A numerical method to quantify the axial shortening of vertical elements in concrete buildings

Differential axial shortening, distortion and deformation in high rise buildings is a serious concern. They are caused by three time dependent modes of volume change; “shrinkage”, “creep” and “elastic shortening” that takes place in every concrete element during and after construction. Vertical concrete components in a high rise building are sized and designed based on their strength demand to carry gravity and lateral loads. Therefore, columns and walls are sized, shaped and reinforced differently with varying concrete grades and volume to surface area ratios. These structural components may be subjected to the detrimental effects of differential axial shortening that escalates with increasing the height of buildings. This can have an adverse impact on other structural and non-structural elements. Limited procedures are available to quantify axial shortening, and the results obtained from them differ because each procedure is based on various assumptions and limited to few parameters. All these prompt to a need to develop an accurate numerical procedure to quantify the axial shortening of concrete buildings taking into account the important time varying functions of (i) construction sequence (ii) Young’s Modulus and (iii) creep and shrinkage models associated with reinforced concrete. General assumptions are refined to minimize variability of creep and shrinkage parameters to improve accuracy of the results. Finite element techniques are used in the procedure that employs time history analysis along with compression only elements to simulate staged construction behaviour. This paper presents such a procedure and illustrates it through an example. Keywords: Differential Axial Shortening, Concrete Buildings, Creep and Shrinkage, Construction Sequence, Finite Element Method.

Prognosis of bearing failure based on health state estimation

This paper proposes a new prognosis model based on the technique for health state estimation of machines for accurate assessment of the remnant life. For the evaluation of health stages of machines, the Support Vector Machine (SVM) classifier was employed to obtain the probability of each health state. Two case studies involving bearing failures were used to validate the proposed model. Simulated bearing failure data and experimental data from an accelerated bearing test rig were used to train and test the model. The result obtained is very encouraging and shows that the proposed prognostic model produces promising results and has the potential to be used as an estimation tool for machine remnant life prediction.

A comparative study of manufacturing practices and performance variables

The reported study was conducted to compare and contrast current manufacturing practices between two countries, Australia and Malaysia, and identify the practices that significantly influence their manufacturing performances. The results are based on data collected from surveys using a standard questionnaire in both countries. Evidence indicates that product quality and reliability is the main competitive factor for manufacturers. Maintaining a supplier rating system and regularly updating it with field failure and warranty data and making use of product data management are found to be effective manufacturing practices. In terms of the investigated manufacturing performance, Australian manufacturers are marginally ahead of their Malaysian counterparts. However, Malaysian manufacturers came out ahead on most dimensions of advanced quality and manufacturing practices, particularly in the adoption of product data management, effective supply chains and relationships with suppliers and customers.

Friends looking out for friends as an intervention strategy for young adults' risky driving

Young adults are at the greatest risk of experiences road trauma disproportionately to those in other age groups. While the influence of peers is commonly associated with motor vehicle crashes and injury few studies examine whether their influence can be positive. In particular friends may be able to actively intervene to reduce the likelihood of risky driving (e.g. speeding, drink driving or drug driving) and alcohol use. The aim of this paper is to conduct a systematic review on intervening in risky driving behaviour including the situations in which it is likely or unlikely to occur, factors associated with individuals who might or report having intervened and any evaluated programs that make use of such strategies. In addition a study was conducted with 247 first year university students (32% males) to examine whether young adults report engaging in protective behaviour with their peers in South-east Queensland. In particular, if they intervene if their friends are about to drive after drinking, drive after taking illicit drugs or when speeding. It examines any differences in reported likelihood of discouraging such illegal and dangerous behaviour (in the past 12 months prior to the survey). Findings showed that young adults (17-25 years) did indeed report protective behaviour in relation to friends’ drink driving, drug driving, speeding and binge drinking. Conclusions will be drawn regarding important considerations in developing positive strategies and advertising campaigns that encourage positive behaviours (e.g. ‘don’t let mates drink and drive’).

Modernity and the 'failure' of crime control

Rather than understanding the recurrent failure of various attempts at crime control as unfortunate and undesirable aberrations, all too familiar glitches an otherwise uninterrupted teleological march to a better society, such failures are instead positioned as part of the fabric of late modernity itself. That is, society changes not according to a predetermined logic along neatly defined and clearly reasoned tracks, rather it hurtles from crisis to crisis, from failure to failure, and it is the regulation of that failure which produces new initiatives and new forms of governance. Utilising the example of the modern prison, this chapter contends that too great an emphasis upon this institution’s ‘failure’ results not only in a neglect of the many other functions that it serves in the regulation of difference, but also, and more generally, it results in an underestimation of the importance of failure in providing new impetus for social transformation.

