Assessing modern ground survey methods and airborne laser scanning for digital terrain modelling:A case study from the Lake District, England

This paper compares the applicability of three ground survey methods for modelling terrain: one man electronic tachymetry (TPS), real time kinematic GPS (GPS), and terrestrial laser scanning (TLS). Vertical accuracy of digital terrain models (DTMs) derived from GPS, TLS and airborne laser scanning (ALS) data is assessed. Point elevations acquired by the four methods represent two sections of a mountainous area in Cumbria, England. They were chosen so that the presence of non-terrain features is constrained to the smallest amount. The vertical accuracy of the DTMs was addressed by subtracting each DTM from TPS point elevations. The error was assessed using exploratory measures including statistics, histograms, and normal probability plots. The results showed that the internal measurement accuracy of TPS, GPS, and TLS was below a centimetre. TPS and GPS can be considered equally applicable alternatives for sampling the terrain in areas accessible on foot. The highest DTM vertical accuracy was achieved with GPS data, both on sloped terrain (RMSE 0.16. m) and flat terrain (RMSE 0.02. m). TLS surveying was the most efficient overall but veracity of terrain representation was subject to dense vegetation cover. Therefore, the DTM accuracy was the lowest for the sloped area with dense bracken (RMSE 0.52. m) although it was the second highest on the flat unobscured terrain (RMSE 0.07. m). ALS data represented the sloped terrain more realistically (RMSE 0.23. m) than the TLS. However, due to a systematic bias identified on the flat terrain the DTM accuracy was the lowest (RMSE 0.29. m) which was above the level stated by the data provider. Error distribution models were more closely approximated by normal distribution defined using median and normalized median absolute deviation which supports the use of the robust measures in DEM error modelling and its propagation. © 2012 Elsevier Ltd.

CMOS IMPLEMENTATION OF A SYSTOLIC MULTI-BIT CONVOLVER CHIP.

The implementation of a multi-bit convolver chip based on a systolic array is described. The convolver is fabricated on a 7mm multiplied by 8mm CMOS chip and operates on 8-bit serial data and coefficient words. It has a length of 17 stages, and this is cascadable. The circuit can be clocked at more than 20 MHz giving a data throughput rate of greater than 1 Mword/s. Details of important implementation decisions and a summary of chip characteristics are given together with the advantages which the systolic approach has afforded to the design process.

Weathering in Arid Regions

Many misconceptions exist regarding weathering in arid regions. Chief among these are assumptions that physical processes dominate and are not very effective because of a perceived lack of moisture. This chapter explores the factors that combine to make weathering in arid regions spatially and temporally complex, reflecting the range of surface microenvironmental conditions. Because of desert landscape complexity, attempts at interpreting weathered features must take into account the long-term history of rock outcrops and debris that mantle them, as most desert landscapes contain legacies of weathering forms and products, which were developed when moisture was more readily available in the past.

The palliative care education needs of nursing home staff

Background: Palliative care is delivered in a number of settings, including nursing homes, where staff often have limited training in palliative care. Aim: We explored the level of palliative care knowledge among qualified staff delivering end-of-life care in nursing home settings, to inform the development of an appropriate education and training programme. Design: An audit of the educational needs assessment was performed using an anonymous postal questionnaire sent to 528 qualified nursing staff within 48 nursing homes. Findings: In total, 227 questionnaires were returned giving a response rate of 43%. Results indicated that less than half the sample had obtained formal training in the area of pain assessment and management and less than a quarter had obtained training in non-malignant conditions. Registered nurses in this study reported a lack of awareness of palliative care principles or national guidelines. Conclusion: Qualified nursing home staff agree that palliative care is a valuable model for care in their setting. There are clear opportunities for improvement in nursing home care, based on education and training in palliative care. Results also support the need for enhanced liaison between nursing homes and specialist palliative care services. © 2006 Elsevier Ltd. All rights reserved.

