267 resultados para Environmental application
Resumo:
Particle number concentrations vary significantly with environment and, in this study, we attempt to assess the significance of these differences. Towards this aim, we reviewed 85 papers that have reported particle number concentrations levels at 126 sites covering different environments. We grouped the results into eight categories according to measurement location including: road tunnel, on-road, road-side, street canyon, urban, urban background, rural, and clean background. From these reports, the overall median number concentration for each of the eight site categories was calculated. The eight location categories may be classified into four distinct groups. The mean median particle number locations for these four types were found to be statistically different from each other. Rural and clean background sites had the lowest concentrations of about 3x103 cm-3. Urban and urban background sites showed concentrations that were three times higher (9x103 cm-3). The mean concentration for the street canyon, roadside and on-road measurement sites was 4.6x104 cm-3, while the highest concentrations were observed in the road tunnels (8.6x104 cm-3). This variation is important when assessing human exposure-response for which there is very little data available, making it difficult to develop health guidelines, a basis for national regulations. Our analyses shows that the current levels in environments affected by vehicle emissions are 3 to 28 times higher than in the natural environments. At present, there is no threshold level in response to exposure to ultrafine particles. Therefore, future control and management strategies should target a decrease of these particles in urban environments by more than one order of magnitude to bring them down to the natural background. At present there is a long way to go to achieve this.
Resumo:
Both environmental economists and policy makers have shown a great deal of interest in the effect of pollution abatement on environmental efficiency. In line with the modern resources available, however, no contribution is brought to the environmental economics field with the Markov chain Monte Carlo (MCMC) application, which enables simulation from a distribution of a Markov chain and simulating from the chain until it approaches equilibrium. The probability density functions gained prominence with the advantages over classical statistical methods in its simultaneous inference and incorporation of any prior information on all model parameters. This paper concentrated on this point with the application of MCMC to the database of China, the largest developing country with rapid economic growth and serious environmental pollution in recent years. The variables cover the economic output and pollution abatement cost from the year 1992 to 2003. We test the causal direction between pollution abatement cost and environmental efficiency with MCMC simulation. We found that the pollution abatement cost causes an increase in environmental efficiency through the algorithm application, which makes it conceivable that the environmental policy makers should make more substantial measures to reduce pollution in the near future.
Resumo:
The Environmental Kuznets Curve (EKC) hypothesises an inverse U-shaped relationship between a measure of environmental pollution and per capita income levels. In this study, we apply non-parametric estimation of local polynomial regression (local quadratic fitting) to allow more flexibility in local estimation. This study uses a larger and globally representative sample of many local and global pollutants and natural resources including Biological Oxygen Demand (BOD) emission, CO2 emission, CO2 damage, energy use, energy depletion, mineral depletion, improved water source, PM10, particulate emission damage, forest area and net forest depletion. Copyright © 2009 Inderscience Enterprises Ltd.
Resumo:
Using a state, pressure, response framework, we provide an evidence-based reflection on environmental outcomes in Australia and New Zealand across the domains of climate change, biodiversity, freshwater and marine management, emphasising the role of Indigenous and business perspectives. Significant developments have occurred in the past 20 years through affirmation of Indigenous rights and responsibilities. Responses to climate change have tended to emphasise passive risk management with unclear outcomes. Despite meeting biodiversity protection targets, outcomes are worsening, suggesting a need to challenge the dualistic preservation/production land categorisations. In freshwater and marine management, a mix of collaborative and market-based responses has emerged, although their efficacy remains untested. A reliance on voluntary approaches by business makes critical assessment of progress difficult. Thus, despite strong progress in some areas, the adaptiveness of environmental management remains limited, and many indicators suggest continuing decline in environmental condition. Our responses have been largely pacifying in nature, leading to perverse outcomes and failure to acknowledge alternatives that might address deteriorating environmental conditions. A shift is needed towards deliberative policy experimentation that truly values the application of novel and diversified approaches and facilitates integrated learning across environmental domains.
