Bibliometric analysis of biological invasions research during the period of 1991 to 2007

The objective of this study is to conduct a bibliometric analysis of all biological invasions-related publications in the Science Citation Index (SCI) from 1991 to 2007. The indicator citation per publication (CPP) was used to evaluate the impact of articles, journals, and institutions. In the 3323 articles published in 521 journals, 7261 authors from 1905 institutions of 100 countries participated. As the most productive country of biological invasions research, the US will benefit from more collaboration between institutions, countries, and continents. In addition, analysis of keywords was applied to reveal research trends.

Bibliometric analysis of nicotine research in China during the period of 1991 to 2007

With the widespread exposure of people to nicotine through recreational use of tobacco products, research into nicotine has attracted increasing attention. Tobacco smoking is by far the most important cause of lung cancer. As the world's largest producer and consumer of tobacco products, China bears a large proportion of the global burden of smoking-related disease; therefore, information on nicotine publications should be collected to formulate future research policy. In the present study, we investigated nicotine-related research articles published by Chinese authors that were indexed in the Science Citation Index (SCI) from 1991 to 2007. An indicator "citations per publication" (CPP) was used in the study to evaluate the impact of journals, articles, and institutes. The quantity of publications has increased at a quicker pace than the worldwide trend. Article visibility, measured as the frequency of being cited, also increased during the period. However, the overall quality of articles, based on the impact factor of journals publishing those articles, dropped behind the worldwide average level. There has been an increase in international collaboration, mainly with researchers in the USA. The average CPP of international co-authorship articles was higher than that of single country publications. Besides the USA, nicotine research in China will benefit from more collaboration with Taiwan, England, and Germany. Some 110 of 264 articles were published by a single institute, and the top six institutes were compared from various angles. Seventy-two subject categories were covered, and trends (in terms of both quantity and quality) of nicotine research in China were compared with worldwide trends. In addition, analysis of keywords in both nicotine and lung cancer research fields was applied to indicate research interests. Mutual cooperation among multiple disciplines needs further strengthening.

Influences Of Precursor Constitution And Processing Speed On Microstructure And Wear Behavior During Laser Clad Composite Coatings On Gamma-Tial Intermetallic Alloy

The effects of constitution of precursor mixed powders and scan speed on microstructure and wear properties were designed and investigated during laser clad gamma/Cr7C3/TiC composite coatings on gamma-TiAl intermetallic alloy substrates with NiCr-Cr3C2 precursor mixed powders. The results indicate that both the constitution of the precursor mixed powders and the beam scan rate have remarkable influence on microstructure and attendant hardness as well as wear resistance of the formed composite coatings. The wear mechanisms of the original TiAl alloy and laser clad composite coatings were investigated. The composite coating with an optimum compromise between constitution of NiCr-Cr3C2 precursor mixed powders as well as being processed under moderate scan speed exhibits the best wear resistance under dry sliding wear test conditions. (C) 2008 Elsevier Ltd. All rights reserved.

Microstructure and Tribological Properties of Laser Clad gamma/Cr7C3/Tic Composite Coatings on gamma-TiA1 Intermetallic Alloy

In order to improve the wear resistance of the gamma-TiAl intermetallic alloy, microstructure, room- and high-temperature (600 degrees C) wear behaviors of laser clad gamma/Cr7C3/TiC composite coatings with different constitution of NiCr-Cr3C2 precursor-mixed powders have been investigated by optical microscopy (OM), scanning electron microscopy (SEM), X-ray diffraction (XRD), energy-dispersive spectrometer (EDS), block-on-ring (room-temperature) and pin-on-disk (high-temperature) wear tests. The responding wear mechanisms are discussed in detail. Results show that microstructures of the laser clad composite coatings have non-equilibrium solidified microstructures consisting of primary hard Cr7C3 and TiC carbides and the inter-primary gamma/Cr7C3 eutectic matrix, about three to five times higher average microhardness compared with the TiAl alloy substrate. Higher wear resistance than the original TiAl alloy is achieved in the clad composite coatings under dry sliding wear conditions, which is closely related to the formation of non-equilibrium solidified reinforced Cr7C3 and TiC carbides and the positive contribution of the relatively ductile and tough gamma/Cr7C3 eutectics matrix and their stability under high-temperature exposure.