'All Good Things Must Come to an End': Terminating Co-Ownership Under the 'Old' Partition and Sale Rules

Despite its benefits, co-ownership of land creates problems where relations between the parties
have soured, or one person simply wants to extricate themselves from this arrangement. The
remedies of compulsory partition and sale allow one joint tenant or tenant in common to terminate
co-ownership against the wishes of the others, by seeking a court order to this effect. Throughout
parts of the common law world, this has be en based on nineteenth century English legislation namely
the Partition Act 1868, the key elements of which remain in force in Western Australia,
South Australia, Tasmania and the Australian Capital Territory. This article provides an up-to-date
analysis of the law on compulsory partition and sale as derived from the 1868 Act and analogous
provisions, drawing not only on Australian cases, but on frequently overlooked decisions from
courts in both parts of Ireland and in parts of Canada, as well as ‘old’ English judgments on the
1868 Act.

Successful medical treatment of Acanthamoeba keratitis

Purpose: To describe the outcome of a series of Acanthamoeba keratitis treated with a similar regimen. Methods: All cases diagnosed with Acanthamoeba keratitis in a referral centre from June 1994 through June 1997 were included. Diagnosis of Acanthamoeba keratitis was based in clinical presentation and laboratory results. Positive laboratory identification of Acanthamoeba from corneal scraping or contact lens was required, unless the patient had very characteristic symptoms (severe pain) and signs of the infection, including perineural infiltrates. Initial intensive treatment included topical polyhexamethylene biguanide (PHMB) 0.02%, propamidine isothionate 0.1% and broad-spectrum antibiotics. The treatment was gradually tapered. After documented response to anti-acanthamoeba therapy, topical steroids were introduced; they were discontinued before cessation of the antiAcanthamoeba regimen. Results: Six males and four females, with a mean age of 30.0 ± 7.4 years were included in this study. All cases weared contact lenses. On presentation all cases had severe pain, and epitheliopathy was associated with stromal infiltrate in most (seven of ten) cases. Four patients had anterior uveitis. Perineural infiltrates were present in three cases and ring infiltrate in one patient. Anti-amoebic treatment was started 12.7 ± 7.2 days after beginning of symptoms. The clinical response to therapy was very satisfactory in all patients. Within two to three weeks all patients had remarkable lessening of pain and photophobia, and improvement of clinical signs. At two to three months, visual acuity had improved in all patients. Two patients required penetrating keratoplasty for visual rehabilitation. Conclusion: The use of PHMB and propamidine cured all cases of Acanthamoeba keratitis. Cautious introduction of steroids was associated with expedited resolution of inflammation and provided symptomatic relief.

A lethal tetrad in diabetes:hyperglycemia, dyslipidemia, oxidative stress, and endothelial dysfunction

This paper addresses the consequences of diabetes and obesity, diseases that have become epidemic in our society, particularly in the past 20 years. Specifically, it summarizes current knowledge about some of the risk factors and mechanisms for the vascular complications of diabetes. These complications can be broadly divided into microvascular disease, such as diabetic retinopathy and diabetic nephropathy, and macrovascular disease, such as accelerated atherosclerosis, and they are the main cause for morbidity and premature mortality among diabetic patients. The roles of hyperglycemia, dyslipidemia and dyslipoproteinemia, oxidative stress, and endothelial dysfunction will be considered. Finally, the "treatment gap" will be addressed. This gap refers to our failure to achieve currently accepted goals to reduce established risk factors for complications in the clinical management of diabetic patients.

A low-cost solution for the restoration of femoral head centre during total hip arthroplasty

Restoration of joint centre during total hip arthroplasty is critical. While computer-aided navigation can improve accuracy during total hip arthroplasty, its expense makes it inaccessible to the majority of surgeons. This article evaluates the use, in the laboratory, of a calliper with a simple computer application to measure changes in femoral head centres during total hip arthroplasty. The computer application was designed using Microsoft Excel and used calliper measurements taken pre- and post-femoral head resection to predict the change in head centre in terms of offset and vertical height between the femoral head and newly inserted prosthesis. Its accuracy was assessed using a coordinate measuring machine to compare changes in preoperative and post-operative head centre when simulating stem insertion on 10 sawbone femurs. A femoral stem with a modular neck was used, which meant nine possible head centre configurations were available for each femur, giving 90 results. The results show that using this technique during a simulated total hip arthroplasty, it was possible to restore femoral head centre to within 6?mm for offset (mean 1.67?±?1.16?mm) and vertical height (mean 2.14?±?1.51?mm). It is intended that this low-cost technique be extended to inform the surgeon of a best-fit solution in terms of neck length and neck type for a specific prosthesis.

