Pilot-scale evaluation of the application of low pH-inducible polyphosphate accumulation to the biological removal of phosphate from wastewaters.

To investigate the possible biotechnological application of the phenomenon of low pH-inducible phosphate uptake and polyphosphate accumulation, previously reported using pure microbial cultures and under laboratory conditions, a 2000 L activated sludge pilot plant was constructed at a municipal sewage treatment works. When operated as a single-stage reactor this removed more than 60% of influent phosphate from primary settled sewage at a pH of 6.0, as opposed to approximately 30% at the typical operational pH for the works of 7.0-7.3-yet without any deleterious effect on other treatment parameters. At these pH values the phosphorus content of the sludge was, respectively, 4.2% and 2.0%. At pH 6.0 some 33.9% of sludge microbial cells were observed to contain polyphosphate inclusions; the corresponding value at pH 7.0 was 18.7%. Such a process may serve as a prototype for the development of alternative biological and chemical options for phosphate removal from wastewaters.

PCB congener dynamics in a heavily industrialized river catchment

PCB congener concentrations in the water column of a highly industrialized river catchment, the Aire/Calder, in N.E. England were determined weekly on a routine basis, and 2 hourly through selected high flow (flood) events. Bed, suspended and floodplain sediment PCB congener concentrations were also determined along transects of the rivers investigated. Weekly monitoring revealed that the sum of 11 quantified (Sigma11) PCBs rose in concentration by two orders of magnitude during late summer compared to their winter minimum values. This rise was concurrent with sustained periods of low flow. SigmaPCB concentrations were rapidly diluted during high flow (flood) events. Suspended sediment was, on average, 13 times more contaminated with PCBs than bed sediment, with means of 4.0 and 53.8 ng/g, respectively, while floodplain samples had an intermediate concentration of 29.8 ng/g. Principle components analysis (PCA) of congener profiles showed that all three sediment types were similar, but that congener profiles differed considerably between sediment and whole-water samples. There was no change in the percentage contribution of individual PCB congeners apparent from weekly whole-water monitoring. However, the congener pattern in whole-waters changed systematically during high flow events. PCA showed that whole-water samples collected during high flow events had progressively more sediment characteristics, and then returned to whole-water characteristics on cessation of the event. The PCA evidence, dilution of PCB concentrations during events, and suspended sediments more contaminated than bed sediments, indicate that the major sources of PCBs in this catchment are current inputs from sewage treatment works, rather than remobilization of bed sediments.

Downstream changes in the transport and storage of sediment-associated contaminants (P, Cr and PCBs) in agricultural and industrialized drainage basins

Samples of suspended, floodplain and channel bed sediment have been used to examine downstream changes in ediment-associated contaminant transport and storage in contrasting rivers in Yorkshire, UK. The concentrations of hosphorus, chromium and selected PCBs associated with sediment in the River Aire and its main tributary, the River Calder, which drain an urbanized and industrialized catchment, are considerably higher than those in the relatively unpolluted River Swale, which drains an agricultural catchment. Concentrations of sediment-associated contaminants in the Aire/Calder system increase downstream, reflecting the location of urban and industrial areas in the middle and lower reaches, and the location of point source inputs, such as sewage treatment works. The ontaminant concentrations associated with floodplain and channel bed sediment in the Rivers Aire and Calder are high, particularly in the lower reaches. This, combined with measurements of sediment storage on the floodplain and channel bed, indicate that significant storage of sediment-associated contaminants occurs in the Rivers Aire and Calder.

Immunological determination of the pharmaceutical diclofenac in environmental and biological samples

A highly sensitive and specific competitive ELISA on 96-microwell plates was developed for the analysis of the nonsteroidal anti-inflammatory drug diclofenac. Within the water cycle in Europe, this is one of the most frequently detected pharmaceutically active compounds. The LOD at a signal-tonoise ratio (S/N) of 3, and the IC ₅₀, were found to be 6 ng/L and 60 ng/L respectively in tap water. In a comparative study using ELISA and GC-MS, diclofenac levels in wastewater from 21 sewage treatment plants were determined and a good correlation between these methods was found (ELISA vs. GCMS: r = 0.70, slope = 0,90, intercept = 0.37, n = 24). An average degradation rate of -25% can be calculated. Labscale-experiments on the elimination of diclofenac in continuous pilot sewage plants revealed a removal rate of only 5% over a period of 13 weeks. In a further study, the ELISA was applied to a number of extracts of various animal tissues from a range of species, and again a very good relationship between ELISA and LC-ESI/MS data sets was obtained (r = 0.90, p<0.0001; n = 117). The ELISA has proven to be a simple, rapid, reliable and affordable alternative to otherwise costly and advanced techniques for the detection of diclofenac in matrix diverse water samples and tissue extracts after only relatively simple sample preparation. © 2007 American Chemical Society.

Spatial and temporal regulation of the pesticide dieldrin within industrial catchments

The river catchments of south Yorkshire support a very high density of wool processing industries. Dieldrin was once used as a moth proofing agent, as a sheep dip, and as a pesticide to protect wool fleeces during storage and transport, all of which caused pollution of these catchments due to textile processing. Weekly sampling of four of these rivers revealed two classes of dieldrin contamination: the Aire and Calder (the rivers which support very high concentrations of wool processing industries) had higher concentrations (averaging ~3 ng/l) than the Don and Trent (~1 ng/l). The average flux of dieldrin from these rivers into the Humber estuary was 9.8 g/day, with the Aire (of which the Calder is a tributary) and the Trent contributing almost equally, with a smaller contribution from the Don. The Trent has the highest average flow, explaining its large contribution to dieldrin flux. Less detailed sampling of rivers from the north Humber catchment which drain predominantly rural areas had dieldrin concentrations similar to the heavily industrialized southern catchment rivers. This suggests that dieldrin from agronomic and domestic usage may be more persistent than the pollution caused by textile processing industries. Evidence is presented to suggest that the principle dieldrin sources to the Humber catchments are sewage treatment plants, and that the dieldrin sources are in rapid equilibrium with the water column. (C) 2000 Elsevier Science B.V.