Geometric bonding effects in the X2A1, A2∑+u, and B2IIg states of Li2F

Published ab-initio and pseudopotential calculations for the dialkali halide systems suggest that the preferred co-linear geometry is for the metal to approach the metal end of the alkali halide. Here, ab-initio calculations on the Li2F system reveal that the well depth on the halide side in this radical is much deeper and is a local saddle-point associated with the ionic non-linear global minima. Although many features of the pseudopotential surfaces are confirmed, significant differences are apparent including the existence of a linear excited state instead of a triangular one, a considerably deeper global minimum some 50% lower in energy and a close approach between the X2A1 and the states, with the minimum 87 kJ mol-1 below the ground state asymptote. All the results can be rationalised as the avoided crossings between a long range, covalent potential dominant within the LiLiF geometry and an ionic state that forms the global minimum. Calculations on the 3rd 2A' potential indicate that even for Li + LiF collisions at ultracold temperatures the collision dynamics could involve as many as three electronic states.

An analysis of geometric uncertainty calculations for prostate radiotherapy in clinical practice.

Margins are used in radiotherapy to assist in the calculation of planning target volumes. These margins can be determined by analysing the geometric uncertainties inherent to the radiotherapy planning and delivery process. An important part of this process is the study of electronic portal images collected throughout the course of treatment. Set-up uncertainties were determined for prostate radiotherapy treatments at our previous site and the new purpose-built centre, with margins determined using a number of different methods. In addition, the potential effect of reducing the action level from 5 mm to 3 mm for changing a patient set-up, based on off-line bony anatomy-based portal image analysis, was studied. Margins generated using different methodologies were comparable. It was found that set-up errors were reduced following relocation to the new centre. Although a significant increase in the number of corrections to a patient's set-up was predicted if the action level was reduced from 5 mm to 3 mm, minimal reduction in patient set-up uncertainties would be seen as a consequence. Prescriptive geometric uncertainty analysis not only supports calculation and justification of the margins used clinically to generate planning target volumes, but may also best be used to monitor trends in clinical practice or audit changes introduced by new equipment, technology or practice. Simulations on existing data showed that a 3 mm rather than a 5 mm action level during off-line, bony anatomy-based portal imaging would have had a minimal benefit for the patients studied in this work.

Development and characterization of 11 polymorphic compound tetranucleotide microsatellite loci for the Leisler's bat, Nyctalus leisleri (Vespertilionidae, Chiroptera)

Eleven polymorphic microsatellite marker loci were developed from a Leisler's bat (Nyctalus leisleri) genomic enriched library. Assessment of the usefulness of these markers for population genetics studies of Leisler's bats was carried out by screening 100 specimens sampled from eight locations in Ireland and two in Northeastern France. Both moderately and highly polymorphic marker loci were identified. Five to 28 alleles were found to be segregating per locus with observed heterozygosities values ranging from 28.4 to 94%. Initial evaluation indicates that these microsatellites will be useful for genetic based studies aiming, for instance, at parentage and population structure of Leisler's bats.

Modeling the geometric characteristics of five-dimensionally woven composites

An analytical modeling approach for the prediction of the geometric characteristics of five-dimensional (5D) woven composites has been formulated. The model is driven by readily available data including the weaving parameters and constituent material properties. The new model calculates the individual proportions of fiber in each direction, areal density, overall fiber volume fraction, and laminate thickness. This information is useful for the engineer in the design and manufacture of 5D woven composites. In addition the present model outputs the mathematical definition of the 5D woven composite unit cell, which could be implemented as the geometric input for a downstream analytical model that is capable of predicting the elastic stiffness of 5D woven composites. Input parameters have been sourced from existing published work and the subsequent predictions made by the model are compared with the available experimental data on 5D woven composites.

The Rise and Fall of a Translational Compound: ‘Only Begotten’ in the English Translations of the New Testament

The present paper is an attempt to account for the emergence of the designation “only begotten” in the English Bible, its widespread use in pre-modern versions, and its gradual and almost complete disappearance from most contemporary translations. A close examination of the origins of this designation, traceable to its Latin cognate unigenitus, first introduced into the biblical tradition by St. Jerome to render selected occurrences of the Greek adjective monogenes, reveals a unique theological inspiration behind it. “Only begotten,” recurring in English translation of the Bible for almost six centuries as an important christological title, has recently been replaced by translational solutions reflecting a more accurate understanding of the underlying Greek word.

