Analysis and correction of voltage profile in low voltage distribution networks containing photovoltaic cells and electric vehicles

Voltage drop and rise at network peak and off–peak periods along with voltage unbalance are the major power quality problems in low voltage distribution networks. Usually, the utilities try to use adjusting the transformer tap changers as a solution for the voltage drop. They also try to distribute the loads equally as a solution for network voltage unbalance problem. On the other hand, the ever increasing energy demand, along with the necessity of cost reduction and higher reliability requirements, are driving the modern power systems towards Distributed Generation (DG) units. This can be in the form of small rooftop photovoltaic cells (PV), Plug–in Electric Vehicles (PEVs) or Micro Grids (MGs). Rooftop PVs, typically with power levels ranging from 1–5 kW installed by the householders are gaining popularity due to their financial benefits for the householders. Also PEVs will be soon emerged in residential distribution networks which behave as a huge residential load when they are being charged while in their later generation, they are also expected to support the network as small DG units which transfer the energy stored in their battery into grid. Furthermore, the MG which is a cluster of loads and several DG units such as diesel generators, PVs, fuel cells and batteries are recently introduced to distribution networks. The voltage unbalance in the network can be increased due to the uncertainties in the random connection point of the PVs and PEVs to the network, their nominal capacity and time of operation. Therefore, it is of high interest to investigate the voltage unbalance in these networks as the result of MGs, PVs and PEVs integration to low voltage networks. In addition, the network might experience non–standard voltage drop due to high penetration of PEVs, being charged at night periods, or non–standard voltage rise due to high penetration of PVs and PEVs generating electricity back into the grid in the network off–peak periods. In this thesis, a voltage unbalance sensitivity analysis and stochastic evaluation is carried out for PVs installed by the householders versus their installation point, their nominal capacity and penetration level as different uncertainties. A similar analysis is carried out for PEVs penetration in the network working in two different modes: Grid to vehicle and Vehicle to grid. Furthermore, the conventional methods are discussed for improving the voltage unbalance within these networks. This is later continued by proposing new and efficient improvement methods for voltage profile improvement at network peak and off–peak periods and voltage unbalance reduction. In addition, voltage unbalance reduction is investigated for MGs and new improvement methods are proposed and applied for the MG test bed, planned to be established at Queensland University of Technology (QUT). MATLAB and PSCAD/EMTDC simulation softwares are used for verification of the analyses and the proposals.

Experiences of a walking intervention in a University community : Qualitative perspectives

Background: This study explored the experiences of university employees that participated in a walking intervention that encouraged individuals to walk more throughout their workday. The 10-week program was comprised of 5 phases (i.e. baseline, anticipating barriers, short planned walks, longer planned walks and maintenance) and utilized a pedometer diary and an online website for logging steps. The pedometer diary included “action plans” for addressing barriers and planning walking and the online dashboard provided graphical outputs that allowed participants to visualize whether they were reaching or exceeding their step targets. Methods: A subsample of 12 academic and administrative employees from the study completed open ended questionnaires at the end of the study. The questions focused on capturing the major themes of benefits/mediators and problems/moderators of the program and were assessed using phenomenological approaches. Results: Participants found a raised consciousness of physical inactivity throughout the work day. They also found it useful to have a graphical display of physical activity patterns, but found time constraints and lack of managerial support to be the primary barriers/moderators of the program. Those most likely to withdraw from the program experienced technical difficulties with objective monitors and the online website. Conclusions: Findings highlight the value in being involved in a group forum and provide insights into the challenges of supporting such programs within the workplace.

Non-invasive method for detecting changes in soil moisture using wireless sensor networks

