Pressure drop of gas–liquid Taylor flow in round micro-capillaries for low to intermediate Reynolds numbers

In this paper, a model is presented that describes the pressure drop of gas-liquid Taylor flow in round capillaries with a channel diameter typically less than 1 mm. The analysis of Bretherton (J Fluid Mech 10:166-188, 1961) for the pressure drop over a single gas bubble for vanishing liquid film thickness is extended to include a non-negligible liquid film thickness using the analysis of Aussillous and Qu,r, (Phys Fluids 12(10):2367-2371, 2000). This result is combined with the Hagen-Poiseuille equation for liquid flow using a mass balance-based Taylor flow model previously developed by the authors (Warnier et al. in Chem Eng J 135S:S153-S158, 2007). The model presented in this paper includes the effect of the liquid slug length on the pressure drop similar to the model of Kreutzer et al. (AIChE J 51(9):2428-2440, 2005). Additionally, the gas bubble velocity is taken into account, thereby increasing the accuracy of the pressure drop predictions compared to those of the model of Kreutzer et al. Experimental data were obtained for nitrogen-water Taylor flow in a round glass channel with an inner diameter of 250 mu m. The capillary number Ca (gl) varied between 2.3 x 10(-3) and 8.8 x 10(-3) and the Reynolds number Re (gl) varied between 41 and 159. The presented model describes the experimental results with an accuracy of +/- 4% of the measured values.

Short-pulse, extreme-ultraviolet continuum emission from a table-top laser plasma light source

We have observed extreme-ultraviolet (XUV) ''line-free'' continuum emission from laser plasmas of high atomic number elements using targets irradiated with 248 nm laser pulses of 7 ps duration at a power density of similar to 10(13) W/cm(2). Using both dispersive spectroscopy and streak camera detection, the spectral and temporal evolution of XUV continuum emission for several target atomic numbers has been measured on a time scale with an upper limit of several hundred picoseconds limited by amplified spontaneous emission. (C) 1997 American Institute of Physics.

FPGA Implementations of the Round Two SHA-3 Candidates

The second round of the NIST-run public competition is underway to find a new hash algorithm(s) for inclusion in the NIST Secure Hash Standard (SHA-3). This paper presents the full implementations of all of the second round candidates in hardware with all of their variants. In order to determine their computational efficiency, an important aspect in NIST's round two evaluation criteria, this paper gives an area/speed comparison of each design both with and without a hardware interface, thereby giving an overall impression of their performance in resource constrained and resource abundant environments. The implementation results are provided for a Virtex-5 FPGA device. The efficiency of the architectures for the hash functions are compared in terms of throughput per unit area. To the best of the authors' knowledge, this is the first work to date to present hardware designs which test for all message digest sizes (224, 256, 384, 512), and also the only work to include the padding as part of the hardware for the SHA-3 hash functions.

Examining the uncertainties in a 'tuned and stacked' peatland water table reconstruction

Tuning and stacking approaches have been used to compile non-annually resolved peatland palaeo-water table records in several studies. This approach has been proposed as a potential way forward to overcome the chronological problems that beset the correlation of records and may help in the upscaling of palaeoclimate records for climate model-data comparisons. This paper investigates the uncertainties in this approach using a published water table compilation from Northern Ireland. Firstly, three plausible combinations of chronological match points are used to assess the variability of the reconstructions. It is apparent that even with markedly different match point combinations, the compilations are highly similar, especially when a 100-year running mean line is used for interpretation. Secondly, sample-specific reconstruction errors are scaled in relation to the standardised water table units and illustrated on the compiled reconstruction. Thirdly, the total chronological errors for each reconstruction are calculated using Bayesian age-modelling software. Although tuning and stacking approaches may be suitable for compiling peat-based palaeoclimate records, it is important that the reconstruction and chronological errors are acknowledged and clearly illustrated in future studies. The tuning of peat-based proxy climate records is based on a potentially flawed assumption that events are synchronous between sites. © 2011 Elsevier Ltd and INQUA.

Rijndael FPGA implementations utilising look-up tables

This paper presents single-chip FPGA Rijndael algorithm implementations of the Advanced Encryption Standard (AES) algorithm, Rijndael. In particular, the designs utilise look-up tables to implement the entire Rijndael Round function. A comparison is provided between these designs and similar existing implementations. Hardware implementations of encryption algorithms prove much faster than equivalent software implementations and since there is a need to perform encryption on data in real time, speed is very important. In particular, Field Programmable Gate Arrays (FPGAs) are well suited to encryption implementations due to their flexibility and an architecture, which can be exploited to accommodate typical encryption transformations. In this paper, a Look-Up Table (LUT) methodology is introduced where complex and slow operations are replaced by simple LUTs. A LUT-based fully pipelined Rijndael implementation is described which has a pre-placement performance of 12 Gbits/sec, which is a factor 1.2 times faster than an alternative design in which look-up tables are utilised to implement only one of the Round function transformations, and 6 times faster than other previous single-chip implementations. Iterative Rijndael implementations based on the Look-Up-Table design approach are also discussed and prove faster than typical iterative implementations.

Flowfield analysis of a linear clustered plug nozzle with round-to-square modules

The plug nozzle is one of the advanced expansion devices proposed to improve the overall performance of launcher liquid rocket engines. The present work investigates the three-dimensional flow field generated on this kind of nozzle by partitioning the primary nozzle into modules. A linear plug nozzle has been designed together with modules having two different geometries: a rectangular cross section and round-to-square module. Numerical simulations have been carried out considering the case where all modules of the primary nozzle are active and the case where one module is turned off. The solutions are compared and specific three-dimensional flow structures taking place inside the modules and on the plug are identified. The relationship between these structures and the skin friction distribution within the module and along the plug surface is investigated. Finally, the effect on performance of these three-dimensional flow features is emphasized. © 2006 Elsevier Masson SAS. All rights reserved.

