SiO2 对Bi2O3-B2O3 玻璃体系光学、热学及结构的 影响

Glasses with compositions 50Bi2O3-xB2O3- (50-x)SiO2(x=0, 10, 20, 30, 40, 50) in mol% have been prepared by using a normal melt-quench technique. The effect of SiO2 addition on thermal stability, optical properties and structural characteristic on Bi2O3-B2O3 glass were systematically investigated by using XRD, DTA, ultraviolet-visible transmittance spectra, midinfrared transmittance spectra and Raman spectra. The experimental results demonstrate that, with the addition of SiO2, thermal stability of glass samples has been obviously improved. Once the amount of SiO2 is too much, the glass samples tend to be phase seperation which results in the decrease of thermal stability. With increasing SiO2 content, the UV cutoff edge firstly shifts to short-wave band and then shifts to long-wave band, and the transmittance of mid-infrared has been greatly improved. With substitution of SiO2 for B2O3, the [BO3] triangles and [BO4] tetrahedral groups are gradually replaced by [SiO4]. [BiO6] octahedral and [SiO4] tetrahedral units are connected forming a vibrational mode of Bi-O-Si. The physical chemistry and optical performance of Bi2O3-B2O3 glass were greatly improved by addition of SiO2.

虎斑夜鳽分布与亚群态势研究

本世纪以来对虎斑夜鳽分布地点的新发现,表明该种从滨海到内陆漫布于中国长江以南广大地区,并向北渗透直逼东洋界北限秦岭-淮河一线;作者据此将各地的虎斑夜鳽初划为11个亚群,提出目前该种存有3个相对健康而稳定的亚群,即黄山-天目山亚群、南岭亚群和广西亚群,且每个亚群的分布范围均至少不会小于5000km2,其中以黄山-天目山亚群的记录由历史至现今相对最为长久而完整,进而提出今后在上述诸亚群范围之外还会有新的发现.文中指出,尽管近期对虎斑夜鳽分布状况有了新认识,目前仍可视该种的受胁等级为濒危.

云南鸟类种的新记录——海南■

2006年10月28日凌晨3点,笔者在位于云南省新平县哀牢山的金山丫口鸟类环志站进行夜间鸟类环志工作时,用灯光诱捕到一只鹭科鸟类,经鉴定为海南(Gorsachius magnificus),为云南省鸟类物种新记录。形态特征:头和颊部黑褐色;枕部具黑褐色的延长羽冠;有明显的白色眼后条纹,颊纹白色;眼球外凸,黄绿色的眼睑向外伸出;眼先裸露皮肤呈黄绿色;喉白,中央有褐色条纹;颈侧棕色,前端有黑色条纹,前颈具褐白斑驳的条纹,后颈黑褐色;背部、翅和尾羽褐色;第一枚初级飞羽外栗红色;胸、腹部、尾下覆羽及翅下覆羽白色,杂有褐色斑纹;上嘴黑色,下嘴嘴基黄色,嘴端黑色;虹膜褐色(中国鸟类野外手册上记载的虹膜为黄色,MacKinnon et al,2000);跗黄绿色。雌性标本量度(g,mm)如下:体重563,全长565,嘴峰72,翅长305,尾长111,跗76。海南是中国的特有种鸟类,属国家Ⅱ级重点保护鸟类。分布于中国南方的少数地区,国外仅在越南东京有过一次记录(MacKinnon et al,2000),种群数量稀少,过去曾记录于安徽、浙江、福建(Cheng,1987)、海南、广西及广东(Gao et al,200...

Analysis of mode characteristics for equilateral-polygonal resonators with a center hole

Mode characteristics for equilateral triangles, squares, and hexagonal resonators with a center hole are numerically simulated by the finite-different time domain (FDTD) technique. The center hole does not break the symmetry behavior of the original resonators and can result in modification of the mode field patterns and mode Q factors. In an equilateral triangle resonator the center hole can suppress the symmetry state of degenerate states with the merit of single mode operation. In a square resonator, the Q factor can be enhanced for some modes with a suitable size of the hole. For a hexagonal resonator with a side length of 1 mu m and a refractive index of 3.2, the mode Q factors first gradually decrease with the increase of the hole diameter for modes at a wavelength of about 1500 nm, then the modes transform to that of a microdisk with a jump of the mode wavelength as the hole diameter approaches 0.7 mu m. Finally, the mode Q factors greatly enhance as the hole diameter reaches about 1 mu m. The results indicate that the center hole can greatly modify mode characteristics, especially that of the mode Q factor. (C) 2009 Optical Society of America

Analysis of mode characteristics for equilateral triangle semiconductor microlasers with imperfect boundaries

The influence of imperfect boundaries on the mode quality factor is investigated for equilateral-triangle-resonator (ETR) semiconductor microlasers by the finite difference time domain technique and the Pade approximation with Baker's algorithm. For 2-D ETR with a refractive index of 3.2 and side length of 5 mum, the confined modes can still have a quality factor of about 1000 as small triangles with side length of 1 mum are cut from the vertices of the ETR. For a deformed 5 mum ETR with round vertices and curve sides, the simulated mode quality factors are comparable to the measured results.

