Switching and release dynamics of an electrostatically actuated MEMS switch under the influence of squeeze-film damping

This paper reports analytical modeling, simulation and experimental validation for switching and release times of an electrostatically actuated micromachined switch. Presented work is an extension of our earlier work [1] that analytically argued, and numerically and experimentally demonstrated, why pull-in time is larger that pull-up time when the actuation voltage is less than twice of the pull-in voltage. In this paper, switching dynamics is investigated under the influence of squeeze-film damping. Tests were performed on SOI (silicon-on-insulator) based parallel beams structures.Typical voltage requirement for actuation is in the range of 10-30 V. All the experiments were performed in normal atmospheric pressure. Measurement results confirm that the quality factor Q has appreciable effect on the release time compared to the switching time. The quality factor Q is extracted from the response measurement and compared with the ANSYS simulation result. In addition, the dynamic pull-in effect has also been studied and reported in this paper. A contribution of this work includes the effect of various phenomena such as squeeze-film damping, dynamic pull-in, and frequency pull-in effects on the switching dynamics of a MEMS switch.

A DC-link Capacitor Voltage Balancing with CMV Elimination using only the Switching State Redundancies for a Reduced Switch Count Multi-Level Inverter fed IM Drive

Common mode voltage (CMV) variations in PWM inverter-fed drives generate unwanted shaft and bearing current resulting in early motor failure. Multilevel inverters reduce this problem to some extent, with higher number of levels. But the complexity of the power circuit increases with an increase in the number of inverter voltage levels. In this paper a five-level inverter structure is proposed for open-end winding induction motor (IM) drives, by cascading only two conventional two-level and three-level inverters, with the elimination of the common mode voltage over the entire modulation range. The DC link power supply requirement is also optimized by means of DC link capacitor voltage balancing, with PWM control., using only inverter switching state redundancies. The proposed power circuit gives a simple power bits structure.

New constraints on the pion EM form factor using Pi `(-Q(2))

We study the constraints arising on the expansion parameters c and d of the pion electromagnetic form factor from the inclusion of pure spacelike data and the phase of timelike data along with one spacelike datum, using as input the first derivative of the QCD polarization amplitude Pi'(-Q(2)). These constraints when combined with other analyses, provide a valuable check on a determination of c due to Guo et al. and on our previous work where pionic contribution to the (g - 2) of the muon was used as the input. This work further illustrates the power of analyticity techniques in form factor analysis.

Future switching technology: bacterial protein-based programmable all-optical switch for integrated optics applications?

We report on the bacterial protein-based all-optical switches which operate at low laser power, high speed and fulfil most of the requirements to be an ideal all-optical switch without any moving parts involved. This consists of conventional optical waveguides coated with bacteriorhodopsin films at switching locations. The principle of operation of the switch is based on the light-induced refractive index change of bacteriorhodopsin. This approach opens the possibility of realizing proteinbased all-optical switches for communication network, integrated optics and optical computers.

Study of internal motions through N.Q.R. in 6-Chloropyridin-2-ol

Chlorine-35 n.q.r, has been observed for the first time in 6-chloropyridin-2-ol and its temperature dependence has been studied from 77 K to room temperature. The torsional frequencies and their temperature dependences have been calculated by using Bayer's theory with and without Tatsuzaki's modification.

Very-high-Q inductor simulation for active tuned filters

Abstract is not available.

Temperature-dependence of 35Cl N.Q.R. in sodium chloroacetate

N.q.r. in sodium chloroacetate has been investigated at temperatures from 77 K to room temperature (c.300 K). A single line has been observed throughout this temperature range. Torsional frequencies of the molecule have been calculated in the above temperature range from Bayer's theory. Also the temperature coefficient of the torsional frequencies has been calculated by Brown's method.

Towards a temperature-guided molecular switch: an unusual reversible low-temperature polymorphic phase transition in a conformational locked environment

A conformationally locked tetraacetate undergoes, quite akin to a temperature-guided molecular switch, a reversible thermal switching between two polymorphic modifications; the room-temperature alpha-form converted at -4 degrees C to a low-temperature denser beta-form, which displayed an unusual kinetic stability till 67 degrees C and transformed back to the alpha-form beyond this temperature.

New algorithms of the Q-learning type

We propose two algorithms for Q-learning that use the two-timescale stochastic approximation methodology. The first of these updates Q-values of all feasible state–action pairs at each instant while the second updates Q-values of states with actions chosen according to the ‘current’ randomized policy updates. A proof of convergence of the algorithms is shown. Finally, numerical experiments using the proposed algorithms on an application of routing in communication networks are presented on a few different settings.

Biosynthesis of coenzyme Q in microorganisms

Incorporation of mevalonate-2-C14, acetate-1-C14, and formate-C14 into the lipids of microorganisms was studied. In the case of four bacteria tested—Agrobacterium tumefaciens, Azotobacter vinelandii, Escherichia coli, and a Pseudomonas species—the various homologues of coenzyme Q present were not labeled with any of the tracers used, although significant amounts of radioactivity were present in the lipids. Both acetate and mevalonate were incorporated into coenzyme Q and sterol of the moulds, Aspergillus niger, Neurospora crassa, Penicillium chrysogenum, and Gibberella fujickuroi, and a yeast, Torulopsis utilis. Mevalonate was incorporated into the side chain but not the ring, whereas acetate was incorporated into both. It appears that the mevalonate pathway for the synthesis of coenzyme Q is operative only in those organisms which also contain other isoprene compounds such as sterol and carotene.

Intracellular distribution of coenzyme Q in rat liver

Coenzyme Q was found to be distributed in rat liver cell fractions. Mitochondria accounted for only 40–60% of the total. The presence of coenzyme Q in nuclei, isolated by several methods, could always be correlated with the presence of oxidative enzymes. It has been established that coenzyme Q is a constituent of microsomes. Administered coenzyme Q10-C14 was preferentially taken up by mitochondrial and microsomal fractions. Exogenous coenzyme Q appears to be rapidly metabolized.

Distribution of coenzyme Q in rat liver cell fractions

COENZYME Q (CoQ), which is widely distributed in animal, plant and microbial sources, has been implicated in electron transport1 and generally assumed to be associated with mitochondria. However, it has also been found in non-mitochondrial fractions of green leaves, although it appears to be concentrated in mitochondria2. A similar distribution has now been demonstrated in rat liver cell fractions.