Measuring Receptor/Ligand Interaction at the Single-Bond Level: Experimental and Interpretative Issues

There is increased interest in measuring kinetic rates, lifetimes, and rupture forces of single receptor/ligand bonds. Valuable insights have been obtained from previous experiments attempting such measurements. However, it remains difficult to know with sufficient certainty that single bonds were indeed measured. Using exemplifying data, evidence supporting single-bond observation is examined and caveats in the experimental design and data interpretation are identified. Critical issues preventing definitive proof and disproof of single-bond observation include complex binding schemes, multimeric interactions, clustering, and heterogeneous surfaces. It is concluded that no single criterion is sufficient to ensure that single bonds are actually observed. However, a cumulative body of evidence may provide reasonable confidence. 0 2002 Biomedical Engineering Society.

Researches on essential mechanics issues for submerged floating tunnel

Since 2001, a research group in the Institute of Mechanics, Chinese Academy of Sciences, has been devoted to the research of essential mechanics issues for submerged floating tunnel (SFT). In addition to the structural design of the SFT prototype in Qiandao Lake, the relevant researches cover a number of topics. This paper briefly describes the research procedure and results, including dynamic response of SFT due to surface wave, vortex-induced vibration of anchoring system, structural analysis of curved SFT, temperature effects of curved SFT, structural dynamic response due to accidental load, and effects of structural parameters (buoyancy-weight ratio, tunnel length，tether stiffness，etc.) on dynamic response.

Some engineering issues of an FBG sensor with the dual gratings parallel matched interrogation method

The key issues of engineering application of the dual gratings parallel matched interrogation method are expanding the measurable range, improving the usability, and lowering the cost by adopting a compact and simple setup based on existing conditions and improving the precision of the data-processing scheme. A credible and effective data-processing scheme based on a novel divisional look-up table is proposed based on the advantages of other schemes. Any undetermined data is belonged to a certain section, which can be confirmed at first, then it can be looked up in the table to correspond to microstrain by the scheme. It not only solves inherent problems of the traditional one (double value and small measurable range) but also enhances the precision, which improves the performance of the system. From the experimental results, the measurable range of the system is 525 mu epsilon, and the precision is +/- 1 mu epsilon based on normal matched gratings. The system works in real time, which is competent for most engineering measurement requirements. (C) 2007 Elsevier GmbH. All rights reserved.

Metrical dental analysis on golden monkey (Rhinopithecus roxellana)

Dental variation in the Chinese golden monkey (Rhinopithecus roxellana) is here evaluated by univariate, bivariate, and multivariate analyses. Allometric analyses indicate that canines and P3s are positively, but other dimensions negatively scaled to mandible and maxilla, and to body size. With the exception of the mesiodistal dimensions of I-1 and M-3, and the buccolingual dimension of Pq, mandibular dental variables show similar scaling relative to body size. Analysis of residuals shows that males have significantly larger canine, P-3 and buccolingual dimensions of the postcanine teeth (M-2 and M-3) than females. A significant difference in shape between the sexes is found in the buccolingual dimension of the upper teeth, but not in the mandible. Unlike the situation in some other species, Female golden monkeys do nor exhibit relatively larger postcanine teeth than males, in fact, the reverse is true, especially for M(2)s and M(3)s. The fact that most of the dental variables show low negative allometry to body size might be related a cold environment that has led to the development of larger body size with I-educed energy loss. When the raw data are examined by Discriminant Function Analysis the sexes are clearly distinguishable.

The Yangtze River dolphin or baiji (Lipotes vexillifer): population status and conservation issues in the Yangtze River, China

