Root system traits of Norway spruce, Scots pine, and silver birch in mixed boreal forests: an analysis of root architecture, morphology, and anatomy

The aim of this thesis was to unravel the functional-structural characteristics of root systems of Betula pendula Roth., Picea abies (L.) Karst., and Pinus sylvestris L. in mixed boreal forest stands differing in their developmental stage and site fertility. The root systems of these species had similar structural regularities: horizontally-oriented shallow roots defined the horizontal area of influence, and within this area, each species placed fine roots in the uppermost soil layers, while sinker roots defined the maximum rooting depth. Large radial spread and high ramification of coarse roots, and the high specific root length (SRL) and root length density (RLD) of fine roots indicated the high belowground competitiveness and root plasticity of B. pendula. Smaller radial root spread and sparser branching of coarse roots, and low SRL and RLD of fine roots of the conifers could indicate their more conservative resource use and high association with and dependence on ectomycorrhiza-forming fungi. The vertical fine root distributions of the species were mostly overlapping, implying the possibility for intense belowground competition for nutrients. In each species, conduits tapered and their frequency increased from distal roots to the stem, from the stem to the branches, and to leaf petioles in B. pendula. Conduit tapering was organ-specific in each species violating the assumptions of the general vascular scaling model (WBE). This reflects the hierarchical organization of a tree and differences between organs in the relative importance of transport, safety, and mechanical demands. The applied root model was capable of depicting the mass, length and spread of coarse roots of B. pendula and P. abies, and to the lesser extent in P. sylvestris. The roots did not follow self-similar fractal branching, because the parameter values varied within the root systems. Model parameters indicate differences in rooting behavior, and therefore different ecophysiological adaptations between species.

Multiplication of hybrid aspen (Populus tremula L. x P. tremuloides Michx.) from cuttings

The primary aim of the present study was to find an efficient and simple method of vegetative propagation for producing large numbers of hybrid aspen (Populus tremuloides L. x P. tremula Michx.) plants for forest plantations. The key objectives were to investigate the main physiological factors that affect the ability of cuttings to regenerate and to determine whether these factors could be manipulated by different growth conditions. In addition, clonal variation in traits related to propagation success was examined. According to our results, with the stem cutting method, depending on the clone, it is possible to obtain only 1−8 plants from one stock plant per year. With the root cutting method the corresponding values for two-year-old stock plants are 81−207 plants. The difference in number of cuttings between one- and two-year-old stock plants is so pronounced that it is economically feasible to grow stock plants for two years. There is no reason to use much older stock plants as a source of cuttings, as it has been observed that rooting ability diminishes as root diameter increases. Clonal variation is the most important individual factor in propagation of hybrid aspen. The fact that the efficiently sprouted clones also rooted best facilitates the selection of clones for large-scale propagation. In practice, root cuttings taken from all parts of the root system of hybrid aspen were capable of producing new shoots and roots. However, for efficient rooting it is important to use roots smaller than one centimeter in diameter. Both rooting and sprouting, as well as sprouting rate, were increased by high soil temperature; in our studies the highest temperature tested (30ºC) was the best. Light accelerated the sprouting of root cuttings, but they rooted best in dark conditions. Rooting is essential because without roots the sprouted cutting cannot survive long. For aspen the criteria for clone selection are primarily fiber qualities and growth rate, but ability to regenerate efficiently is also essential. For large-scale propagation it is very important to find clones from which many cuttings per stock plant can be obtained. In light of production costs, however, it is even more important that the regeneration ability of the produced cuttings be high.

Effect of soil preparation of boreal spruce forest on air and soil temperature conditions in forest regeneration areas.

The effect of scarification, ploughing and cross-directional plouhing on temperature conditions in the soil and adjacent air layer have been studied during 11 consecutive growth periods by using an unprepared clear-cut area as a control site. The maximum and minimum temperatures were measured daily in the summer months, and other temperature observations were made at four-hour intervals by means of a Grant measuring instrument. The development of the seedling stand was also followed in order to determine its shading effect on the soil surface. Soil preparation decreased the daily temperature amplitude of the air at the height of 10 cm. The maximum temperatures on sunny days were lower in the tilts of the ploughed and in the humps of the cross-directional ploughed sites compared with the unprepared area. Correspondingly, the night temperatures were higher and so the soil preparation considerably reduced the risk of night frost. In the soil at the depth of 5 cm, soil preparation increased daytime temperatures and reduced night temperatures compared with unprepared area. The maximum increase in monthly mean temperatures was almost 5 °C, and the daily variation in the surface parts of the tilts and humps increased so that excessively high temperatures for the optimal growth of the root system were measured from time to time. The temperature also rose at the depths of 50 and 100 cm. Soil preparation also increased the cumulative temperature sum. The highest sums accumulated during the summer months were recorded at the depth of 5 cm in the humps of cross-directional ploughed area (1127 dd.) and in the tilts of the ploughed area (1106 dd.), while the corresponding figure in the unprepared soil was 718 dd. At the height of 10 cm the highest temperature sum was 1020 dd. in the hump, the corresponding figure in the unprepared area being 925 dd. The incidence of high temperature amplitudes and percentage of high temperatures at the depth of 5 cm decreased most rapidly in the humps of cross-directional ploughed area and in the ploughing tilts towards the end of the measurement period. The decrease was attributed principally to the compressing of tilts, the ground vegetation succession and the growth of seedlings. The mean summer temperature in the unprepared area was lower than in the prepared area and the difference did not diminish during the period studied. The increase in temperature brought about by soil preparation thus lasts at least more than 10 years.