Resumo:
Background Australian national biomonitoring for persistent organic pollutants (POPs) relies upon age-specific pooled serum samples to characterize central tendencies of concentrations but does not provide estimates of upper bound concentrations. This analysis compares population variation from biomonitoring datasets from the US, Canada, Germany, Spain, and Belgium to identify and test patterns potentially useful for estimating population upper bound reference values for the Australian population. Methods Arithmetic means and the ratio of the 95th percentile to the arithmetic mean (P95:mean) were assessed by survey for defined age subgroups for three polychlorinated biphenyls (PCBs 138, 153, and 180), hexachlorobenzene (HCB), p,p-dichlorodiphenyldichloroethylene (DDE), 2,2′,4,4′ tetrabrominated diphenylether (PBDE 47), perfluorooctanoic acid (PFOA) and perfluorooctane sulfonate (PFOS). Results Arithmetic mean concentrations of each analyte varied widely across surveys and age groups. However, P95:mean ratios differed to a limited extent, with no systematic variation across ages. The average P95:mean ratios were 2.2 for the three PCBs and HCB; 3.0 for DDE; 2.0 and 2.3 for PFOA and PFOS, respectively. The P95:mean ratio for PBDE 47 was more variable among age groups, ranging from 2.7 to 4.8. The average P95:mean ratios accurately estimated age group-specific P95s in the Flemish Environmental Health Survey II and were used to estimate the P95s for the Australian population by age group from the pooled biomonitoring data. Conclusions Similar population variation patterns for POPs were observed across multiple surveys, even when absolute concentrations differed widely. These patterns can be used to estimate population upper bounds when only pooled sampling data are available.
Resumo:
Modern Saudi housing supply is neither sustainable nor efficient in meeting the conservative Islamic culture of the community and the local environmental conditions. This thesis develops a model for successful development of sustainable housing in Saudi Arabia by incorporating multi stakeholder inputs on key barriers, critical success factors and best practice case studies. The model will help create public awareness and education tools for both private and public sectors on sustainable housing. It provides a framework that includes cultural and environmental needs of the conservative Saudi neighbourhood. It may assist the Saudi government to regulate new building codes and regulations.
Resumo:
The type of contract model may have a significant influence on achieving project objectives, including environmental and climate change goals. This research investigates non-standard contract models impacting greenhouse gas emissions (GHG) in transport infrastructure construction in Australia. The research is based on the analysis of two case studies: an Early Contractor Involvement (ECI) contract and a Design and Construct (D&C) contract with GHG reduction requirements embedded in the contractor selection. Main findings support the use of ECIs for better integrating decisions made during the planning phase with the construction activities, and improve environmental outcomes while achieving financial and time savings. Key words: greenhouse gases reduction; road construction; contracting; ECI; D&C
Resumo:
Monitoring the environment with acoustic sensors is an effective method for understanding changes in ecosystems. Through extensive monitoring, large-scale, ecologically relevant, datasets can be produced that can inform environmental policy. The collection of acoustic sensor data is a solved problem; the current challenge is the management and analysis of raw audio data to produce useful datasets for ecologists. This paper presents the applied research we use to analyze big acoustic datasets. Its core contribution is the presentation of practical large-scale acoustic data analysis methodologies. We describe details of the data workflows we use to provide both citizen scientists and researchers practical access to large volumes of ecoacoustic data. Finally, we propose a work in progress large-scale architecture for analysis driven by a hybrid cloud-and-local production-grade website.
