Everyone's problem but nobody's job : staff perceptions and explanations for poor nutritional intake in older medical patients

Aim: Up to 60% of older medical patients are malnourished with further decline during hospital stay. There is limited evidence for effective nutrition intervention. Staff focus groups were conducted to improve understanding of potential contextual and cultural barriers to feeding older adults in hospital. Methods: Three focus groups involved 22 staff working on the acute medical wards of a large tertiary teaching hospital. Staff disciplines were nursing, dietetics, speech pathology, occupational therapy, physiotherapy, pharmacy. A semistructured topic guide was used by the same facilitator to prompt discussions on hospital nutrition care including barriers. Focus groups were tape-recorded, transcribed and analysed thematically. Results: All staff recognised malnutrition to be an important problem in older patients during hospital stay and identified patient-level barriers to nutrition care such as non-compliance to feeding plans and hospital-level barriers including nursing staff shortages. Differences between disciplines revealed a lack of a coordinated approach, including poor knowledge of nutrition care processes, poor interdisciplinary communication, and a lack of a sense of shared responsibility/coordinated approach to nutrition care. All staff talked about competing activities at meal times and felt disempowered to prioritise nutrition in the acute medical setting. Staff agreed education and ‘extra hands’ would address most barriers but did not consider organisational change. Conclusions: Redesigning the model of care to reprioritise meal-time activities and redefine multidisciplinary roles and responsibilities would support coordinated nutrition care. However, effectiveness may also depend on hospitalwide leadership and support to empower staff and increase accountability within a team-led approach.

Negative change and job outcomes : the impact of subjective fit in public sector health care organization

There is an ongoing level of organizational-wide change (such as empowerment and downsizing) occurring within the Australian health care sector. However, there is a paucity of empirical evidence on how public and nonprofit sector nurses cope with these organizational-wide change initiatives and their consequences on individual and work outcomes. This will be the primary aim of the current paper. To this end, a path model is developed base on an integration of existing theoretical perspectives on occupational stress, change management, and person-organizational fit. Data were collected from 252 public and not-for-profit sector nurses. The path analysis suggests that public and nonprofit nurses experience positive and negative change initiatives. Negative change initiatives resulted in an increase in the level of administrative-related stressors. Nurses with more congruent values report less experience with administrative stressors. As nurses experienced more administrative stressors, they tend to report more job dissatisfaction. Nurses whose values were more congruent during organizational change reported higher level of psychological wellbeing. Nurses who were had higher level of psychological wellbeing were found to have higher job satisfaction, which subsequently led to a higher level of organizational commitment.

A common neighbour based two-way collaborative recommendation method

Traditional recommendation methods offer items, that are inanimate and one way recommendation, to users. Emerging new applications such as online dating or job recruitments require reciprocal people-to-people recommendations that are animate and two-way recommendations. In this paper, we propose a reciprocal collaborative method based on the concepts of users' similarities and common neighbors. The dataset employed for the experiment is gathered from a real life online dating network. The proposed method is compared with baseline methods that use traditional collaborative algorithms. Results show the proposed method can achieve noticeably better performance than the baseline methods.

Examination of relationships and mediating effects of self-efficacy, locus of control, coping and the practice environment on caring efficacy and job satisfaction in Australian registered nurses