1. Baiji were sighted 17 times during three recent simultaneous multi-vessel surveys in the Yangtze River, China (November 4-10, 1997; December 4-9, 1998; October 31-November 5, 1999). There were 11 sightings in 1997 (consisting of 17 animals), five in 1998 (seven animals), and two in 1999 (four animals). It was concluded that 13 individuals Could be considered as a minimum number of the baiji currently in the Yangtze River. 2. An annual rate of population decrease was roughly estimated as 10%. From the body sizes observed, the proportions of old, adult and immature individuals were approximately estimated at 57, 26, and 17% respectively. 3. Baiji showed a significant attraction to confluences and sand bars with large eddies. The present distribution range of the baiji is less than 1400 km in length in the Yangtze main river. Distances between the two nearest groups of baiji appear to be increasing. 4. Two typical sightings are described, in which surfacing and movements of baiji were recorded. Baiji were often found swimming together with finless porpoise. In the surveys they occurred in the same group in 63% of occurrences. Interactions between baiji and finless porpoise are described and discussed. 5. Human activities are the main threats to the baiji. Illegal electrical fishing accounted for 40% of known mortalities during the 1990s. Engineering explosions for maintaining navigation channels have become another main cause of baiji deaths. The last hope of saving the species may be to translocate the remaining baiji into a semi-captive reserve. known as the 'Baiji Semi-natural Reserve'. Copyright (C) 2003 John Wiley Sons, Ltd.

Morphological defects and uniformity issues of 4H-SiC homoepitaxial layers grown on off-oriented (0001)Si faces

The morphological defects and uniformity of 4H-SiC epilayers grown by hot wall CVD at 1500 degrees C on off-oriented (0001) Si faces are characterized by atomic force microscope, Nomarski optical microscopy, and Micro-Raman spectroscopy. Typical morphological defects including triangular defects, wavy steps, round pits, and groove defects are observed in mirror-like SiC epilayers. The preparation of the substrate surface is necessary for the growth of high-quality 4H-SiC epitaxial layers with low-surface defect density under optimized growth conditions. (c) 2006 Elsevier Ltd. All rights reserved.

Morphological defects and uniformity issues of 4H-SiC homoepitaxial layers grown on off-oriented (0001)Si faces

The morphological defects and uniformity of 4H-SiC epilayers grown by hot wall CVD at 1500 degrees C on off-oriented (0001) Si faces are characterized by atomic force microscope, Nomarski optical microscopy, and Micro-Raman spectroscopy. Typical morphological defects including triangular defects, wavy steps, round pits, and groove defects are observed in mirror-like SiC epilayers. The preparation of the substrate surface is necessary for the growth of high-quality 4H-SiC epitaxial layers with low-surface defect density under optimized growth conditions. (c) 2006 Elsevier Ltd. All rights reserved.

Starch grains from dental calculus reveal ancient plant foodstuffs at Chenqimogou site, Gansu Province

National Natural Science Foundation of China [40771205]; National Science Fund for Distinguished Young Scholars [40625002]; Chinese Academy of Sciences [KZCX2-YW-315]

Coal-burning roasted corn and chili as the cause of dental fluorosis for children in southwestern China

To find the pathologic cause of the children's dental fluorosis in southwestern China, diet structure before the age of 6 and prevalence rate of dental fluorosis (DF) of 405 children were investigated, and the fluorine and arsenic content of several materials were determined. The prevalence rate of DF of children living on roasted corn before the age of 6 is 100% with nearly 95% having the mild to severe DF; while that of children living on non-roasted corn or rice is less than 5% with all having very mild DF. The average fluorine and arsenic concentration are 20.26 mg/kg and 0.249 mg/kg in roasted corn, which are about 16 times and 35 times more than in non-roasted corn, respectively. The average fluorine concentration is 78 mg/kg in coal, 1116 mg/kg in binder clay and 313 mg/kg in briquette (coal mixed with clay). The average arsenic concentration of coal is 5.83 mg/kg, the binder clay is 20.94 mg/kg, with 8.52 mg/kg in the briquette. Living on roasted corn and chili is the main pathologic cause of endemic fluorosis in southwestern China. The main source of fluorine and arsenic pollution of roasted corn and chill is the briquette of coal and binder clay. (C) 2010 Elsevier B.V. All rights reserved.

Effect of immersion in various media on the sorption, solubility, elution of unreacted monomers, and flexural properties of two model dental composite compositions

Immersion in various media has different effect on the properties of dental composites, such as sorption, solubility, elution of unreacted monomers, flexural strength, and flexural elastic modulus. In the present work, the effect of immersion in various media and the relationship between the variation of these properties and the components of dental composite were investigated.