Phylogenetic relationships among Trichodinidae (Ciliophora : Peritricha) derived from the characteristic values of denticles

The phylogenetic relationships among trichodinids remain obscure. As an important diagnostic marker, the morphology of the denticles in the adhesive disc as well as the adoral spiral has been widely used in generic discrimination and species identification of trichodinids. We studied the characters of denticles of the ten genera of Trichodinidae and the sole genus Urceolaria of Urceolariidae by using a quantitative method. The characteristic values were used to generate Manhattan distance, on which the dendrogram was based to construct with the Unweighted Paired Group Method using the Arithmetic mean (UPGMA). The investigations show that all the genera of the family Trichodinidae were clearly separate from the outgroup Urceolaria, and within the Trichodinidae: (i) Dipartiella grouped with Trichodinella and Tripartiella and lay in the closest position to the outgroup with a low dissimilarity, suggesting Dipartiella might be the most primitive genus in the family; (ii) Hemitrichodina clustered in a single clad and lay in the farthest position to the outgroup with the highest dissimilarity, indicating that it might be the most advanced genus; and (iii) the other 6 genera, Trichodina, Paratrichodina, Semitrichodina, Vauchomia, Pallitrichodina and Trichodoxa clustered in a big clad with very low dissimilarity, showing that they are closely related to each other. We discuss the evolutionary trend of the denticle and conclude that the denticles of the adhesive disc should be an apomorphic feature of the trichodinids and their changes could reflect the evolutionary tendencies of these ciliates.

Polydispersity of ethylene sequence length in metallocene ethylene/alpha-olefin copolymers. I. Characterized by thermal-fractionation technique

In this article, the polydispersity of the ethylene sequence length (ESL) in ethylene/alpha-olefin copolymers was studied by atomic force microscopy (AFM) and the thermal-fractionation technique. The crystal morphology observation by AFM showed that morphology changed gradually with decreasing average ESL from complete lamellae over shorter and more curved lamellae to a granular-like morphology, and the mixed morphology was observed after stepwise crystallization from phase-separated melt. This result indicated that the ethylene sequence with different lengths crystallized into a crystalline phase with a different size and stability at the copolymer systems. The thermal-fractionation technique was used to characterize the polydispersity of ESL. Three of the following statistical terms were introduced to describe the distribution of ESL and the lamellar thickness: the arithmetic mean (L) over bar (n), the weight mean (L) over bar (w), and the broadness index I = (L) over bar (w)/(L) over bar (n). It was concluded that the polydispersity of ESL could be quantitatively characterized by the thermal-fractionation technique. The effects of temperature range, temperature-dependent specific heat capacity C-p of copolymer, and the molecular weight on the results of thermal fractionation were discussed,

Improved thermal fractionation technique for chain structure analysis of ethylene/alpha-olefin copolymers

In this report, we describe an improved thermal fractionation technique used to characterize the polydispersity of crystalline ethylene sequence length (CESL) of ethylene/alpha -olefin copolymers. After stepwise isothermal crystallization, the crystalline ethylene sequences are sorted into groups by their lengths. The CESLs are estimated using melting points of known hydrocarbons. The content of each group is determined using the calibrated peak area. The statistical terms: the arithmetic mean (L) over bar (n), the weighted mean (L) over bar (w) and the broadness index I = (L) over bar (w)/(L) over bar (n) are used to describe the distribution of CESL. Results show that improved thermal fractionation technique can quantitatively characterize the polydispersity of CESL with a high degree of accuracy.

Identification and assessing the cultivars of Laminaria Lamx. (phaeophyceae) with molecular markers

Molecular markers were used to identify and assess cultivars of Laminaria Lamx. and to delineate their phylogenetic relationships. Random amplified polymorphic DNA (RAPD) analysis was used for detection. After screening, 11 primers were selected and they yielded 133 bands in all, of which approximately 99.2% were polymorphic. The genetic distances between gametophytes ranged from 0.412 to 0.956. Two clusters were formed with the unweighted pair group method with arithmetic mean (UPGMA) dendrogram based on the simple matching coefficient. All cultivars of Laminaria japonica Aresch. used for breeding in China fell into one cluster. L. japonica from Japan, L. saccharina (L.) Lam., and L. angustata Kjellm. formed the other cluster and showed higher genetic variation than L. japonica from China. Nuclear ribosomal DNA (rDNA) sequences, including internal transcribed spacers (ITS1 and ITS2) were studied and aligned. The nucleotides of the sequences ranged from 634 to 668, with a total of 692 positions including TTS1, ITS2, and the 5.8S coding region. The phylogenetic tree obtained by the neighbor-joining method favored, to some extent, the results revealed by RAPD analysis. The present study indicates that RAPD and ITS analyses could be used to identify and assess Laminaria germplasm and to distinguish some species and, even intraspecies, in Laminaria.