Background to the Problem: Improving nurses' self-efficacy and job satisfaction may improve the quality of nursing care to patients. Moreover, to work effectively and consistently with professional nursing standards, nurses have to believe they are able to make decisions about their practice. In order to identify what strategies and professional development programmes should be developed and implemented for registered nurses in the Australian context, a comprehensive profile of registered nurses and factors that affect nursing care in Australia needs to be available. However, at present, there is limited information available on a) the perceived caring efficacy and job satisfaction of registered nurses in Australia, and b) the relationships between the demographic variables general self-efficacy, work locus of control, coping styles, the professional nursing practice environment and caring efficacy and job satisfaction of registered nurses in Australia. This is the first study to 1) investigate relationships between caring efficacy and job satisfaction with factors such as general self-efficacy, locus of control and coping, 2) the nursing practice environment in the Australian context and 3) conceptualise a model of caring efficacy and job satisfaction in the Australian context. Research Design and Methods: This study used a two-phase cross-sectional survey design. A pilot study was conducted in order to determine the validity and reliability of the survey instruments and to assess the effectiveness of the participant recruitment process. The second study of the research involved investigating the relationships between the socio-demographic, dependent and independent variables. Socio-demographic variables included age, gender, level of education, years of experience, years in current job, employment status, geographical location, specialty area, health sector, state and marital status. Other independent variables in this study included general self-efficacy, work locus of control, coping styles and the professional nursing practice environment. The dependent variables were job satisfaction and caring efficacy. Results: A confirmatory factor analysis of the Brisbane Practice Environment Measure (B-PEM) was conducted. A five-factor structure of the B-PEM was confirmed. Relationships between socio-demographic variables, caring efficacy and job satisfaction, were identified at the bivariate and multivariable levels. Further, examination using structural equation modelling revealed general self-efficacy, work locus of control, coping style and the professional nursing practice environment contributed to caring efficacy and job satisfaction of registered nurses in Australia. Conclusion: This research contributes to the literature on how socio-demographic, personal and environmental variables (work locus of control, general self-efficacy and the nursing practice environment) influence caring efficacy and job satisfaction in registered nurses in Australia. Caring efficacy and job satisfaction may be improved if general self-efficacy is high in those that have an internal work locus of control. The study has also shown that practice environments that provide the necessary resources improve job satisfaction in nurses. The results have identified that the development and implementation of strategies for professional development and orientation programmes that enhance self-efficacy and work locus of control may contribute to better quality nursing practice and job satisfaction. This may further assist registered nurses towards focusing on improving their practice abilities. These strategies along with practice environments that provide the necessary resources for nurses to practice effectively may lead to better job satisfaction. This information is important for nursing leaders, healthcare organisations and policymakers, as the development and implementation of these strategies may lead to better recruitment and retention of nurses. The study results will contribute to the national and international literature on self-efficacy, job satisfaction and nursing practice.

Assessing of circuit breaker restrike risks using computer simulation and wavelet analysis

