The Yonder project: Stories of impact, change, and capacity building through engagement in arts education

This thesis examined the long-term impact of the community arts education project Yonder, a collaboration between Education Queensland and Queensland Performing Arts Centre. The findings from the data reveal that the project was still having impact twelve months after its completion and that in some instances the project served as a 'circuit-breaker', especially for special needs students and struggling students. The intervention of a rich arts project proved to be an opportunity for these students to learn in a different way and to perceive themselves in a new and reinvented light. This confidence was found to transfer into other aspects of their learning.

Medical education and law: Withholding/withdrawing treatment from adults without capacity

BACKGROUND Law is increasingly involved in clinical practice, particularly at the end of life, but undergraduate and postgraduate education in this area remains unsystematic. We hypothesised that attitudes to and knowledge of the law governing withholding/withdrawing treatment from adults without capacity (the WWLST law) would vary and demonstrate deficiencies among medical specialists. AIMS We investigated perspectives, knowledge and training of medical specialists in the three largest (populations and medical workforces) Australian states, concerning the WWLST law. METHODS Following expert legal review, specialist focus groups, pre-testing and piloting in each state, seven specialties involved with end-of-life care were surveyed, with a variety of statistical analyses applied to the responses. RESULTS Respondents supported the need to know and follow the law. There were mixed views about its helpfulness in medical decision-making. Over half the respondents conceded poor knowledge of the law; this was mirrored by critical gaps in knowledge that varied by specialty. There were relatively low but increasing rates of education from the undergraduate to continuing professional development (CPD) stages. Mean knowledge score did not vary significantly according to undergraduate or immediate postgraduate training, but CPD training, particularly if recent, resulted in greater knowledge. Case-based workshops were the preferred CPD instruction method. CONCLUSIONS Teaching of current and evolving law should be strengthened across all stages of medical education. This should improve understanding of the role of law, ameliorate ambivalence towards the law, and contribute to more informed deliberation about end-of-life issues with patients and families.

The peer leader capacity building model: A student learning journey

The benefits of peer leader experiences in building graduate skills and capabilities, is well documented and recognised in the higher education sector (Ender & Kay, 2001; Lindsey, Weiler, Zarich, Haddock, Krafchick, & Zimmerman, 2014; Shook & Keup, J., 2012). While benefits are acknowledged, responsibility for identifying, structuring and recording the learning experiences and learning outcomes is charged to the student. This poster describes a framework ‘The Peer Leader Capacity Building Model’ that purposefully structures the peer-leader’s learning journey providing: timely training, moments of critical reflection and goal setting. The model articulates the fundamental interplay of learning and peer leader service which forms the peer ‘learnership’. The journey begins with the ‘aspiration’ phase where students come to understand their leadership opportunities, progressing through ‘enabling’ and ‘mastering’ phases where students shape their learner-leader experience, and finally, to the ‘contributing graduate’ phase where students emerge as competent graduates able to confidently participate in their communities and workplaces. In shifting from a program centric approach that priorities the needs of the mentees, the Peer Leader Capacity Building Model focuses on the individual as a peer leader encouraging the student to shape their individual ‘learnscape’ through consciously navigating both their curricula and co-curricular learning experiences.

Engaging a multiple-track approach to building capacity for 21st Century engineering, opportunities and challenges for rapid curriculum renewal

‘Complexity’ is a term that is increasingly prevalent in conversations about building capacity for 21st Century professional engineers. Society is grappling with the urgent and challenging reality of accommodating seven billion people, meeting needs and innovating lifestyle improvements in ways that do not destroy atmospheric, biological and oceanic systems critical to life. Over the last two decades in particular, engineering educators have been active in attempting to build capacity amongst professionals to deliver ‘sustainable development’ in this rapidly changing global context. However curriculum literature clearly points to a lack of significant progress, with efforts best described as ad hoc and highly varied. Given the limited timeframes for action to curb environmental degradation proposed by scientists and intergovernmental agencies, the authors of this paper propose it is imperative that curriculum renewal towards education for sustainable development proceeds rapidly, systemically, and in a transformational manner. Within this context, the paper discusses the need to consider a multiple track approach to building capacity for 21st Century engineering, including priorities and timeframes for undergraduate and postgraduate curriculum renewal. The paper begins with a contextual discussion of the term complexity and how it relates to life in the 21st Century. The authors then present a whole of system approach for planning and implementing rapid curriculum renewal that addresses the critical roles of several generations of engineering professionals over the next three decades. The paper concludes with observations regarding engaging with this approach in the context of emerging accreditation requirements and existing curriculum renewal frameworks.

