Distribution feeder loads classification and decomposition

Load in distribution networks is normally measured at the 11kV supply points; little or no information is known about the type of customers and their contributions to the load. This paper proposes statistical methods to decompose an unknown distribution feeder load to its customer load sector/subsector profiles. The approach used in this paper should assist electricity suppliers in economic load management, strategic planning and future network reinforcements.

Long term transmission planning to meet renewable energy targets in Australia

Australia is rich in renewable energy resources such as wind, solar and geothermal. Geographical diversity of these renewable resources combined with developing climate change policies poses a great challenge for the long term interconnection planning. Intermittency of wind and solar potentially driving the development of new transmission lines bring additional complexity to power system operations and planning. This paper provides an overview of generation and transmission planning studies in Australia to meet 20% renewable energy target by 2020. Appraisal of the effectiveness of dispersed energy storage, non schedulable peaking plants, wide area controls and demand management techniques to aid the penetration of renewables is presented in this paper

Probability analysis of machine angle stability with non-gaussian wind power input

The security of power transfer across a given transmission link is typically a steady state assessment. This paper develops tools to assess machine angle stability as affected by a combination of faults and uncertainty of wind power using probability analysis. The paper elaborates on the development of the theoretical assessment tool and demonstrates its efficacy using single machine infinite bus system.

Collaborative efforts to enhance power engineering education in Australia

A review of the issues for supporting learning of power engineering in Australia is presented in this paper. The learning needs of students and the support available in blended learning and through distance educations are explored in this review. Specific software tools to assist the learning environment are appraised and the relevance for the next generation of power engineers assessed.

Rat meets iRat

Biorobotics has the potential to provide an integrated understanding from neural systems to behavior that is neither ethical nor technically feasible with living systems. Robots that can interact with animals in their natural environment open new possibilities for empirical studies in neuroscience. However, designing a robot that can interact with a rodent requires considerations that span a range of disciplines. For the rat's safety, the body form and movements of the robot need to take into consideration the safety of the animal, an appropriate size for the rodent arenas, and behaviors for interaction. For the robot's safety, its form must be robust in the face of typically inquisitive and potentially aggressive behaviors by the rodent, which can include chewing on exposed parts, including electronics, and deliberate or accidental fouling. We designed a rat-sized robot, the iRat (intelligent rat animat technology) for studies in neuroscience. The iRat is about the same size as a rat and has the ability to navigate autonomously around small environments. In this study we report the first interactions between the iRat and real rodents in a free exploration task. Studies with five rats show that the rats and iRat interact safely for both parties.

Coring and augering

This chapter introduces the principles of coring, including the objectives for taking a good core and the major factors that should be considered to ensure the collection of non disturbed, representative core samples. The chapter also provides an overview of the design, function, and operation of the main types of coring equipment that can be used to sample sediments from a variety of settings including lakes, the ocean, peat bogs, soils, and permafrost. The major advantages and disadvantages of each type of corer are also discussed.

Automated marine mammal detection from aerial imagery

This paper presents two algorithms to automate the detection of marine species in aerial imagery. An algorithm from an initial pilot study is presented in which morphology operations and colour analysis formed the basis of its working principle. A second approach is presented in which saturation channel and histogram-based shape profiling were used. We report on performance for both algorithms using datasets collected from an unmanned aerial system at an altitude of 1000 ft. Early results have demonstrated recall values of 48.57% and 51.4%, and precision values of 4.01% and 4.97%.

Understanding requirements of novel healthcare information systems for management of advanced prostate cancer

Effective management of chronic diseases is a global health priority. A healthcare information system offers opportunities to address challenges of chronic disease management. However, the requirements of health information systems are often not well understood. The accuracy of requirements has a direct impact on the successful design and implementation of a health information system. Our research describes methods used to understand the requirements of health information systems for advanced prostate cancer management. The research conducted a survey to identify heterogeneous sources of clinical records. Our research showed that the General Practitioner was the common source of patient's clinical records (41%) followed by the Urologist (14%) and other clinicians (14%). Our research describes a method to identify diverse data sources and proposes a novel patient journey browser prototype that integrates disparate data sources.

Simulation of Au particle interaction on graphene sheets

The interaction of Au particles with few layer graphene is of interest for the formation of the next generation of sensing devices(1). In this paper we investigate the coupling of single gold nanoparticles to a graphene sheet, and multiple gold nanoparticles with a graphene sheet using COMSOL Multiphysics. By using these simulations we are able to determine the electric field strength and associated hot-spots for various gold nanoparticle-graphene systems. The Au nanoparticles were modelled as 8 nm diameter spheres on 1.5 nm thick (5 layers) graphene, with properties of graphene obtained from the refractive index data of Weber(2) and the Au refractive index data from Palik(3). The field was incident along the plane of the sheet with polarisation tested for both s and p. The study showed strong localised interaction between the Au and graphene with limited spread; however the double particle case where the graphene sheet separated two Au nanoparticles showed distinct interaction between the particles and graphene. An offset was introduced (up to 4 nm) resulting in much reduced coupling between the opposed particles as the distance apart increased. Findings currently suggest that the graphene layer has limited interaction with incident fields with a single particle present whilst reducing the coupling region to a very fine area when opposing particles are involved. It is hoped that the results of this research will provide insight into graphene-plasmon interactions and spur the development of the next generation of sensing devices.

