New control algorithm for single-phase series active power filter

This paper presents a single-phase Series Active Power Filter (Series APF) for mitigation of the load voltage harmonic content, while maintaining the voltage on the DC side regulated without the support of a voltage source. The proposed series active power filter control algorithm eliminates the additional voltage source to regulate the DC voltage, and with the adopted topology it is not used a coupling transformer to interface the series active power filter with the electrical power grid. The paper describes the control strategy which encapsulates the grid synchronization scheme, the compensation voltage calculation, the damping algorithm and the dead-time compensation. The topology and control strategy of the series active power filter have been evaluated in simulation software and simulations results are presented. Experimental results, obtained with a developed laboratorial prototype, validate the theoretical assumptions, and are within the harmonic spectrum limits imposed by the international recommendations of the IEEE-519 Standard.

Comparative environmental life-cycle analysis of concretes using biomass and coal fly ashes as partial cement replacement material

Nowadays, the concrete production sector is challenged by attempts to minimize the usage of raw materials and energy consumption, as well as by environmental concerns. Therefore, it is necessary to choose better options, e.g. new technologies or materials with improved life-cycle performance. One solution for using resources in an efficient manner is to close the materials' loop through the recycling of materials that result either from the end-of-life of products or from being the by-product of an industrial process. It is well known that the production of Portland cement, one of the materials most used in the construction sector, has a significant contribution to the environmental impacts, mainly related with carbon dioxide emission. Therefore, the study and utilization of by-products or wastes usable as cement replacement in concrete can supply more sustainable options, provided that these type of concrete produced has same durability and equivalent quality properties as standard concrete. This work studied the environmental benefits of incorporating different percentages of two types of fly ashes that can be used in concrete as cement replacement. These ashes are waste products of power and heat production sectors using coal or biomass as fuels. The results showed that both ashes provide a benefit for the concrete production both in terms of environmental impact minimization and a better environmental performance through an increase in cement replacement. It is possible to verify that the incorporation of fly ashes is a sustainable option for cement substitution and a possible path to improve the environmental performance of the concrete industry.

Seguidor do ponto de máxima potência multi-conversor para sistemas solares fotovoltaicos

Dissertação de mestrado integrado em Engenharia Eletrónica Industrial e de Computadores

Análise técnica - económica da produção de energia em sistemas de abastecimento de água: caso do aproveitamento de fins múltiplos dos socorridos

Dissertação de mestrado integrado em Engenharia Civil

Strategic planning of electricity systems: Integrating renewable energies

Tese de Doutoramento - Programa Doutoral em Engenharia Industrial e Sistemas (PDEIS)

Abordagem histórica e institucional da mudança em contabilidade de gestão: o caso da normalização nos hospitais públicos portugueses

A teoria institucional constituiu o enquadramento no qual foi suportada a pergunta geral desta investigação: como e porquê a Normalização da Contabilidade de Gestão (NCG) nos hospitais públicos portugueses surgiu e evoluiu? O objetivo geral foi compreender de forma profunda o surgimento e a mudança nas regras de NCG dos hospitais públicos portugueses no período histórico 1954-2011. Face ao enquadramento institucional que justificou uma investigação interpretativa, foi usado como método de investigação um estudo de caso explanatório. A evidência sobre o caso da NCG nos hospitais públicos portugueses foi recolhida em documentos e através de 58 entrevistas realizadas em 47 unidades de análise (nos serviços centrais de contabilidade do Ministério da Saúde e em 46 hospitais públicos, num total de 53 existentes). Quanto aos principais resultados obtidos, no período 1954-1974, as regras criadas pelo poder político para controlo dos gastos públicos e a contabilidade orçamental de base de caixa estiveram na génese dos primeiros conceitos de Contabilidade de Gestão (CG) para os serviços públicos de saúde portugueses. A transição de um regime ditatorial para um regime democrático (25 de Abril de 1974), a criação do Plano Oficial de Contabilidade (POC/77) e a implementação de um estado social com Serviço Nacional de Saúde (SNS) criaram a conjuntura crítica necessária para o surgimento de um Plano Oficial de Contabilidade para os Serviços de Saúde (POCSS/80) que incluiu regras de CG. A primeira edição do Plano de Contabilidade Analítica dos Hospitais (PCAH), aprovada em 1996, não foi uma construção de raiz, mas antes uma adaptação para os hospitais das regras de CG incluídas no POCSS/91 que havia revisto o POCSS/80. Após o início da implementação do PCAH, em 1998, ocorreram sequências de autorreforço institucionalizadoras destas normas, no período 1998-2011, por influência de pressões isomórficas coercivas que delinearam um processo de evolução incremental cujo resultado foi uma reprodução por adaptação, num contexto de dependência de recursos. Vários agentes internos e externos pressionaram, no período 2003-2011, através de sequências reativas para a desinstitucionalização do PCAH em resposta ao persistente fenómeno de loose coupling. Mas o PCAH só foi descontinuado nos hospitais com privatização da governação e rejeição dos anteriores sistemas de informação. Ao nível da extensão da teoria, este estudo de caso adotou o institucionalismo histórico na investigação em CG, quanto se sabe pela primeira vez, que se mostra útil na interpretação dos processos e dos resultados da criação e evolução de instituições de CG num determinado contexto histórico. Na condição de dependência de recursos, as sequências de autorreforço, via isomorfismo coercivo, tendem para uma institucionalização com fenómeno de loose coupling. Como resposta a este fenómeno, ocorrem sequências reativas no sentido da desinstitucionalização. Perante as pressões (políticas, funcionais, sociais e tecnológicas) desinstitucionalizadoras, o fator governação privada acelera o processo de desinstitucionalização, enquanto o fator governação pública impede ou abranda esse processo.

