Patient-specific computational biomechanics for simulating adolescent scoliosis surgery : predicted vs clinical correction for a preliminary series of six patients

Scoliosis is a spinal deformity that requires surgical correction in progressive cases. In order to optimize surgical outcomes, patient-specific finite element models are being developed by our group. In this paper, a single rod anterior correction procedure is simulated for a group of six scoliosis patients. For each patient, personalised model geometry was derived from low-dose CT scans, and clinically measured intra-operative corrective forces were applied. However, tissue material properties were not patient-specific, being derived from existing literature. Clinically, the patient group had a mean initial Cobb angle of 47.3 degrees, which was corrected to 17.5 degrees after surgery. The mean simulated post-operative Cobb angle for the group was 18.1 degrees. Although this represents good agreement between clinical and simulated corrections, the discrepancy between clinical and simulated Cobb angle for individual patients varied between -10.3 and +8.6 degrees, with only three of the six patients matching the clinical result to within accepted Cobb measurement error of +-5 degrees. The results of this study suggest that spinal tissue material properties play an important role in governing the correction obtained during surgery, and that patient-specific modelling approaches must address the question of how to prescribe patient-specific soft tissue properties for spine surgery simulation.

Mapping the building and construction product system : preliminary report

This Preliminary Report has been prepared by researchers at The Australian Expert Group in Industry Studies (AEGIS) for the Commonwealth Department of Industry, Science and Resources. It is intended to provide a preliminary 'product system map' of the building and construction industries which defines the system, identifies the major segments, describes key industry players and institutions and provides the basis for exploring relationships, innovation and information flows within the industries. This Preliminary Report is the first of a series of five which will explore the building and construction product system in some depth. This first report does not present original research, although it does include some new interview data and analysis of a variety of written sources. This report is rather a reformulation of existing statistical and analytical material from a product system-based perspective. It is intended to provide the basis for subsequent studies by putting what is already known into an alternative framework and allowing us to see it through a new lens.

The Brisbane Cordon scheme : part A - preliminary investigation

It could be said that road congestion is one of the most significant problems within any modern metropolitan area. For several decades now, around the globe, congestion in metropolitan areas has been worsening for two main reasons. Firstly, road congestion has significantly increased due to a higher demand for road space because of growth in populations, economic activity and incomes (Hensher & Puckett, 2007). This factor, in conjunction with a significant lack of investment in new road and public transport infrastructure, has seen the road network capacities of cities exceeded by traffic volumes and thus, resulted in increased traffic congestion. This relentless increase in road traffic congestion has resulted in a dramatic increase in costs for both the road users and ultimately the metropolitan areas concerned (Bureau of Transport and Regional Economics, 2007). In response to this issue, several major cities around the world, including London, Stockholm and Singapore, have implemented congestion-charging schemes in order to combat the effects of road congestion. A congestion-charging scheme provides a mechanism for regulating traffic flows into the congested areas of a city, whilst simultaneously generating public revenue that can be used to improve both the public transport and road networks of the region. The aim of this paper was to assess the concept of congestion-charging, whilst reflecting on the experiences of various cities that have already implemented such systems. The findings from this paper have been used to inform the design of a congestion-charging scheme for the city of Brisbane in Australia in a supplementary study (Whitehead, Bunker, & Chung, 2011). The first section of this paper examines the background to road congestion; the theory behind different congestion-charging schemes; and the various technologies involved with the concept. The second section of this paper details the experiences, in relation to implementing a congestion-charging scheme, from the city of Stockholm in Sweden. This research has been crucial in forming a list of recommendations and lessons learnt for the design of a congestion-charging scheme in Australia. It is these recommendations that directly inform the proposed design of the Brisbane Cordon Scheme detailed in Whitehead et al. (2011).

Privacy v IP Litigation : preliminary third party discovery on the Internet

The enforcement of Intellectual Property rights poses one of the greatest current threats to the privacy of individuals online. Recent trends have shown that the balance between privacy and intellectual property enforcement has been shifted in favour of intellectual property owners. This article discusses the ways in which the scope of preliminary discovery and Anton Piller orders have been overly expanded in actions where large amounts of electronic information is available, especially against online intermediaries (service providers and content hosts). The victim in these cases is usually the end user whose privacy has been infringed without a right of reply and sometimes without notice. This article proposes some ways in which the delicate balance can be restored, and considers some safeguards for user privacy. These safeguards include restructuring the threshold tests for discovery, limiting the scope of information disclosed, distinguishing identity discovery from information discovery, and distinguishing information preservation from preliminary discovery.

