In order to examine the distribution of energy applied within the mill, the DEM models were compared with measured particle mass losses, in small scale AG and SAG mill experiments. The intensity of contact stresses was estimated using the Hertz theory of elastic contacts. The results indicate that in the case of the AG mill, the highest intensity stresses and strains are likely to occur deep within the charge, and close to the base. This effect is probably more pronounced for large AG mills. In the SAG mill case, the impacts of the steel balls on the surface of the charge are likely to be the most potent. In both cases, the spatial pattern of medium-to-high energy collisions is affected by the rotational speed of the mill. Based on an assumed damage threshold for rock, in terms of specific energy introduced per single collision, the spatial pattern of productive collisions within each charge was estimated and compared with rates of mass loss. We also investigated the nature of the comminution process within AG vs. SAG mill, in order to explain the observed differences in energy utilisation efficiency, between two types of milling. All experiments were performed using a laboratory scale mill of 1.19 m diameter and 0.31 m length, equipped with 14 square section lifters of height 40 mm. (C) 2006 Elsevier Ltd. All rights reserved.
Resumo:
The spatial heterogeneity in the risk of Ross River virus (family Togaviridae, genus Alphavirus, RRV) disease, the most common mosquito-borne disease in Australia, was examined in Redland Shire in southern Queensland, Australia. Disease cases, complaints from residents of intense mosquito biting exposure, and human population data were mapped using a geographic information system. Surface maps of RRV disease age-sex standardized morbidity ratios and mosquito biting complaint morbidity ratios were created. To determine whether there was significant spatial variation in disease and complaint patterns, a spatial scan analysis method was used to test whether the number of cases and complaints was distributed according to underlying population at risk. Several noncontiguous areas in proximity to productive saline water habitats of Aedes vigilax (Skuse), a recognized vector of RRV, had higher than expected numbers of RRV disease cases and complaints. Disease rates in human populations in areas which had high numbers of adult Ae. vigilax in carbon dioxide- and octenol-baited light traps were up to 2.9 times those in areas that rarely had high numbers of mosquitoes. It was estimated that targeted control of adult Ae. vigilax in these high-risk areas could potentially reduce the RRV disease incidence by an average of 13.6%. Spatial correlation was found between RRV disease risk and complaints from residents of mosquito biting. Based on historical patterns of RRV transmission throughout Redland Shire and estimated future human population growth in areas with higher than average RRV disease incidence, it was estimated that RRV incidence rates will increase by 8% between 2001 and 2021. The use of arbitrary administrative areas that ranged in size from 4.6 to 318.3 km2, has the potential to mask any small scale heterogeneity in disease patterns. With the availability of georeferenced data sets and high-resolution imagery, it is becoming more feasible to undertake spatial analyses at relatively small scales.
Resumo:
Objective: To devise more-effective physical activity interventions, the mediating mechanisms yielding behavioral change need to be identified. The Baron-Kenny method is most commonly used. but has low statistical power and May not identify mechanisms of behavioral change in small-to-medium size Studies. More powerful statistical tests are available, Study Design and Setting: Inactive adults (N = 52) were randomized to either a print or a print-plus-telephone intervention. Walking and exercise-related social support Were assessed at baseline, after file intervention, and 4 weeks later. The Baron-Kenny and three alternative methods of mediational analysis (Freedman-Schatzkin; MacKinnon et al.: bootstrap method) were used to examine the effects of social support on initial behavior change and maintenance. Results: A significant mediational effect of social support on initial behavior change was indicated by the MacKinnon et al., bootstrap. and. marginally. Freedman-Schatzkin methods, but not by the Baron-Kenny method. No significant mediational effecl of social support on maintenance of walking was found. Conclusions: Methodologically rigorous intervention studies to identify mediators of change in physical activity are costly and labor intensive, and may not be feasible with large samples. The Use of statistically powerful tests of mediational effects in small-scale studies can inform the development of more effective interventions. (C) 2006 Elsevier Inc. All rights reserved.