A cephalometric study of class II malocclusions treated with mandibular surgery

INTRODUCTION:

Class II malocclusion is often associated with retrognathic mandible. Some of these problems require surgical correction. The purposes of this study were to investigate treatment outcomes in patients with Class II malocclusions whose treatment included mandibular advancement surgery and to identify predictors of good outcomes.
METHODS:

Pretreatment and posttreatment cephalometric radiographs of 90 patients treated with mandibular advancement surgery by 57 consultant orthodontists in the United Kingdom before September 1998 were digitized, and cephalometric landmarks were identified. Paired samples t tests were used to compare the pretreatment and posttreatment cephalometric values for each patient. For each cephalometric variable, the proportion of patients falling within the ideal range was identified. Multiple logistic regression analysis was performed to identify predictors of achieving ideal range outcomes for the key skeletal (ANB and SNB angles), dental (overjet and overbite), and soft-tissue (Holdaway angle) measurements.
RESULTS:

An overjet within the ideal range of 1 to 4 mm was achieved in 72% of patients and was more likely with larger initial ANB angles. Horizontal correction of the incisor relationship was achieved by a combination of 75% skeletal movement and 25% dentoalveolar change. An ideal posttreatment ANB angle was achieved in 42% of patients and was more likely in females and those with larger pretreatment ANB angles. Ideal soft-tissue Holdaway angles (7 degrees to 14 degrees ) were achieved in 49% of patients and were more likely in females and those with smaller initial SNA angles. Mandibular incisor decompensation was incomplete in 28% of patients and was more likely in females and patients with greater pretreatment mandibular incisor proclination. Correction of increased overbite was generally successful, although anterior open bites were found in 16% of patients at the end of treatment. These patients were more likely to have had initial open bites.
CONCLUSIONS:

Mandibular surgery had a good success rate in normalizing the main dental and skeletal relationships. Less ideal soft-tissue profile outcomes were associated with larger pretreatment SNA-angle values, larger final mandibular incisor inclinations, and smaller final maxillary incisor inclinations. The use of mandibular surgery to correct anterior open bite was associated with poor outcomes.

Characterization and optimization of experimental variables within a reproducible bladder encrustation model and in vitro evaluation of the efficacy of urease inhibitors for the prevention of medical device-related encrustation

This study presents a reproducible, cost-effective in vitro encrustation model and, furthermore, describes the effects of components of the artificial urine and the presence of agents that modify the action of urease on encrustation on commercially available ureteral stents. The encrustation model involved the use of small-volume reactors (700 mL) containing artificial urine and employing an orbital incubator (at 37 degrees C) to ensure controlled stirring. The artificial urine contained sources of calcium and magnesium (both as chlorides), albumin and urease. Alteration of the ratio (% w/w) of calcium salt to magnesium salt affected the mass of encrustation, with the greatest encrustation noted whenever magnesium was excluded from the artificial urine. Increasing the concentration of albumin, designed to mimic the presence of protein in urine, significantly decreased the mass of both calcium and magnesium encrustation until a plateau was observed. Finally, exclusion of urease from the artificial urine significantly reduced encrustation due to the indirect effects of this enzyme on pH. Inclusion of the urease inhibitor, acetohydroxamic acid, or urease substrates (methylurea or ethylurea) into the artificial medium markedly reduced encrustation on ureteral stents. In conclusion, this study has described the design of a reproducible, cost-effective in vitro encrustation model. Encrustation was markedly reduced on biomaterials by the inclusion of agents that modify the action of urease. These agents may, therefore, offer a novel clinical approach to the control of encrustation on urological medical devices. (c) 2005 Wiley Periodicals, Inc.

Analysis and Synthesis of pHEMT Class-E Amplifiers with Shunt Inductor including ON-State Active-Device Resistance Effects

In this theoretical paper, the analysis of the effect that ON-state active-device resistance has on the performance of a Class-E tuned power amplifier using a shunt inductor topology is presented. The work is focused on the relatively unexplored area of design facilitation of Class-E tuned amplifiers where intrinsically low-output-capacitance monolithic microwave integrated circuit switching devices such as pseudomorphic high electron mobility transistors are used. In the paper, the switching voltage and current waveforms in the presence of ON-resistance are analyzed in order to provide insight into circuit properties such as RF output power, drain efficiency, and power-output capability. For a given amplifier specification, a design procedure is illustrated whereby it is possible to compute optimal circuit component values which account for prescribed switch resistance loss. Furthermore, insight into how ON-resistance affects transistor selection in terms of peak switch voltage and current requirements is described. Finally, a design example is given in order to validate the theoretical analysis against numerical simulation.

A new device for the study of electron-ion interactions

The conceptual design of a new electron beam ion trap primarily intended for the study of electron-ion interactions is outlined along with some preliminary predictions regarding its capabilities. (C) 2003 Elsevier Science B.V. All rights reserved.

A new device for the study of electron-ion interactions: The Belfast EBIT

An electron beam ion trap ( EBIT) has been designed and is currently under construction for use in atomic physics experiments at the Queen's University, Belfast. In contrast to traditional EBITs where pairs of superconducting magnets are used, a pair of permanent magnets will be used to compress the electron beam. The permanent magnets have been designed in conjunction with bespoke vacuum ports to give unprecedented access for photon detection. Furthermore, the bespoke vacuum ports facillitate a versatile, reconfigurable trap structure able to accommodate various in-situ detectors and in-line charged particle analysers. Although the machine will have somewhat lower specifications than many existing EBITs in terms of beam current density, it is hoped that the unique features will facilitate a number of hitherto impossible studies involving interactions between electrons and highly charged ions. In this article the new machine's design is outlined along with some suggestions of the type of process to be studied once the construction is completed.