The ecological dynamics of decision-making in sailing

Competitive sailing is characterised by continuous interdependencies of decisions and actions. All actions imply a permanent monitoring of the environmental conditions, such as intensity and direction of the wind, sea characteristics, and the behaviour of the opponent sailors. These constraints on sailors’ behavior are in constant change implying continuous adjustments in sailors’ actions and decisions. Among the different parts of a regatta, tactics and strategy at the start are particularly relevant. Among coaches there is an adage that says that “the start is 50% of a regatta” (Houghton, 1984; Saltonstall, 1983/1986). Olympic sailing regattas are performed with boats of the same class, by one, two or three sailors, depending on the boat class. Normally before the start, sailors visit the racing venue and analyse wind and sea characteristics, in order to fine- tune their boats accordingly. Then, five minutes before the start, sailors initiate starting procedures in order to be in a favourable position at the starting line (at the “second zero”). This position is selected during the start period according to wind shifts tendencies and the actions of other boats (Figure 11.1). Only after the start signal can the boats cross the imaginary starting line between the race committee signal boat “A” and the pin end boat. The start takes place against the wind (upwind), and the boats start racing in the direction of mark 1. Based on the evaluation of the sea and wind characteristics (e.g. if the wind is stronger at a particular place on the course), sailors re- adjust their strategy for the regatta. This strategy may change during the regatta, according to wind changes and adversary actions. More to the point, strategic decisions constrain and are constrained by on- line decisions during the regatta.

An ecological footprint for an early learning centre : identifying opportunities for early childhood sustainability education through interdisciplinary research

In this study, engineers and educators worked together to adapt and apply the ecological footprint (EF) methodology to an early learning centre in Brisbane, Australia. Results were analysed to determine how environmental impact can be reduced at the study site and more generally across early childhood settings. It was found that food, transport and energy consumption had the largest impact on the centre’s overall footprint. In transport and energy, early childhood centres can reduce their impact through infrastructure and cultural change, in association with changed curriculum strategies. Building design, the type of energy purchased and appliance usage can all be modified to reduce the energy footprint. The transport footprint can be reduced through more families using active and public transport, which can be encouraged by providing information, support and facilities and appropriate siting of new centres. Introducing the concept of ecological footprint in early childhood education may be an effective way to educate children, staff and parents on the links between the food they eat, land usage and environmental impact. This study responds directly to the call in this journal for research focused on early childhood education and for more to be made of interdisciplinary research opportunities.

Grounded Media: Expanding the Scope of Ecological Art Practices Within New Media Arts Culture

‘Grounded Media’ is a form of art practice focused around the understanding that our ecological crisis is also a cultural crisis, perpetuated by our sense of separation from the material and immaterial ecologies upon which we depend. This misunderstanding of relationships manifests not only as environmental breakdown, but also in the hemorrhaging of our social fabric. ‘Grounded Media’ is consistent with an approach to media art making that I name ‘ecosophical’ and ‘praxis-led’ – which seeks through a range of strategies, to draw attention to the integrity, diversity and efficacy of the biophysical, social and electronic environments of which we are an integral part. It undertakes this through particular choices of location, interaction design,participative strategies and performative direction. This form of working emerged out of the production of two major projects, Grounded Light [8] and Shifting Intimacies [9] and is evident in a recent prototypical wearable art project called In_Step [6]. The following analysis and reflections will assist in promoting new, sustainable roles for media artists who are similarly interested in attuning their practices.

'Homes for Life' : a critical ecological study of an independent living project

In this paper, an ‘ecological’ lens is applied to an independent living project aiming to provide ‘homes for life’ for adult children with disabilities. The qualities of the project as ecological praxis are highlighted along with the implications for an open-ended enquiry into ecologies for and of the interior. In terms of the ecological concern for intimate modes of being, interior design is shown to be well placed through its association with environments in which people spend most of their life and through powerful concepts such as ‘interiority’ and ‘home’ which link to fundamental existential notions of ‘self ’ and ‘identity’. However, despite the interior being a significant generative force, this has not happened to the exclusion of other disciplines. Ignoring territorial urges to claim areas and concepts as one’s own, the paper describes how the project has actively encouraged design disciplines to trespass in each other’s territories. Ecologies for and of the interior, while recognising the need for discipline emphasis, also demand an integrated and collective approach through what is in effect transdisciplinary practice.

