Critical sets in direct products of back circulant Latin squares

To date very Few families of critical sets for latin squares are known. The only previously known method for constructing critical sets involves taking a critical set which is known to satisfy certain strong initial conditions and using a doubling construction. This construction can be applied to the known critical sets in back circulant latin squares of even order. However, the doubling construction cannot be applied to critical sets in back circulant latin squares of odd order. In this paper a family of critical sets is identified for latin squares which are the product of the latin square of order 2 with a back circulant latin square of odd order. The proof that each element of the critical set is an essential part of the reconstruction process relies on the proof of the existence of a large number of latin interchanges.

Prediction of impact forces in a vibratory ball mill using an inverse technique

To understand the dynamic mechanisms of the mechanical milling process in a vibratory mill, it is necessary to determine the characteristics of the impact forces associated with the collision events. However, it is difficult to directly measure the impact force in an operating mill. This paper describes an inverse technique for the prediction of impact forces from acceleration measurements on a vibratory ball mill. The characteristics of the vibratory mill have been investigated by the modal testing technique, and its system modes have been identified. In the modelling of the system vibration response to the impact forces, two modal equations have been used to describe the modal responses. The superposition of the modal responses gives rise to the total response of the system. A method based on an optimisation approach has been developed to predict the impact forces by minimising the difference between the measured acceleration of the vibratory ball mill and the predicted acceleration from the solution of the modal equations. The predicted and measured impact forces are in good agreement. Copyright (C) 1996 Elsevier Science Ltd.

Supersaturated solutions evaluated with an in vitro stratum corneum tape stripping technique

The flux of a compound across a membrane from any formulation, whether it contains penetration enhancers or not, is limited by its saturated solubility in the vehicle. Under such conditions the concentration of the permeant in the outer layers of the stratum corneum is also saturated. Consequently, when the permeation of a drug from a supersaturated solution leads to enhanced penetration, the concentration of the drug in the outer layers of the membrane is also supersaturated. Therefore, the stratum corneum may possess antinucleant properties which inhibit or retard the crystallisation process. In this study, the enhanced in vitro permeation of supersaturated solutions of piroxicam across human skin in diffusion cells was demonstrated. The amount of permeant in the stratum corneum was determined using a tape stripping technique. Supersaturated solutions up to four degrees of saturation were investigated which produced a linear relationship between the degree of saturation and the amount of piroxicam in the stratum corneum (R-2 = 0.970). Furthermore, the amount of piroxicam in the viable layers of the skin also increased with increasing degree of saturation. An analysis of the results suggested that enhanced penetration across human skin from supersaturated solutions of piroxicam may occur as a result of the antinucleating ability of the intercellular lipids of the stratum corneum. (C) 1997 Elsevier Science B.V.

National audit of anaesthesia for major abdominal surgery

A postal survey was conducted of all hospitals in Australia known to have a department of anaesthesia and an intensive care or high dependency unit. Each hospital was asked to report the anaesthetic and postoperative analgesic techniques used for the last ten cases of four common major surgical procedures-aorto-femoral bypass, repair of an abdominal aortic aneurysm, hemicolectomy and anterior resection of the rectum. Half of 76 hospitals sent a survey form completed and returned it. Responding hospitals were larger on average, than non-responding ones, but otherwise typical of them in terms of university affiliation and metropolitan versus rural location. For each of the procedures studied the proportion of cases in which epidural block was used intra- or postoperatively varied from 0% to 100%. Depending on the procedure, between 65% and 85% of hospitals used epidural block sometimes, with between 10% and 90% of patients in these hospitals being managed with this technique. There is wide variation in the use of epidural block, intra- and postoperatively, in Australia, variation that is unlikely to be explained by systematic differences between institutions in the patients seen or their suitability for one or other technique. This pattern of practice mirrors the lack of agreement about the proper place for epidural techniques evident in the recent literature. There is a widespread belief among clinicians that this is a question of great importance. Accordingly, we believe that anaesthetists and surgeons share an ethical responsibility to enter suitable patients in an appropriately designed randomized controlled trial in order to resolve this question.

Ramp and constant power trials produce equivalent critical power estimates

The standard critical power test protocol on the cycle prescribes a series of trials to exhaustion, each at a different but constant power setting. Recently the protocol has been modified and applied to a series of trials to exhaustion each at a different ramp incremental rate. This study was undertaken to compare critical power and anaerobic work capacity estimates in the same group of subjects when derived from the two protocols. Ten male subjects of mixed athletic ability cycled to exhaustion on eight occasions in randomized order over a 3-wk period. Four trials were performed at differing constant power settings and four trials on differing ramp incremental rates. Both critical power and anaerobic work capacity were estimated for each subject by curve fitting of the ramp model and of three versions of the constant power model. After adjusting for inter-subject variability, no significant differences were detected between critical power estimates or between anaerobic work capacity estimates from any model formulation or from the two protocols. It is concluded that both the ramp and constant power protocols produce equivalent estimates for critical power and anaerobic work capacity.

Out of the shadows: The critical sociology of sport in Australia, 1986 to 1996

The sociology of sport in Australia has reached a key point in its development. A critical tradition in the subdiscipline has been established over the last decade, but its intellectual and institutional progress has been uneven. This article briefly traces the emergence of critical sports sociology in a country outside the major centers in the UK and U.S., its break with functionalist approaches, and its attempts to overcome the neglect of local mainstream sociology. The authors proceed to examine (self-reflexively) the changes of theoretical direction and the new lines of research that are being explored in the field. A recent ''skirmish'' with narrative history over the preferred theories and methods in sports analysis is discussed as illustrative of the difficulties encountered by an energetic but small, dispersed and underorganized scholarly movement in Australia.