Heat-producing element enrichment in granitic rocks, the role of crustal composition and evolution

This study greatly enhanced our knowledge of the potential for geothermal energy development in Queensland as a viable clean energy source in the coming decades. Key outcomes of the project were understanding the first-order controls on the concentration of the heat-producing elements: uranium, thorium and potassium in granitic rocks, and constraining where rocks with the greatest heat-producing potential lie at depth in Queensland. Importantly, new temperature and heat flow maps for southwest Queensland were developed that will greatly assist future exploration efforts.

National Profiles of In-Country Capacity to Support Disability-Inclusive Education; Fiji, Samoa, Soloman Islands and Vanuatu

This publication emanates from the four-country research project entitled “Strengthening capacity for disability-inclusive education development policy formulation, implementation and monitoring in the South Pacific region” funded by the Australian Development Research Award Scheme (ADRAS) and conducted jointly by the academic staff from the Queensland University of Technology and the University of the South Pacific.

Miami heat: Patent law, informed consent and benefit-sharing

This article considers whether the granting of patents in respect of biomedical genetic research should be conditional upon the informed consent of research participants. It focuses upon several case studies. In Moore v the Regents of the University Of California, a patient sued his physician for breach of fiduciary duty and lack of informed consent, because the doctor had obtained a patent on the patient's cell line, without the patient's authorisation. In Greenberg v Miami Children's Hospital, the research participants, the Greenbergs, the National Tay Sachs and Allied Diseases Association, and Dor Yeshorim brought a legal action against the geneticist Reubon Matalon and the Miami Children's Hospital over a patent obtained on a gene related to the Canavan disease and accompany genetic diagnostic test. PXE International entered into a joint venture with Charles Boyd and the University of Hawaii, and obtained a patent together for ‘methods for diagnosing Pseudoxanthoma elasticum’. In light of such case studies, it is contended that there is a need to reform patent law, so as to recognise the bioethical principles of informed consent and benefit-sharing. The 2005 UNESCO Declaration on Bioethics and Human Rights provides a model for future case law and policy-making.

Hampson type heat-exchanger technology and economic evaluation for LNG re- gasification and power generation At LNG receiving terminals

The system for high utilization of LNG cold energy is proposed by use of process simulator. The proposed design is a closed loop system, and composed by a Hampson type heat exchanger, turbines, pumps and advanced humid air turbine (AHAT) or Gas turbine combined cycle (GTCC). Its heat sources are Boil-off gas and cooling water for AHAT or GTCC. The higher cold exergy recovery to power can be about 38 to 56% as compared to the existing cold power generation of about 20% with a Rankine cycle of a single component. The advantage of the proposed system is to reduce the number of heat exchangers. Furthermore, the environmental impact is minimized because the proposed design is a closed loop system. A life cycle comparative cost is calculated to demonstrate feasibility of the proposed design. The development of the Hampson type exchangers is expected to meet the key functional requirements and will result in much higher LNG cold exergy recovery and the overall system performance i.e. re-gasification. Additionally, the proposed design is expected to provide flexibility to meet different gas pressure suited for the deregulation of energy system in Japan and higher reliability for an integrated boil-off gas system.

Assessing testamentary and decision-making capacity: Approaches and models

The need for better and more accurate assessments of testamentary and decision-making capacity grows as Australian society ages and incidences of mentally disabling conditions increase. Capacity is a legal determination, but one on which medical opinion is increasingly being sought. The difficulties inherent within capacity assessments are exacerbated by the ad hoc approaches adopted by legal and medical professionals based on individual knowledge and skill, as well as the numerous assessment paradigms that exist. This can negatively affect the quality of assessments, and results in confusion as to the best way to assess capacity. This article begins by assessing the nature of capacity. The most common general assessment models used in Australia are then discussed, as are the practical challenges associated with capacity assessment. The article concludes by suggesting a way forward to satisfactorily assess legal capacity given the significant ramifications of getting it wrong.

Assessing testamentary capacity – who does it better? Lawyers or doctors?