A breaker restrike is an abnormal arcing phenomenon, leading to a possible breaker failure. Eventually, this failure leads to interruption of the transmission and distribution of the electricity supply system until the breaker is replaced. Before 2008, there was little evidence in the literature of monitoring techniques based on restrike measurement and interpretation produced during switching of capacitor banks and shunt reactor banks in power systems. In 2008 a non-intrusive radiometric restrike measurement method and a restrike hardware detection algorithm were developed by M.S. Ramli and B. Kasztenny. However, the limitations of the radiometric measurement method are a band limited frequency response as well as limitations in amplitude determination. Current restrike detection methods and algorithms require the use of wide bandwidth current transformers and high voltage dividers. A restrike switch model using Alternative Transient Program (ATP) and Wavelet Transforms which support diagnostics are proposed. Restrike phenomena become a new diagnostic process using measurements, ATP and Wavelet Transforms for online interrupter monitoring. This research project investigates the restrike switch model Parameter „A. dielectric voltage gradient related to a normal and slowed case of the contact opening velocity and the escalation voltages, which can be used as a diagnostic tool for a vacuum circuit-breaker (CB) at service voltages between 11 kV and 63 kV. During current interruption of an inductive load at current quenching or chopping, a transient voltage is developed across the contact gap. The dielectric strength of the gap should rise to a point to withstand this transient voltage. If it does not, the gap will flash over, resulting in a restrike. A straight line is fitted through the voltage points at flashover of the contact gap. This is the point at which the gap voltage has reached a value that exceeds the dielectric strength of the gap. This research shows that a change in opening contact velocity of the vacuum CB produces a corresponding change in the slope of the gap escalation voltage envelope. To investigate the diagnostic process, an ATP restrike switch model was modified with contact opening velocity computation for restrike waveform signature analyses along with experimental investigations. This also enhanced a mathematical CB model with the empirical dielectric model for SF6 (sulphur hexa-fluoride) CBs at service voltages above 63 kV and a generalised dielectric curve model for 12 kV CBs. A CB restrike can be predicted if there is a similar type of restrike waveform signatures for measured and simulated waveforms. The restrike switch model applications are used for: computer simulations as virtual experiments, including predicting breaker restrikes; estimating the interrupter remaining life of SF6 puffer CBs; checking system stresses; assessing point-on-wave (POW) operations; and for a restrike detection algorithm development using Wavelet Transforms. A simulated high frequency nozzle current magnitude was applied to an Equation (derived from the literature) which can calculate the life extension of the interrupter of a SF6 high voltage CB. The restrike waveform signatures for a medium and high voltage CB identify its possible failure mechanism such as delayed opening, degraded dielectric strength and improper contact travel. The simulated and measured restrike waveform signatures are analysed using Matlab software for automatic detection. Experimental investigation of a 12 kV vacuum CB diagnostic was carried out for the parameter determination and a passive antenna calibration was also successfully developed with applications for field implementation. The degradation features were also evaluated with a predictive interpretation technique from the experiments, and the subsequent simulation indicates that the drop in voltage related to the slow opening velocity mechanism measurement to give a degree of contact degradation. A predictive interpretation technique is a computer modeling for assessing switching device performance, which allows one to vary a single parameter at a time; this is often difficult to do experimentally because of the variable contact opening velocity. The significance of this thesis outcome is that it is a non-intrusive method developed using measurements, ATP and Wavelet Transforms to predict and interpret a breaker restrike risk. The measurements on high voltage circuit-breakers can identify degradation that can interrupt the distribution and transmission of an electricity supply system. It is hoped that the techniques for the monitoring of restrike phenomena developed by this research will form part of a diagnostic process that will be valuable for detecting breaker stresses relating to the interrupter lifetime. Suggestions for future research, including a field implementation proposal to validate the restrike switch model for ATP system studies and the hot dielectric strength curve model for SF6 CBs, are given in Appendix A.

A computer model to simulate scoliosis surgery

Use of patient-specific computer models as a pre-operative planning tool permits predictions of the likely deformity correction and allows a more detailed investigation of the biomechanical influence of different surgical procedures on the scoliotic spinal anatomy. In this paper, patient-specific computer models are used of adolescent idiopathic scoliosis patients who underwent a single rod anterior procedure at the Mater Children’s Hospital in Brisbane, to predict deformity correction and to investigate the change in biomechanics of the scoliotic spine due to surgical compressive forces applied during implant placement.

Assessing occupational stress in psychiatric nurses using the full job strain model the value of social support to nurses

The present research examined the effects of occupational stress in psychiatric nursing on employee well!being using the full Job Strain Model.The Job Strain Model was assessed for its ability to predict employee well!being in terms of job satisfaction and mental health. The original Job Strain Model was expanded to include social support based on previous research concerning the impact of social support on well!being[ In the present study\ both work support and non-work were assessed for their contribution to wellbeing.The results of this study indicate that the full Job Strain Model can be used to significantly predict job satisfaction and mental health in this sample of Australian psychiatric nurses. Furthermore social support was shown to be an important component of the Job Strain Model.

