Nonfatal heroin overdoses in Queensland, Australia : an analysis of ambulance data

In the past decade, the utilization of ambulance data to inform the prevalence of nonfatal heroin overdose has increased. These data can assist public health policymakers, law enforcement agencies, and health providers in planning and allocating resources. This study examined the 672 ambulance attendances at nonfatal heroin overdoses in Queensland, Australia, in 2000. Gender distribution showed a typical 70/30 male-to-female ratio. An equal number of persons with nonfatal heroin overdose were between 15 and 24 years of age and 25 and 34 years of age. Police were present in only 1 of 6 cases, and 28.1% of patients reported using drugs alone. Ambulance data are proving to be a valuable population-based resource for describing the incidence and characteristics of nonfatal heroin overdose episodes. Future studies could focus on the differences between nonfatal heroin overdose and fatal heroin overdose samples.

Algebraic Analysis of LEX

LEX is a stream cipher that progressed to Phase 3 of the eSTREAM stream cipher project. In this paper, we show that the security of LEX against algebraic attacks relies on a small equation system not being solvable faster than exhaustive search. We use the byte leakage in LEX to construct a system of 21 equa- tions in 17 variables. This is very close to the require- ment for an efficient attack, i.e. a system containing 16 variables. The system requires only 36 bytes of keystream, which is very low.

Comparison of 3D finite element analysis derived stiffness and BMD to determine the failure load of the excised proximal femur

Introduction: Bone mineral density (BMD) is currently the preferred surrogate for bone strength in clinical practice. Finite element analysis (FEA) is a computer simulation technique that can predict the deformation of a structure when a load is applied, providing a measure of stiffness (Nmm−1). Finite element analysis of X-ray images (3D-FEXI) is a FEA technique whose analysis is derived froma single 2D radiographic image. Methods: 18 excised human femora had previously been quantitative computed tomography scanned, from which 2D BMD-equivalent radiographic images were derived, and mechanically tested to failure in a stance-loading configuration. A 3D proximal femur shape was generated from each 2D radiographic image and used to construct 3D-FEA models. Results: The coefficient of determination (R2%) to predict failure load was 54.5% for BMD and 80.4% for 3D-FEXI. Conclusions: This ex vivo study demonstrates that 3D-FEXI derived from a conventional 2D radiographic image has the potential to significantly increase the accuracy of failure load assessment of the proximal femur compared with that currently achieved with BMD. This approach may be readily extended to routine clinical BMD images derived by dual energy X-ray absorptiometry. Crown Copyright © 2009 Published by Elsevier Ltd on behalf of IPEM. All rights reserved

How well are Australian children doing in the first year of school : a demographic analysis

Background: The transition to school is a sensitive period for children in relation to school success. In the early school years, children need to develop positive attitudes to school and have experiences that promote academic, behavioural and social competence. When children begin school there are higher expectations of responsibility and independence and in the year one class, there are more explicit academic goals for literacy and numeracy and more formal instruction. Most importantly, children’s early attitudes to learning and learning styles have an impact on later educational outcomes. Method: Data were drawn from The Longitudinal Study of Australian Children (LSAC). LSAC is a cross-sequential cohort study funded by the Australian Government. In these analyses, Wave 2 (2006) data for 2499 children in the Kindergarten Cohort were used. Children, at Wave 2, were in the first year of formal school. They had a mean age of 6.9 years (SD= 0.26). Measures included a 6-item measure of Approaches to Learning (task persistence, independence) and the Academic Rating Scales for language and literacy and mathematical thinking. Teachers rated their relationships with children on the short form of the STRS. Results: Girls were rated by their teachers as doing better than boys on Language and literacy, Approaches to learning; and they had a better relationship with their teacher. Children from an Aboriginal or Torres Strait Island (ATSI) background were rated as doing less well on Language and Literacy and Mathematical thinking and on their Approaches to learning. Children from high Socio Economic Position families are doing better on teacher rated Language and Literacy, Mathematical thinking, Approaches to learning and they had a better relationship with their teacher. Conclusions: Findings highlight the importance of key demographic variables in understanding children’s early school success.

