Nanotubes of mixed-valence, transition metal compounds synthesized by solution phase approach

A solution-phase approach to synthesize four kinds of mixed-valence, transition metal compounds nanotube is described. The approach is based on the self-assembly of siloxane sol. The resulted production of mixed-valence, transition metal compounds share a common structural characteristic of tubular geometrical morphology, at least for the ones we studied. The results demonstrate that the synthesis strategy can be a general route for preparation of compound nanotubes. In addition, the size control of nanotubular materials can be easily achieved through varying the ionic strength of solution. Based on the strategy, the diameters of ultrathin Ru-Fe nanotubes can be easily tuned between 100 nm and 800 nm.

Self-assembly of a water chain with tetrameric and decameric clusters in the channel of a mixed-valence (CuCuII)-Cu-I complex

The reaction of Cu(BF4)(2) with pyridine-2,6-dicarboxylic acid (H(2)pydc) and trans-1,2-bis(4-pyridyl)ethylene (bpe) under hydrothermal conditions afforded a porous mixed-valence (CuCuII)-Cu-I coordination polymer. Coexistence of tetrameric and decameric water clusters within the channels of the complex leads to a novel water chain. The metal-organic framework provides both hydrophilic and hydrophobic environments for stabilizing the clusters and retains its integrity upon dehydration and rehydration.

The first discrete mixed-valence hexadecavanadate host shell cluster anions: hydrothermal synthesis, structure and characterization of [V16O38(Cl)](8-)

A new compound, [NH4](2)[Zn(phen)(3)](2)[Zn(phen)(2)(H2O)(2)][V16O38(Cl)] (.) 5H(2)O (1), was synthesized in the hydrothermal condition. The "naked" [V16O38(Cl)](8-) is the first observation with host shell structure in polyoxovanadate chemistry.

High-pressure and-temperature synthesis and characterization of mixed valence perovskite oxides LaTi1-xMgxO3

Perovskite oxides LaTi1-xMgxO3 (x = 0.25, 0.5) were synthesized using high-pressure and-temperature method. LaTi0.75Mg0.25O3 is a new compound. This new synthesis route has some advantages. XRD analysis showed that the x = 0.25 sample belongs to cubic perovskite-type structure and the a = 0.5 sample belongs to orthorhombic perovskite-type structure. EPR measurement indicated that Ti ions were in mixed valence state of +3 and +4. IR measurement indicated that the vibration frequency and width of BO6 octahedron stretching vibration absorption band decreases with the increasing of x. The valence state of Ti ions can be altered by high-pressure and-temperature. (C) 2000 Elsevier Science S.A. All rights reserved.

Hydrothermal synthesis and structural characterization of a mixed-valence molybdenum (IV,VI) arsenate (III): Ni(H2NCH2CH2NH2)(3)[((MoO6)-O-IV)(Mo6O18)-O-VI((As3O3)-O-III)(2)]H2O

A novel mixed-valence molybdenum(IV, VI) arsenate(III), Ni(H2NCH2CH2NH2)(3)[((MoO6)-O-IV)(Mo6O18)-O-VI((As3O3)-O-III)(2)]H2O, hydrothermally synthesized and characterized by single-crystal X-ray diffraction and thermogravimetric analysis. The polyanion cage derives from the Anderson structure, in which the central octahedron was filled up by molybdenum(IV) and it was capped on both sides by a novel As3O63- cyclo-triarsenate(III). The title compound had a high catalytic activity for the oxidation of benzaldehyde to benzoic acid using H2O2 as oxidant in a liquid-solid biphase system. (C) 1999 Elsevier Science B.V. All rights reserved.

Synthesis and structural characterization of V(IV) and V(V) containing mixed-valence heteropolytungstogermanates

V(IV) and V(V) containing mixed-valence heteropolytungstogermanates have been prepared by controlled potential reduction of corresponding GeW9V3O407-, their electronic spectra have been recorded. The ESR spectra of one-electron-reduced anions in solution at 340K consist of more than 40 equally spaced lines, showing that the three VO6 octahedra in both alpha- and beta-forms are corner-shaped and one of the bridging oxygen atoms is protonated at pH 4.7.

