How does ‘Newstainment’ actually work? : ethnographic research methods and contemporary popular news

Much debate has taken place recently over the potential for entertainment genres and unorthodox forms of news to provide legitimate – indeed democratized – in-roads into the public sphere. Amidst these discussions, however, little thought has been paid to the audiences for programs of this sort, and (even when viewers are considered) the research can too easily treat audiences in homogenous terms and therefore replicate the very dichotomies these television shows directly challenge. This paper is a critical reflection on an audience study into the Australian morning “newstainment” program Sunrise. After examining the show and exploring how it is ‘used’ as a news source, this paper will promote the use of ethnographic study to better conceptualize how citizens integrate and connect the increasingly fragmented and multifarious forms of postmodern political communication available in their everyday lives.

Particle and gaseous emissions from commercial aircraft at each stage of the landing and takeoff cycle

A novel technique was used to measure emission factors for commonly used commercial aircraft including a range of Boeing and Airbus airframes under real world conditions. Engine exhaust emission factors for particles in terms of particle number and mass (PM2.5), along with those for CO2, and NOx were measured for over 280 individual aircraft during the various modes of landing/takeoff (LTO) cycle. Results from this study show that particle number, and NOx emission factors are dependant on aircraft engine thrust level. Minimum and maximum emissions factors for particle number, PM2.5, and NOx emissions were found to be in the range of 4.16×1015-5.42×1016 kg-1, 0.03-0.72 g.kg-1, and 3.25-37.94 g.kg-1 respectively for all measured airframes and LTO cycle modes. Number size distributions of emitted particles for the naturally diluted aircraft plumes in each mode of LTO cycle showed that particles were predominantly in the range of 4 to 100 nm in diameter in all cases. In general, size distributions exhibit similar modality during all phases of the LTO cycle. A very distinct nucleation mode was observed in all particle size distributions, except for taxiing and landing of A320 aircraft. Accumulation modes were also observed in all particle size distributions. Analysis of aircraft engine emissions during LTO cycle showed that aircraft thrust level is considerably higher during taxiing than idling suggesting that International Civil Aviation Organization (ICAO) standards need to be modified as the thrust levels for taxi and idle are considered to be the same (7% of total thrust) [1].

Tangible interfaces to explain Gaudi's use of ruled-surface geometries

This paper summarises the development of a machine-readable model series for explaining Gaudi's use of ruled surface geometry in the Sagrada Familia in Barcelona, Spain. The first part discusses the modeling methods underlying the columns of the cathedral and the techniques required to translate them into built structures. The second part discusses the design and development of a tangible machine-readable model to explain column-modeling methods interactively in educational contexts such as art exhibitions. It is designed to explain the principles underlying the column design by means of physical interaction without using mathematical terms or language.

Developing a vision for an nD modelling tool

The design of a building is a complicated process, having to formulate diverse components through unique tasks involving different personalities and organisations in order to satisfy multi-faceted client requirements. To do this successfully, the project team must encapsulate an integrated design that accommodates various social, economic and legislative factors. Therefore, in this era of increasing global competition integrated design has been increasingly recognised as a solution to deliver value to clients.----- The ‘From 3D to nD modelling’ project at the University of Salford aims to support integrated design; to enable and equip the design and construction industry with a tool that allows users to create, share, contemplate and apply knowledge from multiple perspectives of user requirements (accessibility, maintainability, sustainability, acoustics, crime, energy simulation, scheduling, costing etc.). Thus taking the concept of 3-dimensional computer modelling of the built environment to an almost infinite number of dimensions, to cope with whole-life construction and asset management issues in the design of modern buildings. This paper reports on the development of a vision for how integrated environments that will allow nD-enabled construction and asset management to be undertaken. The project is funded by a four-year platform grant from the Engineering and Physical Sciences Research Council (EPSRC) in the UK; thus awarded to a multi-disciplinary research team, to enable flexibility in the research strategy and to produce leading innovation. This paper reports on the development of a business process and IT vision for how integrated environments will allow nD-enabled construction and asset management to be undertaken. It further develops many of the key issues of a future vision arising from previous CIB W78 conferences.