The making of a void sovereignty: political implications of the military checkpoints in the West Bank

Research on the Israeli checkpoints in the West Bank has emphasized not only that these checkpoints have dire implications for the Palestinians living there, at the personal, familial, and communal levels, and devastating eff ects on the Palestinian economy, but also that they have far-reaching consequences for the ability of the Palestinians to establish an independent political entity. At the same time, analysis of the Israeli forms of domination over the Palestinians has also stressed the role of a Palestinian governing authority in sustaining the Israeli rule, since the former relieves the latter of its responsibility to care for the occupied Palestinian population. This paper aims to address this apparent contradiction claiming that a comprehensive analysis of Israeli forms of domination requires a spatial examination of the operation of sovereignty with an assessment of governmentalizing arrays. This combined analysis suggests that a Palestinian sovereignty, but one which is emptied of its actual ruling power, is construed at the checkpoints as an epiphenomenon of Israeli apparatuses of control. © 2013 Pion and its Licensors.

The AstraLux large M-dwarf multiplicity survey

We present the results of an extensive high-resolution imaging survey of M-dwarf multiplicity using the Lucky Imaging technique. The survey made use of the AstraLux Norte camera at the Calar Alto 2.2m telescope and the AstraLux Sur camera at the ESO New Technology Telescope in order to cover nearly the full sky. In total, 761 stars were observed (701M-type and 60 late K-type), among which 182 new and 37 previously known companions were detected in 205 systems. Most of the targets have been observed during two or more epochs, and could be confirmed as physical companions through common proper motion, often with orbital motion being confirmed in addition. After accounting for various bias effects, we find a total M-dwarf multiplicity fraction of 27% ± 3% within the AstraLux detection range of 008-6? (semimajor axes of ~3-227 AU at a median distance of 30pc). We examine various statistical multiplicity properties within the sample, such as the trend of multiplicity fraction with stellar mass and the semimajor axis distribution. The results indicate that M-dwarfs are largely consistent with constituting an intermediate step in a continuous distribution from higher-mass stars down to brown dwarfs. Along with other observational results in the literature, this provides further indications that stars and brown dwarfs may share a common formation mechanism, rather than being distinct populations. © 2012. The American Astronomical Society. All rights reserved.

Multibody modelling of a TB31 and a TB32 crash test with vertical portable concrete barriers: model verification and sensitivity analysis.

In this article the multibody simulation software package MADYMO for analysing and optimizing occupant safety design was used to model crash tests for Normal Containment barriers in accordance with EN 1317. The verification process was carried out by simulating a TB31 and a TB32 crash test performed on vertical portable concrete barriers and by comparing the numerical results to those obtained experimentally. The same modelling approach was applied to both tests to evaluate the predictive capacity of the modelling at two different impact speeds. A sensitivity analysis of the vehicle stiffness was also carried out. The capacity to predict all of the principal EN1317 criteria was assessed for the first time: the acceleration severity index, the theoretical head impact velocity, the barrier working width and the vehicle exit box. Results showed a maximum error of 6% for the acceleration severity index and 21% for theoretical head impact velocity for the numerical simulation in comparison to the recorded data. The exit box position was predicted with a maximum error of 4°. For the working width, a large percentage difference was observed for test TB31 due to the small absolute value of the barrier deflection but the results were well within the limit value from the standard for both tests. The sensitivity analysis showed the robustness of the modelling with respect to contact stiffness increase of ±20% and ±40%. This is the first multibody model of portable concrete barriers that can reproduce not only the acceleration severity index but all the test criteria of EN 1317 and is therefore a valuable tool for new product development and for injury biomechanics research.