The failure of Australian legislation on indirect discrimination to detect the systemic racism which prevents Aboriginal people from fully participating in the workforce

Government figures put the current indigenous unemployment rate at around 23%, 3 times the unemployment rate for other Australians. This thesis aims to assess whether Australian indirect discrimination legislation can provide a remedy for one of the causes of indigenous unemployment - the systemic discrimination which can result from the mere operation of established procedures of recruitment and hiring. The impact of those practices on indigenous people is examined in the context of an analysis of anti-discrimination legislation and cases from all Australian jurisdictions from the time of the passing of the Racial Discrimination Act by the Commonwealth in 1975 to the present. The thesis finds a number of reasons why the legislation fails to provide equality of opportunity for indigenous people seeking to enter the workforce. In nearly all jurisdictions it is obscurely drafted, used mainly by educated middle class white women, and provides remedies which tend to be compensatory damages rather than change to recruitment policy. White dominance of the legal process has produced legislative and judicial definitions of "race" and "Aboriginality" which focus on biology rather than cultural difference. In the commissions and tribunals complaints of racial discrimination are often rejected on the grounds of being "vexatious" or "frivolous", not reaching the required standard of proof, or not showing a causal connection between race and the conduct complained of. In all jurisdictions the cornerstone of liability is whether a particular employment term, condition or practice is reasonable. The thesis evaluates the approaches taken by appellate courts, including the High Court, and concludes that there is a trend towards an interpretation of reasonableness which favours employer arguments such as economic rationalism, the maintenance of good industrial relations, managerial prerogative to hire and fire, and the protection of majority rights. The thesis recommends that separate, clearly drafted legislation should be passed to address indigenous disadvantage and that indigenous people should be involved in all stages of the process.

Comparison of 3D finite element analysis derived stiffness and BMD to determine the failure load of the excised proximal femur

Bone mineral density (BMD) is currently the preferred surrogate for bone strength in clinical practice. Finite element analysis (FEA) is a computer simulation technique that can predict the deformation of a structure when a load is applied, providing a measure of stiffness (N mm− 1). Finite element analysis of X-ray images (3D-FEXI) is a FEA technique whose analysis is derived from a single 2D radiographic image. This ex-vivo study demonstrates that 3D-FEXI derived from a conventional 2D radiographic image has the potential to significantly increase the accuracy of failure load assessment of the proximal femur compared with that currently achieved with BMD.

"There's no way in hell I would pull up" : Deterrent and other effects of vehicle impoundment laws for hooning

Traffic law enforcement is based on deterrence principles, whereby drivers control their behaviour in order to avoid an undesirable sanction. For “hooning”-related driving behaviours in Queensland, the driver’s vehicle can be impounded for 48 hours, 3 months, or permanently depending on the number of previous hooning offences. It is assumed that the threat of losing something of value, their vehicle, will discourage drivers from hooning. While official data shows that the rate of repeat offending is low, an in-depth understanding of the deterrent effects of these laws should involve qualitative research with targeted drivers. A sample of 22 drivers who reported engaging in hooning behaviours participated in focus group discussions about the vehicle impoundment laws as applied to hooning offences in Queensland. The findings suggested that deterrence theory alone cannot fully explain hooning behaviour, as participants reported hooning frequently, and intended to continue doing so, despite reporting that it is likely that they will be caught, and perceiving the vehicle impoundment laws to be extremely severe. The punishment avoidance aspect of deterrence theory appears important, as well as factors over and above legal issues, particularly social influences. A concerning finding was drivers’ willingness to flee from police in order to avoid losing their vehicle permanently for a third offence, despite acknowledging risks to their own safety and that of others. This paper discusses the study findings in terms of the implications for future research directions, enforcement practices and policy development for hooning and other traffic offences for which vehicle impoundment is applied.

Pram and stroller related injury in Queensland children under 5 years of age

An estimated 200 Queensland children under 5 years of age are injured every year in incidents involving prams or strollers. The majority of injuries are due to falls from or falls with the pram or stroller Nineteen children were identified as having been caught in the pram or stroller mechanism (13 sustained finger injuries). Stairs and escalators were a factor in nearly 10 percent of pram or stroller fall injuries, with children being tipped out of the pram or stroller, or rolling down the stairs in the device. Roll away injuries accounted for eight percent of all pram or stroller fall injuries (some also involving stairs) Roll away injuries could be prevented by a default brake system similar to airport trolleys. Pram or stroller failure was identified in 2% of injuries