Heating values of mature trees.

The effective heating values of the above and below ground biomass components of mature Scots pine (Pinus sylvestris), Norway spruce (Picea abies), downy birch (Betula pubescens), silver birch (Betula pendula), grey alder (Alnus incana), black alder (Alnus glutinosa) and trembling aspen (Populus tremula) were studied. Each sample tree was divided into wood, bark and foliage components. Bomb calorimetry was used to determine the calorimetric heating values. The species is a significant factor in the heating value of individual tree components. The heating value of the wood proper is highest in conifers. Broad-leaved species have a higher heating value of bark than conifers. The species factor diminishes when the weighted heating value of crown, whole stems or stump-root-system are considered. The crown material has a higher heating value per unit weight in comparison with fuelwood from small-sized stems or wholetrees. The additional advantages of coniferous crown material are that it is a non-industrial biomass resource and is readily available. The variability of both the chemical composition and the heating value is small in any given tree component of any species. However, lignin, carbohydrate and extractive content were found to vary from one part of the tree to another and to correlate with the heating value.

Jakojuuriviljelyn vaikutus kasvihuonekurkun (Cucumis sativus L.) kasvuun ja kehitykseen

Kasvit ottavat vettä parhaiten kasteluravinneliuoksesta, jonka ravinnepitoisuus on pieni. Intensiivisessä kasvihuonetuotannossa käytetään silti kastelulannoituksessa usein korkeita ravinnepitoisuuksia ravinnepuutosten ja satotappioiden välttämiseksi. Jakojuuriviljelyssä kasvin juuriston annetaan kasvaa kahteen erilliseen kasvualustaosioon. Tällöin toiselle puolelle annetaan johtokyvyltään väkevää ja toiselle puolelle laimeaa ravinneliuosta. Erityisesti kasvihuonekurkun, joka on herkkä kasvualustan suolaisuuden aiheuttamille vedensaantiongelmille, on todettu hyötyvän tästä tekniikasta, mikä näkyy kasvaneina satoina. Tämän MTT Piikkiössä toteutetun kasvihuonekurkun jakojuuriviljelytutkimuksen tavoitteena oli tarkentaa tekniikkaa erityisesti kasteluliuosten johtokyvyn osalta. Yhtenäisjuuriviljelyn ja perinteisen jakojuuriviljelyn lisäksi kokeessa oli kaksi jakojuuriviljelykäsittelyä, joissa ravinneliuosväkevyyksiä vaihdettiin väliajoin juuriston toimintakyvyn parantamiseksi. Erillisessä osakokeessa tutkittiin erilaisten johtokyky-yhdistelmien vaikutusta kasvihuonekurkun vegetatiiviseen kasvuun maanpäällisten ja -alaisten kasvinosien välillä sekä juurten morfologiaan ja anatomiaan. Tulokset osoittivat, että jakojuuriviljely lisäsi kasvihuonekurkun sadontuottoa jopa 16 %, mutta ei vaikuttanut koko viljelykauden veden tai ravinteiden ottoon. Yhtenäisjuuriviljelyssä muodostui eniten piikkikärkisiä hedelmiä, mikä viittaa vedensaantiongelmiin haihdutustarpeen ollessa suurin. Viljelytekniikalla ei ollut vaikutusta kasvien vegetatiiviseen kasvuun tai kasvuston rakenteeseen. Lehtiruodeista tehdyt nitraatti- ja kaliummittaukset osoittivat, ettei kasteluliuosten ravinnepitoisuuksilla ollut vaikutusta juurten ravinteiden ottoon. Erilaisilla johtokyky-yhdistelmillä oli huomattavampi vaikutus kasvihuonekurkun juurten painoon kuin verson painoon tai varren pituuskasvuun. Lehtiruotianalyysit viittasivat ravinteiden erilaiseen allokointiin eri johtokyky-yhdistelmissä. Korkeiden johtokykyjen aiheuttama osmoottinen stressi johti muutoksiin juurten morfologiassa ja anatomiassa. Tulosten perusteella jakojuuriviljely paransi kehittyvien hedelmien kohdevahvuutta suhteessa muihin kohteisiin vaikuttamatta vegetatiiviseen kasvuun. Kun laimean ja väkevän ravinneliuoksen puolia vaihdettiin, juuristo otti joustavasti vettä ja ravinteita olosuhteiden määräämästä edullisemmasta johtokyvystä, jolloin kasvihuonekurkun viljelyssä saavutettiin merkittävä satoetu. Juuriston jakaminen vaikuttanee kasvien hormoniaineenvaihduntaan ja voi heikentää juuriston kasvua heikentämättä sen toimintakykyä, jolloin yhteyttämistuotteita kohdennetaan tehokkaammin maanpäällisten osien kasvuun.