Effect of NaCl on emergence and growth of a range of provenances of Eucalyptus citriodora, Eucalyptus populnea, Eucalyptus camaldulensis and Acacia salicina

High salt levels in mine spoils have been identified as one of the major chemical limitations to plant establishment after coal mining in central Queensland. Soil solution extracts from spoils indicated that EC levels of up to 26 dS/m could be encountered. Glasshouse trials examined the emergence and growth of Eucalyptus citriodora, Eucalyptus camaldulensis and Eucalyptus populnea provenances and Acacia salicina subjected to such EC levels. Relatively low levels of salt (100 mM NaCl, or 11 dS/m) with respect to the levels encountered on mine spoils, were enough to substantially reduce the rate and percentage emergence of all eucalypt provenances. A. salicina was found to be superior to the eucalypts in its ability to emerge and survive under saline conditions. It was the only species to have seedlings emerge and survive at 200 mM NaCl (20 dS/m), and the effect of salt on decreasing seedling dry weight was less pronounced for A. salicina than for any of the eucalypts. Established plants survived the range of salt treatments far better than emerging seedlings, with survival of established plants being reduced only at 300 and 400 mM NaCl (28 and 36 dS/m, respectively). A. salicina performed significantly better at 300 and 400 mM NaCl than most of the eucalypts studied. (c) 2006 Elsevier B.V. All rights reserved.

Relationship between ash content and R-70 self-heating rate of Callide Coal

Borecore samples from the Trap Gully pit at Callide have been assessed using the R-70 self-heating test. The highest R-70 self-heating rate value was 16.22 degrees C/h, which is consistent with the subbituminous rank of the coal. R-70 decreases significantly with increasing mineral matter content, as defined by the ash content of the coal. This effect is due to the mineral matter in the coal acting as a heat sink. A trendline equation has been fitted to the borecore data from the Trap Gully pit: R-70 = 0.0029 x ash(2) - 0.4889 x ash + 20.644, where all parameters are on a dry-basis. This relationship can be used to model the self-heating hazard of the pit, both vertically and laterally. (c) 2005 Elsevier B.V All rights reserved.

Effect of moisture content on the R-70 self-heating rate of Callide coal

Strip samples from the Boundary Hill pit at Callide have been tested in an adiabatic oven to assess the effect of moisture on the R-70 self-heating rate of coal. The two strip samples tested had R-70 self-heating rate values of 10.23 and 8.61 degrees C/h. As the moisture content of the coal was progressively increased, from the dry state of the test, the R-70 value decreased dramatically. At approximately 40-50% of the moisture holding capacity of the coal, the self-heating rate becomes measurable. Above this critical level of moisture content, the heat produced by oxidation is dissipated by moisture evaporation and coal self-heating is significantly delayed. (c) 2005 Elsevier B.V All rights reserved.

Blast fragmentation modelling for a green field open cut gold deposit

This paper outlines the methodology of blast fragmentation modeling undertaken for a green field feasibility study at the Riska gold deposit in Indonesia. The favoured milling process for the feasibility study was dump leaching,with no crushing of the ore material extracted from the pit. For this reason,blast fragmentation was a critical issue to be addressed by the study. A range of blast designs were considered with bench heights and blasthole diameters ranging from 4 m to 7 m and 76 mm to 102 mm respectively. Rock mass data was obtained from 19 diamond drill cores across the deposit (total drill length approximately 2200 m). Intact rock strength was estimated from qualitative strength descriptors,while the in situ block size distribution of the rock mass was estimated from the Rock Quality Designation (RQD) of the core.

Pore, surface and fillet moisture in centrifuged beds of coarse coal

The moisture content of the coarse coking coal product from the centrifuges of preparation plants was investigated to evaluate the contribution of three types of water: that held internally in pores, that in fillets at points of contacts between the particles, and the moisture covering the surface. A standardised laboratory centrifuge test was used to measure the total non-centrifugable moisture (NCM) content and also the quantity held in internal pores, called NCMi. The fillet moisture NCMf was estimated by means of a formulation which relies on experimentally measured holdup volumes, supplemented by a physical model. The surface moisture NCMs could then be derived by difference. The NCMf, which depends on the body force, the particle size and the surface tension and contact angle of the liquid, ranges from effectively zero for large particles to 10% for fines. The surface moisture NCMs is of the order of 0.5% for high rank coals and increases to 4.5% for lower rank coals. (C) 2002 Elsevier Science Ltd. All rights reserved.

The role of technology in the shift towards open innovation: the case of Procter & Gamble

As with all new ideas, the concept of Open Innovation requires extensive empirical investigation, testing and development. This paper analyzes Procter and Gamble's 'Connect and Develop' strategy as a case study of the major organizational and technological changes associated with open innovation. It argues that although some of the organizational changes accompanying open innovation are beginning to be described in the literature, more analysis is warranted into the ways technological changes have facilitated open innovation strategies, particularly related to new product development. Information and communications technologies enable the exchange of distributed sources of information in the open innovation process. The case study shows that furthermore a suite of new technologies for data mining, simulation, prototyping and visual representation, what we call 'innovation technology', help to support open innovation in Procter and Gamble. The paper concludes with a suggested research agenda for furthering understanding of the role played by and consequences of this technology.

Improving the recovery of coarse coal particles in a Jameson cell

It has been observed in several Jameson cell installation where the source for flotation feed is deslime screens, that the recovery of coal particles greater than 0.5 mm is not as great as that of finer material. Consequently, a research project was undertaken at a CHPP in the Bowen Basin Queensland to assess the possibility of increasing the recovery of coarser particles (+0.5 mm) within the downcomer of the Jameson cell. The effect of decreasing turbulence and agitation in a commercial-scale downcomer was investigated to assess the effect oil the recovery of both coarse and fine coal particles. This paper details the findings of the test work, summarising the results relating to differences in the operating parameters within the downcomer. (C) 2005 Elsevier Ltd. All rights reserved.

Chemistry of acid production in black coal mine washery wastes

Column leaching tests on black coal mine washery wastes were performed, to determine the chemistry of acid generation. Coal mine coarse rejects and tailings were subjected to wet and dry cycle dissolution and subsequently column leached. The rates of iron sulphide oxidation and carbonate mineral dissolution were determined based on the drainage chemistry. The kinetic data from column leach experiments are used to predict the time required to deplete the acid producing and acid consuming minerals in the mine wastes. The acid production in the mine rejects was found to depend upon iron chemistry, carbonate chemistry, diffusion of oxygen, and permeability. The chemistry of the drainage from two different coal mines is compared. (c) 2005 Elsevier B.V. All rights reserved.