Examination of socio-demographics and job satisfaction in Australian registered nurses

Aims and Objectives To examine relationships between socio-demographic factors and job satisfaction and to identify if these factors predict job satisfaction levels in an Australian registered nurses. Background Reports indicate that in Australia there are 30,000 qualified nurses no longer working in the healthcare and that current nursing shortages vary as a result of certain socio-demographic variables including type of nurse, geographic, location, sector, service and organisation. Furthermore it has been revealed that there is not only a real shortage but also a pseudo-shortage (i.e. either there are not enough nurses are available, or not enough are willing to work under existing workplace conditions). International studies have found significant relationships exist between some socio-demographic factors and job satisfaction in registered nurses however there is limited information available on relationships between socio-demographic factors and job satisfaction in nurses in the Australian context. Design A cross sectional survey was undertaken of Australian registered nurses. Methods Two thousand Australian registered nurses who were members of an industrial and professional organisation were sent the questionnaire in 2008. They were stratified and randomised according to gender. Six hundred and thirty-nine registered nurses responded. Descriptive analyses, correlation analyses, one- way ANOVA tests, simple linear regression and multivariable analyses were conducted to examine further if any relationships existed between the variables. Results The majority of respondents showed positive job satisfaction scores. An ANOVA found significant positive relationships existed between job satisfaction, specialty area, health sector and Australian states. Multivariable analyses found relationships existed between specialty area, health sector, and job satisfaction. Conclusions The variables specialty area and health sector were found to be significantly associated with job satisfaction. The different specialty areas and health sectors in relation to job satisfaction should be investigated further. Clinical Relevance The study results have provided new knowledge for policy makers, organisational and nursing leaders of the socio-demographic variables that may affect job satisfaction in registered nurses in the Australian context.

Researching doctoral pedagogy close up : design and action in two doctoral programs

With growing international interest in diversifying sites for pedagogical work within the doctorate, doctoral programs of different kinds are being developed in different disciplinary, institutional and national settings. However, little is known about how the pedagogical work of these programs is designed and enacted, and with what effects. In this paper, we present two cases of doctoral pedagogical work being undertaken within different disciplinary and institutional settings to describe how learning opportunities were designed and to theorise what it means to be engaged in doing doctoral pedagogy. Starting from the position that working from a design model supports systematic and rigorous documentation and development of pedagogy, we employ the twin concepts of design and action, drawing broadly on rhetorical and ethnomethodological understandings of pedagogy as social action. Of particular interest within the concept of design itself is the concept of enactment, the translation of designs into the practices of doctoral work. Together, the two cases become a resource for ‘slowing down’ and making visible the practices of doctoral pedagogy that often go unrecognised because they appear so ordinary and everyday. This call for examining close-up existing doctoral education practices and relationships is attending to the ‘next challenge for doctoral education’ (Green, 2009).

A method for measuring the creative potential of computer games

This paper describes a method for measuring the creative potential of computer games. The research approach applies a behavioral and verbal protocol to analyze the factors that influence the creative processes used by people as they play computer games from the puzzle genre. Creative potential is measured by examining task motivation and domain-relevant and creativity-relevant skills. This paper focuses on the reliability of the factors used for measurement, determining those factors that are more strongly related to creativity. The findings show that creative potential may be determined by examining the relationship between skills required and the effect of intrinsic motivation within game play activities.

Articulation in property programs : an international multi-campus tertiary model

This paper will present program developers and institutional administrators with a program delivery model suitable for cross cultural international delivery developing students from industry through to master’s level tertiary qualifications. The model was designed to meet the needs of property professionals from an industry where technical qualifications are the norm and tertiary qualifications are emerging. A further need was to develop and deliver a program that enhanced the University’s current program profile in both the domestic and international arenas. Early identification of international educational partners, industry need and the ability to service the program were vital to the successful development of Master of Property program. The educational foundations of the program rest in educational partners, local tutorial support, international course management, cultural awareness of and in content, online communication fora, with a delivery focus on problem-based learning, self-directed study, teamwork and the development of a global understanding and awareness of the international property markets. In enrolling students from a diverse cultural background with technical qualifications and/or extensive work experience there are a number of educational barriers to be overcome for all students to successfully progress and complete the program. These barriers disappear when the following mechanisms are employed: individual student pathways, tutorial support by qualified peers, enculturation into tertiary practice, assessment tasks that recognise cultural norms and values, and finally that value is placed on the experiential knowledge, cultural practices and belief systems of the students.