Transition into high school : a phenomenological study

Transition is a process of moving from the known to the unknown (Green, 1997) and transition from primary school to high school can be described in this way. In Australia, there is a two tiered system of primary and secondary schooling operating where school students typically undergo at least two transitions. Firstly, when they leave home to attend pre-school/primary school; and secondly, when they leave primary school to enter secondary school. Potentially some students may experience up to four transitions: from home to kindergarten to pre-school to primary school to secondary school while for a smaller number of students who attend P-12 schools, there may be only one transition: from home to preschool.

Improvements in sustainable energy and water practice in the food processing industry : an in depth analysis of the manufacture of Ghee at the Butter Producers' Cooperative Federation Limited, Brisbane

This thesis is a documented energy audit and long term study of energy and water reduction in a ghee factory. Global production of ghee exceeds 4 million tonnes annually. The factory in this study refines dairy products by non-traditional centrifugal separation and produces 99.9% pure, canned, crystallised Anhydrous Milk Fat (Ghee). Ghee is traditionally made by batch processing methods. The traditional method is less efficient, than centrifugal separation. An in depth systematic investigation was conducted of each item of major equipment including; ammonia refrigeration, a steam boiler, canning equipment, pumps, heat exchangers and compressed air were all fine-tuned. Continuous monitoring of electrical usage showed that not every initiative worked, others had pay back periods of less than a year. In 1994-95 energy consumption was 6,582GJ and in 2003-04 it was 5,552GJ down 16% for a similar output. A significant reduction in water usage was achieved by reducing the airflow in the refrigeration evaporative condensers to match the refrigeration load. Water usage has fallen 68% from18ML in 1994-95 to 5.78ML in 2003-04. The methods reported in this thesis could be applied to other industries, which have similar equipment, and other ghee manufacturers.

Combination strategies for a factor analysis phone-conditioned speaker verification system

This work aims to take advantage of recent developments in joint factor analysis (JFA) in the context of a phonetically conditioned GMM speaker verification system. Previous work has shown performance advantages through phonetic conditioning, but this has not been shown to date with the JFA framework. Our focus is particularly on strategies for combining the phone-conditioned systems. We show that the classic fusion of the scores is suboptimal when using multiple GMM systems. We investigate several combination strategies in the model space, and demonstrate improvement over score-level combination as well as over a non-phonetic baseline system. This work was conducted during the 2008 CLSP Workshop at Johns Hopkins University.

Site survey and analysis of highway trucks overloading status quo in Anhui

In 2004, with the increasing overloading restriction requirements of society in Anhui, a provincial comprehensive overloading transportation survey has been developed to take evaluations on overloading actuality and enforcement efficiency with the support of the World Bank. A total of six site surveys were conducted at Hefei, Fuyang, Luan, Wuhu, Huainan and Huangshan Areas with four main contents respectively: traffic volume, axle load, freight information and registration information. Via statistical analysis on the survey data, conclusions were gained that: vehicle overloading are very universal and serious problems at arterial highways in Anhui now. The traffic loads have far exceeded the designed endure capacity of highways and have caused prevalent premature pavement damage, especially for rigid pavement. The overloading trucks are unimpeded engaged in highway freight transportation actually due to the disordered overloading enforcement strategies and the deficient inspecting technologies.

Confirmatory factor analysis of the Way of Coping Checklist-Revised (WCCL-R) in the Asian context

Industrial employment growth has been one of the most dynamic areas of expansion in Asia; however, current trends in industrialised working environments have resulted in greater employee stress. Despite research showing that cultural values affect the way people cope with stress, there is a dearth of psychometrically established tools for use in non-Western countries to measure these constructs. Studies of the "Way of Coping Checklist-Revised" (WCCL-R) in the West suggest that the WCCL-R has good psychometric properties, but its applicability in the East is still understudied. A confirmatory factor analysis (CFA) is used to validate the WCCL-R constructs in an Asian population. This study used 1,314 participants from Indonesia, Sri Lanka, Singapore, and Thailand. An initial exploratory factor analysis revealed that original structures were not confirmed; however, a subsequent EFA and CFA showed that a 38-item, five-factor structure model was confirmed. The revised WCCL-R in the Asian sample was also found to have good reliability and sound construct and concurrent validity. The 38-item structure of the WCCL-R has considerable potential in future occupational stress-related research in Asian countries.

