Evaluating Train Protection Systems

This paper arose from the work carried out for the Cullen/Uff Joint Inquiry into Train Protection Systems. It is concerned with the problem of evaluating the benefits of safety enhancements in order to avoid rare, but catastrophic accidents, and the role of Operations Research in the process. The problems include both input values and representation of outcomes. A key input is the value of life. This paper briefly discusses why the value of life might vary from incident to incident and reviews alternative estimates before producing a 'best estimate' for rail. When the occurrence of an event is uncertain, the normal method is to apply a single 'expected' value. This paper argues that a more effective method of representing such situations is through Monte-Carlo simulation and demonstrates the use of the methodology on a case study of the decision as to whether or not advanced train protection (ATP) should have been installed on a route to the west of London. This paper suggests that the output is more informative than traditional cost-benefit appraisals or engineering event tree approaches. It also shows that, unlike the results from utilizing the traditional approach, the value of ATP on this route would be positive over 50% of the time.

Lighting Strike Protection Systems

refers to composites that are specifically made/modified to provide more than one functionality. Typically, composites' main functionality is structural

Loss-of-Mains Protection System by Application of Phasor Measurement Unit Technology with Experimentally Assessed Threshold Settings

Loss-of-mains protection is an important component of the protection systems of embedded generation. The role of loss-of-mains is to disconnect the embedded generator from the utility grid in the event that connection to utility dispatched generation is lost. This is necessary for a number of reasons, including the safety of personnel during fault restoration and the protection of plant against out-of-synchronism reclosure to the mains supply. The incumbent methods of loss-of-mains protection were designed when the installed capacity of embedded generation was low, and known problems with nuisance tripping of the devices were considered acceptable because of the insignificant consequence to system operation. With the dramatic increase in the installed capacity of embedded generation over the last decade, the limitations of current islanding detection methods are no longer acceptable. This study describes a new method of loss-of-mains protection based on phasor measurement unit (PMU) technology, specifically using a low cost PMU device of the authors' design which has been developed for distribution network applications. The proposed method addresses the limitations of the incumbent methods, providing a solution that is free of nuisance tripping and has a zero non-detection zone. This system has been tested experimentally and is shown to be practical, feasible and effective. Threshold settings for the new method are recommended based on data acquired from both the Great Britain and Ireland power systems.

Investigation of a ship's propeller jet using momentum decay and energy decay

Previous researchers use the velocity decay as an input to investigate the ship’s propeller jet induced scour. A researcher indicated that most of the equations used to predict the stability of various protection systems are often missing a physical background. The momentum decay and energy decay are currently proposed as an initial input for seabed scouring investigation, which are more sensible in physics. Computational fluid dynamics (CFD) and laser Doppler anemometry (LDA) experiments are used to obtain the velocity data and then transforming into momentum and energy decays. The findings proposed several exponential equations of velocity, momentum and energy decays to estimate the region exposed to the seabed scouring.

Multiphysics Simulation of Thermal Plasma Produced by Lightning Strike on Aircraft Structures

A novel numerical technique is proposed to model thermal plasma of microseconds/milliseconds time-scale effect. Modelling thermal plasma due to lightning strike will allow the estimation of electric current density, plasma pressure, and heat flux at the surface of the aircraft structure. These input data can then be used for better estimation of the mechanical/thermal induced damage on the aircraft structures for better protection systems design. Thermal plasma generated during laser cutting, electric (laser) welding and other plasma processing techniques have been the focus of many researchers. Thermal plasma is a gaseous state that consists from a mixture of electrons, ions, and natural particles. Thermal plasma can be assumed to be in local thermodynamic equilibrium, which means the electrons and the heavy species have equal temperature. Different numerical techniques have been developed using a coupled Navier Stokes – Heat transfer – Electromagnetic equations based on the assumption that the thermal plasma is a single laminar gas flow. These previous efforts focused on generating thermal plasma of time-scale in the range of seconds. Lighting strike on aircraft structures generates thermal plasma of time-scale of milliseconds/microseconds, which makes the previous physics used not applicable. The difficulty comes from the Navier-Stokes equations as the fluid is simulated under shock load, this introducing significant changes in the density and temperature of the fluid.

