AN EXPERIMENTAL-STUDY ON MEMBRANE DISTILLATION FOR TREATMENT OF GINSENG DEW AND GINSENG WASHING WATER

Membrane distillation is a new membrane separation process which has been developed in the last few years. When a piece of microporous hydrophobic membrane separates two kinds of aqueous solutions different in temperature, the solutions cannot transport through the pores of membrane in any directions because of the hydrophobicity of membrane. However, vapor can readily penetrate through the

生物质煤气废水氨氮脱除的研究

生物质煤气废水是一种新出现的高浓度氨氮有机废水。作者采用化学沉淀法去除该废水中的氨氮，研究了不同沉淀剂、pH、温度和搅拌时间对氨氮去除效果的影响。结果表明，MgCl2＋Na3PO4·12H2O明显优于其他沉淀剂组合。当n（Mg^2＋）：n（NH4^＋）：n（PO4^3-）=1：1：1、pH10．0、温度30℃、搅拌时间30min时，废水中的氨氮质量浓度从处理前的222mg/L降到17mg／L，去除率为92.3％。

植物路与土质路产流产沙过程的比较试验

通过室内人工降雨+放水冲刷相结合的方法,对5个坡度(3~18°),5种雨强(1~3mm.min-1),5组放水流量(1.4~9.0kg.m-2.s-1)下的黄棉土土质路面和早熟禾植物路面进行了共60余场次试验,对比分析了植物路相对于土质路侵蚀过程差异及产水、减沙效果。结果表明:在放水冲刷条件下,植物路侵蚀率随放水历时降低,其过程可用对数函数描述;土质路面侵蚀率变化复杂。两类道路的放水流量与侵蚀强度均呈现幂函数变化,且植物道路表现出明显的防蚀作用。雨强增加引起径流量、侵蚀强度增加,土质路的增加快于植物路;坡度增大时,侵蚀强度增大,径流深则为植物路稳定,土质路有小幅增加。植物路相对土质路的减沙幅度为26.24%~47.22%,减少能力可用抛物线方程描述,但植物路较土质路面有利于产生径流,径流深增加幅度平均为58.7%~144.1%,由于径流的泥沙含量大大降低,道路的侵蚀产沙反而有一定降低。

On-line introduction of high-pressure gas-liquid sample for capillary gas chromatographic analysis

An on-line sample introduction technique in capillary gas chromatograph (CGC) for the analysis of high-pressure gas-liquid mixtures has been designed and evaluated. A sample loop of 0.05 muL and a washing solvent loop of 0.5 muL are mounted on a 10-port switching valve, which serves as the injection valve. A capillary resistor was connected to the vent of sample loop in order to maintain the pressure of the sample. Both the sample and the washing solvent are transferred into the split-injection port through a narrow bore fused silica capillary inserted into the injection liner through a septum. The volume of the liner is used both as the pressure-release damper and evaporation chamber of the sample. On-line analysis of both reactants and resultants in ethylene olimer reaction mixture at 5 MPa was carried out, which demonstrated the applicability of the technique. (C) 2004 Elsevier B.V. All rights reserved.

Controlled release of urea encapsulated by starch-g-poly(L-lactide)

This paper presented a new approach for preparing a new type of slow-release membrane-encapsulated urea fertilizer with starch-g-PLLA as biodegradable carrier materials. By solution-casting and washing rapidly with water the urea was individually encapsulated within the starch matrix modified by L-lactide through in situ graft-copolymerization.

Carbon dioxide pressure induced heterogeneous and homogeneous Heck and Sonogashira coupling reactions using fluorinated palladium complex catalysts

The Heck reaction of iodobenzene and methyl acrylate was investigated with CO2-philic Pd complex catalysts having fluorous ponytails and the organic base triethylamine (Et3N) in the presence of CO2 under solventless conditions at 80 degrees C. The catalysts are not soluble in the organic phase in the absence Of CO2 and the reaction occurs in a solid-liquid biphasic system. When the organic liquid mixture is pressurized by CO2, CO2 is dissolved into the organic phase and this promotes the dissolution of the I'd complex catalysts. As a result, the Heck reaction occurs homogeneously in the organic phase, which enhances the rate of reaction. This positive effect Of CO2 pressurization competes with the negative effect that the reacting species are diluted by an increasing amount of CO2 molecules dissolved. Thus, the maximum conversion appears at a CO2 pressure of around 4 MPa under the present reaction conditions. The catalysts are separated in the solid granules by depressurization and are recyclable without loss of activity after washing with n-hexane and/or water.

Studies on Mechanical Properties of Full-Biodegradable Starch-PVA-Polyester Films

A kind of full-biodegradable film material is discussed in this article. The film material is composed of starch, PVA, degradable polyesters(PHB, PHB-V, PCL) with built plasticizer, a cross-linking reinforcing agent and a wet strengthening agent. It contains a high percentage of starch, costs cheap and is excellent in weather fastness, temperature resistance and waterproof and it could be completely biodegraded. The present paper deals mainly with a new technical route using a new type of electromagnetic dynamic blow molding extruder and some effects on mechanical properties of the system.