Information technology support to improved construction processes : inter-disciplinarity in research and practice

Research and innovation in the built environment is increasingly taking on an inter-disciplinary nature. The built environment industry and professional practice have long adopted multi and inter-disciplinary practices. The application of IT in Construction is moving beyond the automation and replication of discrete mono and multi-disciplinary tasks to replicate and model the improved inter-disciplinary processes of modern design and construction practice. A major long-term research project underway at the University of Salford seeks to develop IT modelling capability to support the design of buildings and facilities that are buildable, maintainable, operable, sustainable, accessible, and have properties of acoustic, thermal and business support performance that are of a high standard. Such an IT modelling tool has been the dream of the research community for a long time. Recent advances in technology are beginning to make such a modelling tool feasible.----- Some of the key problems with its further research and development, and with its ultimate implementation, will be the challenges of multiple research and built environment stakeholders sharing a common vision, language and sense of trust. This paper explores these challenges as a set of research issues that underpin the development of appropriate technology to support realisable advances in construction process improvements.

Stretching-induced orientation to improve mechanical properties of electrospun pan nanocomposites

Partially aligned and oriented polyacrylonitrile(PAN)-based nanofibers were electrospun from PAN and SWNTs/PAN in the solution of dimethylformamide(DMF) to make the carbon nanofibers. The as-spun nanofibers were hot-stretched in an oven to enhance its orientation and crystallinity. Then it were stabilized at 250 square under a stretched stress, and carbonized at 1000 square in N-2 atmosphere by fixing the length of the stabilized nanofiber to convert them into carbon nanofibers. With this hot-stretched process and with the introduction of SWNTs, the mechanical properties will be enhanced correspondingly. The crystallinity of the stretched fibers confirmed by X-ray diffraction has also increased. For PAN nanofibers, the improved fiber alignment and crystallinity resulted in the increased mechanical properties, such as the modulus and tensile strength of the nanofibers. It was concluded that the hot-stretched nanofiber and the SWNTs/PAN nanofibers can be used as a potential precursor to produce high-performance carbon composites.

Increasing relevance and interest : teaching environmental and planning law to built environment students

A new approach was taken to delivering a challenging "stewarship of land" unit to over 350 predominantly first year built environment students stewardship. The new approach involved incorporating environmental and planning law into the syllabus, exposing students to a wide range of statutes, selecting legal cases according to a et of criteria and revisiting the material using different modes of delivery and teaching resources. To evaluate the effectiveness of the new approach, the students were surveyed to elicit their learning experience and preferences. The survey found that most students perceived learning about environmental and planning law, including legal cases, worthwhile.----- Areas identified by the surcey for improvement included the perception by some students that: environmenatl and planning law is irrelevant to their discipline and future caree; studying law is dull and sometimes daunting; and the prescribed reading could be omitted.----- To address student perceptions, it is proposed to reorder the topics commencing with local, charismatic topics, while explanding international content and cases, to enlarge and enhance the repertoire of video clips to include sites of legal cawses and development projects, and to reformat the online weekly quizzes to promote reading of primary material.----- Overall, the approach to teaching environmental and planning law to built environment students, including the criteria for selecting legal cases, described in this paper, was found to be effective.

A generative design system based on evolutionary and mathematical functions

Previous work by Professor John Frazer on Evolutionary Architecture provides a basis for the development of a system evolving architectural envelopes in a generic and abstract manner. Recent research by the authors has focused on the implementation of a virtual environment for the automatic generation and exploration of complex forms and architectural envelopes based on solid modelling techniques and the integration of evolutionary algorithms, enhanced computational and mathematical models. Abstract data types are introduced for genotypes in a genetic algorithm order to develop complex models using generative and evolutionary computing techniques. Multi-objective optimisation techniques are employed for defining the fitness function in the evaluation process.

Gail Sorronda - New York, Paris, London, Sydney

QUT Fine Arts Fashion Design graduate Gail Reid is making a name for herself nationally and internationally. As one of the first QUT graduates to establish and sustain her own label, it begs the question how, why and what's next for her career aspirations.

