Rodent Scope: A User-Configurable Digital Wireless Telemetry System for Freely Behaving Animals

This paper describes the design and implementation of a wireless neural telemetry system that enables new experimental paradigms, such as neural recordings during rodent navigation in large outdoor environments. RoSco, short for Rodent Scope, is a small lightweight user-configurable module suitable for digital wireless recording from freely behaving small animals. Due to the digital transmission technology, RoSco has advantages over most other wireless modules of noise immunity and online user-configurable settings. RoSco digitally transmits entire neural waveforms for 14 of 16 channels at 20 kHz with 8-bit encoding which are streamed to the PC as standard USB audio packets. Up to 31 RoSco wireless modules can coexist in the same environment on non-overlapping independent channels. The design has spatial diversity reception via two antennas, which makes wireless communication resilient to fading and obstacles. In comparison with most existing wireless systems, this system has online user-selectable independent gain control of each channel in 8 factors from 500 to 32,000 times, two selectable ground references from a subset of channels, selectable channel grounding to disable noisy electrodes, and selectable bandwidth suitable for action potentials (300 Hz–3 kHz) and low frequency field potentials (4 Hz–3 kHz). Indoor and outdoor recordings taken from freely behaving rodents are shown to be comparable to a commercial wired system in sorting for neural populations. The module has low input referred noise, battery life of 1.5 hours and transmission losses of 0.1% up to a range of 10 m.

Technique for evaluating photo sharing interfaces with the early prototypes - group simulation

User evaluations using paper prototypes commonly lack social context. The Group simulation technique described in this paper offers a solution to this problem. The study introduces an early-phase participatory design technique targeted for small groups. The proposed technique is used for evaluating an interface, which enables group work in photo collection creation. Three groups of four users, 12 in total, took part in a simulation session where they tested a low-fidelity design concept that included their own personal photo content from an event that their group attended together. The users’ own content was used to evoke natural experiences. Our results indicate that the technique helped users to naturally engage with the prototype in the session. The technique is suggested to be suitable for evaluating other early-phase concepts and to guide design solutions, especially with the concepts that include users’ personal content and enable content sharing.

Media innovations, user innovations, societal innovations

As the Journal of Media Innovations comes into existence, this article reflects on the first and most obvious question: just what do we mean by “media innovations”? Drawing on the examples of a range of recent innovations in media technologies and practices, initiated by a variety of media audiences, users, professionals, and providers, it explores the interplay between the different drivers of innovation and the effects of such innovation on the complex frameworks of contemporary society and the media ecology which supports it. In doing so, this article makes a number of key observations: first, it notes that media innovation is an innovation in media practices at least as much as in media technologies, and that changes to the practices of media both reflect and promote societal changes as well – media innovations are never just media technology innovations. Second, it shows that the continuing mediatisation of society, and the shift towards a more widespread participation of ordinary users as active content creators and media innovators, make it all the more important to investigate in detail these interlinked, incremental, everyday processes of media and societal change – media innovations are almost always also user innovations. Finally, it suggests that a full understanding of these processes as they unfold across diverse interleaved media spaces and complex societal structures necessarily requires a holistic perspective on media innovations, which considers the contemporary media ecology as a crucial constitutive element of societal structures and seeks to trace the repercussions of innovations across both media and society – media innovations are inextricably interlinked with societal innovations (even if, at times, they may not be considered to be improvements to the status quo).

Identifying the Events That Connect Social Media Users : Charting Follower Accession on Twitter

Twitter is the focus of much research attention, both in traditional academic circles and in commercial market and media research, as analytics give increasing insight into the performance of the platform in areas as diverse as political communication, crisis management, television audiencing and other industries. While methods for tracking Twitter keywords and hashtags have developed apace and are well documented, the make-up of the Twitter user base and its evolution over time have been less understood to date. Recent research efforts have taken advantage of functionality provided by Twitter's Application Programming Interface to develop methodologies to extract information that allows us to understand the growth of Twitter, its geographic spread and the processes by which particular Twitter users have attracted followers. From politicians to sporting teams, and from YouTube personalities to reality television stars, this technique enables us to gain an understanding of what prompts users to follow others on Twitter. This article outlines how we came upon this approach, describes the method we adopted to produce accession graphs and discusses their use in Twitter research. It also addresses the wider ethical implications of social network analytics, particularly in the context of a detailed study of the Twitter user base.