There are several popular soil moisture measurement methods today such as time domain reflectometry, electromagnetic (EM) wave, electrical and acoustic methods. Significant studies have been dedicated in developing method of measurements using those concepts, especially to achieve the characteristics of noninvasiveness. EM wave method provides an advantage because it is non-invasive to the soil and does not need to utilise probes to penetrate or bury in the soil. But some EM methods are also too complex, expensive, and not portable for the application of Wireless Sensor Networks; for example satellites or UAV (Unmanned Aerial Vehicle) based sensors. This research proposes a method in detecting changes in soil moisture using soil-reflected electromagnetic (SREM) wave from Wireless Sensor Networks (WSNs). Studies have shown that different levels of soil moisture will affects soil’s dielectric properties, such as relative permittivity and conductivity, and in turns change its reflection coefficients. The SREM wave method uses a transmitter adjacent to a WSNs node with purpose exclusively to transmit wireless signals that will be reflected by the soil. The strength from the reflected signal that is determined by the soil’s reflection coefficients is used to differentiate the level of soil moisture. The novel nature of this method comes from using WSNs communication signals to perform soil moisture estimation without the need of external sensors or invasive equipment. This innovative method is non-invasive, low cost and simple to set up. There are three locations at Brisbane, Australia chosen as the experiment’s location. The soil type in these locations contains 10–20% clay according to the Australian Soil Resource Information System. Six approximate levels of soil moisture (8, 10, 13, 15, 18 and 20%) are measured at each location; with each measurement consisting of 200 data. In total 3600 measurements are completed in this research, which is sufficient to achieve the research objective, assessing and proving the concept of SREM wave method. These results are compared with reference data from similar soil type to prove the concept. A fourth degree polynomial analysis is used to generate an equation to estimate soil moisture from received signal strength as recorded by using the SREM wave method.

Unpacking the connections between network and stakeholder management and their application to road infrastructure networks in Queensland

Since the late twentieth century, there has been a shift away from delivery of infrastructure, including road networks, exclusively by the state. Subsequently, a range of alternative delivery models including governance networks have emerged. However, little is known about how connections between these networks and their stakeholders are created, managed or sustained. Using an analytical framework based on a synthesis of theories of network and stakeholder management, three cases in road infrastructure in Queensland, Australia are examined. The paper finds that although network management can be used to facilitate stakeholder engagement, such activities in the three cases are mainly focused within the core network of those most directly involved with delivery of the infrastructure often to the exclusion of other stakeholder groups.

Mining work, family and community : a spatially-oriented approach to the impact of the Ravensthorpe nickel mine closure in remote Australia

While changes in work and employment practices in the mining sector have been profound, the literature addressing mining work is somewhat partial as it focuses primarily on the workplace as the key (or only) site of analysis, leaving the relationship between mining work and families and communities under-theorized. This article adopts a spatially oriented, case-study approach to the sudden closure of the Ravensthorpe nickel mine in the south-west of Western Australia to explore the interplay between the new scales and mobilities of labour and capital and work–family–community connections in mining. In the context of the dramatically reconfigured industrial arena of mining work, the study contributes to a theoretical engagement between employment relations and the spatial dimensions of family and community in resource-affected communities.

Through the viewfinder : using multimedia techniques to engage Latino youth in community planning

This chapter reviews common barriers to community engagement for Latino youth and suggests ways to move beyond those barriers by empowering them to communicate their experiences, address the challenges they face, and develop recommendations for making their community more youth-friendly. As a case study, this chapter describes a program called Youth FACE IT (Youth Fostering Active Community Engagement for Integration and Transformation)in Boulder County, Colorado. The program enables Latino youth to engage in critical dialogue and participate in a community-based initiative. The chapter concludes by explaining specific strategies that planners can use to support active community engagement and develop a future generation of planners and engaged community members that reflects emerging demographics.

Privacy by design : Does it matter for social networks?

Privacy is an important component of freedom and plays a key role in protecting fundamental human rights. It is becoming increasingly difficult to ignore the fact that without appropriate levels of privacy, a person’s rights are diminished. Users want to protect their privacy - particularly in “privacy invasive” areas such as social networks. However, Social Network users seldom know how to protect their own privacy through online mechanisms. What is required is an emerging concept that provides users legitimate control over their own personal information, whilst preserving and maintaining the advantages of engaging with online services such as Social Networks. This paper reviews “Privacy by Design (PbD)” and shows how it applies to diverse privacy areas. Such an approach will move towards mitigating many of the privacy issues in online information systems and can be a potential pathway for protecting users’ personal information. The research has also posed many questions in need of further investigation for different open source distributed Social Networks. Findings from this research will lead to a novel distributed architecture that provides more transparent and accountable privacy for the users of online information systems.