Control of Mean and Fluctuating Forces on a Circular Cylinder at High Reynolds Numbers

A narrow strip is used to control mean and fluctuating forces on a circular cylinder at Reynolds numbers from 2.0 x 10(4) to 1.0 x 10(5). The axes of the strip and cylinder are parallel. The control parameters are strip width ratio and strip position characterized by angle of attack and distance from the cylinder. Wind tunnel tests show that the vortex shedding from both sides of the cylinder can be suppressed, and mean drag and fluctuating lift on the cylinder can be reduced if the strip is installed in an effective zone downstream of the cylinder. A phenomenon of mono-side vortex shedding is found. The strip-induced local changes of velocity profiles in the near wake of the cylinder are measured, and the relation between base suction and peak value in the power spectrum of fluctuating lift is studied. The control mechanism is then discussed from different points of view.

Growth of zero-mean-shear turbulent-mixed layer with suspended particles in a 2-layer fluid system

The growth behaviour of zero-mean-shear turbulent-mixed layer containing suspended solid particles has been studied experimentally and analysed theoretically in a two-layer fluid system. The potential model for estimating the turbulent entrainment rate of the mixed layer has also been suggested, including the results of the turbulent entrainment for pure two-layer fluid. The experimental results show that the entrainment behaviour of a mixed layer with the suspended particles is well described by the model. The relationship between the entrainment distance and the time, and the variation of the dimensionless entrainment rate E with the local Richardson number Ri1 for the suspended particles differ from that for the pure two-layer fluid by the factors-eta-1/5 and eta-1, respectively, where eta = 1 + sigma-0-DELTA-rho/DELTA-rho-0.

Parallel optical negabinary arithmetic based on logic operations

On the basis of signed-digit negabinary representation, parallel two-step addition and one-step subtraction can be performed for arbitrary-length negabinary operands.; The arithmetic is realized by signed logic operations and optically implemented by spatial encoding and decoding techniques. The proposed algorithm and optical system are simple, reliable, and practicable, and they have the property of parallel processing of two-dimensional data. This leads to an efficient design for the optical arithmetic and logic unit. (C) 1997 Optical Society of America.

Compact parallel optical modified-signed-digit arithmetic-logic array processor with electron-trapping device

A compact two-step modified-signed-digit arithmetic-logic array processor is proposed. When the reference digits are programmed, both addition and subtraction can be performed by the same binary logic operations regardless of the sign of the input digits. The optical implementation and experimental demonstration with an electron-trapping device are shown. Each digit is encoded by a single pixel, and no polarization is included. Any combinational logic can be easily performed without optoelectronic and electro-optic conversions of the intermediate results. The system is compact, general purpose, simple to align, and has a high signal-to-noise ratio. (C) 1999 Optical Society of America.

Classified one-step modified signed-digit arithmetic and its optical implementation

Based on the two-step modified signed-digit (MSD) algorithm, we present a one-step algorithm for the parallel addition and subtraction of two MSD numbers. This algorithm is reached by classifying the three neighboring digit pairs into 10 groups and then making a decision on the groups. It has only a look-up truth table, and can be further formulated by eight computation rules. A joint spatial encoding technique is developed to represent both the input data and the computation rules. Furthermore, an optical correlation architecture is suggested to implement the MSD adder in parallel. An experimental demonstration is also given. (C) 1996 Society of Photo-Optical instrumentation Engineers.

Mean-field study of Fe2+- and Co2+-doped diluted magnetic semiconductors

Based on a modified mean-field model, we calculate the Curie temperatures of Fe2+- and Co2+-doped diluted magnetic semiconductors (DMSs) and their dependence on the hole concentration. We find that the Curie temperatures increase with an increase in hole concentration and the relationship T(C)proportional to p(1/3) also approximately holds for Fe2+- and Co2+-doped systems with moderate hole concentration. For either low or high hole concentrations, however, the p(1/3) law is violated due to the anomalous magnetization of the Fe2+ and Co2+ ions, and the nonparabolic nature of the hole bands. Further, the values of T-C for Fe2+- and Co2+-doped DMSs are significantly higher than those for Mn2+-doped DMSs, due to the larger exchange interaction strength.

Electronic structure of Mn-doped ZnO quantum wires: A mean-field theory study

Based on the effective-mass model and the mean-field approximation, we investigate the energy levels of the electron and hole states of the Mn-doped ZnO quantum wires (x=0.0018) in the presence of the external magnetic field. It is found that either twofold degenerated electron or fourfold degenerated hole states split in the field. The splitting energy is about 100 times larger than those of undoped cases. There is a dark exciton effect when the radius R is smaller than 16.6 nm, and it is independent of the effective doped Mn concentration. The lowest state transitions split into six Zeeman components in the magnetic field, four sigma(+/-) and two pi polarized Zeeman components, their splittings depend on the Mn-doped concentration, and the order of pi and sigma(+/-) polarized Zeeman components is reversed for thin quantum wires (R < 2.3 nm) due to the quantum confinement effect.