Table-Top Laser-Based Source of Femtosecond, Collimated, Ultrarelativistic Positron Beams

The generation of ultrarelativistic positron beams with short duration (τ_e⁺≃30 fs), small divergence (θ_e⁺≃3 mrad), and high density (n _e⁺≃1014-1015 cm^-3) from a fully optical setup is reported. The detected positron beam propagates with a high-density electron beam and γ rays of similar spectral shape and peak energy, thus closely resembling the structure of an astrophysical leptonic jet. It is envisaged that this experimental evidence, besides the intrinsic relevance to laser-driven particle acceleration, may open the pathway for the small-scale study of astrophysical leptonic jets in the laboratory. 

Periodontitis and systemic diseases:A record of discussions of working group 4 of the Joint EFP/AAP Workshop on Periodontitis and Systemic Diseases

Background There has been an explosion in research into possible associations between periodontitis and various systemic diseases and conditions. Aim To review the evidence for associations between periodontitis and various systemic diseases and conditions, including chronic obstructive pulmonary disease (COPD), pneumonia, chronic kidney disease, rheumatoid arthritis, cognitive impairment, obesity, metabolic syndrome and cancer, and to document headline discussions of the state of each field. Periodontal associations with diabetes, cardiovascular disease and adverse pregnancy outcomes were not discussed by working group 4. Results Working group 4 recognized that the studies performed to date were largely cross-sectional or case-control with few prospective cohort studies and no randomized clinical trials. The best current evidence suggests that periodontitis is characterized by both infection and pro-inflammatory events, which variously manifest within the systemic diseases and disorders discussed. Diseases with at least minimal evidence of an association with periodontitis include COPD, pneumonia, chronic kidney disease, rheumatoid arthritis, cognitive impairment, obesity, metabolic syndrome and cancer. The working group agreed that there is insufficient evidence to date to infer causal relationships with the exception that organisms originating in the oral microbiome can cause lung infections. Conclusions The group was unanimous in their opinion that the reported associations do not imply causality, and establishment of causality will require new studies that fulfil the Bradford Hill or equivalent criteria. Precise and community-agreed case definitions of periodontal disease states must be implemented systematically to enable consistent and clearer interpretations of studies of the relationship to systemic diseases. The members of the working group were unanimous in their opinion that to develop data that best inform clinicians, investigators and the public, studies should focus on robust disease outcomes and avoid surrogate endpoints. It was concluded that because of the relative immaturity of the body of evidence for each of the purported relationships, the field is wide open and the gaps in knowledge are large. © 2013 European Federation of Periodontology and American Academy of Periodontology.

Barriers to Goals of Care Discussions With Seriously Ill Hospitalized Patients and Their Families: A Multicenter Survey of Clinicians

Importance: Seriously ill hospitalized patients have identified communication and decision making about goals of care as high priorities for quality improvement in end-of-life care. Interventions to improve care are more likely to succeed if tailored to existing barriers.

Objective: To determine, from the perspective of hospital-based clinicians, (1) barriers impeding communication and decision making about goals of care with seriously ill hospitalized patients and their families and (2) their own willingness and the acceptability for other clinicians to engage in this process.

Design, Setting, and Participants: Multicenter survey of medical teaching units of nurses, internal medicine residents, and staff physicians from participating units at 13 university-based hospitals from 5 Canadian provinces.

Main Outcomes and Measures: Importance of 21 barriers to goals of care discussions rated on a 7-point scale (1 = extremely unimportant; 7 = extremely important).

Results: Between September 2012 and March 2013, questionnaires were returned by 1256 of 1617 eligible clinicians, for an overall response rate of 77.7% (512 of 646 nurses [79.3%], 484 of 634 residents [76.3%], 260 of 337 staff physicians [77.2%]). The following family member-related and patient-related factors were consistently identified by all 3 clinician groups as the most important barriers to goals of care discussions: family members' or patients' difficulty accepting a poor prognosis (mean [SD] score, 5.8 [1.2] and 5.6 [1.3], respectively), family members' or patients' difficulty understanding the limitations and complications of life-sustaining treatments (5.8 [1.2] for both groups), disagreement among family members about goals of care (5.8 [1.2]), and patients' incapacity to make goals of care decisions (5.6 [1.2]). Clinicians perceived their own skills and system factors as less important barriers. Participants viewed it as acceptable for all clinician groups to engage in goals of care discussions-including a role for advance practice nurses, nurses, and social workers to initiate goals of care discussions and be a decision coach.

Conclusions and Relevance: Hospital-based clinicians perceive family member-related and patient-related factors as the most important barriers to goals of care discussions. All health care professionals were viewed as playing important roles in addressing goals of care. These findings can inform the design of future interventions to improve communication and decision making about goals of care.

A table-top laser-based source of short, collimated, ultra-relativistic positron beams

An ultra-relativistic electron beam passing through a thick, high-Z solid target triggers an electromagnetic cascade, whereby a large number of high energy photons and electron-positron pairs are produced. By exploiting this physical process, we present here the first experimental evidence of the generation of ultra-short, highly collimated and ultra-relativistic positron beams following the interaction of a laser-wake field accelerated electron beam with high-Z solid targets. Clear evidence has also been obtained of the generation of GeV electron-positron jets with variable composition depending on the solid target material and thickness. The percentage of positrons in the overall leptonic beam has been observed to vary from a few per cent up to almost fifty per cent, implying a quasi-neutral electron-positron beam. We anticipate that these beams will be of direct relevance to the laboratory study of astrophysical leptonic jets and their interaction with the interstellar medium.