Python PSS/E Simulation to Test Efficacy of Proposed PMU Based WAMS and Potential WAMPAC Applications

A PSS/E 32 model of a real section of the Northern Ireland electrical grid was dynamically controlled with Python 2.5. In this manner data from a proposed wide area monitoring system was simulated. The area is of interest as it is a weakly coupled distribution grid with significant distributed generation. The data was used to create an optimization and protection metric that reflected reactive power flow, voltage profile, thermal overload and voltage excursions. Step changes in the metric were introduced upon the operation of special protection systems and voltage excursions. A wide variety of grid conditions were simulated while tap changer positions and switched capacitor banks were iterated through; with the most desirable state returning the lowest optimization and protection metric. The optimized metric was compared against the metric generated from the standard system state returned by PSS/E. Various grid scenarios were explored involving an intact network and compromised networks (line loss) under summer maximum, summer minimum and winter maximum conditions. In each instance the output from the installed distributed generation is varied between 0 MW and 80 MW (120% of installed capacity). It is shown that in grid models the triggering of special protection systems is delayed by between 1 MW and 6 MW (1.5% to 9% of capacity), with 3.5 MW being the average. The optimization and protection metric gives a quantitative value for system health and demonstrates the potential efficacy of wide area monitoring for protection and control.

Linking Family Engagement with a Rights Perspective: Macro Factors Influencing Practice

While child welfare practitioners in many countries are struggling to develop methods of effective family engagement, they operate within different national and cultural contexts which influence, both positively and negatively, the ability to engage with families. Increasingly, international comparisons are necessary to further understanding of the development of social work practice. This is particularly necessary because most countries utilize international frameworks (such as the United National Convention on the Rights of the Child) to provide guidance in the development of policies, programs, and interventions. Each country (and locality) struggles to advance practice to be more effective and humane. Our paper offers a comparative analysis focused on family-oriented and rights-based frameworks of different countries. Based on a review of current national policies and a review of the literature regarding family based practices, we examine similarities and differences among four countries: the United Kingdom, Sweden, the United States, and South Korea. These countries were selected because they have some similarities (advanced industrialized democracies, professional social work, formal child protection systems) but have some differences in their social welfare systems (policies, specific practices, socio-cultural context). These differences can be utilized to advance understanding regarding the promise and potential for family engagement strategies. We then discuss the utility of this comparison for theory-building in the arena of child care practice and conclude by identifying the challenges and limitations of this work.

Logic and Memory Design Based on Unequal Error Protection for Voltage-scalable, Robust and Adaptive DSP Systems

In this paper, we propose a system level design approach considering voltage over-scaling (VOS) that achieves error resiliency using unequal error protection of different computation elements, while incurring minor quality degradation. Depending on user specifications and severity of process variations/channel noise, the degree of VOS in each block of the system is adaptively tuned to ensure minimum system power while providing "just-the-right" amount of quality and robustness. This is achieved, by taking into consideration block level interactions and ensuring that under any change of operating conditions, only the "less-crucial" computations, that contribute less to block/system output quality, are affected. The proposed approach applies unequal error protection to various blocks of a system-logic and memory-and spans multiple layers of design hierarchy-algorithm, architecture and circuit. The design methodology when applied to a multimedia subsystem shows large power benefits ( up to 69% improvement in power consumption) at reasonable image quality while tolerating errors introduced due to VOS, process variations, and channel noise.

Chronic child abuse: The characteristics and careers of children caught in the child protection system

The introduction of the Quality Protects initiative in England and the focus on performance management has challenged social services departments to examine the systems, processes and outcomes for children who have their name on a child protection register. Research indicates that approximately one-quarter of the situations in which children are registered could be described as chronic—that is, they remain on the child protection register for significant periods of time, experience more than one period of registration or suffer a further incident of significant harm whilst subject to a child protection plan. In this article, the findings from a research study conducted into this group of vulnerable children are reported, focusing on the characteristics of the children and their families, and their careers in the child protection system. The paper concludes with observations about the weak conceptualization of performance management and the need to recognize the complexity of the factors that influence children’s careers in the child protection system.

Channel characterization for single- and multiple-antenna wearable systems used for indoor body-to-body communications

In this paper, an analysis of radio channel characteristics for single- and multiple-antenna bodyworn systems for use in body-to-body communications is presented. The work was based on an extensive measurement campaign conducted at 2.45 GHz representative of an indoor sweep and search scenario for fire and rescue personnel. Using maximum-likelihood estimation in conjunction with the Akaike information criterion (AIC), five candidate probability distributions were investigated and from these the kappa - mu distribution was found to best describe small-scale fading observed in the body-to-body channels. Additional channel parameters such as autocorrelation and the cross-correlation coefficient between fading signal envelopes were also analyzed. Low cross correlation and small differences in mean signal levels between potential dual-branch diversity receivers suggested that the prospect of successfully implementing diversity in this type application is extremely good. Moreover, using selection combination, maximal ratio, and equal gain combining, up to 8.69-dB diversity gain can be made available when four spatially separated antennas are used at the receiver. Additional improvements in the combined envelopes through lower level crossing rates and fade durations at low signal levels were also observed.