Modelling of ellipsoidal nanowires : control and application

The properties of ellipsoidal nanowires are yet to be examined. They have likely applications in sensing, solar cells, microelectronics and cloaking devices. Little is known of the qualities that ellipse nanowires exhibit as we vary the aspect ratio with different dielectric materials and how varying these attributes affects plasmon coupling and propagation. It is known that the distance a plasmon can travel is further if it is supported by a thicker circular nanowire, while thinner nanowires are expected to be able to increase QD coupling. Ellipsoidal nanowires may be a good compromise due to their ability to have both thin and thick dimensions. Furthermore it has been shown that the plasmon resonances along the main axis of an ellipsoidal particle is governed by the relative aspect ratio of the ellipsoid, which may lead to further control of the plasmon. Research was done by the use of COMSOL Multiphysics by looking at the fundamental plasmon mode supported by an ellipsoidal nanowire and then studying this mode for various geometrical parameters, materials and illumination wavelength. Accordingly it was found that ellipsoidal nanowires exhibit a minimum for the wavenumber and a maximum for the propagation distance at roughly the same dimensions - Highlighting that there is an aspect ratio for which there is poor coupling but low loss. Here we investigate these and related attributes.

Persistent robot tasking for environmental monitoring through crowd-sourcing

Persistent monitoring of the ocean is not optimally accomplished by repeatedly executing a fixed path in a fixed location. The ocean is dynamic, and so should the executed paths to monitor and observe it. An open question merging autonomy and optimal sampling is how and when to alter a path/decision, yet achieve desired science objectives. Additionally, many marine robotic deployments can last multiple weeks to months; making it very difficult for individuals to continuously monitor and retask them as needed. This problem becomes increasingly more complex when multiple platforms are operating simultaneously. There is a need for monitoring and adaptation of the robotic fleet via teams of scientists working in shifts; crowds are ideal for this task. In this paper, we present a novel application of crowd-sourcing to extend the autonomy of persistent-monitoring vehicles to enable nonrepetitious sampling over long periods of time. We present a framework that enables the control of a marine robot by anybody with an internet-enabled device. Voters are provided current vehicle location, gathered science data and predicted ocean features through the associated decision support system. Results are included from a simulated implementation of our system on a Wave Glider operating in Monterey Bay with the science objective to maximize the sum of observed nitrate values collected.

The Watermemories Swimming Club

This pilot project aimed to try something different - rekindle positive memories of swimming in people with dementia who enjoyed swimming throughout their lives, and involve them in active swimming again using a swimming club intervention. Club members were recruited from two residential aged care facilities in Queensland, Australia (n=25 recruited, n=18 commenced, n=11 (median age=88.4, IQR=12.3; 1 male) completed the intervention). The 12 week program consisted of two, 45 minute sessions per week held at a municipal pool, using a trained instructor and assistants. Measures, taken at baseline, Week 6, Week 9 and post intervention included psychosocial and physical assessments such as the Revised Memory and Behavior Problems Checklist, Psychological Well-Being in Cognitively Impaired Persons, Seniors Physical Performance Battery and bioelectric impedance analysis. Stakeholder focus groups determined the barriers and facilitators for the club. Three outcomes have been achieved: 1) the development of a dementia specific, evidence-based, aquatic exercise program. This valuable resource will ensure that the benefits will be maximized with tailored exercises for strength, agility, flexibility, balance, relaxation and stress reduction, 2) improved quality of life for members, with statistically significant improvements in psychological wellbeing (χ2 =8.66, p<0.05), BPSD expression (χ2=16.91, p=0.001) and staff distress (χ2=16.86, p=0.001) and 3) an informative website with instructional video clips and a manual to assist others in implementing and maintaining a Watermemories Swimming Club. This pilot project has provided strong evidence that aquatic exercise can produce positive physical, psychosocial and behavioral outcomes for people with dementia.

Applying the ecological model of behavior change to a physical activity trial in retirement communities : description of the study protocol

Objectives To describe the intervention protocol for the first multilevel ecological intervention for physical activity in retirement communities that addresses individual, interpersonal and community influences on behavior change. Design A cluster randomized controlled trial design was employed with two study arms: a physical activity intervention and an attention control successful aging condition. Setting Sixteen continuing care retirement communities in San Diego County. Participants Three hundred twenty older adults, aged 65 years and older, are being recruited to participate in the trial. In addition, peer leaders are being recruited to lead some study activities, especially to sustain the intervention after study activities ceased. Intervention Participants in the physical activity trial receive individual, interpersonal and community intervention components. The individual level components include pedometers, goal setting and individual phone counseling. The interpersonal level components include group education sessions and peer-led activities. The community level components include resource audits and enumeration, tailored walking maps, and community improvement projects. The successful aging group receives individual and group attention about successful aging topics. Measurements The main outcome is light to moderate physical activity, measured objectively by accelerometry. Other objective outcomes included physical functioning, blood pressure, physical fitness, and cognitive functioning. Self report measures include depressive symptoms and health related quality of life. Results The intervention is being delivered successfully in the communities and compliance rates are high. Conclusion Ecological Models call for interventions that address multiple levels of the model. Previous studies have not included components at each level and retirement communities provide a model environment to demonstrate how to implement such an intervention.

Comprehensive Addictive Behaviors and Disorders, Volume 1 : Principles of Addiction

"Principles of Addiction provides a solid understanding of the definitional and diagnostic differences between use, abuse, and disorder. It describes in great detail the characteristics of these syndromes and various etiological models. The book's three main sections examine the nature of addiction, including epidemiology, symptoms, and course; alcohol and drug use among adolescents and college students; and detailed descriptions of a wide variety of addictive behaviors and disorders, encompassing not only drugs and alcohol, but caffeine, food, gambling, exercise, sex, work, social networking, and many other areas. This volume is especially important in providing a basic introduction to the field as well as an in-depth review of our current understanding of the nature and process of addictive behaviors. Principles of Addiction is one of three volumes comprising the 2,500-page series, Comprehensive Addictive Behaviors and Disorders. This series provides the most complete collection of current knowledge on addictive behaviors and disorders to date. In short, it is the definitive reference work on addictions."--publisher website