Resumo:
A multi-season 15N tracer recovery experiment was conducted on an Oxisol cropped with wheat, maize and sorghum to compare crop N recoveries of different fertilisation strategies and determine the main pathways of N losses that limit N recovery in these agroecosystems. In the wheat and maize seasons, 15N-labelled fertiliser was applied as conventional urea (CONV) and urea coated with a nitrification inhibitor (DMPP). In sorghum, the fate of 15N-labelled urea was monitored in this crop following a legume ley pasture (L70) or a grass ley pasture (G100). The fertiliser N applied to sorghum in the legume-cereal rotation was reduced (70 kg N ha−1) compared to the grass-cereal (100 kg N ha−1) to assess the availability of the N residual from the legume ley pasture. Average crop N recoveries were 73 % (CONV) and 77 % (DMPP) in wheat and 50 % (CONV) and 51 % (DMPP) in maize, while in sorghum were 71 % (L70) and 53 % (G100). Data gathered in this study indicate that the intrinsic physical and chemical conditions of Oxisols can be extremely effective in limiting N losses via deep leaching or denitrification. Elevated crop 15N recoveries can be therefore obtained in subtropical Oxisols using conventional urea while in these agroecosystems DMPP urea has no significant scope to increase fertiliser N recovery in the crop. Overall, introducing a legume phase to limit the fertiliser N requirements of the following cereal crop proved to be the most effective strategy to reduce N losses and increase fertiliser N recovery.
Resumo:
Giving and Volunteering in Australia: literature review summarises the findings of a comprehensive literature search that identifies relevant research on giving and volunteering in Australia. The report comments on the strengths and weaknesses of the methods used and the lessons that can be learned for the development of a future research agenda. The report arranges the findings in separate sections under the headings government sources, industry sources, university/peer-reviewed sources and international comparative sources. We learned that in the last 25 years there has been a growing body of knowledge about the dimensions of giving and volunteering in Australia, but much of the available data is not easily comparable or collected at regular intervals.
Resumo:
In the Australian fashion industry, few fashion brands have intervened in the design of their products or the systems around their product to tackle environmental pollution and waste. Instead, support of charities (whether social or environmental) has become conflated with sustainability in the eyes of the public. Thus it is difficult to assess with any accuracy fashion brands’ response to sustainability. This article aims to address this through proposing a categorization system to structure the various interventions that a company may make. This system is applied to two case studies, analysing campaigns that respond to environmental sustainability by two established Australian brands, Country Road and Billabong. The case studies demonstrate how the interventions employed by a company, at least in the Australian context, are carefully developed to align with their brand story, revealing the interplay between the intangible aspects of a brand’s positioning and the tangible, measurable impacts of their garments.
Resumo:
Significance of colour schemes in appraisal of the urban aesthetic has been traditionally recognised by design professionals. However, the proven psychological and emotional impacts of urban colour remain overlooked in design thinking. This paper argues that health-conscious approach to environmental colour design requires consideration of phenomenological human needs in addition to aesthetic and stylistic preferences of a designer. A body of knowledge accumulated in environmental colour psychology provides a foundation for a shift in the environmental colour design. Though, some architectural critics suggest that design professionals have little understanding of how different aspects of colour psychology can be integrated in design process. Lack of an explicit design methodology has been described as a main constraint to applicability of the related knowledge in design process. Understanding the notion of environmental colour is essential in developing health-conscious approach to environmental colour design. Therefore, this paper is primarily focused on conceptualisation of environmental colour and experiential environmental colour design. Additionally, a role of environmental colour design in the delivery of health-enhancing environments and balanced sensorial experiences is briefly discussed.
Resumo:
Previous attempts to determine the degree to which exposure to environmental factors contribute to noncommunicable diseases (NCDs) have been very conservative and have significantly underestimated the actual contribution of the environment for at least two reasons. Firstly, most previous reports have excluded the contribution of lifestyle behavioral risk factors, but these usually involve significant exposure to environmental chemicals that increase risk of disease. Secondly, early life exposure to chemical contaminants is now clearly associated with an elevated risk of several diseases later in life, but these connections are often difficult to discern. This is especially true for asthma and neurodevelopmental conditions, but there is also a major contribution to the development of obesity and chronic diseases. Most cancers are caused by environmental exposures in genetically susceptible individuals. In addition, new information shows significant associations between cardiovascular diseases and diabetes and exposure to environmental chemicals present in air, food, and water. These relationships likely reflect the combination of epigenetic effects and gene induction. Environmental factors contribute significantly more to NCDs than previous reports have suggested. Prevention needs to shift focus from individual responsibility to societal responsibility and an understanding that effective prevention of NCDs ultimately relies on improved environmental management to reduce exposure to modifiable risks.