Chirp-spread-spectrum-based real time location system for construction safety management: A case study

Observing the working procedure of construction workers is an effective means of maintaining the safety performance of a construction project. It is also difficult to achieve due to a high worker-to-safety-officer ratio. There is an imminent need for the development of a tool to assist in the real-time monitoring of workers, in order to reduce the number of construction accidents. The development and application of a real time locating system (RTLS) based on the Chirp Spread Spectrum (CSS) technique is described in this paper for tracking the real-time position of workers on construction sites. Experiments and tests were carried out both on- and off-site to verify the accuracy of static and dynamic targets by the system, indicating an average error of within one metre. Experiments were also carried out to verify the ability of the system to identify workers’ unsafe behaviours. Wireless data transfer was used to simplify the deployment of the system. The system was deployed in a public residential construction project and proved to be quick and simple to use. The cost of the developed system is also reported to be reasonable (around 1800USD) in this study and is much cheaper than the cost of other RTLS. In addition, the CCS technique is shown to provide an economical solution with reasonable accuracy compared with other positioning systems, such as ultra wideband. The study verifies the potential of the CCS technique to provide an effective and economical aid in the improvement of safety management in the construction industry.

Non-destructive structural integrity assessment of a decommissioned rail wagon system

This paper presents a multi-criteria based approach for nondestructive diagnostic structural integrity assessment of a decommissioned flatbed rail wagon (FBRW) used for road bridge superstructure rehabilitation and replacement applications. First, full-scale vibration and static test data sets are employed in a FE model of the FBRW to obtain the best ‘initial’ estimate of the model parameters. Second, the ‘final’ model parameters are predicted using sensitivity-based perturbation analysis without significant difficulties encountered. Consequently, the updated FBRW model is validated using the independent sets of full-scale laboratory static test data. Finally, the updated and validated FE model of the FBRW is used for structural integrity assessment of a single lane FBRW bridge subjected to the Australian bridge design traffic load.

Toward the multilevel older person's transportation and road safety model: A new perspective on the role of demographic, functional, and psychosocial factors

Objectives Self-regulation refers to the practice of using self-imposed restrictions to protect oneself from situations that are, or are perceived to be, unsafe. Within the driving context, self-regulation refers the compensatory practices that some older adults adopt to restrict their driving to situations in which they feel safe. However, the way in which demographic, functional, and psychosocial factors, and the interactions between these factors, influence older adults’ driving self-regulation is not well understood. Improving this understanding could lead to new ways of considering the mobility concerns faced by older drivers. Method A systematic review of the current literature was conducted to explore this issue. Twenty-nine empirical studies investigating the factors associated with older adults’ self-regulatory driving behaviors were examined. Results The review findings were used to construct the Multilevel Older Persons Transportation and Road Safety (MOTRS) model. The MOTRS model proposes that individual and environmental factors such as age, gender, and the availability of alternative transportation predict older adults’ practice of driving-related self-regulation. However, these variables influence self-regulation through psychosocial variables such as driving confidence, affective attitude, and instrumental attitude toward driving. Discussions The MOTRS model extends previous attempts to model older adults’ driving by focusing on a novel target, driving self-regulation, and by including a wider range of predictors identified on the basis of the systematic literature review. This focus enables consideration of broader mobility issues and may inform new strategies to support the mobility of older adults.

Proactive behavior-based safety management for construction safety improvement

Construction is one of the most hazardous industries due to its dynamic, temporary, and decentralized nature. The Hong Kong Commissioner for Labor identifies worker behavior as the root cause of construction accidents. Behavior-based safety (BBS) is one effective approach in managing employee safety issues. However, there is little research on the application of BBS in the construction industry. This research proposes an extension of the BBS approach, proactive behavior-based safety (PBBS), to improve construction safety. PBBS integrates the theory of BBS with the technology of Proactive Construction Management System (PCMS). The innovations of PBBS are: (1) automatically monitoring location-based behaviors; (2)quantitatively measuring safety performance; (3) investigating potential causes of unsafe behaviors; and (4) improving the efficiency of safety management. A pilot study of a Hong Kong construction site practicing PBBS was conducted. The experiment results showed that PBBS performed well on construction accident prevention and the Safety Index (SI) of the two project teams, with increased improvements by 36.07% and 44.70% respectively. It is concluded that PBBS is effective and adaptable to construction industry.