Self-assembling of submicrometer three-dimensional photonic crystals in concave microzones etched on silicon substrates

By vertical sedimentation and oblique titration, silica microspheres were grown in different shapes of concave microzones that were etched on a (100) p-silicon substrate. Through scanning electron microscope observation and optical reflective spectra measurement, sedimentation of microspheres in those microzones was compared. An index was introduced to judge the efficiency of sedimentation. The comparison demonstrates that regular hexagons and triangles facilitate the growth of photonic crystals the most. (c) 2006 Optical Society of America

Micro-mould method for self-assembling three-dimensional opal photonic crystals

By vertical sedimentation, silica micro-spheres were grown in different shapes of concave micro-zones which were etched on a (100) p-silicon substrate. The following were found: this method can effectively raise the quality of films by avoiding cracks; the geometry of the micro-zones affects the sediment of the film; regular hexagons and triangles best facilitate the growth of photonic crystals. This method is practical for its ability to fabricate self-assembly photonic crystals in previously designed small areas.

VGIS-COLLIDE: an effective collision detection algorithm for

Collision detection is an important component in simulation applications which are based on virtual geographic information system (VGIS). In this paper, an effective collision detection algorithm for multiple objects in VGIS, VGIS-COLLIDE, is presented. The algorithm firstly integrates existing quadtree, which is the global hierarchical structure of VGIS, with axis-aligned bounding box of object to perform the broad-phase of collision detection. After that, exact collision detection between two objects which have passed the broad-phase of collision detection is performed. The algorithm makes no assumption about input primitives or object's motion and is directly applicable to all triangulated models. It can be applicable to both rigid and deformable objects without preprocessing. The performance of the algorithm has been demonstrated in several environments consisting of a high number of objects with hundreds of thousands of triangles.

Fabrication and characterization of uniform Fe3O4 octahedral micro-crystals

Uniform Fe3O4 octahedral microcrystals with perfect appearance have been successfully synthesized by a Triton X100-assisted polyol process. During the polyols process for the preparation of Fe3O4 octahedra. the introduction of Triton X100 decreases significantly the needed concentration of NaOH. The results show that Fe3O4 octahedra are composed of eight triangular sheets, which are equilateral triangles. The edge size of Fe3O4 octahedron is about 4 mu m. The magnetic properties of Fe3O4 octahedral particles were evaluated on a SQUID magnetometer at room temperature.

Thiacalix[4]arene-Supported Planar Ln(4) (Ln = Tb-III, Dy-III) Clusters: Toward Luminescent and Magnetic Bifunctional Materials

This paper reports the syntheses, crystal structures, and luminescent and magnetic properties of four tetranuclear Tb-III (1 and 3) and Dy-III (2 and 4) complexes supported by p-phenylthiacalix[4]arene (H(4)PTC4A) and p-tert-butylthiacalix-[4]arene (H(4)TC4A). All four frameworks can be formulated as [Ln(4)(III)(PTC4A/TC4A)(2)(mu(4)-OH)Cl-3(CH3OH)(2)(H2O)(3)], and some methanol and water solvent molecules are occupied in the interstices. The compounds are featured with a sandwichlike unit constructed by two tail-to-tail calixarene molecules and a planar tetragonal (mu(4)-OH)Ln(4) cluster. The photoluminescent analyses suggest that there is an efficient ligand-to-Ln(III) energy transfer for compounds 1-3 and H(4)PTC4A is a more efficient "antenna" than H(4)TC4A.

点云数据的曲面重构新算法

针对采用视觉测量方式得到的点云数据特点，提出了基于动力学数值仿真的网格曲面逼近方法。依据曲面曲率变化特性，该方法可对点云数据进行自适应压缩，并能显著提高逼近网格的品质，从而实现了点云数据的精确曲面重构。实际的算例结果表明，该方法实用可靠。