Capturing Australian indigenous perception of virtual landscape

This short paper presents a means of capturing non spatial information (specifically understanding of places) for use in a Virtual Heritage application. This research is part of the Digital Songlines Project which is developing protocols, methodologies and a toolkit to facilitate the collection and sharing of Indigenous cultural heritage knowledge, using virtual reality. Within the context of this project most of the cultural activities relate to celebrating life and to the Australian Aboriginal people, land is the heart of life. Australian Indigenous art, stories, dances, songs and rituals celebrate country as its focus or basis. To the Aboriginal people the term “Country” means a lot more than a place or a nation, rather “Country” is a living entity with a past a present and a future; they talk about it in the same way as they talk about their mother. The landscape is seen to have a spiritual connection in a view seldom understood by non-indigenous persons; this paper introduces an attempt to understand such empathy and relationship and to reproduce it in a virtual environment.

Building a supportive environment for teaching and learning : a reflective commentary

Universities are increasingly caught in the transition between college institutions of independant academics to become managed businesses of research and teaching and learning. This is introducing substantial issues with the work, approach and personal development needs of individual academics. It is causing even greater concerns for managers within universities. The developments in University Management have increasingly become driven towards issues of finance, quality and marketing. Organizational development in teaching and learning practices has been less commonly a point of focus. This paper outlines developments of this nature at the University of Salford. Through its combination of authors it does so at whole University, Faculty and School levels. It outlines the variety of ways in which teaching and learning developments can be supported within an organisation.

Governance and effectiveness in regional planning: an analysis of North American, European, and Australasian practice

Over the past several years, there has been resurgent interest in regional planning in North America, Europe and Australasia. Spurred by issues such as metropolitan growth, transportation infrastructure, environmental management and economic development, many states and metropolitan regions are undertaking new planning initiatives. These regional efforts have also raised significant question about governance structures, accountability and measures of effectiveness.n this paper, the authors conducted an international review of ten case studies from the United States, Canada, England, Belgium, New Zealand and Australia to explore several critical questions. Using qualitative data template, the research team reviewed plans, documents, web sites and published literature to address three questions. First, what are the governance arrangements for delivering regional planning? Second, what are the mechanisms linking regional plans with state plans (when relevant) and local plans? Third, what means and mechanisms do these regional plans use to evaluate and measure effectiveness? The case study analysis revealed several common themes. First, there is an increasing focus on goverance at the regional level, which is being driven by a range of trends, including regional spatial development initiatives in Europe, regional transportation issues in the US, and the growth of metropolitan regions generally. However, there is considerable variation in how regional governance arrangements are being played out. Similarly, there is a range of processes being used at the regional level to guide planning that range from broad ranging (thick) processes to narrow and limited (thin) approaches. Finally, evaluation and monitoring of regional planning efforts are compiling data on inputs, processes, outputs and outcomes. Although there is increased attention being paid to indicators and monitoring, most of it falls into outcome evaluations such as Agenda 21 or sustainability reporting. Based on our review we suggest there is a need for increased attention on input, process and output indicators and clearer linkages of these indicators in monitoring and evaluation frameworks. The focus on outcome indicators, such as sustainability indicators, creates feedback systems that are too long-term and remote for effective monitoring and feedback. Although we found some examples of where these kinds of monitoring frameworks are linked into a system of governance, there is a need for clearer conceptual development for both theory and practice.

Creative Industries come to China (MATE)

This paper introduces the special issue “China: Internationalizing the Creative Industries”, describing the Australian Research Council funded “MATE” project which provides the conceptual background for the questions the issue explores. The MATE project began with the expectation that as China evolves from its status as a developing country with an emphasis on primary industries and manufacturing, to a mature, market-driven economy benefiting from high levels of international investment, it will become more actively engaged with the global “knowledge economy” and “information society”. In this context, developments in the “creative industries”, which are playing such an important role in developed economies, might reasonably be expected in China. Although China continues to be characterised by strong central-policy settings, as the domestic consumer market matures there is greater scope for consumer-led creative business development. The “MATE” project aimed to capture some of these changes as they began to gain momentum across a range of services: Media, Advertising, Tourism and Education. This special issue continues this theme with papers that explore the theoretical challenges, economic questions and implications, and practical instantiations of creative industries growth in China. All papers contained in this special issue have been peer-reviewed.