Effect of orthokeratology on peripheral aberrations of the eye

Purpose: To investigate the effect of orthokeratology on peripheral aberrations in two myopic volunteers. Methods: The subjects wore reverse geometry orthokeratology lenses overnight and were monitored for 2 weeks of wear. They underwent corneal topography, peripheral refraction (out to ±34° along the horizontal visual field) and peripheral aberration measurements across the 42° × 32° central visual field using a modified Hartmann-Shack aberrometer. Results: Spherical equivalent refraction was corrected for the central 25° of the visual fields beyond which it gradually returned to its preorthokeratology values. There were increases in axial coma, spherical aberration, higher order root mean square aberrations, and total root-mean-squared aberrations (excluding defocus). The rates of change of vertical and horizontal coma across the field changed in sign. Total root mean square aberrations showed a quadratic rate of change across the visual field which was greater subsequent to orthokeratology. Conclusion: Although orthokeratology can correct peripheral relative hypermetropia it induces dramatic increases in higher-order aberrations across the field

It's time to be more serious about activating youngsters : lessons for childhood obesity

The epidemic of obesity is impacting an increasing proportion of children, adolescents and adults with a common feature being low levels of physical activity (PA). Despite having more knowledge than ever before about the benefits of PA for health and the growth and development of youngsters, we are only paying lip-service to the development of motor skills in children. Fun, enjoyment and basic skills are the essential underpinnings of meaningful participation in PA. A concurrent problem is the reported increase in sitting time with the most common sedentary behaviors being TV viewing and other screen-based games. Limitations of time have contributed to a displacement of active behaviors with inactive pursuits, which has contributed to reductions in activity energy expenditure. To redress the energy imbalance in overweight and obese children, we urgently need out-of-the-box multisectoral solutions. There is little to be gained from a shame and blame mentality where individuals, their parents, teachers and other groups are singled out as causes of the problem. Such an approach does little more than shift attention from the main game of prevention and management of the condition, which requires a concerted, whole-of-government approach (in each country). The failure to support and encourage all young people to participate in regular PA will increase the chance that our children will live shorter and less healthy lives than their parents. In short, we need novel environmental approaches to foster a systematic increase in PA. This paper provides examples of opportunities and challenges for PA strategies to prevent obesity with a particular emphasis on the school and home settings.

Application of a continuum theory to vertical vibrations of a layer of granular material

Many interesting phenomena have been observed in layers of granular materials subjected to vertical oscillations; these include the formation of a variety of standing wave patterns, and the occurrence of isolated features called oscillons, which alternately form conical heaps and craters oscillating at one-half of the forcing frequency. No continuum-based explanation of these phenomena has previously been proposed. We apply a continuum theory, termed the double-shearing theory, which has had success in analyzing various problems in the flow of granular materials, to the problem of a layer of granular material on a vertically vibrating rigid base undergoing vertical oscillations in plane strain. There exists a trivial solution in which the layer moves as a rigid body. By investigating linear perturbations of this solution, we find that at certain amplitudes and frequencies this trivial solution can bifurcate. The time dependence of the perturbed solution is governed by Mathieu’s equation, which allows stable, unstable and periodic solutions, and the observed period-doubling behaviour. Several solutions for the spatial velocity distribution are obtained; these include one in which the surface undergoes vertical velocities that have sinusoidal dependence on the horizontal space dimension, which corresponds to the formation of striped standing waves, and is one of the observed patterns. An alternative continuum theory of granular material mechanics, in which the principal axes of stress and rate-of-deformation are coincident, is shown to be incapable of giving rise to similar instabilities.

Contracting-out asset maintenance : how arrangements adapt over time

Technological and societal change, along with organisational and market change (driven by contracting-out and privatisation), are “creating a new generation of infrastructures” [1]. While inter-organisational contractual arrangements can improve maintenance efficiency through consistent and repeatable patterns of action - unanticipated difficulties in implementation can reduce the performance of these arrangements. When faced with unsatisfactory performance of contracting-out arrangements, government organisations may choose to adapt and change these arrangements over time, with the aim of improving performance. This paper enhances our understanding of ‘next generation infrastructures’ by examining adaptation of the organisational arrangements for the maintenance of these assets, in a case study spanning 20 years.

The innovation deficit in public services : the curious problem of too much efficiency and not enough waste and failure

It has long been recognised that government and public sector services suffer an innovation deficit compared to private or market-based services. This paper argues that this can be explained as an unintended consequence of the concerted public sector drive toward the elimination of waste through efficiency, accountability and transparency. Yet in an evolving economy this can be a false efficiency, as it also eliminates the 'good waste' that is a necessary cost of experimentation. This results in a systematic trade0off in the public sector between the static efficiency of minimizing the misuse of public resources and the dynamic efficiency of experimentation. this is inherently biased against risk and uncertainty and therein, explains why governments find service innovation so difficult. In the drive to eliminate static inefficiencies, many political systems have susequently overshot and stifled policy innovation. I propose the 'Red Queen' solution of adaptive economic policy.