Government initiative and start-up firms’ eco-innovation : A case study through the ecological modernisation lens

Government programs to finance small firms or start-ups have attracted a little empirical attention. From an economical perspective, the effect of government grants is evaluated by a measure of innovation or firm productivity. Yet, this paper takes a different approach from economical view aiming to address the research question “How do start ups firms view the relationship between government grants and their co-efficient innovation effort?” Semi-structured interviews with grant recipients (start-up business owners revealed that the grants assist firms to leverage their resource limitations but at the same time the grants also act as a major roadblock for their product development success.

Processpedia : an ecological environment for BPM stakeholders' collaboration

Purpose: The purpose of this paper is to clarify how end-users’ tacit knowledge can be captured and integrated in an overall business process management (BPM) approach. Current approaches to support stakeholders’ collaboration in the modelling of business processes envision an egalitarian environment where stakeholders interact in the same context, using the same languages and sharing the same perspectives on the business process. Therefore, such stakeholders have to collaborate in the context of process modelling using a language that some of them do not master, and have to integrate their various perspectives. Design/methodology/approach: The paper applies the SECI knowledge management process to analyse the problems of traditional top-down BPM approaches and BPM collaborative modelling tools. Besides, the SECI model is also applied to Wikipedia, a successful Web 2.0-based knowledge management environment, to identify how tacit knowledge is captured in a bottom-up approach. Findings – The paper identifies a set of requirements for a hybrid BPM approach, both top-down and bottom-up, and describes a new BPM method based on a stepwise discovery of knowledge. Originality/value: This new approach, Processpedia, enhances collaborative modelling among stakeholders without enforcing egalitarianism. In Processpedia tacit knowledge is captured and standardised into the organisation’s business processes by fostering an ecological participation of all the stakeholders and capitalising on stakeholders’ distinctive characteristics.

Utilization of bio-oil for cooking and lighting

Among the available alternative sources of energy in Bangladesh bio-oil is recognized to be a promising alternative energy source. Bio-oil can be extracted by pyrolysis as well as expelling or solvent extractionmethod. In these days bio-oil is merely used in vehicles and power plants after some up gradation .However, it is not used for domestic purposes like cooking and lighting due to its high density and viscosity. This paper outlines the design of a gravity stove to use high dense and viscous bio-oil for cooking purpose. For this, Pongamia pinnata (karanj) oil extracted by solvent extraction method is used as fuel fed under gravity force. Efficiency of gravity stove with high dense and viscous bio-oil (karanj) is 11.81% which of kerosene stove is 17.80% also the discharge of karanj oil through gravity stove is sufficient for continuous burning. Thus, bio-oil can be effective replacement of kerosene for domestic purposes.

The unfinished landscape fractal geometry and the aesthetics of ecological design

During the late 20th century it was proposed that a design aesthetic reflecting current ecological concerns was required within the overall domain of the built environment and specifically within landscape design. To address this, some authors suggested various theoretical frameworks upon which such an aesthetic could be based. Within these frameworks there was an underlying theme that the patterns and processes of Nature may have the potential to form this aesthetic — an aesthetic based on fractal rather than Euclidean geometry. In order to understand how fractal geometry, described as the geometry of Nature, could become the referent for a design aesthetic, this research examines the mathematical concepts of fractal Geometry, and the underlying philosophical concepts behind the terms ‘Nature’ and ‘aesthetics’. The findings of this initial research meant that a new definition of Nature was required in order to overcome the barrier presented by the western philosophical Nature¯culture duality. This new definition of Nature is based on the type and use of energy. Similarly, it became clear that current usage of the term aesthetics has more in common with the term ‘style’ than with its correct philosophical meaning. The aesthetic philosophy of both art and the environment recognises different aesthetic criteria related to either the subject or the object, such as: aesthetic experience; aesthetic attitude; aesthetic value; aesthetic object; and aesthetic properties. Given these criteria, and the fact that the concept of aesthetics is still an active and ongoing philosophical discussion, this work focuses on the criteria of aesthetic properties and the aesthetic experience or response they engender. The examination of fractal geometry revealed that it is a geometry based on scale rather than on the location of a point within a three-dimensional space. This enables fractal geometry to describe the complex forms and patterns created through the processes of Wild Nature. Although fractal geometry has been used to analyse the patterns of built environments from a plan perspective, it became clear from the initial review of the literature that there was a total knowledge vacuum about the fractal properties of environments experienced every day by people as they move through them. To overcome this, 21 different landscapes that ranged from highly developed city centres to relatively untouched landscapes of Wild Nature have been analysed. Although this work shows that the fractal dimension can be used to differentiate between overall landscape forms, it also shows that by itself it cannot differentiate between all images analysed. To overcome this two further parameters based on the underlying structural geometry embedded within the landscape are discussed. These parameters are the Power Spectrum Median Amplitude and the Level of Isotropy within the Fourier Power Spectrum. Based on the detailed analysis of these parameters a greater understanding of the structural properties of landscapes has been gained. With this understanding, this research has moved the field of landscape design a step close to being able to articulate a new aesthetic for ecological design.

