Preliminary Studies of Practicability of Laminar Plasma Surface Treatment Process

The basic remelting and cladding tests with laminar plasma technology on metals have been conducted in order to demonstrate the possibility of the technology applied in material surface modification. The experimental results show that the properties of the modified layers of the cast iron surface can be improved notably by the remelting treatment and those of the stainless steel by the cladding treatment. The related results are also verified by microscopic studies such as scanning electron microscopic (SEM) observations, energy dispersive spectra (EDS) analysis and the Vickers hardness measurements of the surface modified layers.

Preliminary Investigations on Low-Pressure Laminar Plasma Spray Processing

The usual plasma spraying methods often involve entrainment of the surrounding air into the turbulent plasma core and result in coated materials having relatively high porosity and low adhesive strength. Therefore, exploration of new plasma spraying methods for fabricating high quality coatings to meet the requirement of special applications will be quite important. In this study, an alternative plasma spraying method, i.e. the low-pressure laminar plasma spraying process, is investigated and used in an attempt for spraying thermal barrier coatings (TBCs). Investigations on the characteristics of the laminar plasma jets, feeding methods for the ceramic powder and the formation process of the individual quenched splats have been carried out. The properties of the TBCs sprayed by laminar plasma jet process, such as the adhesive strength at the interface of the ceramic coating/bond coat, the surface roughness and microstructure, are examined by tensile tests and scanning electron microscope (SEM) observations.

Preliminary Analysis on the May 1st Landslide at Wulong

分析了边坡工程地质条件和地质成因机制；根据现场调查数据建立了滑坡地质剖面,反演了滑坡发生时滑动面的抗剪强度参数；分析了原坡形及降雨所引起孔隙水压力对其稳定性的影响,并以反演获得的强度参数结合类似边坡岩体结构面强度试验统计结果,对原边坡进行了可靠度分析,获得了原边坡的潜在破坏概率,从而又在定量角度上获得了滑坡发生的原因。

Preliminary Investigation of Fluid Flow in Meso-Scale Rectangular Tube

The fluid flow associated with micro and meso scale devices is currently of interest. Experiments were performed to study the fluid flow in meso-scale channels. A straight flow tube was fabricated with 1.0x4.0mm^2 in rectangular cross section and 200mm in length, which was made of quartz for flow visualization and PIV measurements. Reynolds numbers were ranged from 311 to over 3105. The corresponding pressure drop was from 0.65KPa to over 16.58KPa between the inlet and outlet of the tube. The micro PIV was developed to measure the velocity distribution in the tube. A set of microscope object lens was mounted ahead of CCD camera to obtain optimized optical magnification on the CCD chip. The velocity distributions near the outlet of the tube were measured to obtain full-developed flow. A CW laser beam was focused directly on the test section by a cylinder lens to form a small light sheet. Thus, high power density of light was formed on the view region. It is very important to the experiment while the velocity of the flow reaches to a few meters per second within millimeter scale. In this case, it is necessary to reduce exposure time to microseconds for PIV measurements. In the present paper, the experimental results are compared with the classical theories.

Preliminary report on the energy balance for nonlinear oscillations

In this paper, a reliable technique for calculating angular frequencies of nonlinear oscillators is developed. The new algorithm offers a promising approach by constructing a Hamiltonian for the nonlinear oscillator. Some illustrative examples are given. (C) 2002 Published by Elsevier Science Ltd.

Preliminary-results of gaas single-crystal growth under high gravity conditions

GaAs single crystals have been grown under high gravity conditions, up to 9g0, by a recrystallization method with decreasing temperature. The impurity striations in GaAs grown under high gravity become weak and indistinct with smaller striation spacings. The dislocation density of surcharge-grown GaAs increases with increase of centrifugal force. The cathodoluminescence results also show worse perfection in the GaAs grown at high gravity than at normal earth gravity.

Subcooled Pool Boiling at Microgravity: Preliminary Ground-Based Experimental Results

A temperature-controlled pool boiling (TCPB) device was developed to perform pool boiling heat transfer studies at both normal gravity on Earth and microgravity in the drop tower Beijing and aboard a Chinese recovery satellite. Two platinum wires of 60 ?m in diameter were simultaneously used as heaters and thermometers. The lengths were 30 mm and 40 mm, respectively. The ends of wires were soldered with copper poles to provide low resistance paths for the electric current. The heater resistance, and thus the heater temperature, was kept constant by a feedback circuit similar to that used in constant-temperature hot-wire anemometry. The fluid was R113 at 0.1 Mpa and subcooled by 30 ?C nominally for all cases. The results of the experiments at normal gravity were presented. Four modes, namely single-phase convection, nucleate boiling, transition two-mode boiling, and film boiling were observed. A few data obtained from several preliminary experiments at microgravity in the drop tower Beijing were also presented. A slight increase of the heat flux was obtained.