ELECTROCATALYTIC PROPERTIES OF MIXED-VALENCE MOLYBDENUM OXIDE THIN-FILM MODIFIED MICROELECTRODES

A compact blue conducting mixed-valence Mo (VI,V) oxide film was grown on the surface of a carbon fibre (CF) microelectrode by cycling the potential between +0.20 and similar to 0.70 V SCE in freshly prepared Na2MoO4 solution in H2SO4 (pH 2). The thicknes

The synthesis and crystal structure of vanadium complexes: [(VO2)-O-IV(phen)(2)]center dot 6H(2)O and [2,2 '-(bipy)(2)(VO2)-O-V](H2BO3)center dot 3H(2)O

The organic-inorganic hybrid materials vanadium oxide [(VO2)-O-IV(phen)(2)](.)6H(2)O (1) and [(2,2'-bipy)(2)(VO2)-O-V](H2BO3)(.)3H(2)O (2) have been conventional and hydrothermal synthesized and characterized by single crystal X-ray diffraction, elemental analyses, respectively. Although the method and the ligand had been used in the syntheses of the compounds (1) and (2) are different, they almost possess similar structure. They all exhibit the distorted octahedral [VO2N4] unit with organonitrogen donors of the phen and 2,2'-bipy ligands, respectively, which coordinated directly to the vanadium oxide framework. And they are both non-mixed-valence complexes. But the compound (1) is isolated, and the compound (2) consists of a cation of [(2,2'-bipy)(2)(VO2)-O-V](+) and an anion of (H2BO3)(-). So the valence of vanadium of (1) and (2) are tetravalence and pentavalence, respectively. Meanwhile it is noteworthy that pi-pi stacking interaction between adjacent phen and 2,2'-bipy groups in compounds I and 2 also play a significant role in stabilization of the structure. Thus, the structure Of [(VO2)-O-IV(phen)(2)](.)6H(2)O and [(2,2'-bipy)(2)(VO2)-O-V](H2BO3)(.)3H(2)O are both further extended into interesting three-dimensional supramolecular.

Structure characteristics and valence state study for La1-xNaxTiO3 synthesized under high-pressure and high-temperature conditions

By using a novel high-pressure, high-temperature method, perovskite oxides of La1-xNaxTiO3 (x = 0.05, 0.1-0.8) with mixed valence state were synthesized. XRD analysis shows a cubic cell for the samples. Cell volumes of the samples with 0.1 less than or equal to x less than or equal to 0.5 decreases as x increases, and the cell Volume for x = 0.05 is smaller than that for x = 0.1. XPS of surface and EPR measurements indicate that Ti ions are of mixed valence of +3 and +4 and that A-cations vacancies exist in the samples. As x increases, the amount of Ti3+ ions decreases and the amount of A-cations vacancies increases. The valence state of Ti ions can be altered by changing both pressure and temperature. (C) 2000 Elsevier Science B.V. All rights reserved.

Simultaneous Determination of Multi-Organotin Compounds in Seawater by Liquid-Liquid Extraction-High Performance Liquid Chromatography-Inductively Coupled Plasma Mass Spectrometry

The hyphenated technique of high performance liquid chromatography coupled with inductively coupled plasma mass spectrometry (HPLC-ICP-MS) was applied to the simultaneous determination of five organotin compounds (trimethyltin, dibutyltin, tributyltin, diphenyltin and triphenyltin) in seawater samples. Agilent TC-C18 column was used for the separation, the mobile phase of HPLC was CH3CN : H2O: CH3COOH=65 : 23 : 12 (phi), 0.05% TEA, and pH value was adjusted to 3.0 by diluent ammonia. The flow rate was 0.6 mL . min(-1). Five mixed organotin compounds in a mix standard solution from 100 to 0.5 mu g . L-1 were applied for the method assessment. The experimental results indicate that the correlation coefficient of calibration curves (R-2) for each organotin compound was over 0.998 and the detection limits of the five organotin compounds were lower than 3 ng . L-1. Different mixed organic solvents including dichloromethane or toluene were used for extraction of organotin and the extraction condition of organotin from seawater was optimized. The 100 mL seawater acidized by hydrochloric acid was extracted by 10 mL carbon dichloride (CH2Cl2) with 2% tropolone for 10 min twice. Extracted organic solvents were mixed And blown to one drop by nitrogen with the rate of 1.7 mL . min(-1), then 1 mL acetonitrile was added to the drop for redissolving the organotin compounds. Finally, the mixed redissolution was filtered by 0.22 mu m organic filter membrane before analysis. it was found that the only organotin compound in seawater was triphenyltin (TPHT) and the content was 53.2 ng . L-1. The recoveries test from the standard addition for diphenyltin (DPHT), dibutyltin (DBT), tributyltin (TBT) and triphenyltin (TPHT) were over 80%. However, the recovery for trimethyltin (TMT) was relatively low and the value was 50%. The reason might be attributed to the decomposition or adsorption of those compounds during the extraction procedure. Further study on this subject is in progress.