Microstructure and high-temperature wear and oxidation resistance of laser clad gamma/W2C/TiC composite coatings on gamma-TiAl intermetallic alloy

There are very strong interests in improving the high-temperature wear resistance of the y-TiAl intermetallic alloy, especially when applied as tribological moving components. In this paper, microstructure, high-temperature dry sliding wear at 600 degrees C and isothermal oxidation at 1000 degrees C on ambient air of laser clad gamma/W2C/TiC composite coatings with different constitution of Ni-Cr-W-C precursor mixed powders on TiAl alloy substrates have been investigated. The results show that microstructure of the laser fabricated composite coatings possess non-equilibrium microstructure consisting of the matrix of nickel-base solid solution gamma-NiCrAl and reinforcements of TiC, W2C and M23C6 carbides. Higher wear resistance than the original TiAl alloy is achieved in the composite coatings under high-temperature wear test conditions. However, the oxidation resistance of the laser clad gamma/W2C/TiC composite coatings is deceased. The corresponding mechanisms resulting in the above behaviors of the laser clad composite coatings are discussed. (c) 2006 Elsevier B.V. All rights reserved.

Preparation and Characterization of Interpenetration Polymer Network Films Based on Poly(vinyl alcohol) and Poly(acrylic acid) for Drug Delivery

A series of full interpenetrating polymer network (full-IPN) films of poly(acrylic acid) (PAA)/poly (vinyl alcohol) (PVA) were prepared by radical solution polymerization and sequential IPN technology. Attenuated total reflectance-Fourier transform infrared spectroscopy, swelling properties, mechanical properties, morphology, and glass transition temperature of the films were investigated. FTIR spectra analysis showed that new interaction hydrogen bonds between PVA and PAA were formed. Swelling property of the films in distilled water and different pH buffer solution was studied. Swelling ratio increased with increasing PAA content of IPN films in all media, and swelling ratio decreased with increasing PVA crosslink degree. Tensile strength and elongation at break related not only to the constitution of IPNs but also to the swelling ratio of IPNs.

THE VISCOSITY BEHAVIOUR OF SEP BLOCK COPOLYMER SOLUTION DURING ITS MICELLIZATION

The viscosities of polystyrene-b-poly (ethylene/propylene) diblock copolymer in mixed solvent of n-octane and benzene were measured. The influences of the constitution of the mixed solvent, temperature and concentration were on the viscosity investigated. During the micellization the solution viscosity increases rapidly. The results are consistent with the study on the micellization by light scattering. The average mass of micelleswas measured and the hydrodynamic radius of gyrations were calculated.

Gastropods on submersed macrophytes in Yangtze lakes: Community characteristics and empirical modelling

Epiphytic gastropods in Yangtze lakes have suffered from large-scale declines of submersed macrophytes during past decades. To better understand what controls gastropod community, monthly investigations were carried out in four Yangtze lakes during December, 2001-March, 2003. Composed of 23 species belonging to Pulmonata and Prosobranchia, the community is characterized by the constitution of small individuals. The average density and biomass were 417 +/- 160 ind/m(2) and 18.05 +/- 7.43 g/m(2), with maxima a-round August. Submersed macrophyte biomass is shown to be the key factor affecting species number, density, and biomass of gastropods. Accordingly, a series of annual and seasonal models yielding high predictive powers were generated. Preference analyses demonstrated that pulmonates and prosobranchs with different respiratory organs prefer different macrophyte functional groups.

汉语韵律短语切分及语调降阶和下倾研究

Firstly, prosodic boundaries of 1991 common sentences were labeled based on speech perception experiment, relation between prosodic structure and syntactic structure was examined after immediate constituent analysis, an example of prosodic phrasing from text sentences was provided using CART. Then, using designed sentences, phenomena of downstep and declination in pitch downtrend of Chinese declarative sentences were examined, commonness and speciality of Chinese intonation were discussed. The main results of the study are: 1 The distribution patterns of prosodic phrase boundaries for different syntactic structures are different, and there is great freedom in prosodic chunking. The relation between syntactic structure and prosodic structure can only be discussed in statistical sense. 2 Besides of syntactic relation, the second most important factor which influences prosodic phrase boundaries is length. The distances to the front boundary and the back boundary are more important than the lengths of the left syntactic contituent and the right one. In our corpus, the length distributions of prosodic phrases are 5±3 syllables. 3 Automatic downstep can lower intonation linearly, but is affected by stress easily. Non-automatic downstep lowers the higher part of pitch contours and has no effect on the lower one of the intonation. 4 The downtrend reason of low point is declination. The extent of declination relates to not only tones of low points, but also their positions in prosodic words, the baselines decline much faster when low point are in the initial position of a prosodic word. In long sentences, the baselines of prosodic phrases are the basic declination units, and the whole declination pattern of a sentence is related to syntactic relations between two neighboring prosodic phrases.