Oscillatory instability of Rayleigh-Marangoni-Bénard convection in two-layer liquid systems

The oscillatory behaviour of the Rayleigh-Marangoni-Bénard convective instability (R-M-B instability) regarding two combinations of two-layer fluid systems has been investigated theoretically and numerically. For the two-layer system of Silicone oil (10cSt) over Fluorinert (FC70), both linear instability analysis and 2D numerical simulation show that the instability of the system depends strongly on the depth ratio Hr = H1/H2 of the two-layer liquid. The oscillatory regime at the onset of R-M-B convection enlarges with reducing Γ = Ra/Ma values. In the two-layer system of Silicone oil (2cSt) over water, it loses its stability and onsets to steady convection at first, then the steady convection bifurcates to oscillatory convection with increasing Rayleigh number Ra. This behaviour was found through numerical simulation above the onset of steady convection in the case of r = 2.9, ε=(Ra-Ruc)/Rac = 1.0, and Hr = 0.5. Our findings are different from the previous study of the Rayleigh-Benard instability and show the strong effects of the thermocapillary force at the interface on the time-dependent oscillations at or after the onset of convection. We propose a secondary oscillatory instability mechanism to explain the experimental observation of Degen et al. [Phys. Rev. E, 57 (1998), 6647-6659].

Study of the Adsorption of Fibrinogen on Gold-Coated Silicon Wafer by an Impedance Method

In 0.1 mol/l KH2PO4–Na2HPO4 (pH 7.80) buffer solution, the potential of zero charge (PZC) and the open circuit potential of gold-coated silicon were determined to be about −0.6 and +0.10 V (vs SCE), respectively. The open circuit potential was higher than the PZC, which indicated that the surface of the gold-coated electrode had a positive charge. The ellipsometry experiment showed that the adsorption of fibrinogen onto the gold-coated silicon wafer surface arrived at a saturated state when the adsorption time exceeded 50 min. The percentage of surface without adsorbed protein, θ, was about 63%. This means that the proportion of surface actually occupied by fibrinogen was only about 37% after the adsorption arrived at saturation. The solution/protein capacitance value was determined in an impulse state around −0.59 V (vs SCE) and was stable (4.2×10−5 F) at other potentials.

MODIFIED DIRECT TWOS-COMPLEMENT PARALLEL ARRAY MULTIPLICATION ALGORITHM FOR COMPLEX MATRIX OPERATION

A direct twos-complement parallel array multiplication algorithm is introduced and modified for digital optical numerical computation. The modified version overcomes the problems encountered in the conventional optical twos-complement algorithm. In the array, all the summands are generated in parallel, and the relevant summands having the same weights are added simultaneously without carries, resulting in the product expressed in a mixed twos-complement system. In a two-stage array, complex multiplication is possible with using four real subarrays. Furthermore, with a three-stage array architecture, complex matrix operation is straightforwardly accomplished. In the experiment, parallel two-stage array complex multiplication with liquid-crystal panels is demonstrated.

激光脉冲宽度对有质动力加速电子的影响

基于真空中单电子运动模型，编程计算得到了高斯激光脉冲与初始位于激光传播轴上电子的相互作用结果。不同激光参鼍条件下，得到了电子的能量增益与激光强度、焦斑大小和脉冲宽度关系。结果表明，高斯激光脉冲焦斑较大时，电子没有明显的能量增益，高斯激光脉冲焦斑太小时，电子也没有明显的能量增益。电子的能量增益有一个最佳焦斑大小。在相同激光强度下，电子能量增益的最佳焦斑大小随脉冲宽度的增大而增大，但最佳焦斑大小与脉冲宽度的比值基本上是不变的。

Cu膜的光学特性尺寸效应及最小连续膜厚研究

采用离子束溅射在K9玻璃基底上沉积了不同厚度的Cu膜，利用Lambda-900分光光度计，测量了波长为310nm到1300nm范围内Cu膜的反射率和透射率．选定波长为310、350、400、430、550、632、800、1200nm时对薄膜的反射率、透射率和吸收率随膜厚变化的关系进行研究．同时，对Cu膜的光学常量也进行了讨论．结果显示，Cu膜的光学特性都有明显的尺寸效应．将波长为550nm时的反射率和透射率随Cu膜厚度变化关系的交点对应厚度作为特征厚度，该厚度可认为是金属Cu膜生长从不连续膜进入连续膜的