FPGA field oriented control of an axial flux motor-in-wheel

This paper presents the design and the prototype implementation of a three-phase power inverter developed to drive a motor-in-wheel. The control system is implemented in a FPGA (Field Programmable Gate Array) device. The paper describes the Field Oriented Control (FOC) algorithm and the Space Vector Modulation (SVM) technique that were implemented. The control platform uses a Spartan-3E FPGA board, programmed with Verilog language. Simulation and experimental results are presented to validate the developed system operation under different load conditions. Finally are presented conclusions based on the experimental results.

Multifunctional converter to interface renewable energy sources and electric vehicles with the power grid in smart grids context

This paper proposes a multifunctional converter to interface renewable energy sources (e.g., solar photovoltaic panels) and electric vehicles (EVs) with the power grid in smart grids context. This multifunctional converter allows deliver energy from the solar photovoltaic panels to an EV or to the power grid, and exchange energy in bidirectional mode between the EV and the power grid. Using this multifunctional converter are not required multiple conversion stages, as occurs with the traditional solutions, where are necessary two power converters to integrate the solar photovoltaic system in the power grid and also two power converters to integrate an off-board EV battery charger in the power grid (dc-dc and dc-ac power converters in both cases). Taking into account that the energy provided (or delivered) from the power grid in each moment is function of the EV operation mode and also of the energy produced from the solar photovoltaic system, it is possible to define operation strategies and control algorithms in order to increase the energy efficiency of the global system and to improve the power quality of the electrical system. The proposed multifunctional converter allows the operation in four distinct cases: (a) Transfer of energy from the solar photovoltaic system to the power grid; (b) Transfer of energy from the solar photovoltaic system and from the EV to the power grid; (c) Transfer of energy from the solar photovoltaic system to the EV or to the power grid; (d) Transfer of energy between the EV and the power grid. Along the paper are described the system architecture and the control algorithms, and are also presented some computational simulation results for the four aforementioned cases. It is also presented a comparative analysis between the traditional and the proposed solution in terms of operation efficiency and estimated cost of implementation.

Three-phase current-source shunt active power filter with solar photovoltaic grid interface

This paper presents the proposal of a three phase current source shunt active power filter (CS-SAPF) with photovoltaic grid interface. The proposed system combines the compensation of reactive power and harmonics with the injection of energy from a solar photovoltaic array into the electrical power grid. The proposed equipment presents the advantage of giving good use to the current source inverter, even when the solar photovoltaic array is not producing energy. The paper describes the control system of the CS SAPF, the energy injection control strategy, and the current harmonics and power factor compensation strategy. Simulation results to assess the performance of the proposed system are also presented.

Implementation and comparison of different switching techniques for shunt active power filters

This paper presents a comparison between three switching techniques that can be used in three-phase four-wire Shunt Active Power Filters (SAPFs). The implemented switching techniques are: Periodic-Sampling (PS), Triangular Carrier Pulse-Width Modulation (TC-PWM) and Space Vector PWM (SVPWM). The comparison between them is made in terms of the compensated currents THD%, implementation complexity, necessary CPU time and SAPF efficiency. To perform this comparison are presented and analyzed several experimental results, obtained with a 20 kVA Shunt Active Power Filter prototype, specially developed for this purpose. The control system of the developed SAPF is based in the p-q Theory with a grid synchronization algorithm p-PLL.

Renewable energy system for an isolated micro grid

This paper presents the development of the power electronics needed for the interaction between the electrical generator of a wind turbine and an isolated ac micro grid. In this system there are basically two types of receptors for the energy produced by the wind turbine, which are the loads connected to the isolated micro grid and the batteries used to store energy. There are basically two states in which the system will work. One of the states is when there is enough wind power to supply the loads and the extra energy is used to charge the batteries. The other state is when there is low wind power and the batteries have to compensate the lack of power, so that the isolated micro grid has enough power to supply at least the priority loads. In this paper are presented the hardware and the control algorithm for the developed system. The topology was previously tested in computer simulations, using the software PSIM 9.0, and then validated with the implementation of a laboratory prototype.

Aproveitamento de energia em sistemas de abastecimento de água

Dissertação de mestrado integrado em Engenharia Civil

Microfluidic based on aqueous two-phase system for plasmidic DNA purification

Dissertação de mestrado em Bioquímica Aplicada (área de especialização em Biotecnologia)