Disability due to road traffic crashes and the management of road safety in developing countries

Injury as a result of road traffic crashes is one of the most significant public health problems in developing countries. It intersects with disability as a development issue because a substantial proportion of people injured in road traffic crashes experience disability, both short term and long term. While there have been significant steps towards better management of road safety globally, especially in developing countries, the implications for road safety policy and practice of disability due road traffic crashes is not fully appreciated. In particular, qualitative information on the lived experience people with a long term disability as a result of a road traffic crash can inform better road safety policy and practice, as demonstrated in a case study from Thailand. The benefits of better policies and practices are likely to accrue to a wide range of road users, and to contribute to the achievement of sustainable development.

Perceived safety, quality and cultural competency of maternity care for culturally and linguistically diverse women in Queensland

Various policies, plans, and initiatives have been implemented to provide safe, quality, and culturally competent care to patients within Queensland’s healthcare system. A series of models of maternity care are available in Queensland that range from standard public care to private midwifery care. The current study aimed to determine whether identifying as Culturally or Linguistically Diverse (CALD) was associated with the perceived safety, quality, and cultural competency of maternity care from a consumer perspective, and to identify specific needs and preferences of CALD maternity care consumers. Secondary analysis of data collected in the Having a Baby in Queensland Survey 2012 was used to compare the experiences of 655 CALD women to those of 4049 non-CALD women in Queensland, Australia, across three stages of maternity care: pregnancy, labour and birth, and after birth. After adjustment for model of maternity care received and socio-demographic characteristics, CALD women were significantly more likely than non-CALD women to experience suboptimal staff technical competence in pregnancy, overall perceived safety in pregnancy and labour/birth, and interpersonal sensitivity in pregnancy and labour/birth. Approximately 50% of CALD women did not have the choice to use a translator or interpreter, or the gender of their care provider, during labour and birth. Thirteen themes of preferences and needs of CALD maternity care consumers based on ethnicity, cultural beliefs, or traditions were identified, however, these were rarely met. Findings imply that CALD women in Queensland experience disadvantageous maternity care with regards to perceived staff technical competence, safety, and interpersonal sensitivity, and receive care that lacks cultural competence. Improved access to support persons, continuity and choice of carer, and staff availability and training is recommended.

Road safety and pavement management: A case study of Tanzania

The implementation of pavement management seems to ignore road safety, with its focus being mainly on infrastructure condition. Safety management as part of pavement management should consider various means of reducing the frequency of vehicle crashes by allocating corrective measures to mitigate accident exposure, as well as reduce accident severity and likelihood. However, it is common that lack of accident records and crash contributing factors impedes incorporating safety into pavement management. This paper presents a case study for the initial development of pavement management systems considering data limitations for 3000 km of Tanzania’s national roads. A performance based optimization utilizes indices for safety and surface condition to allocate corrective measures. A modified Pareto analysis capable of accounting for annual performance and of balancing resources to achieve good surface condition and low levels of safety was applied. Tradeoff analysis for the case study found the need to assign 30% relevance to condition and 70% to road safety. Safety and condition deficiencies were corrected within 5 years with the majority of improvements dedicated to surface treatments and some geometric corrections. Large investments for correcting geometric issues were observed in years two and three if more money was made available.

Minimising the failure of rail joints through managing the localised condition of track

To effectively address the high rate of failure of Insulated Rail Joints (IRJs) in the heavy haul lines, a research plan was designed and implemented with particular attention to understand their mechanical behaviour and deterioration process. In this paper, part of this ongoing research is described. During the past decades many studies have tried to improve the service life of IRJs by introducing a new structural design or material for IRJ components. This paper looks into this problem from a different perspective highlighting the significance of localised condition of track to the loads and responses of the IRJs. Results from a series of field measurements conducted in a rail track within the Australian Rail Track Corporation (ARTC) network are discussed. The interactive effects of IRJ responses and localised track condition are further investigated using the results obtained from numerical simulations. The field measurements and the simulation results provide valuable insight on the influence of track condition to the behaviour of IRJs.

Fatigue and sleepiness: Complex bedfellows

Do you know how to drive a train? If you don’t you probably believe that you have a fair idea of what it’s all about. Forget what you know, or think you know. Trains are heavy and fast but they feel and handle like driving on ice so they take a long time to stop. The braking distances for a typical piece of track are unlike anything you will have experienced before. With that in mind, imagine you were driving with a bit of dew, or grease, or millipede over the track. You would lose traction and slip everywhere. To avoid this, you would need a compensatory driving strategy. You could drive more slowly, or brake sooner, or change how you brake. Your experience and intuition would lead the way. Folks, this is why it’s called “driving by the seat of your pants”...