Development of an immunobiosensor assay for the beta-adrenergic compound zilpaterol

A surface plasmon resonance biosensor method was developed to measure zilpaterol residues in sheep urine. A CM-5 sensor chip previously reacted with ethylenediamine to produce an aminoethyl group was coupled with 4-carboxybutyl zilpaterol activated using EDC/NHS. Five polyclonal and four monoclonal antibodies were screened for their suitability to detect low levels of zilpaterol using the biosensor technology. Total binding was greater for polyclonal than monoclonal antibodies, but a less diluted antibody solution was required for polyclonal antibodies. A fixed antibody concentration and various concentrations of zilpaterol were injected to obtain a standard curve for each antibody to allow for B-0 and IC50 determination. The stability of the assay was assessed by the consistency of B0 in repeated experiments extending at least six hours. A measure of non-specific binding allowed the assessment of the specificity of the antibody-immobilized ligand interaction. The effect of varying concentrations of urine on B-0 and IC50 was evaluated to assess the degree of

Fasciola hepatica: Histological changes in the reproductive structures of triclabendazole (TCBZ)-sensitive and TCBZ-resistant flukes after treatment in vivo with TCBZ and the related benzimidazole derivative, Compound Alpha

Twenty-four shed-reared lambs were each infected orally with 250 metacercariae of Fasciola hepatica, using either the triclabendazole (TCBZ)-sensitive Cullompton isolate or the TCBZ-resistant Sligo isolate. Twelve weeks after infection the lambs were treated with TCBZ (10 mg/kg) or with the experimental fasciolicide, Compound Alpha (Cpd alpha), a benzimidazole derivative of TCBZ (15 mg/kg). The lambs were euthanised 48,72 and 96 h after TCBZ treatment, or 24, 48 and 72 h after Cpd a treatment, and flukes were collected from the liver and/or gall bladder of each animal. Untreated animals harbouring 12-week infections were euthanised 24 h after administration of anthelmintic to the treatment groups, and the untreated flukes provided control material. A semi-quantitative assessment of the degree of histological change induced by the two drugs after different times of exposure was achieved by scoring the intensity of three well-defined lesions that developed in the testes and uteri of a representative sample of flukes from each lamb. In general, it was found that in those tissues where active meiosis and/or mitosis occurred (testis, ovary, and vitelline follicles), there was progressive loss of cell content due to apparent failure of cell division to keep pace with expulsion of the mature or effete products. Further, actively dividing cell types tended to become individualised, rounded and condensed, characteristic of apoptotic cell death. Protein synthetic activity was apparently inhibited in the Mehlis' secretory cells. In the uterus, where successful formation of shelled eggs represents the culmination of a complex sequence of cytokinetic, cytological and synthetic activity involving the vitelline follicles, the ovary and the Mehlis' gland, histological evidence indicating failure of ovigenesis was evident from 24 h post-treatment onwards. The development of these lesions may be related to the known antitubulin activity of the benzimidazole class of anthelmintics, to the induction of apoptosis in cells where mitosis or meiosis has aborted due to failure of spindle formation, and to drug-induced inhibition of protein synthesis. The semi-quantitative findings indicated that Cpd a is slightly less efficacious than TCBZ itself in causing histological damage to the reproductive structures of TCBZ-sensitive flukes, and that, like TCBZ, it caused no histological damage in flukes of the TCBZ-resistant isolate. This study illustrates the potential utility of histological techniques for conveniently screening representative samples of flukes in field trials designed to validate instances of drug resistance or to test the efficacy of new products against known drug-resistant and drug-susceptible fluke isolates. It also provides reference criteria for drug-induced histopathological changes in fluke reproductive structures which may aid interpretation of TEM findings. (C) 2009 Elsevier B.V. All rights reserved.