神农架巴山冷杉天然林凋落物特性的研究

神农架地区的巴山冷杉（Abies fargesii）林是秦巴山地重要的森林生态系统类型，长期以来其在水土保持、水源涵养、林产品供给等方面的生态服务功能受到了广泛的重视，近年来该类森林的生物地球化学循环正成为关注的热点。本文以神农架巴山冷杉天然林为研究对象，从其凋落物的数量、养分、能量3个方面入手，着重研究1)凋落物组成及其凋落量的月变化模式;2)凋落物养分含量及养分年归还量的特征;3）凋落物的能流量及其月变化模式。研究表明： 巴山冷杉天然林的年凋落量为5702.99kg.hm-2，处于亚热带森林年凋落量的范围内;巴山冷杉林的凋落物组成比较丰富，主要有落叶、落枝、球花、球果和其它五部分，其中以落叶为多，占总凋落量的46.00%;凋落量的月变化模式呈双峰型，分别在2006年10-11月和2007年4-5月达到峰值。 巴山冷杉林凋落物养分含量的大小顺序为：N＞K＞Ca＞P＞Mg;N、P、K、Ca、Mg的年归还量分别为：39.1063 kg.hm-2、4.5346 kg.hm-2、13.4367 kg.hm-2、5.4965 kg.hm-2、0.0911 kg.hm-2，以N的年归还量最多;就凋落物各组分的养分年归还量而言，落叶的养分归还量远远大于其余组分的养分归还量，占总归还量的52.65%。因此，不论凋落量还是养分归还量，巴山冷杉林凋落物中的落叶都占有绝对的优势。 在巴山冷杉林凋落物各组分中，干重热值介于20.60 KJ/g 至22.70 KJ/g之间，灰分浓度介于1.38%至5.94%之间，去灰分热值介于21.34 KJ/g至23.55KJ/g之间，充分表明了灰分对热值的影响。在各组分中，无论是干重热值还是去灰分热值，均以落叶的热值最高。从整年来看，落叶的热值在2006年10－11月和2007年6－7月较高。巴山冷杉林通过凋落物的年能流量为 12500.96 KJ.m-2，以落叶能流量最大，占总能流量的47.72%。通过计算凋落物的能流量占太阳有效辐射的百分数可以得出太阳辐射进入凋落物的转化效率，巴山冷杉林凋落物的能量转化效率为0.61%，这在亚热带和热带森林类型中属于中等水平。

基于磷酸丙糖异构酶基因序列的蓝氏贾第鞭毛虫分子系统发育的研究

[目的 ]探讨蓝氏贾第鞭毛虫种内系统发育及遗传多样性。 [方法 ]对不同来源虫株的磷酸丙糖异构酶(tim)基因进行 PCR扩增、序列测定后 ,用简约法和 NJ法构建分子系统树进行系统学分析。 [结果 ]在所测序列中共有 12 4个位点存在变异 (2 3% ) ,且大多数为发生在第三密码子的同义突变 ,两种构树方法所得两树的分枝结构相似 ,均将受试的 16株蓝氏贾第鞭毛虫分为明显的两组。 [结论 ]tim基因可作为研究蓝氏贾第鞭毛虫群体遗传结构一个有效的遗传标记

脂质体携载抗HIV-1药物

由于mV耐药株的产生、特殊器官和细胞中}Ⅱv的隐匿、抗}Ⅱv药物的毒副反应及半衰期短等问题的出现．促 使人们寻找高效低毒和具有靶向性的抗Ⅲv药物。脂质体具有被动或主动靶向病毒复制活跃和贮存区、细胞内靶向和控制药 物释放、延长药物半衰期、提高药效和降低毒副作用等优点．是潜在携载抗}Ⅱv药物的良好载体。

巢湖富营养化对河蚬和环棱螺分布及种群密度影响

2001年9月和2002年9月两次对巢湖河蚬和环棱螺的调查表明,在富营养化程度较重的西湖区,河蚬生物量分别为17.87和47.29g.m-2;环棱螺生物量分别为45.45和12.56g.m-2.而在富营养化程度较轻的东湖区,河蚬的生物量分别为67.86和96.18g.m-2;环棱螺的生物量分别为32.00和31.21g.m-2.河蚬和环棱螺的种群密度和生物量均随水体富营养化的加剧而下降.近岸带河蚬和环棱螺的密度和生物量明显高于敞水区.河蚬的分布型为核心型,而环棱螺更接近随机性分布.河蚬和环棱螺的种群密度和

Directional emission InP/GaInAsP square-resonator microlasers

InP/GaInAsP square-resonator microlasers with an output waveguide connected to the midpoint of one side of the square are fabricated by standard photolithography and inductively-coupled-plasma etching technique. For a 20-mu m-side square microlaser with a 2-mu m-wide output waveguide, cw threshold current is 11 mA at room temperature, and the highest mode Q factor is 1.0 X 10(4) measured from the mode linewidth at the injection current of 10 mA. Multimode oscillation is observed with the lasing mode wavelength 1546 nm and the side-mode suppression ratio of 20 dB at the injection current of 15 mA. (C) 2008 Optical Society of America

Growth and characterization of GaInNAs by molecular beam epitaxy using a nitrogen irradiation method

We propose an innovative technique, making use of the In segregation effect, referred as the N irradiation method, to enhance In-N bonding and extend the emission wavelength of GaInNAs quantum wells (QWs). After the formation of a complete In floating layer, the growth is interrupted and N irradiation is initiated. The majority of N atoms are forced to bond with In atoms and their incorporation is regulated independently by the N exposure time and the As pressure. The effect of the N exposure time and As pressure on the N incorporation and the optical quality of GaInNAs QWs were investigated. Anomalous photoluminescence (PL) wavelength red shifts after rapid thermal annealing (RTA) were observed in the N-irradiated samples, whereas a normal GaInNAs sample revealed a blue shift. This method provides an alternative way to extend the emission wavelength of GaInNAs QWs with decent optical quality. We demonstrate light emission at 1546 nm from an 11-nm-thick QW, using this method and the PL intensity is similar to that of a 7-nm-thick GaInNAs QW grown at a reduced rate. (C) 2008 Elsevier B.V. All rights reserved.