The development of an intervention to improve the safety of community care nurses while driving and a qualitative investigation of its preliminary effects

This paper details the development of, and perceived role and effectiveness of an innovative intervention designed to ultimately improve the safety of a group of community care (CC) nurses while driving. Recruiting participants from an Australian CC nursing car fleet, qualitative responses from a series of open-ended questions were obtained from drivers (n = 36), supervisors (n = 22), and managers (n = 6). The findings supported the effectiveness of the intervention in reducing self-reported speeding and promoting greater insight into one’s behaviour on the road. This research has important practical implications in that it highlights the value of developing an intervention based on a sound theoretical framework and which is aligned with the needs and beliefs of personnel within a particular organisation.

Design of a preliminary error impact analysis model for spatial safety assessment of earthmoving operations

Regardless of technology benefits, safety planners still face difficulties explaining errors related to the use of different technologies and evaluating how the errors impact the performance of safety decision making. This paper presents a preliminary error impact analysis testbed to model object identification and tracking errors caused by image-based devices and algorithms and to analyze the impact of the errors for spatial safety assessment of earthmoving and surface mining activities. More specifically, this research designed a testbed to model workspaces for earthmoving operations, to simulate safety-related violations, and to apply different object identification and tracking errors on the data collected and processed for spatial safety assessment. Three different cases were analyzed based on actual earthmoving operations conducted at a limestone quarry. Using the testbed, the impacts of the errors were investigated for the safety planning purpose.

Preliminary characterisation of the surface of cartilage following exposure to saturated and unsaturated synthetic lipids

Articular cartilage is covered by a microscopic structure known as surface amorphous layer. This surface structure is often the first victim of attack during cartilage degeneration, thereby resulting in a gross impairment in cartilage function such as lubrication and load bearing. We hypothesize that incubation of degraded cartilage in solutions of different species of synthetic surface active phospholipids (saturated and unsaturated species) can remodel this lost surface structure. To test this hypothesis, the structural configuration of the surface of articular cartilage was studied and characterised with the lipid filled surface amorphous layer intact using the AFM. The results were then compared with those obtained following a systematic removal (delipidization) and replacement (relipidization) of this layer. Our results show that the unsaturated surfactant partially restored the lost surface amorphous layer while the saturated surfactant specie settled on the surface due to its poor solubility in aqueous solution.

Using Fiber Bragg Grating (FBG) sensors to measure vertical displacements of bridges : a preliminary study

In many bridges, vertical displacements are the most relevant parameter for monitoring in the both short and long term. However, it is difficult to measure vertical displacements of bridges and yet they are among the most important indicators of structural behaviour. Therefore, it prompts a need to develop a simple, inexpensive and yet more practical method to measure vertical displacements of bridges. With the development of fiber-optics technologies, fiber Bragg grating (FBG) sensors have been widely used in structural health monitoring. The advantages of these sensors over the conventional sensors include multiplexing capabilities, high sample rate, small size and electro magnetic interference (EMI) immunity. In this paper, methods of vertical displacement measurements of bridges are first reviewed. Then, FBG technology is briefly introduced including principle, sensing system, characteristics and different types of FBG sensors. Finally, the methodology of vertical displacement measurements using FBG sensors is presented and a trial test is described. It is concluded that using FBG sensors is feasible to measure vertical displacements of bridges. This method can be used to understand global behaviour of bridge‘s span and can further develop for structural health monitoring techniques such as damage detection.

Categorisation of activities of daily living of lower limb amputees during short-term use of a portable kinetic recording system : a preliminary study

The purpose of this preliminary study was to determine the relevance of the categorization of the load regime data to assess the functional output and usage of the prosthesis of lower limb amputees. The objectives were a) to introduce a categorization of load regime, b) to present some descriptors of each activity, and c) to report the results for a case. The load applied on the osseointegrated fixation of one transfemoral amputee was recorded using a portable kinetic system for 5 hours. The periods of directional locomotion, localized locomotion, and stationary loading occurred 44%, 34%, and 22% of recording time and each accounted for 51%, 38%, and 12% of the duration of the periods of activity, respectively. The absolute maximum force during directional locomotion, localized locomotion, and stationary loading was 19%, 15%, and 8% of the body weight on the anteroposterior axis, 20%, 19%, and 12% on the mediolateral axis, and 121%, 106%, and 99% on the long axis. A total of 2,783 gait cycles were recorded. Approximately 10% more gait cycles and 50% more of the total impulse than conventional analyses were identified. The proposed categorization and apparatus have the potential to complement conventional instruments, particularly for difficult cases.