Information sharing and reporting systems in the UK and Ireland: Professional barriers to reporting child maltreatment concerns

Across the UK recent policy developments have focused on improved information sharing and inter-agency cooperation. Professional non-reporting of child maltreatment concerns has been consistently highlighted as a problem in a range of countries and the research literature indicates that this can happen for a variety of reasons. Characteristics such as the type of abuse and the threshold of evidence available are key factors, as are concerns that reporting will damage the professional-client relationship. Professional discipline can also impact on willingness to report, as can personal beliefs about abuse, attitudes towards child protection services and experiences of court processes. Research examining the role of organisational factors in information sharing and reporting emphasises the importance of training and there are some positive indications that training can increase professional awareness of reporting processes and requirements and help to increase knowledge of child abuse and its symptoms. Nonetheless, this is a complex issue and the need for training to go beyond simple awareness raising is recognised. In order to tackle non-reporting in a meaningful way, childcare professionals need access to on-going multidisciplinary training which is specifically tailored to address the range of different factors which impact on reporting attitudes and behaviours.

Moisture-Activated Rheological Structuring of Nonaqueous Poloxamine–Poly(Acrylic Acid) Systems Designed as Novel Biomedical Implants

This study reports the formulation/characterisation of novel polymeric platforms designed to behave as low-viscosity systems in the nonaqueous state, however, following uptake of aqueous ?uids, exhibit rheological structuring and mucoadhesion. The rheological/mechanical and mucoadhesive properties of platforms containing poly(acrylic acid) (PAA, 1%, 3%, 5%, w/w) and poloxamines (Tetronic 904, 901, 704, 701, 304), both in the absence and presence of phosphate buffered saline (PBS, pH 7.4) are described. With the exception of Tetronic 904, all formulations exhibited Newtonian ?ow in the nonaqueous state, whereas, all aqueous formulations displayed pseudoplastic ?ow. The consistency and viscoelastic properties were dependent on the concentrations of PAA and PBS and Tetronic grade. PBS signi?cantly increased the consistency, viscoelasticity and mucoadhesion, reaching a maximum at a de?ned concentration of PBS that was dependent on PAA concentration and Tetronic grade. Formulations containing Tetronic 904 exhibited greatest consistency and elasticity both prior to and after dilution with PBS. Increasing PAA concentration enhanced the mucoadhesive properties. Prolonged drug release of metronidazole was observed from formulations containing 10% (w/w) PBS, 3% and, particularly, 5% (w/w) PAA. It is suggested that the physicochemical properties of formulations containing 3% or 5% (w/w) PAA and Tetronic 904, would render them suitable platforms for administration to body cavities.

Rheological Evaluation of the Isothermal Cure Characteristics of Medical Grade Silicone Elastomers

Silicone elastomer systems have been shown to offer potential for the fabrication of medical devices and sustained release drug delivery devices comprising low molecular weight drugs and protein therapeutics. For drug delivery systems in particular, there is often no clear rationale for selection of the silicone elastomer grade, particularly in respect of optimizing the manufacturing conditions to ensure thermal stability of the active agent and short cycle times. In this study, the cure characteristics of a range of addition-cure and condensation-cure, low-consistency, implant-grade silicone elastomers, either as supplied or loaded with the model protein bovine serum albumin (BSA) and the model hydrophilic excipient glycine, were investigated using oscillatory rheology with a view to better understanding the isothermal cure characteristics. The results demonstrate the influence of elastomer type, cure temperature, protein loading, and glycine loading on isothermal cure properties. By measuring the cure time required to achieve tan delta values representative of early and late-stage cure conditions, a ratio t(1)/t(2) was defined that allowed the cure characteristics of the various systems to be compared. Sustained in vitro release of BSA from glycine-loaded silicone elastomer covered rod devices was also demonstrated over 14 days. (C) 2010 Wiley Periodicals, Inc. J Appl Polym Sci 116: 2320-2327, 2010