Capacitive detection of glucose using molecularly imprinted polymers

A novel glucose biosensor based on capacitive detection has been developed using molecularly imprinted polymers. The sensitive layer was prepared by electropolymerization of o-phenylenediamine on a gold electrode in the presence of the template (glucose). Cyclic voltammetry and capacitive measurements monitored the process of electropolymerization. Surface uncovered areas were plugged with 1-dodecanethiol to make the layer dense, and the insulating properties of the layer were studied in the presence of redox couples. The template molecules and the nonbound thiol were removed from the modified electrode surface by washing with distilled water. A capacitance decrease could be obtained after injection of glucose. The electrode constructed similarly but with ascorbic acid or fructose only showed a small response compared with glucose. The stability and reproducibility of the biosensor were also investigated. (C) 2001 Elsevier Science B.V. All rights reserved.

Studies on the transport of lanthanides ions through the membrane of human erythrocyte in vitro by ICP-MS

A method was developed for the determination of lanthanum in the cytoplasm of human erythrocytes after they were incubated in lanthanum nitrate or citrate solutions. The lanthanum concentration in the cytoplasm of incubated erythrocytes is much higher than that in normal erythrocytes. It is suggested lanthanum can transport through the membrane of erythrocyte in vitro. Solutions containing chelator are unsuitable to be washing buffer in the investigation.

Role of Lithium in Multicomponent Oxide Catalysts for Oxidative Coupling of Methane

The effect of Li content in a series of multicomponent oxides LixLa0.5Ti0.5 For methane oxidative coupling has been studied. The catalytic activities of LiLa0.5Ti0.5 catalyst before and after washing with boiling water have been compared. The surface and

海洋藻类功能性蛋白质的纯化、鉴定及其应用的研究

使用膨化柱和离子交换或羟基磷灰石柱层析相结合的方法，分别从多管藻、坛紫菜及钝顶螺旋藻中分离纯化了R-藻红蛋白溶液和C-藻蓝蛋白。光谱检测及电泳分析结果证明完全符合经典的藻胆蛋白纯度标准。彭化床最突出的优点是克服了常规分离方法堵塞色谱柱的难题，纯化速度快、产量高、不需要常规色谱方法所要求的填料的平衡及粗提液的预处理，仅需一步操作就可以得到满足一般食品添加剂纯度要求的藻胆蛋白，极大地简化了后续的纯化程序，减少了分离纯化的步骤和时间，而其产率及纯度均高于常规的藻胆蛋白分离方法。这同时也降低了藻胆蛋白分离纯化的成本。 本文通过戊二醛或环氧氯丙烷交联的方法，合成了四种壳聚糖-氨基酸共聚小球。并选取吸附性好的戊二醛交联孔球和戊二醛交联微球系统测定了其对R-藻红蛋白和C-藻蓝蛋白的吸附和缓释性能。 纯化了藓羽藻中与其细胞器团聚密切相关的一种凝集素并进行了部分性质的鉴定。N端前15个氨基酸序列及LC-ESI-MS质谱分析结果证明此凝集素属于一种新的蛋白质族。实验证明，凝血活性与细胞器团聚活性并不完全依赖于此凝集素分子相同的结构域。 通过异双功能试剂SPDP处理藓羽藻凝集素使之衍生化，DTT处理R-PE在其分子内引入外源巯基，然后将活化的R-藻红蛋白与凝集素进行交联反应。交联产物经凝胶过滤纯化并检测，但电泳及荧光显微镜检测结果并不能证明交联探针的成功制备。

Preliminary studies on the vitrification of red sea bream (Pagrus major) embryos

The objective was to identify an appropriate cryoprotectant and protocol for vitrification of red sea bream (Pagrus major) embryos. The toxicity of five single-agent cryoprotectants, dimethyl sulfoxide (DMSO), propylene glycol (PG), ethylene glycol (EG), glycerol (GLY), and methyl alcohol (MeOH), as well as nine cryoprotectant mixtures, were investigated by comparing post-thaw hatching rates. Two vitrifying protocols, a straw method and a solid surface vitrification method (copper floating over liquid nitrogen), were evaluated on the basis of post-thaw embryo morphology. Exposure to single-agent cryoprotectants (10% concentration for 15 min) was not toxic to embryos, whereas for higher concentrations (20 and 30%) and a longer duration of exposure (30 min), DMSO and PG were better tolerated than the other cryoprotectants. Among nine cryoprotectant mixtures, the combination of 20% DMSO + 10% PG + 10% MeOH had the lowest toxicity after exposure for 10 min or 15 min. High percentages of morphologically intact embryos, 50.6 +/- 16.7% (mean +/- S.D.) and 77.8 +/- 15.5%, were achieved by the straw vitrifying method (20.5% DMSO + 15.5% acetamide + 10% PG, thawing at 43 degrees C and washing in 0.5 M sucrose solution for 5 min) and by the solid surface vitrification method (40% GLY, thawing at 22 degrees C and washing in 0.5 M sucrose solution for 5 min). After thawing, morphological changes in the degenerated embryos included shrunken yolks and ruptured chorions. Furthermore, thawed embryos that were morphologically intact did not consistently survive incubation. (C) 2007 Elsevier Inc. All rights reserved.

The study of immersion chloride extraction of iron artifacts

The chloride extraction rules of iron artifacts were studied by immersion methods. Different chloride extraction results between the alkaline solution and a washing solution were obtained. The microstructure and the anti-corrosion performance of the samples before and after treatment, were, respectively studied by the scanning electron microscope (SEM) and the potentiodynamic scanning method. The results indicated that Cl- removed according to the diffusion law. The microstructure of the samples transformed after treatment. The rusts became more compact, and the porosity also increased. The chloride extraction effect in the washing solution was better than that in the NaOH solution.