Barriers to information technology governance adoption : a preliminary empirical investigation

The adoption of IT Governance (ITG) continues to be an important topic for research. Many researchers have focused their attention on how these practices are currently being implemented in the many diverse areas and industries. Literature shows that a majority of these studies have only been based on industries and organizations in developed countries. There exist very few researches that look specifically within the context of a developing country. Furthermore, there seems to be a lack of research on identifying the barriers or inhibitors to IT Governance adoption within the context of an emerging yet still developing Asian country. This research sets out to justify, substantiate and improve on a priori model developed to study the barriers to the adoption of ITG practice using qualitative data obtained through a series of semi-structured interviews conducted on organizations in Malaysia.

An exercise intervention for women undergoing chemotherapy for ovarian cancer : feasibility and preliminary outcomes

Exercise interventions during adjuvant cancer treatment have been shown to increase functional capacity, relieve fatigue and distress and in one recent study, assist chemotherapy completion. These studies have been limited to breast, prostate or mixed cancer groups and it is not yet known if a similar intervention is even feasible among women diagnosed with ovarian cancer. Women undergoing treatment for ovarian cancer commonly have extensive pelvic surgery followed by high intensity chemotherapy. It is hypothesized that women with ovarian cancer may benefit most from a customised exercise intervention during chemotherapy treatment. This could reduce the number and severity of chemotherapy-related side-effects and optimize treatment adherence. Hence, the aim of the research was to assess feasibility and acceptability of a walking intervention in women with ovarian cancer whilst undergoing chemotherapy, as well as pre-post intervention changes in a range of physical and psychological outcomes. Newly diagnosed women with ovarian cancer were recruited from the Royal Brisbane and Women’s Hospital (RBWH), to participate in a walking program throughout chemotherapy. The study used a one group pre- post-intervention test design. Baseline (conducted following surgery but prior to the first or second chemotherapy cycles) and follow-up (conducted three weeks after the last chemotherapy dose was received) assessments were performed. To accommodate changes in side-effects associated with treatment, specific weekly walking targets with respect to frequency, intensity and duration, were individualised for each participant. To assess feasibility, adherence and compliance with prescribed walking sessions, withdrawals and adverse events were recorded. Physical and psychological outcomes assessed included functional capacity, body composition, anxiety and depression, symptoms experienced during treatment and quality of life. Chemotherapy completion data was also documented and self-reported program helpfulness was assessed using a questionnaire post intervention. Forty-two women were invited to participate. Nine women were recruited, all of whom completed the program. There were no adverse events associated with participating in the intervention and all women reported that the walking program was helpful during their neo-adjuvant or adjuvant chemotherapy treatment. Adherence and compliance to the walking prescription was high. On average, women achieved at least two of their three individual weekly prescription targets 83% of the time (range 42% to 94%). Positive changes were found in functional capacity and quality of life, in addition to reductions in the number and intensity of treatment-associated symptoms over the course of the intervention period. Functional capacity increased for all nine women from baseline to follow-up assessment, with improvements ranging from 10% to 51%. Quality of life improvements were also noted, especially in the physical well-being scale (baseline: median 18; follow-up: median 23). Treatment symptoms reduced in presence and severity, specifically, in constipation, pain and fatigue, post intervention. These positive yet preliminary results suggest that a walking intervention for women receiving chemotherapy for ovarian cancer is safe, feasible and acceptable. Importantly, women perceived the program to be helpful and rewarding, despite being conducted during a time typically associated with elevated distress and treatment symptoms that are often severe enough to alter or cease chemotherapy prescription.

The measurement of information system use: preliminary considerations

The concept of system use has suffered from a "too simplistic definition" (DeLone and McLean [9], p. 16). This paper reviews various attempts at conceptualization and measurement of system use and then proposes a re-conceptualization of it as "the level of incorporation of an information system within a user's processes." We then go on to develop the concept of a Functional Interface Point and four dimensions of system usage: automation level, the proportion of the business process encoded by the information system; extent, the proportion of the FIPs used by the business process; frequency, the rate at which FIPs are used by the participants in the process; and thoroughness, the level of use of information/functionality provided by the system at an FIP. The article concludes with a discussion of some implications of this re-conceptualization and areas for follow on research.