Vastu Purusha Mandala : A human ecological framework for designing living environments

This paper aims to present ‘vastu purusha mandala’(VPM), a symbolic diagram used in the indigenous system of Indian architecture as a human ecologic frame work for designing living environments. The article begins with an attempt to provide a working definition for the ‘living environment’ based on the theories developed by Rapoport (2005) and Lawrence (2001). It then discusses the symbolism and the human ecologic significance of VPM. This is substantiated through the works of Kramrisch (1976), Moore (1989), Shukla (1996) and Chakrabarthi (1998). Some recent papers on Vastu Shastra are also examined. Furthermore, VPM is compared with the livability guidelines developed for high-rise living by the Centre for Subtropical Design, Queensland University of Technology, Brisbane, Australia. A meaningful interpretation of vastushastra which is free from mysticism and symbolism is proffered through this paper.

The utilization of waste date seed as bio-oil and activated carbon by pyrolysis process

The renovation of biomass waste in the form of date seed waste into activated carbon and biofuel by fixed bed pyrolysis reactor has been focused in this study to obtain gaseous, liquid, and solid products. The date seed in particle form is pyrolysed in an externally heated fixed bed reactor with nitrogen as the carrier gas. The reactor is heated from 400◦C to 600◦C. A maximum liquid yield of 50wt.% and char of 30wt.% are obtained at a reactor bed temperature of 500◦C with a running time of 120 minutes. The oil is found to possess favorable flash point and reasonable density and viscosity. The higher calorific value is found to be 28.636 MJ/kg which is significantly higher than other biomass derived. Decolonization of 85–97% is recorded for the textile effluent and 75–90% for the tannery effluent, in all cases decreasing with temperature increase. Good adsorption capacity of the prepared activated carbon in case of diluted textile and tannery effluent was found.

Fast pyrolysis for better utilization of tamarind seed from renewable energy point of view

The conversion of tamarind seeds into pyrolytic oil by fixed bed fire-tube heating reactor has been taken into consideration in this study. The major components of the system were fixed bed fire-tube heating reactor, liquid condenser and collectors. The raw and crushed tamarind seed in particle form was pyrolized in an electrically heated 10 cm diameter and 27 cm high fixed bed reactor. The products are oil, char and gases. The parameters varied were reactor bed temperature, running time, gas flow rate and feed particle size. The parameters were found to influence the product yields significantly. The maximum liquid yield was 45 wt% at 4000C for a feed size of 1.07cm3 at a gas flow rate of 6 liter/min with a running time of 30 minute. The pyrolysis oil was obtained at these optimum process conditions were analyzed for physical and chemical properties to be used as an alternative fuel.

Utilization of bio-oil for cooking and lighting

Considerable attention has been given to development of renewable energy due to imminent depletion of fossil fuels and environmental concerns over global warming. Therefore, it is necessary to find out all the available alternative sources of energy immediately to meet the increasing energy demand of Bangladesh. Among the available alternative sources of energy in Bangladesh bio-oil is recognized to be a promising alternative energy source. In these days bio-oil is merely used in vehicles and power plants after some up gradation .However, it is not used for domestic purposes like cooking and lighting due to it’s high density and viscosity. A gravity stove is designed to use this high dense and viscous bio-oil for cooking purpose. Efficiency of gravity stove with high dense and viscous bio-oil (karanj) is 11.81% which of kerosene stove is 17.80% also the discharge of karanj oil through gravity stove is sufficient for continuous burning.