Does counting still count? Revisiting the security of counting based user authentication protocols against statistical attacks

At NDSS 2012, Yan et al. analyzed the security of several challenge-response type user authentication protocols against passive observers, and proposed a generic counting based statistical attack to recover the secret of some counting based protocols given a number of observed authentication sessions. Roughly speaking, the attack is based on the fact that secret (pass) objects appear in challenges with a different probability from non-secret (decoy) objects when the responses are taken into account. Although they mentioned that a protocol susceptible to this attack should minimize this difference, they did not give details as to how this can be achieved barring a few suggestions. In this paper, we attempt to fill this gap by generalizing the attack with a much more comprehensive theoretical analysis. Our treatment is more quantitative which enables us to describe a method to theoretically estimate a lower bound on the number of sessions a protocol can be safely used against the attack. Our results include 1) two proposed fixes to make counting protocols practically safe against the attack at the cost of usability, 2) the observation that the attack can be used on non-counting based protocols too as long as challenge generation is contrived, 3) and two main design principles for user authentication protocols which can be considered as extensions of the principles from Yan et al. This detailed theoretical treatment can be used as a guideline during the design of counting based protocols to determine their susceptibility to this attack. The Foxtail protocol, one of the protocols analyzed by Yan et al., is used as a representative to illustrate our theoretical and experimental results.

Geometric sensitivity of patient-specific finite element models of the spine to variability in user-selected anatomical landmarks

Software to create individualised finite element (FE) models of the osseoligamentous spine using pre-operative computed tomography (CT) data-sets for spinal surgery patients has recently been developed. This study presents a geometric sensitivity analysis of this software to assess the effect of intra-observer variability in user-selected anatomical landmarks. User-selected landmarks on the osseous anatomy were defined from CT data-sets for three scoliosis patients and these landmarks were used to reconstruct patient-specific anatomy of the spine and ribcage using parametric descriptions. The intra-observer errors in landmark co-ordinates for these anatomical landmarks were calculated. FE models of the spine and ribcage were created using the reconstructed anatomy for each patient and these models were analysed for a loadcase simulating clinical flexibility assessment. The intra-observer error in the anatomical measurements was low in comparison to the initial dimensions, with the exception of the angular measurements for disc wedge and zygapophyseal joint (z-joint) orientation and disc height. This variability suggested that CT resolution may influence such angular measurements, particularly for small anatomical features, such as the z-joints, and may also affect disc height. The results of the FE analysis showed low variation in the model predictions for spinal curvature with the mean intra-observer variability substantially less than the accepted error in clinical measurement. These findings demonstrate that intra-observer variability in landmark point selection has minimal effect on the subsequent FE predictions for a clinical loadcase.

From impact assessment to user-friendly risk management decision-making

In earlier cultures and societies, hazards and risks to human health were dealt with by methods derived from myth, metaphor and ritual. In modem society however, notions of hazard and risk have been transformed from the level of a folk discourse to that of an expert centred concept (Plough & Krimsky, 1987). With the professionalization of risk and hazard analysis came a preferred framework for decision making based on a range of 'technical' methodologies (Giere, 1991 ). This is especially true for decision processes relating to risk assessment and management, and impact assessment. Such approaches however, often entail narrow technical-based theoretical assumptions about human behaviour and the natural world, and the· methods used. They therefore carry 'in-built' error factors that contribute considerable uncertainty to the results.

Histories of user-generated content : between formal and informal media economies

Debates about user-generated content (UGC) often depend on a contrast with its normative opposite, the professionally produced content that is supported and sustained by commercial media businesses or public organisations. UGC is seen to appear within or in opposition to professional media, often as a disruptive, creative, change-making force. Our suggestion is to position UGC not in opposition to professional or "producer media", or in hybridised forms of subjective combination with it (the so-called "pro-sumer" or "pro-am" system), but in relation to different criteria, namely the formal and informal elements in media industries. In this article, we set out a framework for the comparative and historical analysis of UGC systems and their relations with other formal and informal media activity, illustrated with examples ranging from games to talkback radio. We also consider the policy implications that emerge from a historicised reading of UGC as a recurring dynamic within media industries, rather than a manifestation of consumer agency specific to digital cultures.

