6 resultados para cross-head speed

em Biblioteca Digital da Produção Intelectual da Universidade de São Paulo


Relevância:

100.00% 100.00%

Publicador:

Resumo:

Shear bond strength between Ni-Cr alloy bonded to a ceramic substrate Introduction: The aim of this study was to evaluate the shear bond strength between a Ni-Cr alloy and a ceramic system submitted or not to thermocycling. Materials and methods: Forty-eight cylinder blocks of Ni-Cr with 3.0 mm diameter by 4.0 mm hight and 48 disc-shaped specimens (7.0 mm in diameter by 2.0 mm thick) composed of ceramic were prepared. The Ni-Cr cylinder blocks were randomised in two groups of 24 specimens each. One group was submitted to air-particle abrasion (sandblasting) with 50 mu m Al2O3 (0.4-0.7 MPa) during 20 s, and the other group was submitted to mechanical retentions with carbide burrs. Each group was subdivided into other two groups (n = 12), submitted or not to thermocycling (500 cycles, 5-55 degrees C). The cylinder blocks were bonded to the disc-shaped ceramic specimens under 10 N of load. The shear bond strengths (MPa) were measured using a universal testing machine at a cross head speed of 0.5 mm/min and 200 kgf of load. The data were submitted to statistical analysis (ANOVA and Tukey's test). Results: The air-particle abrasion group exhibited significantly higher shear bond strength when compared to drilled group (p < 0.05). Conclusions: Thermocycling decreased significantly the bond strengths for all groups tested.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

The objective of this study was to evaluate the push-out bond strength of fiberglass resin reinforced bonded with five ionomer cements. Also, the interface between cement and dentin was inspected by means of SEM. Fifty human canines were chose after rigorous scrutiny process, endodontically treated and divided randomly into five groups (n = 3) according to cement tested: Group I – Ionoseal (VOCO), Group II – Fugi I (GC), Group III – Fugi II Improved (GC), Group IV – Rely X Luting 2 (3M ESPE), Group V – Ketac Cem (3M ESPE). The post-space was prepared to receive a fiberglass post, which was tried before cementation process. No dentin or post surface pretreatment was carried out. After post bonding, all roots were cross-sectioned to acquire 3 thin-slices (1 mm) from three specific regions of tooth (cervical, medium and apical). A Universal test machine was used to carry out the push-out test with cross-head speed set to 0.5mm/mim. All failed specimens were observed under optical microscope to identify the failure mode. Representative specimens from each group was inspected under SEM. The data were analyzed by Kolmogorov-Smirnov and Levene’s tests and by two-way ANOVA, and Tukey’s port hoc test at a significance level of 5%. It was compared the images obtained for determination of types of failures more occurred in different levels. SEM inspection displayed that all cements filled the space between post and dentin, however, some imperfections such bubles and voids were noticed in all groups in some degree of extension. The push-out bond strength showed that cement Ketac Cem presented significant higher results when compared to the Ionoseal (P = 0.02). There were no statistical significant differences among other cements.

Relevância:

40.00% 40.00%

Publicador:

Resumo:

Aims: To evaluate the associations of excision repair cross complementing-group 1 (ERCC1) (DNA repair protein) (G19007A) polymorphism, methylation and immunohistochemical expression with epidemiological and clinicopathological factors and with overall survival in head and neck squamous cell carcinoma (HNSCC) patients. Methods and results: The study group comprised 84 patients with HNSCC who underwent surgery and adjuvant radiotherapy without chemotherapy. Bivariate and multivariate analyses were used. The allele A genotype variant was observed in 79.8% of the samples, GG in 20.2%, GA in 28.6% and AA in 51.2%. Individuals aged more than 45 years had a higher prevalence of the allelic A variant and a high (83.3%) immunohistochemical expression of ERCC1 protein [odds ratio (OR) = 4.86, 95% confidence interval (CI): 1.2-19.7, P = 0.027], which was also high in patients with advanced stage (OR= 5.04, 95% CI: 1.07-23.7, P = 0.041). Methylated status was found in 51.2% of the samples, and was higher in patients who did not present distant metastasis (OR = 6.67, 95% CI: 1.40-33.33, P = 0.019) and in patients with advanced stage (OR = 5.04, 95% CI: 1.07-23.7, P = 0.041). At 2 and 5 years, overall survival was 55% and 36%, respectively (median = 30 months). Conclusion: Our findings may reflect a high rate of DNA repair due to frequent tissue injury during the lifetime of these individuals, and also more advanced disease presentation in this population with worse prognosis.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Cornachione AS, Rassier DE. A non-cross-bridge, static tension is present in permeabilized skeletal muscle fibers after active force inhibition or actin extraction. Am J Physiol Cell Physiol 302: C566-C574, 2012. First published November 16, 2011; doi: 10.1152/ajpcell.00355.2011.-When activated muscle fibers are stretched, there is a long-lasting increase in the force. This phenomenon, referred to as "residual force enhancement," has characteristics similar to those of the " static tension," a long-lasting increase in force observed when muscles are stretched in the presence of Ca2+ but in the absence of myosin-actin interaction. Independent studies have suggested that these two phenomena have a common mechanism and are caused either by 1) a Ca2+-induced stiffening of titin or by 2) promoting titin binding to actin. In this study, we performed two sets of experiments in which activated fibers (pCa(2+) 4.5) treated with the myosin inhibitor blebbistatin were stretched from 2.7 to 2.8 mu m at a speed of 40 L-o/s, first, after partial extraction of TnC, which inhibits myosin-actin interactions, or, second, after treatment with gelsolin, which leads to the depletion of thin (actin) filaments. We observed that the static tension, directly related with the residual force enhancement, was not changed after treatments that inhibit myosin-actin interactions or that deplete fibers from troponin C and actin filaments. The results suggest that the residual force enhancement is caused by a stiffening of titin upon muscle activation but not with titin binding to actin. This finding indicates the existence of a Ca2+-regulated, titin-based stiffness in skeletal muscles.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Objective: To evaluate the prevalence and nutritional and social determinants of overweight in a population of schoolchildren in Southern Brazil. Methods: Cross-sectional descriptive study of 5,037 children of both genders, between 6 and 10.9 years of age, from public and private schools of Maringa, Parana, Brazil. Evaluation of factors associated with excess weight (overweight and obesity) included gender, age, school type, socioeconomic level, education of the head of the family, eating habits, and means of commuting to school. After univariate analysis (Fisher's exact test), we adjusted a logistic regression model and used Wald's test for decision-making (p < 0.05). Results: The mean age was 8.7 +/- 1.3 years, with 52.8% females; 79.1% of the students attended public school and 54.6% had families of socioeconomic class A or B. Regarding nutritional status, 24% of children were overweight (7% obesity, 17% overweight). Being male, attending a private school, and having a head of the family with over four years of education were significantly associated with excess weight. In relation to food, inadequate intake of,carbohydrates was associated with a 48% greater chance of overweight/obesity (p < 0.001; OR: 1.48; 95% CI: 1.25-1.76), Conclusion: The prevalence of overweight found in this study is approximate to that reported in national studies. Its association with gender and inadequate food intake indicates that these factors should be considered in initiatives aimed at preventive measures in childhood.

Relevância:

30.00% 30.00%

Publicador:

Resumo:

Introduction. The reconstruction of complex cervicofacial defects arising from surgical treatment for cancer is a real challenge for head and neck surgeons, especially in salvage reconstruction surgery and/or failed previous reconstruction. The pectoralis major myocutaneous flap (PMMF) has been widely used in these specific situations due to its reliability and low rate of failure or complications. Objectives. Identify factors that determine complications and influence the final outcome of the reconstructions with PMMF in salvage cancer surgery or in salvage reconstruction. Methods. A cross-sectional study design was used to evaluate a sample including 17 surgical patients treated over a period of ten years that met the inclusion criteria. Results. Reconstruction was successful in 13 cases (76.5%), with two cases of partial flap loss and no case of total loss. Complications occurred in 13 cases (76.5%) and were specifically related to the flap in nine instances (52.9%). An association was identified between the development of major complications and reconstruction of the hypopharynx (P = 0.013) as well as in patients submitted to surgery in association with radiation therapy as a previous cancer treatment (P = 0.002). The former condition is also associated with major reconstruction failure (P = 0.018). An even lower incidence of major complications was noted in patients under the age of 53 (P = 0.044). Conclusion. Older patients, with hypopharyngeal defects and submitted to previous surgery plus radiation therapy, presented a higher risk of complications and reconstruction failure with PMMF.