The effects of mentally disabling conditions on legal capacity are escalating, particularly given the ageing Australian demographic. Wills, enduring powers of attorney, and advance health directives are coming to the fore as a means of ensuring that the wishes of people with regard to their property, finances and health care needs are respected should they become legally incapable of making their own decisions. Assessing when a person has lost legal capacity in this context is an ever-increasing concern facing society as a whole but, in particular, the legal and medical professionals conducting the assessments. Empirical and doctrinal research has been undertaken which canvassed legal and medical opinions about the relationship between members of these professions when assessing legal capacity. This research supports the hypothesis that tensions exist when assessing capacity, especially testamentary capacity. One source of tension is the effect of conflicting evidence about the loss of legal capacity given by legal and medical professionals in court, which raises questions such as: which evidence is, and should be, preferred; and who should be responsible? The exploration of these issues will be conducted with reference to the empirical data collected, and a review of the relevant Australian case law.

Development of a new design expression for the in-plane shear capacity of the partially grouted concrete masonry walls

Partially grouted masonry walls subjected to in-plane shear exhibit a complex behaviour because of the influence of the aspect ratio, the pre-compression, the grouting pattern, the ratios of the horizontal and the vertical reinforcements, the boundary conditions and the characteristics of the constituent materials. The existing in-plane shear expressions for the partially grouted masonry are formulated as sum of strength of three parameters, namely, the masonry, the reinforcement and the axial force. The parameter ‘masonry’ includes the wall aspect ratio and the masonry compressive strength; the aspect ratio of the unreinforced panel inscribed into the grouted cores and bond beams are not considered, although failure is often dominated by these unreinforced masonry panels. This paper describes the dominance of these panels, particularly those that are squat, to the shear capacity of whole of shear walls. Further, the current design formulae are shown highly un-conservative by many researchers; this paper provides a potential reason for this un-conservativeness. It is shown that by including an additional term of the unreinforced panel aspect ratio a rational design formula could be established. This new expression is validated with independent test results reported in the literature – both Australian and overseas; the predictions are shown to be conservative.

Deathbed instructions and the assessment of capacity: A practical perspective

The assessment of capacity in the context of wills and advance care planning is a challenging task for modern practitioners with the increase in mentally disabling conditions, such as acquired brain injury. This challenge is only heightened in the situation where the assessment occurs at the client’s deathbed as there are the added elements of urgency, and emotional upheaval at the impending death of a loved one. This situation poses a minefield of problems a legal practitioner should be aware of, involving not only the assessment process but also potential professional liability issues. This presentation will address the practical considerations a legal professional should take into account when in this situation. We will focus on two discrete situations and the issues arising from them: first, where there has been an acquired brain injury and legal capacity is in question; and second, where a spinal injury has occurred which does not affect capacity, rather results in the inability to use conventional forms of communication to communicate his/her instructions. We will examine these case studies with a view to proposing a best practice model for legal practitioners when assessing capacity in this context.

Transition to an unsteady flow induced by a fin on the sidewall of a differentially heated air-filled square cavity and heat transfer

The transition from a steady to an unsteady flow induced by an adiabatic fin on the sidewall of a differentially heated air-filled cavity is numerically investigated. Numerical simulations have been performed over the range of Rayleigh numbers from Ra = 105–109. The temporal development and spatial structures of natural convection flows in the cavity with a fin are described. It has been demonstrated that the fin may induce the transition to an unsteady flow and the critical Rayleigh number for the occurrence of the transition is between 3.72 × 106 and 3.73 × 106. Furthermore, the peak frequencies of the oscillations triggered by different mechanisms are obtained through spectral analysis. It has been found that the flow rate through the cavity with a fin is larger than that without a fin under the unsteady flow, indicating that the fin may improve the unsteady flow in the cavity.

Narrow linewidth DFB waveguide laser fabricated via ultrafast laser inscription

Linewidth measurement of a femtosecond laser direct-written distributed feedback (DFB) waveguide laser (WGL) is reported. The WGL was fabricated in Yb-doped phosphate glass using the femtosecond laser direct-write technique. The linewidth was measured using a loss-compensated recirculating delayed self-heterodyne interferometer. By recirculating the output signal in a 10.2-km fiber delay loop, the linewidth was measured to be 35.4±1.4 kHz at a delay time of 306 μs , which is comparable with that of narrow-linewidth fiber DFB lasers.