Evaluating the use of a very large-scale presentation and collaboration framework

In this paper we describe the use and evaluation of CubIT, a multi-user, very large-scale presentation and collaboration framework. CubIT is installed at the Queensland University of Technology’s (QUT) Cube facility. The “Cube” is an interactive visualisation facility made up of five very large-scale interactive multi-panel wall displays, each consisting of up to twelve 55-inch multi-touch screens (48 screens in total) and massive projected display screens situated above the display panels. The paper outlines the unique design challenges, features, use and evaluation of CubIT. The system was built to make the Cube facility accessible to QUT’s academic and student population. CubIT enables users to easily upload and share their own media content, and allows multiple users to simultaneously interact with the Cube’s wall displays. The features of CubIT are implemented via three user interfaces, a multi-touch interface working on the wall displays, a mobile phone and tablet application and a web-based content management system. The evaluation reveals issues around the public use and functional scope of the system.

Analysis of the NF-κB p50 dimer interface by diversity screening

An in vivo screen has been devised for NF-κB p50 activity in Escherichia coli exploiting the ability of the mammalian transcription factor to emulate a prokaryotic repressor. Active intracellular p50 was shown to repress the expression of a green fluorescent protein reporter gene allowing for visual screening of colonies expressing active p50 on agar plates. A library of mutants was constructed in which the residues Y267, L269, A308 and V310 of the dimer interface were simultaneously randomised and twenty-five novel functional interfaces were selected which repressed the reporter gene to similar levels as the wild-type protein. The leucine-269 alanine-308 core was repeatedly, but not exclusively, selected from the library whilst a diversity of predominantly non-polar residues were selected at positions 267 and 310. These results indicate that L269 and A308 may form a hot spot of interaction and allow an insight into the processes of dimer selectivity and evolution within this family of transcription factors.

Aspect-based model of user experience

Traditional HCI design and evaluation methods merely focus on functional and usability aspects of a product. Although these aspects are important, they do not guarantee product’s success, especially the consumer product. Many consumer products are now part of user’s everyday activities – that support fun, pleasure, entertainment, etc. Secondly, in today’s consumer market many of the products have become similar in terms of their technology, functionality, price and quality. In response, many companies have started designing products with added emotional and experiential values. This has challenged designer’s to explore and visualize directions in product design field that could evoke intended and desired experiences amongst its users. Subjective product qualities such as fun, pleasure, entertainment, etc. are not the part of a product, but they are better thought of as the outcome of user’s interaction with the product...

Measuring Online user engagement : the limitations of Web analytics

The ability to identify and assess user engagement with transmedia productions is vital to the success of individual projects and the sustainability of this mode of media production as a whole. It is essential that industry players have access to tools and methodologies that offer the most complete and accurate picture of how audiences/users engage with their productions and which assets generate the most valuable returns of investment. Drawing upon research conducted with Hoodlum Entertainment, a Brisbane-based transmedia producer, this chapter outlines an initial assessment of the way engagement tends to be understood, why standard web analytics tools are ill-suited to measuring it, how a customised tool could offer solutions, and why this question of measuring engagement is so vital to the future of transmedia as a sustainable industry.

Design of a robust grid interface system for PMSG-based wind turbine generators

A robust and reliable grid power interface system for wind turbines using a permanent-magnet synchronous generator (PMSG) is proposed in this paper, where an integration of a generator-side three-switch buck-type rectifier and a grid-side Z-source inverter is employed as a bridge between the generator and the grid. The modulation strategy for the proposed topology is developed from space-vector modulation and Z-source network operation principles. Two PMSG control methods, namely, unity-power-factor control and rotor-flux-orientation control (Id = 0), are studied to establish an optimized control scheme for the generator-side three-switch buck-type rectifier. The system control scheme decouples active- and reactive-power control through voltage-oriented control and optimizes PMSG control for the grid- and generator-side converters independently. Maximum power point tracking is implemented by adjusting the shoot-through duty cycles of the Z-source network. The design considerations of the passive components are also provided. The performances and practicalities of the designed architecture have been verified by simulations and experiments.

Improvement of a dynamic accumulator at ICICS 07 and its application in multi-user keyword-based retrieval on encrypted data

A dynamic accumulator is an algorithm, which merges a large set of elements into a constant-size value such that for an element accumulated, there is a witness confirming that the element was included into the value, with a property that accumulated elements can be dynamically added and deleted into/from the original set. Recently Wang et al. presented a dynamic accumulator for batch updates at ICICS 2007. However, their construction suffers from two serious problems. We analyze them and propose a way to repair their scheme. We use the accumulator to construct a new scheme for common secure indices with conjunctive keyword-based retrieval.