Development of a colorimetric assay for heparanase activity suitable for kinetic analysis and inhibitor screening

The role that heparanase plays during metastasis and angiogenesis in tumors makes it an attractive target for cancer therapeutics. Despite this enzyme’s significance, most of the assays developed to measure its activity are complex. Moreover, they usually rely on labeling variable preparations of the natural substrate heparan sulfate, making comparisons across studies precarious. To overcome these problems, we have developed a convenient assay based on the cleavage of the synthetic heparin oligosaccharide fondaparinux. The assay measures the appearance of the disaccharide product of heparanase-catalyzed fondaparinux cleavage colorimetrically using the tetrazolium salt WST-1. Because this assay has a homogeneous substrate with a single point of cleavage, the kinetics of the enzyme can be reliably characterized, giving a Km of 46 μM and a kcat of 3.5 s−1 with fondaparinux as substrate. The inhibition of heparanase by the published inhibitor, PI-88, was also studied, and a Ki of 7.9 nM was determined. The simplicity and robustness of this method, should, not only greatly assist routine assay of heparanase activity but also could be adapted for high-throughput screening of compound libraries, with the data generated being directly comparable across studies.

The bereavement response : a cluster analysis

BACKGROUND: Literature and clinical experience suggest that some people experience atypical, complicated or pathological bereavement reactions in response to a major loss. METHOD: Three groups of community-based bereaved subjects--spouses (n = 44), adult children (n = 40), and parents (n = 36)--were followed up four times in the 13 months after a loss. A 17-item scale of core bereavement times was developed and used to investigate the intensity of the bereavement response over time. RESULTS: Cluster analysis revealed a pattern of bereavement-related symptoms approximating a syndrome of chronic grief in 11 (9.2%) of the 120 subjects. None of the respondents displayed a pattern consistent with delayed or absent grief. CONCLUSIONS: In a non-clinical community sample of bereaved people, delayed or absent grief is infrequently seen, unlike chronic grief, which is demonstrated in a minority.

A review on degradation models in reliability analysis

With increasingly complex engineering assets and tight economic requirements, asset reliability becomes more crucial in Engineering Asset Management (EAM). Improving the reliability of systems has always been a major aim of EAM. Reliability assessment using degradation data has become a significant approach to evaluate the reliability and safety of critical systems. Degradation data often provide more information than failure time data for assessing reliability and predicting the remnant life of systems. In general, degradation is the reduction in performance, reliability, and life span of assets. Many failure mechanisms can be traced to an underlying degradation process. Degradation phenomenon is a kind of stochastic process; therefore, it could be modelled in several approaches. Degradation modelling techniques have generated a great amount of research in reliability field. While degradation models play a significant role in reliability analysis, there are few review papers on that. This paper presents a review of the existing literature on commonly used degradation models in reliability analysis. The current research and developments in degradation models are reviewed and summarised in this paper. This study synthesises these models and classifies them in certain groups. Additionally, it attempts to identify the merits, limitations, and applications of each model. It provides potential applications of these degradation models in asset health and reliability prediction.

Desktop Audit and Analysis of Model Server Capability

This report presents the current state and approach in Building Information Modelling (BIM). The report is focussed at providing a desktop audit of the current state and capabilities of the products and applications supporting BIM. This includes discussion on BIM model servers as well as discipline specific applications, for which the distinction is explained below. The report presented here is aimed at giving a broad overview of the tools and applications with respect to their BIM capabilities and in no way claims to be an exhaustive report for individual tools. Chapter 4 of the report includes the research and development agendas pertaining to the BIM approach based on the observations and analysis from the desktop audit.