[await full-text]Evaluation of QAS Workplace Health and Safety Action Plan

This report identifies the outcomes of a program evaluation of the five year Workplace Health and Safety Strategy (2012-2017), specifically, the engagement component within the Queensland Ambulance Service. As part of the former Department of Community Safety, their objective was to work towards harmonising the occupational health and safety policies and process to improve the workplace culture. The report examines and assess the process paths and resource inputs into the strategy, provides feedback on progress to achieving identified goals as well as identify opportunities for improvements and barriers to progress. Consultations were held with key stakeholders within QAS and focus groups were facilitated with managers and health and safety representatives of each Local Area Service Network.

The practical potential of self-advocacy for improving safety outcomes for school-aged workers

Young workers are over-represented in workplace injury statistics and there is growing interest in addressing their vulnerability and safety exposure. Such concerns have been raised within a broader discursive framework of responsibilisation which has seen a transfer of responsibility for workplace safety from employer to worker. This article examines the potential for self-advocacy as a strategy for improving the safety of young workers through the provision of resources to articulate and act on workplace rights. The study utilises data derived from 48 group interviews involving 216 high school students (13–16 years of age) at 19 high schools in Queensland, Australia, who were asked to discuss their knowledge and experience of workplace rights and responsibilities. The limitations of the safety self-advocacy approach are explored, including the social, developmental and organisational issues that might affect the ability or willingness of school-aged workers to self-advocate. The findings reveal that the notion of self-advocacy is internalised by young people before they even enter the formal labour market but that in practice, attempts by young people to enact rights to safety are often dismissed or undermined.

Direct observations of pedestrian unsafe crossing at urban Australian level crossings

The number of pedestrian victims at Australian and foreign level crossings has remained stable over the past decade and it continues to be a significant problem. To examine the factors contributing to pedestrians’ unsafe crossing behaviours, direct observations were conducted at three black spot urban level crossings in Brisbane for a total of 45 h during morning and afternoon peak. In total, 129 pedestrians transgressed the active controls. More transgressions were observed at the crossings located in more populated suburbs in close proximity to large shopping centres and school zones, whereas the smallest number of transgressions were observed at the least populated locations. In addition to characteristics associated with the larger socio-economic area, the patterns of transgression could be associated with the properties of the existing safety equipment and the design of each level crossing (i.e. location of the platforms, number of rail tracks). Indeed, the largest number of crossed unoccupied but “at risk” rail tracks (where a train could have passed), was observed at the crossing with the least transgressions. Contrary to previous findings, younger adults were the most frequent transgressors. School children and elderly were most likely to transgress in groups. Potential directions for future research and more effective measures are discussed.

Compliance with seafood safety standards within the Vietnamese finfish capture distribution chain

This thesis examined the level of food safety compliance with government regulations and investigated routes of microbiological contaminations in raw finfish within Vietnamese domestic seafood distribution chains. Findings from direct observation, microbiological analysis and employee surveys were synthesized to identify the main factors affecting food safety and hygiene practices of fish distributors. The studies produced clear recommendations for food safety management in the domestic distribution chains. The findings may contribute to national efforts to decrease the risks of fish-borne illness for consumers in Vietnam.

Reviewing in-vehicle systems to improve fuel efficiency and road safety

Road transport plays a significant role in various industries and mobility services around the globe and has a vital impact on our daily lives. However it also has serious impacts on both public health and the environment. In-vehicle feedback systems are a relatively new approach to encouraging driver behavior change for improving fuel efficiency and safety in automotive environments. While many studies claim that the adoption of eco-driving practices, such as eco-driving training programs and in-vehicle feedback to drivers, has the potential to improve fuel efficiency, limited research has integrated safety and eco-driving. Therefore, it is crucial to understand the human factors related theories and practices which will inform the design of an in-vehicle Human Machine Interface (HMI) that could provide real-time driver feedback and consequently improve both fuel efficiency and safety. This paper provides a comprehensive review of the current state of published literature on in-vehicle systems to identify and evaluate the impact of eco-driving and safety feedback systems. This paper also discusses how these factors may conflict with one another and have a negative effect on road safety, while also exploring possible eco-driving practices that could encourage more sustainable, environmentally-conscious and safe driving behavior. The review revealed a lack of comprehensive theoretical research integrating eco-driving and safe driving, and no current available HMI covering both aspects simultaneously. Furthermore, the review identified that some eco-driving in-vehicle systems may enhance fuel efficiency without compromising safety. The review has identified a range of concepts which can be developed to influence driver acceptance of safety and eco-driving systems within the area of HMI. This can promote new research aimed at enhancing our understanding of the relationship between eco-driving and safety from the human factors viewpoint. This provides a foundation for developing innovative, persuasive and acceptable in-vehicle HMI systems to improve fuel efficiency and road safety.