Ab initio study on the electronic, magnetic, and mechanical properties of CaCu3V4O12

The electronic, magnetic, and mechanical properties of CaCu3V4O12 are investigated by use of the density functional theory method. The calculated results indicate that CaCu3V4O12 is a half-metallic and ferrimagnetic compound. The magnetic coupling for Cu-V is antiferromagnetic, while those for Cu-Cu and V-V are ferromagnetic. The obtained elastic constants suggest that the compound is mechanically stable. The calculated oxidation states and density of states reveal the existence of a mixed valence for Cu and V. This supports the experimental observation of the mixed valence in Ca2+Cu2+Cu2+(V25+V24+)O-12.

A novel 3D network coordination polymer consisting of paddlewheel Co-3 clusters connected by PO4 and 4-pyridinecarboxylate

The synthesis, structural characterization and preliminary magnetic studies of a novel coordination polymer with paddlewheel Co-3 clusters are reported firstly. In the polymer, Co-3 clusters are covalently linked through PO4 tetrahedra and 4-pyridinecarboxylate (4-pya) ligands into interpenetrated three-dimensional network.

Photochemical synthesis, characterization and X-ray crystal structure of dodecamolybdophosphate tetrabutylammonium heteropoly blue (Bu4N)(4)[PMo12O40]center dot 2DMF center dot H2O

In this paper, we will report the preparation of a mixed-valence polyoxometalate compound (Bu4N)(4)[PMo12O40].2DMF.H2O (TBA = tetrabutylammonium; DMF = N,N-dimethyl formamide). The title compound has been photochemically synthesized and characterized by using elemental analysis, IR, solid diffusion reflectance electronic spectra, ESR spectra, XPS, CV and X-ray single-crystal analysis. The crystal lographic data are as follows: monoclinic, P2(1)/c, a = 14.124(3), b = 17.481(4), c = 22.744(5) Angstrom, beta = 101.66(3)degrees, V = 5500(2) Angstrom(3), C70H160Mo12N6O43P, M-r = 2956.29, Z = 2, D-c = 1.785 g/cm(3), F(000) = 2970 and mu(MoKalpha) = 1.412 mm(-1). The structure has been refined to R = 0.0638 and wR = 0.1975 by full-matrix least-squares methods. The title compound is composed of four tetrabutylammonium cations, one [(PMoMo11O40)-Mo-V](4-) heteropoly anion, two N,N-dimethyl formamide and one H2O molecule.

Synthesis, properties and X-ray crystal structure of a new heteropolyacid supermolecular charge-transfer complex [(VB1)(2)DMFHPMo12O40 center dot 5DMF]

The title complex [(VB1)(2)DMFHPMo12O40.5DMF, VB1 = vitamin B-1 (thiamine chloride), DMF = N,N-dimethylformamide] has been synthesized and characterized by elemental analysis, IR, UV-Vis, electron spin resonance, X-ray photoelectron spectroscopy and cyclic voltammetry methods. The X-ray crystal structure revealed that there is one independent molecule in the unit cell of the title complex that contains one mixed-valence heteropolyanion, two VB1+ cations and six DMF molecules. The title complex possesses a centrosymmetrical arrangement in the unit cell, with the P atom at the symmetry center of the heteropolyanion and with eight O atoms surrounding the central P atom, such that two sets of PO4 tetrahedra are formed. The PO4 tetrahedra and MoO66-(7-) octahedra are disordered in the heteropolyanion. The bond distances of P-O-a and Mo=O-d are in the ranges 1.57 (4)-1.70 (4) Angstrom and 1.61 (2)-1.67 (2) Angstrom, respectively.

Heptairon bis(phosphate) tetrakis(hydrogenphosphate)

A new iron hydrogen phosphate, heptairon bis(phosphate) tetrakis(hydrogenphosphate), Fe-7(PO4)(2)(HPO4)(4), has been prepared hydrothermally and characterized by single-crystal X-ray diffraction. The compound has one Fe atom on an inversion centre and is isostructural with Mn-7(PO4)(2)(HPO4)(4) and Co-7(PO4)(2)(HPO4)(4). The structure is based on a framework of edge- and corner-sharing FeO6, Fe-5 and PO4 polyhedra, isotypic with that found in the mixed-valence iron phosphate Fe-7(PO4)(6). The Fe atoms in the title compound are purely in the divalent state, just like the Co atoms in Co-7(PO4)(2)(HPO4)(4), the necessary charge balance being maintained by the addition of H atoms in the form of bridging Fe-OH-P groups.