Second-harmonic generation from biological tissues : effect of excitation wavelength

We report on the measurement of second-harmonic signals from hyperplastic parenchyma and stroma in malignant human prostate tissue under femtosecond pulsed illumination in the wavelength range from 730 to 870 nm. In particular, the relationship of the second-harmonic generation to the excitation wavelength is measured. The result in these two regions behaves considerably differently and thus provides a possible indicator for identifying tissue components and malignancy.

Dependence of second-harmonic signals generated in malignant human prostate tissue on excitation wavelength

The dependence of second harmonic generation (SHG) from hyperplastic parenchyma and stroma in maligant human prostate tissue on excitation wavelengths was measured. A femtosecond pulsed laser, a scanning microscope and a spectrograph were used to perform the measurements. The spectra were measured under excitation power of 10 mW at excitation wavelengths of 730 nm, 750 nm, 800 nm, 850 nm and 890 nm. Analysis suggested that the SHG in prostate tissue is highly structured and wavelength dependent signifying its ability to be used as an indicator for recognizing tissue components, ultrastructures, micro-environments and diseases.

Characterisation of the micro-architecture of direct writing melt electrospun tissue engineering scaffolds using diffusion tensor and computed tomography microimaging

This article describes the first steps toward comprehensive characterization of molecular transport within scaffolds for tissue engineering. The scaffolds were fabricated using a novel melt electrospinning technique capable of constructing 3D lattices of layered polymer fibers with well - defined internal microarchitectures. The general morphology and structure order was then determined using T 2 - weighted magnetic resonance imaging and X - ray microcomputed tomography. Diffusion tensor microimaging was used to measure the time - dependent diffusivity and diffusion anisotropy within the scaffolds. The measured diffusion tensors were anisotropic and consistent with the cross - hatched geometry of the scaffolds: diffusion was least restricted in the direction perpendicular to the fiber layers. The results demonstrate that the cross - hatched scaffold structure preferentially promotes molecular transport vertically through the layers ( z - axis), with more restricted diffusion in the directions of the fiber layers ( x – y plane). Diffusivity in the x – y plane was observed to be invariant to the fiber thickness. The characteristic pore size of the fiber scaffolds can be probed by sampling the diffusion tensor at multiple diffusion times. Prospective application of diffusion tensor imaging for the real - time monitoring of tissue maturation and nutrient transport pathways within tissue engineering scaffolds is discussed.

Investigation on bioactivity of titanium dioxide thin films fabricated by electron cyclotron resonance plasma aided pulsed laser deposition

Titanium dioxide thin films with a rutile crystallinite size around 20 nm were fabricated by pulsed laser deposition (PLD) aided with an electron cyclotron resonance (ECR) plasma. With annealing treatment, the crystal size of the rutile crystallinite increased to 100 nm. The apatite-forming ability of the films as deposited and after annealing was investigated in a kind of simulated body fluid with ion concentrations nearly equal to those of human blood plasma. The results indicate that ECR aided PLD is an effective way both to fabricate bioactive titanium dioxide thin films and to optimize the bioactivity of titanium dioxide, with both crystal size and defects of the film taken into account.

The impact of fuser roller temperature on laser printer particle emission

The emission of particles in the ultrafine range (<100 nm) from laser printers has not been reported until recently (Uhde et al., 2006; He et al., 2007; Morawska et al., 2009). The research reported to date has provided a body of information about printer emissions and shed light on particle formation mechanisms. However, until now, the effect of fuser roller temperature on particle emissions had not been comprehensively investigated...

Thermal effect of plasmon oscillations on the tunnel current in gold nanoisland thin film at low laser intensity

The effect of plasmon oscillations on the DC tunnel current in a gold nanoisland thin film (GNITF) is investigated using low intensity P~1W/cm2 continuous wave lasers. While DC voltages (1–150 V) were applied to the GNITF, it was irradiated with lasers at different wavelengths (k¼473, 532, and 633 nm). Because of plasmon oscillations, the tunnel current increased. It is found that the tunnel current enhancement is mainly due to the thermal effect of plasmon oscillations rather than other plasmonic effects. The results are highly relevant to applications of plasmonic effects in opto-electronic devices.

Raman-active wurtzite CdO nanophase and phonon signatures in CdO/ZnO heterostructures fabricated by nonequilibrium laser plasma ablation and stress control

A combination of laser plasma ablation and strain control in CdO/ZnO heterostructures is used to produce and stabilize a metastable wurtzite CdO nanophase. According to the Raman selection rules, this nanophase is Raman-active whereas the thermodynamically preferred rocksalt phase is inactive. The wurtzite-specific and thickness/strain-dependent Raman fingerprints and phonon modes are identified and can be used for reliable and inexpensive nanophase detection. The wurtzite nanophase formation is also confirmed by x-ray diffractometry. The demonstrated ability of the metastable phase and phonon mode control in CdO/ZnO heterostructures is promising for the development of next-generation light emitting sources and exciton-based laser diodes.

Drawing and writing on the screen

This chapter focuses on the physicality of the iPad as an object, and how that physicality affects the interactions children have with the device generally, and the apps specifically. Thinking about the physicality of the iPad is important because the materials, size, weight and appearance make the iPad quite unlike most other toys and equipment in the kindergarten space. Most strikingly, this physicality does not ‘represent’ the virtual vast dimensions of the iPad brought about through the diverse functions and contents of the apps contained in it. While the iPad is small enough and functional enough to be easily handled and operated even by young children, it is capable of performing highly complex, highly technological tasks that take it beyond its diminutive dimensions. This virtual-actual contrast is interesting to consider in relation to the other resources more commonly found in a kindergarten space. While objects such as toys, bricks, building materials often do prompt the child to imagine and invent beyond the physical boundaries of the toy, they not have the same types of virtual-actual contrasts of a digital device such as the iPad. How then, might children be drawn to the iPad because of its physical, technological and virtual difference? Particularly, how might this virtual-actual difference impact on the physical skills associated with writing and drawing: skills usually learnt through the use of a pencil and paper? While the research project did not set out to compare how digital and paper-based resources affect writing and drawing skills there was great interest to see how young children negotiated drawing and writing on the shiny glass surface of the iPad.

Writing Indigenous vampires: Aboriginal gothic or Aboriginal fantastic?

The usual postmodern suspicions about diligently deciphering authorial intent or stridently seeking fixed meaning/s and/or binary distinctions in an artistic work aside, this self-indulgent essay pushes the boundaries regarding normative academic research, for it focusses on my own (minimally celebrated) published creative writing’s status as a literary innovation. Dedicated to illuminating some of the less common denominators at play in Australian horror, my paper recalls the creative writing process involved when I set upon the (arrogant?) goal of creating a new genre of creative writing: that of the ‘Aboriginal Fantastic’. I compare my work to the literary output of a small but significant group (2.5% of the population), of which I am a member: Aboriginal Australians. I narrow my focus even further by examining that creative writing known as Aboriginal horror. And I reduce the sample size of my study to an exceptionally small number by restricting my view to one type of Aboriginal horror literature only: the Aboriginal vampire novel, a genre to which I have contributed professionally with the 2011 paperback and 2012 e-book publication of That Blackfella Bloodsucka Dance! However, as this paper hopefully demonstrates, and despite what may be interpreted by some cynical commentators as the faux sincerity of my taxonomic fervour, Aboriginal horror is a genre noteworthy for its instability and worthy of further academic interrogation. (first paragraph)