岷江中上游植被生态恢复过程中若干问题的探讨

　1．对四川省岷江上游地区（茂县）的锐齿槲栎（Quercus aliena var. acuteserrata）天然次生林进行研究，发现：(1) 坚果完好比例约在14% ~26%之间，完好坚果的发芽率和发芽势都比较高，但在天然状况下能够留存到翌年5月的坚果几乎没有。因此，实生幼苗的天然补充就受到了严重的限制。(2) 林缘的幼苗密度低于所有其它生境的 (P<0.05)，林中的幼苗密度最高，和林窗的比较有显著差异(P<0.05), 而和灌丛的比较则差异不显著（P>0.05）。在灌丛幼苗密度和林中以及林窗的比较都没有差异。动物对坚果的取食速度则是林中的最慢 (10.0%)，林窗和林缘的基本相同(分别为61.1%和66.5%)，取食速度都明显快于林中(P<0.01)。(3) 林中的幼苗在小于100 cm的各高度内都有大量分布，说明在林中树冠下幼苗是可以长期存在的，暗示在幼苗阶段的锐齿槲栎可能是耐荫的。(4) 在林中缺失幼树，在林缘则有包括幼树在内的完整的更新大小系列，表明林缘是更新的关键地点。(5) 在栎林的每一个大小级别上，萌生个体和实生个体都按各种比例伴生，说明导致萌生的干扰一直在发生，并可能在森林的更新中扮演重要角色;也说明该地区的锐齿槲栎林由萌生和实生起源的个体混合组成。 2．栎林是北半球温带森林的重要组成部分，因此栎林更新是全球森林更新研究的热点之一，而啮齿动物对栎林更新的影响则是关注的焦点。在2002~2003年，通过坚果标记研究了未被取食和遗弃坚果（即咬开后只有少部分被捕食后丢弃在林中的坚果）的健康比例，并定量测定了坚果的捕食、搬运、遗弃、丢弃、贮藏和留存等各种命运的比例和特点;对坚果也进行了各种人为的处理，以观测其命运和动物取食速度，发现：(1) 遗弃坚果中不健康坚果的比例比动物未取食的天然坚果中的比例有极显著的增加 (P>0.05)，暗示啮齿动物一般是通过咬开坚果来识别坚果健康与否并决定是否捕食。(2) 根据坚果命运和对照相比改变与否以及如何改变，各种人工处理坚果的命运可以分为 4 类：① 坚果命运没有任何显著改变;② 坚果被就地捕食的速度降低，搬运的速度不变，最终搬运坚果的比例增加而就地捕食坚果的比例降低，留存坚果的比例偶尔能增加至0.2%;③ 坚果就地捕食的速度几乎降至0，搬运的速度则在下降一段时间后又上升，并且搬运作用持续了相对长的时间，最终搬运坚果的比例大大增加，就地捕食坚果的比例很低，留存率为0;④ 坚果被搬运和就地捕食的速度和比例都降低，留存坚果的比例相应的大大增加，甚至可以达到50%。(3) 命运得到显著改变的②、③、④类坚果所承受的人工处理按照作用方式又可以分为主要作用于坚果化学状态（即气味浓度）的处理、主要作用于坚果物理状态（颜色、形态、有无附属物等）的处理以及使坚果处于不同颜色背景的处理;其中主要作用于坚果化学状态的处理对坚果命运具有最重大的改变，如胶带包裹处理和烧焦处理;其它各种主要作用于坚果的物理状态和所处背景的处理对其命运则也具有相对轻微的改变。这一试验结果可能证明：啮齿动物在对坚果进行识别和取食选择等活动时主要依赖于嗅觉来感知坚果的可食性，但是能感觉物理状态和所处背景的视觉也起一定程度的作用。(4) 啮齿动物对栎树坚果进行就地捕食、遗弃、搬运、异地捕食、丢弃、贮藏等作用，使各种命运的坚果都具有一定的数量比例和特点，也提供了动物影响栎林更新的多种可能途径。 3．人工干扰是任何退化生态系统中都始终存在的重大问题。除了明显的砍伐或者采摘外，人工践踏也是一种重要的干扰，特别是在茂县的山林普遍被牛马不断的放牧的情况下，这个干扰的后果就更加显著。为此研究了人脚踩踏的路上的白车轴草和未踩踏草坪上白车轴草在最大叶长、株高、芽高、构件数量、构件平均鲜重、死叶数量、根长等构型指标，根、茎、叶三者的生物量（干重）及比例等生物量指标，平均花序数量、花平均数量等繁殖指标方面的不同，发现踩踏使白车轴草植株：(1) 株高降低，芽高降低，最大叶长变小，平均每厘米的构件数量增加，构件平均鲜重降低，根长度减小，死叶数量增加。(2) 平均花序数量下降，每花序的花平均数量下降。(3) 但是在生物量的分配上，根和茎的生物量没有显著的下降，但是叶的生物量显著减低。因为白车轴草的茎可以不断克隆繁殖，所以踩踏对其存活可能没有太大的影响，只是造成了植株的矮化和密集化，根也变短;但是对种子繁殖有重大影响，反映在平均花序数量和每花序平均花数的显著下降上。在生物量的分配中，作为主要的同化器官，叶的生物量显著下降，而根茎比没有变化。这可能说明这样的克隆植物其物质流动是呈现网络化的特征，具有比较强的抗干扰能力。 4．连香树、油松、日本落叶松、华山松油松混合林是茂县地区的几种主要的已经营造的林型或者树种。为了了解其20年来的营林效果，运用样方调查的方法测量了这几种树种或者林型的胸径、持水量、凋落物现存量、密度等，评价了它们在生长、营业循环和水土保持等方面的差异。结果表明：日本落叶松具有生长缓慢，凋落物现存量大，涵养水分能力良好的树种，值得推广;油松生长迅速，凋落物现存量巨大，涵养水分能力一般的树种，也可以大力栽植;油松和华山松的混交林具有比较大的蓄积量和较好的涵养水分的能力，可以推广;而连香树则做为生长速度中等，成材率低，凋落物现存量小，涵养水分能力差的树种，不应该进一步推广。